M3法测定土壤有效态Cd、Cr、Pb和Ni

通过M3法对耕地土壤重金属的联合测定,为土壤重金属污染监测应用提供快速联合测定的方法。用M3法测定北方耕地土壤的有效Cd、Cr、Pb和Ni,通过对M3法与其他方法进行有效重金属测定值差异性及其相关性比较,与全量的浸出率分析等探讨M3法对耕地土壤有效重金属测定的特征。结果表明,M3法在《土壤环境质量标准》(GB 15618—1995)的土壤重金属含量范围内可以测定土壤有效态重金属Cd、Cr、Pb和Ni,且呈线性极显著相关。M3法与其他方法有效Cd、Cr、Pb和Ni有较好的相关性,与DTPA法呈极显著相关;与NaNO₃法除有效Pb外,呈极显著和显著相关;与HCl法除褐土和潮土的有效Pb外,也呈极显著和显著相关。M3法的有效态Cd、Cr、Pb和Ni的测定值均为最大。M3法对4种耕地土壤有效Cd、Cr、Pb和Ni的浸出率,因土壤类型不同,有效重金属含量所占比率不同,但利用M3法测定的有效态Cd、Cr、Pb和Ni的浸出率最大。     

基于卫星遥感的广东地区对流层二氧化碳时空变化特征

利用瓦里关全球本底站和番禺气象局地面观测的CO2浓度资料对SCIAMACHY反演得到的对流层CO2产品进行验证.结果显示:SCIAMACHY产品能较好地反映对流层CO2的分布状况,在珠三角地区反演和观测的残差为1.29×10-6,相关系数为0.69,可用于分析区域对流层CO2的时空分布特征.利用2003~2009年SCIAMACHY观测资料分析研究显示:广东地区对流层CO2柱浓度最高值出现在春季,最低值出现在夏季,浓度年均值和年增长率分别为384.84′10-6和1.53′10-6/a,大于全球和我国同期的观测结果;粤东、粤西、粤北和珠三角地区的浓度均在春、冬季显著高于夏季、秋季 ,相同季节内各区域之间的差异不显著;粤西地区CO2柱浓度的年增长率最高,为1.82′10-6/a,珠三角和粤东地区的年增长率相当,分别为1.65,1.64′10-6/a,粤北地区的年增长率最低,为1.61′10-6/a.     

Survey of polycyclic aromatic hydrocarbons (PAHs) in arterial street air of Hangzhou

ＩｎｔｒｏｄｕｃｔｉｏｎＰｏｌｙｃｙｃｌｉｃａｒｏｍａｔｉｃｈｙｄｒｏｃａｒｂｏｎｓ (ＰＡＨｓ)ａｒｅｗｉｄｅｓｐｒｅａｄｅｎｖｉｒｏｎｍｅｎｔａｌｐｏｌｌｕｔａｎｔｓｉｎｔｈｅａｔｍｏｓｐｈｅｒｅ.Ｔｈｅｙａｒｅｇｅｎｅｒａｔｅｄｉｎｔｈｅｃｏｍｂｕｓｔｉｏｎ .Ｔｈｅｍａｊｏｒｓｏｕｒｃｅｓｉｄｅｎｔｉｆｉｅｄｉｎｃｌｕｄｅｆｏｓｓｉｌｆｕｅｌｓ,ｖｅｈｉｃｕｌａｒｔｒａｆｆｉｃ,ｉｎｄｕｓｔｒｉａｌｐｒｏｃｅｓｓｅｓ,ｓｍｏｋｉｎｇａｎｄｄｏｍｅｓｔｉｃｈｅａｔｉｎｇ (Ｐｅｌｔｏｎｅｎ ,1995) .Ｔ…     

Status of air pollution in Beijing

A study has been made on elements organic constituents, TSP, SO2,NO2 of atmospheric pollutants in Beijing. 17 elements, and some PAHs, e. g. B(a)P, B(b, j, k)P, and B(g, h, i)P, in airborne particles by X-ray fluorescence spectroscopy and HPLC, GC/MS, have been determined respectively. It has been shown that the elements Pb, Zn, S and Cu were more enriched in fine particles and different valence states of sulfur at various sites. It was found that the concentrations of S6+ and S2-were more than 85% and less than 15% of the total sulfur respectively. Concentrations of major PAHs and sulfur-containing compounds increased in winter and in urban area. High values for Pb and Zn in city, Fe and Mn at industrial area and Cu, Al rural sites were obtained respectively. This implies the functions of different elemental sources of various sites. Thus, elements can be from distingushed anthropogenic and natural sources.The main contribution of SO2 was found of to have same seasonal variation as the anthropogenic el     

纹缟虾虎鱼对Cu~(2+)、Cd~(2+)和氨氮的毒性响应和敏感性分析

以纹缟虾虎鱼为受试生物,分别进行了Cu~(2+)、Cd~(2+)和氨氮为环境因子的急性毒性实验和氨氮慢性暴露实验,结合文献数据分析纹缟虾虎鱼对3种污染物的敏感性。结果表明,Cu~(2+)、Cd~(2+)和氨氮对纹缟虾虎鱼的EC50分别为4.527、40.408和63.182mg·L~(-1)。组织切片结果显示,氨氮暴露能够引起纹缟虾虎鱼肝组织结构退化,组织细胞畸变,其损伤程度随着氨氮浓度的升高而加剧。氨氮暴露对肠管未见明显影响。敏感性分析结果表明,纹缟虾虎鱼对Cu~(2+)、Cd~(2+)和氨氮的累积概率分别为83.33%、96.27%和90.48%,均表现为不敏感。在Cu~(2+)、Cd~(2+)和氨氮对海洋生物的敏感性排名中,纹缟虾虎鱼分别在第31/35、32/32和19/20位。在8~12种海洋鱼类中,纹缟虾虎鱼对上述3种污染物的敏感性都处在较低水平。     

特殊区域地表水环境背景值表征技术方法研究与应用

选取黑龙江省源头水保护区作为研究对象,根据DEM数据对保护区内随机布设的水质监测点控制单元进行划分并提取单元内的相关指标建立监测点背景特性量化模型,基于量化结果提出地表水环境背景值监测方案,建立背景值数据库.选取研究区自然属性指标与空间属性指标,以空间叠置技术与聚类分析方法对研究区地表水进行背景值分区,最终将黑龙江省分为六大地表水水质背景值地理分区,并计算了各分区地表水环境背景值表征范围.表征范围显示：依据现行标准进行水质评价,保护区内水质背景值已超出Ⅱ类水质标准限值.因此,基于水质背景值研究成果提出了考虑背景值影响下的水环境质量评价方法,并将方法应用于研究区,结果表明方法切实可行且优于单因子评价法.研究成果可为区域制定背景值影响下的水环境评价方法提供科学的数据支撑与理论依据.     

非离子型聚丙烯酰胺絮凝剂的制备及其絮凝性能

以丙烯酰胺（AM）和烷基酚聚醚（APAP）为单体,采用反相乳液聚合法制备了流动性好的非离子型聚丙烯酰胺絮凝剂（PAM-APAP）。考察了乳化剂和引发剂的种类、单体总质量分数、单体配比和反应温度等因素对聚合反应的影响。实验结果表明,制备PAM-APAP的最佳工艺条件为：单体总质量分数35%、m（AM）∶m（APAP）=9.0∶1.0、Span80+Tween80复配乳化剂加入量为油水总质量的7%、m（Span80）∶m（Tween80）=7.0∶1.5、V50加入量为单体总质量的1.5‰、反应温度50℃。PAM-APAP具有较好的絮凝效果,与其他絮凝剂相比用量较少,在加入量为100mg/L时,对聚合物驱油中产生的含聚合物污水的浊度去除率为87.9%,去油率为89.5%,且絮体不黏壁。     

Modelling local and synoptic scale influences on ozone concentrations in a topographically complex region of Southern Italy

A modelling study with the on-line coupled Eulerian chemical-weather model WRF/Chem for the Southern Italian region around Cosenza (Calabria) was conducted to identify the influences of synoptic scale meteorology, local scale wind systems and local emissions on ozone concentrations in this orographically complex region. Four periods of 5–7 days were chosen, one from each season, which had wind pattern characteristics representative of typical local climatological conditions, in order to study the local versus non-local impacts on ozone transport and formation. To account for the complex terrain, the horizontal resolution of the smallest modelling domain was 3 km. Model results were compared with measurements to demonstrate the capability of the model to reproduce ozone concentrations in the region. The comparison was favourable with a mean bias of ?1.1 ppb. The importance of local emissions on ozone formation and destruction was identified with the use of three different emission scenarios. Generally the influence of regional emissions on the average ozone concentration was small. However during periods when mountain-sea wind systems were well developed and synoptic scale winds were weak, the influence of local emissions from the urban area was at its greatest. The maximum influence of local emissions on ozone concentrations was 18 ppb.     

Isoprene emissions and climate

Biogenic volatile organic compounds (BVOCs) play an important role in atmospheric chemistry and the carbon cycle. Isoprene is quantitatively the most important of the non-methane BVOCs (NMBVOCs), with an annual emission of about 400–600 TgC; about 90% of this is emitted by terrestrial plants. Incorporating a mechanistic treatment of isoprene emissions within land-surface schemes has recently become a focus for the modelling community, the aim being to quantify the potential magnitude of associated climate feedbacks. However, these efforts are hampered by major uncertainties about why plants emit isoprene and the relative importance of different environmental controls on isoprene emission. The availability and reliability of observations of isoprene fluxes from different types of vegetation is limited, and this also imposes constraints on model development. Nevertheless, progress is being made towards the development of mechanistic models of isoprene emission which, in conjunction with atmospheric chemistry models, will ultimately allow improved quantification of the feedbacks between the terrestrial biosphere and climate under past and future climate states.     

Investigation of the positive artifact formation during sampling semi-volatile aerosol using wet denuders

Wet denuders are used in several steam-based semi-continuous aerosol monitors to avoid gaseous absorption artifacts and pre-humidify the air stream, while simultaneously allowing measurements of water-soluble gaseous species. Unlike dry denuders, wet denuders saturate the sample air stream with water vapor, which can lead to re-partitioning of water-soluble volatile species to the aerosol phase, thereby causing a positive artifact in aerosol measurements. This paper investigates the magnitude of the positive artifact formation occurring in wet denuders using modeling techniques. Gaseous nitric acid was used as an example of volatile water-soluble gas in both flat and annular wet denuders. We have also verified the occurrence of the positive artifact in a flat wet denuder through a laboratory experiment. The model results indicate that the magnitude of the artifact is rather limited under typical conditions being less than 2.5% of ambient nitric acid concentration for the flat denuder and less than 0.6% for the annular denuder. The magnitude of the artifact increases with condensational sink of the aerosol (i.e. with the mean aerosol size and number concentration) and aerosol water solubility. While the artifact is relatively small in the absolute sense, it could be substantial for aerosol nitrate measurements, especially in ammonia limited conditions, when the concentration of the nitric acid is high and the concentration of nitrate is low. Therefore, we recommend that the artifact is assessed regularly by replacing the wet denuder with a dry denuder.