Comparison of nitrification rates in conventional and membrane-assisted biological nutrient removal processes

A membrane-assisted and a conventional activated sludge system, both operated in an enhanced biological phosphorus removal (EBPR) mode and under identical operating conditions, were studied to investigate the effect of the membrane solids-liquid separation on nitrification activity. Both the membrane EBPR (MEBPR) and conventional EBPR (CEBPR) processes achieved stable and complete removal of ammonium-nitrogen from the influent wastewater. However, when the intrinsic nitrification activity was assessed in offline batch tests, the CEBPR mixed liquor exhibited 15 to 75% greater nitrification potential than the MEBPR counterpart. These results were further validated by monitoring nitrification rates of conventional mixed liquor as it evolved toward a membrane mixed liquor. It was also demonstrated that the larger aerobic mass fraction of the MEBPR system could not be the only factor influencing the reduced intrinsic nitrification rate. The present study strongly suggests that the presence of a membrane solids-liquid separation per se may be sufficient to alter the nitrification kinetics of an EBPR mixed liquor and that this possibility should be considered in arriving at an appropriate process design.     

A Rating of the Major Air Pollutants and Their Sources by Effect

The available national annual air pollution emissions are based on mass. Different air pollutants have greatly different toxicities per unit mass, hence the emissions should be rated by effect, not by mass, so that more sensible priorities can be set in control research and regulation. Effect factors are derived from the health effect literature indirectly by using the national ambient air quality standards. The resulting analysis by effects shows transportation to be still the largest source as it is in the mass analysis while hydrocarbons become the largest pollutants by effect compared to carbon monoxide being the largest pollutant by mass.     

Development and validation of a method for analysis of "dioxin-like" PCBs in environmental samples from the steel industry

A method, previously used for determination of 2,3,7,8-substituted polychlorinated dibenzo-p-dioxins (PCDDs) and polychlorinated dibenzofurans (PCDFs), has been modified for quantitative analysis of "dioxin-like" polychlorobiphenyls (PCBs) in environmental samples from the steel industry. The existing sample clean-up procedure, involving liquid chromatography on multi-layered silica and Florisil columns, has been extended to include a third chromatography stage on a basic alumina stationary phase. The additional clean-up stage is required for PCB analysis in order to eliminate interferences from relatively large concentrations of saturated cyclic and aliphatic hydrocarbons. Samples were analysed for WHO-12 congeners using high resolution gas chromatography/high resolution mass spectrometry (HRGC/HRMS) and standard solutions of the method US EPA 1668A. Replicate analysis of method blanks revealed background contamination for PCBs 118, 105 and 77, which are generally abundant in ambient air. These contaminants were taken into account using a subtraction method. The entire procedure was validated by replicate analysis (N = 3) of a certified reference sediment. The RSD for each WHO-12 congener was below 15%, 13C12-labelled PCB internal standard recoveries were in the range 70-95%. A waste dust sample collected in the electrostatic precipitator of a UK sinter plant was analysed for determination of PCDD/Fs and WHO-12 PCBs and exhibited a PCDD/F I-TEQ of 148.5 +/- 21.2 ngkg(-1) and a WHO-TEQ of 7.2 +/- 1.5 ngkg(-1). WHO-12 congeners contributed only 4.6% to the overall TEQ and PCB 126 was the major congener contributing to the WHO-TEQ (96%). The contribution to the overall TEQ of the waste dust sample was mainly attributed to PCDF followed by PCDD, which accounted for 86.6% and 8.7% to the overall TEQ, respectively.     

The Southeastern Aerosol Research and Characterization Study: part 1--Overview

This paper presents an overview of a major, long-term program for tropospheric gas and aerosol research in the southeastern United States. Building on three existing ozone (O3)-focused research sites begun in mid-1992, the Southeastern Aerosol Research and Characterization Study (SEARCH) was initiated in mid-1998 as a 7-year observation and research program with a broader focus including aerosols and an expanded geographical coverage in the Southeast. The monitoring network comprises four urban-rural (or urban-suburban) site pairs at locations along the coast of the Gulf of Mexico and inland, including two moderately sized and two major urban areas (Pensacola, FL; Gulfport, MS; Atlanta, GA; and Birmingham, AL). The sites are equipped with an extensive suite of instruments for measuring particulate matter (PM), gases relevant to secondary O3 and the production of secondary aerosol particles, and surface meteorology. The measurements taken to date have added substantially to the knowledge about the temporal behavior and geographic variability of tropospheric aerosols in the Southeast. Details are presented in four papers to follow.     

Proteomic insights into Lysinibacillus sp.-mediated biosolubilization of manganese

Environmental Science and Pollution Research - There has been alarming depletion of manganese (Mn) reserves owing to the ongoing extensive mining operations for catering the massive industrial...     

Congener-specific concentrations and carbon stable isotope ratios (delta13C) of two technical toxaphene products (Toxaphene and Melipax)

In this study we compared the contribution of individual congeners and the ratios of stable carbon isotopes of two technical toxaphene products. The former US-American product Toxaphene was from 1978 and the East-German product Melipax from 1979. Both technical products showed the known complexity in GC/ECD measurements. Contributions of 24 peaks to each of the technical products were determined by gas chromatography in combination high resolution electron capture negative ion mass spectrometry (GC/ECNI-HRMS). The percentages of the compounds studied in the technical mixtures ranged from approximately 0.05% to approximately 2.5% but showed some individual differences. 2,2,5,5,8,9,9,10,10-nonachlorobornane (B9-1025 or P-62) was identified as a major congener in both mixtures. 2-Endo,3-exo,5-endo,6-exo,8,8,10,10-octachlorobornane (B8-1413 or P26) and 2-endo,3-exo,5-endo,6-exo,8,8,9,10,10-nonachlorobornane (B9-1679 or P-50) were found at similar concentration in both technical products. Identical amounts of Melipax or Toxaphene were combusted to CO2 in an element analyzer and their delta13C values were determined relative to the international standard Vienna PeeDee belemnite (VPDB). The mean delta13C values of both products varied by 2.8% (determined at two different locations) which is roughly one order of magnitude more than the precision obtained in repetitive analyses of the individual products. Thus, both investigated products could be unequivocally distinguished by stable isotope ratio mass spectrometry (IRMS). IRMS analyses may thus be a suitable tool for tracing back toxaphene residues in environmental and food samples to the one or both of the products.     

First assessment of persistent organic pollutants in the Greater rhea (Rhea americana), a near-threatened flightless herbivorous bird of the Pampas grasslands

Environmental Science and Pollution Research - Persistent organic pollutants (POPs) are still globally distributed and can exert different effects on ecosystems. Little is known about the...