Air pollutant concentrations near three Texas roadways, part II: Chemical characterization and transformation of pollutants

Spatial gradients of vehicular emitted air pollutants were measured in the vicinity of three roadways in the Austin, Texas area: (1) State Highway 71 (SH-71), a heavily traveled arterial highway dominated by passenger vehicles; (2) Interstate 35 (I-35), a limited access highway north of Austin in Georgetown; and (3) Farm to Market Road 973 (FM-973), a heavily traveled surface roadway with significant truck traffic. A mobile monitoring platform was used to characterize the gradients of CO and NO_x concentrations with increased distance from each roadway, while concentrations of carbonyls in the gas-phase and fine particulate matter mass and composition were measured at stationary sites upwind and at one (I-35 and FM-973) or two (SH-71) downwind sites. Regardless of roadway type or wind direction, concentrations of carbon monoxide (CO), nitric oxide (NO), and oxides of nitrogen (NO_x) returned to background levels within a few hundred meters of the roadway. Under perpendicular wind conditions, CO, NO and NO_x concentrations decreased exponentially with increasing distance perpendicular to the roadways. The decay rate for NO was more than a factor of two greater than for CO, and it comprised a larger fraction of NO_x closer to the roadways than further downwind suggesting the potential significance of near roadway chemical processing as well as atmospheric dilution. Concentrations of most carbonyl species decreased with distance downwind of SH-71. However, concentrations of acetaldehyde and acrolein increased farther downwind of SH-71, suggesting chemical generation from the oxidation of primary vehicular emissions. The behavior of particle-bound organic species was complex and further investigation of the size-segregated chemical composition of particulate matter (PM) at increasing downwind distances from roadways is warranted. Fine particulate matter (PM_2.5) mass concentrations, polycyclic aromatic hydrocarbons (PAHs), hopanes, and elemental carbon (EC) concentrations generally exhibited concentrations that decreased with distance downwind of SH-71. Concentrations of organic carbon (OC) increased from upwind concentrations immediately downwind of SH-71 and continued to increase further downwind from the roadway. This behavior may have primarily resulted from condensation of semi-volatile organic species emitted from vehicle sources with transport downwind of the roadway.     

Hormesis and plant biology

A database has been developed that demonstrates experimental evidence of hormesis. It includes information from a broad range of biological models, including plants, and information on study design, dose-response features, and physical/chemical properties of the agents. An assessment of plant hormetic dose responses is presented based on greater than 3000 plant endpoints. Plant hormetic dose responses were observed for numerous endpoints including disease incidence, reproductive indices, mutagenic endpoints, various metabolic parameters, developmental processes, and a range of growth indicators. Quantitative features of these dose responses typically display a maximum stimulatory response less than two-fold greater than controls and a width of the stimulatory response usually less than 10-fold in dose range. The database establishes that hormetic dose responses commonly occur in plants, are broadly generalizable, and have quantitative features similar to hormetic dose responses found for animals.     

Evaluation of best management practice products in preventing discharge of metals: a laboratory evaluation

Heavy metal accumulation in soil poses serious environmental and health risks, as metals are carried with eroded soils. In this study, 17 different soil erosion and sediment control products were investigated for their effectiveness in controlling transport of particulate heavy metals (Cu, Zn, Pb, Cd). Among the treatments investigated, wood mulch and tackifiers were found to be the most effective in reducing total suspended solids (TSS) and total heavy metal losses. They reduced TSS to an undetectable level during short-term simulation tests. Paper mulch was the only treatment that had no significant reduction in both total metal loss and TSS. Fiber rolls, silt fences, and gravel bags were effective in reducing sediment loss. Although the netting/blanket treatments were not effective in reducing total metal discharge, they significantly reduced sediment loss compared with the control.     

South Pole Antarctica observations and modeling results: New insights on HOx radical and sulfur chemistry

Measurements of OH, H₂SO₄, and MSA at South Pole (SP) Antarctica were recorded as a part of the 2003 Antarctic Chemistry Investigation (ANTCI 2003). The time period 22 November, 2003–2 January, 2004 provided a unique opportunity to observe atmospheric chemistry at SP under both natural conditions as well as those uniquely defined by a solar eclipse event. Results under natural solar conditions generally confirmed those reported previously in the year 2000. In both years the major chemical driver leading to large scale fluctuations in OH was shifts in the concentration levels of NO. Like in 2000, however, the 2003 observational data were systematically lower than model predictions. This can be interpreted as indicating that the model mechanism is still missing a significant HO_x sink reaction(s); or, alternatively, that the OH calibration source may have problems. Still a final possibility could involve the integrity of the OH sampling scheme which involved a fixed building site. As expected, during the peak in the solar eclipse both NO and OH showed large decreases in their respective concentrations. Interestingly, the observational OH profile could only be approximated by the model mechanism upon adding an additional HO_x radical source in the form of snow emissions of CH₂O and/or H₂O₂. This would lead one to think that either CH₂O and/or H₂O₂ snow emissions represent a significant HO_x radical source under summertime conditions at SP. Observations of H₂SO₄ and MSA revealed both species to be present at very low concentrations (e.g., 5 × 10⁵ and 1 × 10⁵ molec cm^?3, respectively), but similar to those reported in 2000. The first measurements of SO₂ at SP demonstrated a close coupling with the oxidation product H₂SO₄. The observed low concentrations of MSA appear to be counter to the most recent thinking by glacio-chemists who have suggested that the plateau's lower atmosphere should have elevated levels of MSA. We speculate here that the absence of MSA may reflect efficient atmospheric removal mechanisms for this species involving either dynamical and/or chemical processes.     

Verification of diffusive and pumped samplers for volatile organic compounds using a controlled atmosphere test facility

There is a requirement to verify the performance of sorbent-based passive or active samplers and to extend their use, where possible, to monitor volatile organic compounds (VOCs) that are known to be photochemical ozone pre-cursors or are relevant to the activities of the petrochemical industry. We report measurements of the 14-day diffusive uptake rates for the VOCs: i-butane (2-methyl propane), n-butane, i-pentane (2-methyl butane), n-pentane, n-hexane, benzene, toluene, and m-xylene (at environmental level concentrations) for industry standard axial samplers (Perkin–Elmer-type samplers) containing the sorbents Carbopack-X, -Z, -B or Tenax-TA. We also present data on back-diffusion, blank levels, and storage for the above sorbents, and describe the simultaneous use of the sorbent Carbopack-X for pumped sampling of certain VOCs. The results were obtained by dosing samplers in a controlled atmosphere test facility (CATFAC) operating under well-defined conditions of concentration, nominal temperature of 20 °C, wind speed of 0.5 m s^?1, and relative humidities of 0% and 80%. Field measurements were also obtained to provide supplementary data to support the laboratory study. Results are compared to existing published data, where these are available.     

Chromium speciation and fractionation in ground and surface waters in the vicinity of chromite ore processing residue disposal sites

Chromium concentrations of up to 91 mg l(-1) were found by ICP-OES for ground water from nine boreholes at four landfill sites in an area of S.E. Glasgow/S. Lanarkshire where high-lime chromite ore processing residue (COPR) from a local chemical works had been deposited from 1830 to 1968. Surface water concentrations of up to 6.7 mg l(-1) in a local tributary stream fell to 0.11 mg l(-1) in the River Clyde. Two independent techniques of complexation/colorimetry and speciated isotope dilution mass spectrometry (SIDMS) showed that Cr was predominantly (>90%) in hexavalent form (CrVI) as CrO4(2-), as anticipated at the high pH (7.5-12.5) of the sites. Some differences between the implied and directly determined concentrations of dissolved CrIII, however, appeared related to the total organic carbon (TOC) content. This was most significant for the ground water from one borehole that had the highest TOC concentration of 300 mg l(-1) and at which < 3% of Cr was in the form of CrVI. Subsequent ultrafiltration produced significant decreases in Cr concentration with decreasing size fractions, e.g. <0.45 microm, < 100 kDa, <30 kDa and < 1 kDa by the tangential-flow method. As this appeared related more to concentrations of humic substances than of TOC per se, horizontal bed gel electrophoresis of freeze-dried ultrafilter retentates was carried out to further characterise the CrIII-organic complex. This showed for the main Cr-containing fraction, 100 kDa-0.45 microm, that the Cr was associated with a dark brown band characteristic of organic (humic) matter. Comparison of gel electrophoresis and FTIR results for ultrafilter retentates of ground water from this borehole with those for a borehole at another site where CrVI predominated suggested the influence of carboxylate groups, both in reducing CrVI and in forming soluble CrIII-humic complexes. The implications of this for remediation strategies (especially those based on the addition of organic matter) designed to reduce highly mobile and carcinogenic Cr(VI)O4(2-) to the much less harmful CrIII as insoluble Cr(OH)3 are discussed.     

Examples of the role of analytical chemistry in environmental risk management research

Analytical chemistry is an important tier of environmental protection and has been traditionally linked to compliance and/or exposure monitoring activities for environmental contaminants. The adoption of the risk management paradigm has led to special challenges for analytical chemistry applied to environmental risk analysis. Namely, methods developed for regulated contaminants may not be appropriate and/or applicable to risk management scenarios. This paper contains examples of analytical chemistry applied to risk management challenges broken down by the analytical approach and analyte for some selected work in our laboratory. Specific techniques discussed include stable association complex electrospray mass spectrometry (cESI-MS), gas chromatography-mass spectrometry (GC-MS), split-flow thin cell (SPLITT) fractionation and matrix-assisted laser desorption time of flight mass spectrometry (MALDI-ToF-MS). Specific analytes include haloacetic acids (HAA9), perchlorate, bromate, triazine degradation products, metal-contaminated colloids and Cryptosporidium parvum oocysts.     

Performance of poly(vinyl alcohol) gel columns on the ion chromatographic determination of perchlorate in fertilizers

Interest in possible sources of perchlorate (ClO4) that could lead to environmental release has been heightened since the Environmental Protection Agency placed this anion on its Contaminant Candidate List for drinking water. Although recent investigations have suggested that fertilizers are minor contributors to environmental perchlorate contamination overall, there is still interest in screening commercial products for possible contamination and quantitating perchlorate when it is found. Ion chromatography (IC) has been used for this application owing to its speed, low detection limits, widespread availability, and moderate ruggedness relative to other techniques. However, fertilizer matrixes complicate the IC analysis relative to potable water matrixes. In this study, the performance of poly(vinyl alcohol) gel resin IC columns (100 mm and 150 mm) was evaluated for fertilizer matrixes using method EPA/600/R-01/026. The NaOH eluent included an organic salt, sodium 4-cyanophenoxide. Detection was by suppressed conductivity. A set of 55 different field samples representing 48 products and previously used by the EPA to assess occurrence of perchlorate in fertilizers (EPA/600/R-01/049) was reanalyzed on the 150 mm column. The 100 mm column was used to further investigate the positive hits. Both columns gave satisfactory performance in fertilizer matrixes, with spike recoveries (+/- 15%), assured reporting levels (0.5-225 microg g(-1) except for one at 1,000 microg g(-1)), accuracy (relative error < 30% always and most < 15%), and precision [injection-to-injection reproducibility < 3% relative standard deviation (RSD)] comparable to those reported in other studies. Performance did not vary substantially between column lengths. Lastly, the results of this investigation provided further evidence in support of the conclusions that had been reached previously by the EPA on the occurrence of perchlorate in fertilizers.     

Dynamics in the global protected-area estate since 2004

Nations of the world have committed to a number of goals and targets to address global environmental challenges. Protected areas have for centuries been a key strategy in conservation and play a major role in addressing current challenges. The most important tool used to track progress on protected-area commitments is the World Database on Protected Areas (WDPA). Periodic assessments of the world's protected-area estate show steady growth over the last 2 decades. However, the current method, which uses the latest version of the WDPA, does not show the true dynamic nature of protected areas over time and does not provide information on sites removed from the WDPA. In reality, this method can only show growth or remain stable. We used GIS tools in an approach to assess protected-area change over time based on 12 temporally distinct versions of the WDPA that quantify area added and removed from the WDPA annually from 2004 to 2016. Both the narrative of continual growth of protected area and the counter-narrative of protected area removal were overly simplistic. The former because growth was almost entirely in the marine realm and the latter because some areas removed were reprotected in later years. On average 2.5 million km² was added to the WDPA annually and 1.1 million km² was removed. Reasons for the inclusion and removal of protected areas in the WDPA database were in part due to data-quality issues but also to on-the-ground changes. To meet the 17% protected-area component of Aichi Biodiversity Target 11 by 2020, which stood at 14.7% in 2016, either the rate of protected-area removal must decrease or the rate of protected-area designation and addition to the WDPA must increase.