调理剂和通风方式对污泥生物干化效果的影响

采用了自主设计的污泥生物干化实验室模拟系统,研究了调理剂、物料配比和通风方式等实验条件对脱水污泥生物干化的影响效果。研究结果表明,与锯末相比,秸秆有利于反应物料温度的上升,含水率下降程度更大;利用秸秆调节污泥初始含水率在60%和65%的实验条件下时,物料的平均含水率分别下降了7%和6%,当初始含水率65%时,生物堆体的温度和含水率没有明显的变化;与连续通风相比较,间歇通风的实验条件有利于生物堆体的温度的升高和干化效果;在该实验中,最佳的生物干化条件是以秸秆为调理剂,初始含水率调至65%以下,以间歇方式进行通风。     

生态功能区划在县域可持续发展指标体系中的应用

在分析县域可持续发展指标体系特点的基础上,从生态功能区划依据的原则、目标等方面,深入论述了生态功能区划在县域可持续发展指标体系中的三方面作用,提出了应用生态功能区划结果对某一区域内不同县域的可持续发展状况分类别进行评价的观点。     

中国石油HSE专业标准化工作探讨

简要回顾了中国石油HSE标准化工作的历程,综合分析了HSE标准化工作面临的形势任务,对改进中国石油HSE标准化工作思路进行了探讨,明确了指导思想、遵循原则、重点工作,并提出做好HSE标准化工作要处理好四个方面关系的原则。     

Characterization of PM10 atmospheric aerosol at urban and urban background sites in Fuzhou city, China

Background

PM₁₀ aerosol samples were simultaneously collected at two urban and one urban background sites in Fuzhou city during two sampling campaigns in summer and winter. PM₁₀ mass concentrations and chemical compositions were determined.

Methods

Water-soluble inorganic ions (Cl^?, NO ₃ ^? , SO ₄ ^2? , NH ₄ ⁺ , K⁺, Na⁺, Ca²⁺, and Mg²⁺), carbonaceous species (elemental carbon and organic carbon), and elements (Al, Si, Mg, K, Ca, Ti, V, Cr, Mn, Fe, Ni, Cu, Zn, As, Se, Br, and Pb) were detected using ion chromatography, thermal/optical reflectance, and proton-induced X-ray emission methods, respectively.

Results

PM₁₀ mass concentrations, as well as most of the chemical components, were significantly increased from urban background to urban sites, which were due to enhanced anthropogenic activities in urban areas. Elements, carbonaceous species, and most of the ions were more uniformly distributed at different types of sites in winter, whereas secondary ion SO ₄ ^2? , NO ₃ ^? , and NH ₄ ⁺ showed more evident urban-background contrast in this season. The chemical mass closure indicated that mineral dust, organic matters, and sulfate were the most abundant components in PM₁₀. The sum of individually measured components accounted for 86.9?C97.7% of the total measured PM₁₀ concentration, and the discrepancy was larger in urban area than in urban background area.

Conclusion

According to the principal component analysis?Cmultivariate linear regression model, mineral dust, secondary inorganic ions, sea salt, and motor vehicle were mainly responsible for the PM₁₀ particles in Fuzhou atmosphere, and contributed 19.9%, 53.3%, 21.3%, and 5.5% of PM₁₀, respectively.     

混合硫酸盐还原菌代谢过程的影响因素

采用间歇实验,研究不同初始pH、Fe2+投加量、COD/SO24-及NO3-/SO24-比值等因素对SRB还原硫酸盐效果与速率的影响。实验结果表明:中性条件下(pH=7),硫酸盐的去除效果最佳,去除率达到84.66%,还原速率为15.07 mg/(L.h),在初始pH为4～9的范围内,体系具有较好的缓冲能力;当COD/SO24-比值为3时,反应209 h,硫酸盐去除率为85.33%,还原速率为8.16 mg/(L.h),随着反应的进行,体系的pH趋于中性;当溶液中有亚铁离子存在,且浓度为0～200 mg/L时可促进硫酸盐还原菌的生长,提高其对硫酸盐的去除率;NO3-对硫酸盐的还原有明显的抑制作用。     

SMBR处理含油废水出水COD数学模型

根据微生物生长动力学特征以及膜分离特征,建立恒通量下运行的一体式膜生物反应器系统出水COD数学模型,提出膜生物反应器处理效率的数学模型。以实验及模型为基础,分别对进水COD浓度控制在300、400、500 mg/L附近时经过反应器后COD的去除效率进行了比较。通过公式计算的数据和实验数据分析可得:COD去除率的公式计算值与实验结果比较吻合,相对偏差仅为0.0223,为膜系统有机物的去除效果估算提供了基础,可为该类工艺的参数选择与优化提供参考。     

强制循环厌氧反应器处理中低浓度废水

为解决内循环厌氧反应器在对低浓度有机废水处理时,因产气量不足、内循环量小而不能正常运行的问题,提出了强制循环反应器的概念,给出了设计方法。以低浓度、碱性印染工业废水为研究对象,进行了强制循环厌氧反应器的启动与运行的研究,得出了该反应器的最佳HRT和最佳外加循环量。结果表明:在高硫、低性状絮状厌氧泥为接种泥情况下,最佳外循环流量1 m3/h,最佳HRT为7 h时,FCR出水的T-COD和S-COD去除率分别为53.6%和58%。     

掺碘二氧化钛薄膜自组装制备、表征及光催化性能

通过自组装技术在低温液相反应体系中制备出大尺寸纳米二氧化钛及其掺碘薄膜。使用XRD、TEM、荧光发射光谱仪、激光拉曼光谱仪等手段对样品进行表征,发现掺I^5＋后的二氧化钛薄膜在可见光区也表现出明显的响应,而且合成的I^5＋／TiO2纳米薄膜在TEMggNT其晶型显示为金红石型,并且碘掺杂后样品的拉曼光谱强度减弱,峰位蓝移且宽化。掺杂I^5＋原溶液浓度为2mmol／L时,其可见光下光催化效果最优,5h后降解率可达到95％,较未掺杂的TiO2纳米薄膜提高了40％,I^5＋掺杂明显提高了TiO2对甲基橙溶液的光催化降解效率。     

Biosorption of divalent Pb, Cd and Zn on aragonite and calcite mollusk shells

The potential of using mollusk shell powder in aragonite (razor clam shells, RCS) and calcite phase (oyster shells, OS) to remove Pb²⁺, Cd²⁺ and Zn²⁺ from contaminated water was investigated. Both biogenic sorbents displayed very high sorption capacities for the three metals except for Cd on OS. XRD, SEM and XPS results demonstrated that surface precipitation leading to crystal growth took place during sorption. Calcite OS displayed a remarkably higher sorption capacity to Pb than aragonite RCS, while the opposite was observed for Cd. However, both sorbents displayed similar sorption capacities to Zn. These could be due to the different extent of matching in crystal lattice between the metal bearing precipitate and the substrates. The initial pH of the solution, sorbent’s dosage and grain size affected the removal efficiency of the heavy meals significantly, while the organic matter in mollusk shells affected the removal efficiency to a lesser extent.     

Highly efficient decolorization of Malachite Green by a novel Micrococcus sp. strain BD15

Purpose

Malachite Green (MG) is used for a variety of applications but is also known to be carcinogenic and mutagenic. In this study, a novel Micrococcus sp. (strain BD15) was observed to efficiently decolorize MG. The purposes of this study were to explore the optimal conditions for decolorization and to evaluate the potential use of this strain for MG decolorization.

Methods

Optical microscope and UV?Cvisible analyses were carried out to determine whether the decolorization was due to biosorption or biodegradation. A Plackett?CBurman design was employed to investigate the effect of various parameters on decolorization, and response surface methodology was then used to explore the optimal decolorization conditions. Kinetics analysis and antimicrobial activity tests were also performed.

Results

The results indicated that the decolorization by the strain was mainly due to biodegradation. Concentrations of MG, urea, and yeast extract and inoculum size had significantly positive effects on MG decolorization, while concentrations of CuCl₂ and MgCl₂, and temperature had significantly negative effects. The interaction between different parameters could significantly affect decolorization, and the optimal conditions for decolorization were 1.0 g/L urea, 0.9 g/L yeast extract, 100 mg/L MG, 0.1 g/L inoculums (dry weight), and incubation at 25.2°C. Under the optimal conditions, 96.9% of MG was removed by the strain within 1 h, which represents highly efficient microbial decolorization. Moreover, the kinetic data for decolorization fit a second-order model well, and the strain showed a good MG detoxification capability.

Conclusion

Based on the results of this study, we propose Micrococcus sp. strain BD15 as an excellent candidate strain for MG removal from wastewater.