Metallothionein induction and cadmium uptake in Bufo arenarum embryos following an acclimation protocol

Bufo arenarum embryos at the end of their embryonic development were acclimated to cadmium (Cd) by means of a 10-day treatment protocol. Embryos were processed for metallothionein (Mt) isolation and Cd and zinc (Zn) contents were measured. The results showed that: (1) the uptake of Cd in the experimental embryos was 7 microg/g embryo (wet weight) representing a bioaccumulation of Cd 255 times higher than in the maintaining medium; (2) a major Mt-like fraction was Cd-induced 7.8 times that in control embryos; two other protein fractions also bound Cd and Zn but were induced by Cd only about 2 and 1.4 times; (3) the Zn concentration was about 44 microg Zn/g embryo (wet weight) and did not change significantly (p>0.01) in the experimental embryos with respect to controls, but in acclimated embryos the essential metal was released from the Mts. The enhanced Mt synthesis and release of Zn from the native Mts are discussed in relation to the acclimation phenomenon.     

Surfactant solubilization of hydrophobic compounds in soil and water

The soil/water partition coefficient (K_d) of hexachlorobenzene (HCB) ranged from 220 1/kg to 1800 1/kg for eight soils having a wide range of physico-chemical properties. K_d normalised to soil organic carbon (K_oc) was found to be 28000 ± 4800 1/kg. Anionic surfactant dodecylsulphate (DS) present at concentrations above the critical micellar concentration (CMC) caused reductions in the apparent soil/water partition coefficient (K_d ^*) in the range of 3–26 times for most soils and up to 36–91 times for sandy soils. Below CMC, at environmentally relevant surfactant concentrations, K_d ^* was reduced by a factor of 1–13. For clay and calcareous soils significant adsorption/complexation/precipitation of DS occurred. At the lowest DS concentration this produced a two-fold increase in K_d ^*. At increasing DS concentrations this effect was shielded by the solubihzing effect from DS. Monomer (K_mn) and micellar (K_mc) surfactant/water partition coefficients for HCB were determined to be, 980 ± 190 1/kg and 21000 ± 1600 1/kg, respectively.     

Estimations of real-world N2O emissions from road vehicles by means of measurements in a traffic tunnel

Ambient air measurements of N2O, NOx, CO, and HC based on grab sampling were conducted in a major traffic tunnel in Sweden, that carries up to 4,000 vehicles per hour, in order to estimate real-world emissions of N2O for road traffic. Two different methods--relative and mass balance-were used to calculate a N2O emission factor for the mixed vehicle fleet, which gave an average emission factor, at average speeds of 30-70 km/h, of approximately 25 mg N2O/ km, with a range of 7-56 mg/km.     

Studies on metal content in the brown seaweed, Fucus vesiculosus, from the Archipelago of Stockholm

Concentrations of eleven metals (Al, Cd, Co, Cr, Cu, Fe, Mn, Ni, Pb, V and Zn) were determined in the brown seaweed Fucus vesiculosus collected from the Archipelago of Stockholm. Several factors which influence the metal content in the seaweed have been studied, including errors caused by epiphytes, sea exposure and differences depending on which part of the seaweed is analysed. It is concluded that, if all these factors are considered, Fucus vesiculosus plants are excellent bio-indicators of metal pollution. This is also demonstrated by a significant increase in metal content in transplanted Fucus vesiculosus near the city of Stockholm. The results from this investigation also indicate increasing metal concentrations, especially Cd, in samples from the northern parts of the Archipelago and the reason for this is discussed.     

Biopesticide and formulation processes based on starch industrial wastewater fortified with soybean medium

Abstract

The aim of this study was to produce Bacillus thuringiensis-based biopesticide using starch-producing industry wastewater (SIW) fortified with soybean medium and optimize the formulated product using different adjuvants. This study was necessary as low endotoxin concentration is obtained in formulated biopesticide when SIW alone is used as fermentation medium. The fermentation runs were conducted using SIW alone and SIW fortified with 25% soybean (w/v) medium in 2000?L and 150?L bioreactor, respectively. SIW supplemented with soybean medium showed an increase in cell count (from 1.95?×?10⁸ to 1.65?×?10⁹ CFU mL^–1), spore synthesis (from 1.5?×?10⁸ to 1.35?×?10⁹ CFU mL^–1) and endotoxin concentration (from 436 to 1170?μg mL^–1) when compared to SIW medium alone. The fermented broth was concentrated using continuous centrifugation and adjuvants were added for biopesticide formulation in order to enhance its resistance against UV rays and rainfastness. Entomotoxicity of the formulation produced using fermented broth of SIW fortified with soybean (38,000?IU μL^–1) was higher than that obtained by SIW medium alone (21,000?IU μL^–1), commercial biopesticide Foray 76B (20,000?IU μL^–1) and Btk sander’s (12,500?IU μL^–1).     

Impact of ozone on the growth of birch (Betula pendula) saplings

Saplings of one half-sib family of birch, Betula pendula, were exposed to three levels of ozone in open-top chambers (OTCs) during two growing seasons 1997-1998. The ozone treatments were non-filtered air (NF, accumulated daylight AOT40 over the two growing seasons of 3.0 l l-1 h), non-filtered air with extra ozone (NF+, accumulated daylight AOT40 of 27.3 l l-1 h) and non-filtered air with additional extra ozone (NF++, accumulated daylight AOT40 of 120 l l-1 h). The birch saplings, including the roots, were harvested after the first and second growing seasons. After the first growing season, the NF++ treatment reduced the total wood biomass by 22%, relative to the NF treatment. There was no further reduction of the total wood biomass in the NF++ treatment after the second growing season. The root biomass was reduced by 30% after the first growing season. The shoot/root ratio, as well as the proportional biomass of leaves, were increased by ozone during both years. The ozone impact on the relative growth rate was estimated to -2% per 10 l l-1 h daylight AOT40 per growing season.     

ESPR subject area 5 ‘Environmental Microbiology, (Bio)Technologies, Health Issues’

Goal, Scope and Background  Aquaculture activities are well known to be the major contributor to the increasing level of organic waste and toxic compounds in the aquaculture industry. Along with the development of intensive aquaculture in China, concerns are evoked about the possible effects of everincreasing aquaculture waste both on productivity inside the aquaculture system and on the ambient aquatic ecosystem. Therefore, it is apparent that appropriate waste treatment processes are needed for sustaining aquaculture development. This review aims at identifying the current status of aquaculture and aquaculture waste production in China. Main Features  China is the world’s largest fishery nation in terms of total seafood production volume, a position it has maintained continuously since 1990. Freshwater aquaculture is a major part of the Chinese fishery industry. Marine aquaculture in China consists of both land-based and offshore aquaculture, with the latter mostly operated in shallow seas, mud flats and protected bays. The environmental impacts of aquaculture are also striking. Results  Case studies on pollution hot spots caused by aquaculture have been introduced. The quality and quantity of waste from aquaculture depends mainly on culture system characteristics and the choice of species, but also on feed quality and management. Wastewater without treatment, if continuously discharged into the aquatic environment, could result in remarkable elevation of the total organic matter contents and cause considerable economy lost. Waste treatments can be mainly classified into three categories: physical, chemical and biological methods. Discussion  The environmental impacts of different aquaculture species are not the same. New waste treatments are introduced as references for the potential development of the waste treatment system in China. The most appropriate waste treatment system for each site should be selected according to the sites’ conditions and financial status as well as by weighing the advantages and disadvantages of each system. Strategies and perspectives for sustainable aquaculture development are proposed, with the emphasis on environmental protection. Conclusions  Negative effects of waste from aquaculture to aquatic environment are increasingly recognized, though they were just a small proportion to land-based pollutants. Properly planned use of aquaculture waste alleviates water pollution problems and not only conserves valuable water resources but also takes advantage of the nutrients contained in effluent. It is highly demanding to develop sustainable aquaculture which keeps stocking density and pollution loadings under environmental capacity. Recommendations and Perspectives  The traditional procedures for aquaculture waste treatment, mainly based on physical and chemical means, should be overcome by more site-specific approaches, taking into account the characteristics and resistibility of the aquatic environment. Further research needs to improve or optimize the current methods of wastewater treatment and reuse. Proposed new treatment technology should evaluate their feasibility at a larger scale for practical application. ESS-Submission Editor: Dr. Ding Wang (wangd@ihb.ac.cn)     

Cobalt-based alumina pillared zirconium phosphate catalysts for the selective catalytic reduction of NO by propane

A series of cobalt containing alumina pillared zirconium phosphate materials have been prepared by ion exchange or by impregnation, and fully characterised. The catalytic behaviour of these materials in the selective catalytic reduction of NO by propane, in excess of oxygen, at temperatures ranging between 350 and 550 degrees C, has been also evaluated. A maximum NO conversion close to 14% is obtained on Co-impregnated catalysts heated at 600 degrees C. The NO reduction seems to be related to the presence of Co3+, thus the calcination temperature of samples influences the resulting activity much more than the cobalt content.     

Concentrations of cadmium and other metals in Fucus vesiculosus L. and Fontinalis dalecarlica Br. Eur. from the northern Baltic Sea and the southern Bothnian Sea

Concentrations of Cd and ten other metals (Al, Co, Cr, Cu, Fe, Mn, Ni, Pb, V and Zn) were determined in the brown seaweed Fucus vesiculosus L. and the aquatic moss, Fontinalis dalecarlica Br. Eur. from the northern Baltic Sea and the southern Bothnian Sea. Elevated concentrations of metals were found in samples taken close to densely populated areas, such as Stockholm and Nyn?shamn. Very high concentrations of especially Zn were found in both Fucus and Fontinalis samples taken from the area south of the Gulf of G?vle. The results indicate that mining and industrial activities along the river Dal?lven are the main sources of Zn and several other metals. Cd concentrations in Fucus plants reached maximum values (24.5 mg kg(-1)) at the northern site. The gradual increase of Cd concentrations in Fucus plants northward could not be totally explained by the salinity gradient in the Baltic Sea; reasons for this are discussed in this paper.     

Comparison of vehicle exhaust emissions from modified diesel fuels

Three diesel fuels, one oil sand-derived (OSD) diesel serving as base fuel, one cetane-enhanced base fuel, and one oxygenate [diethylene glycol dimethyl ether (DEDM)]-blended base fuel, were tested for their emission characterizations in vehicle exhaust on a light-duty diesel truck that reflects the engine technology of the 1994 North American standard. Both the cetane-enhanced and the oxygenate-blended fuels were able to reduce regulated [CO, particulate matter (PM), total hydrocarbon (THC)] and nonregulated [polyaromatic hydrocarbons (PAHs), carbonyls, and other volatile organic chemicals] emissions, except for nitrogen oxides (NO(x)), compared with the base fuel. Although burning a fuel that contains oxygen could conceivably yield more oxygenated compounds in emissions, the oxygenate-blended diesel fuel resulted in reduced emissions of formaldehyde along with hydrocarbons such as benzene, 1,3-butadiene, and PAHs. Reductions in nitro-PAH emissions have been observed in both the cetane-enhanced and oxygenated fuels. This further demonstrates the benefits of using a cetane enhancer and the oxygenated fuel component.