印刷用铝基材碱洗废液的循环利用

对印刷用铝基材碱洗废液进行了循环利用研究。首先将高COD含量的碱洗废液进行除油脱色处理,通过石灰和硬脂酸的协同效应,使COD含量从26300mg／L降至480mg／L,色度降至60°;然后利用含铝碱性废液通过碳化法制备出结晶度66％的拟薄水铝石产品;最后对分离后的碱性废水按配方要求配制,对铝基材进行除油实验,经5次循环表明,除油效果和对铝基材的腐蚀率均100％达标。     

城市污泥桨叶式干化优化实验研究

桨叶式干化是一种高效的污泥干化处理技术,为了降低污泥含水率达到污泥减量减容效果,同时为后期的工程化应用提供依据和参考,实验采用倾斜盘式桨叶干燥机,以北京市污水处理厂污泥为研究对象,研究了不同滞留时间、污泥供给量、干燥机换热面积等因素对桨叶式干化处理后蒸发速度和污泥含水率的影响,并从处理效率以及与工程化应用数据对比分析等多方面考核,确定最佳工艺运行条件：使用0．5—0．8MPa的蒸气,蒸发速率达到14～21．8kg／（m^2·h）时,干化处理后污泥含水率〈40％。     

Aquatic plant debris improve phosphorus sorption into sediment under anoxic condition

The effects of plant debris on phosphorus sorption by anoxic sediment were investigated. Addition of plant debris significantly enhanced the decrease of soluble relative phosphorus (SRP) in overlying water at both 10 and 30 °C during the 30-day investigation. Both cellulose and glucose, two typical plant components, also clearly enhanced the SRP decrease in anoxic overlying water. The measurement of phosphorus (P) fractions in sediment revealed that the levels of unstable P forms were decreased by plant debris addition, whereas the opposites were true for stable P forms. However, under sterilized condition, plant debris/glucose addition has no effect on the SRP decrease in overlying water. Overall, our results suggested that plant debris improve P sorption into sediment under anoxic condition through a microorganism-mediated mechanism.     

鸟粪石循环利用处理高氨氮废水的热解行为

为了循环利用鸟粪石处理高氨氮废水,探讨了鸟粪石煅烧与加碱热解的脱氮率,利用电镜扫描(SEM)和X射线衍射(XRD)对2种热解产物进行了分析。鸟粪石煅烧条件为:温度100～225℃,时间1～5 h;加碱热解条件为:温度60～95℃,时间0.5～4 h,加碱量OH-∶NH4+摩尔比值0.4～1.5。结果表明,虽然XRD分析显示2种热解产物都已失去鸟粪石的特征峰,但是鸟粪石加碱热解效果更好,最佳热解条件为:加碱量OH-∶NH4+摩尔比值1,温度90℃,时间2 h,鸟粪石脱氮率95%以上;加碱热解产物表面为多孔状,完全失去了晶体结构;煅烧热解鸟粪石脱氮率仅为80%左右,热解产物晶体结构破坏不完全。鸟粪石在最佳条件下热解循环处理高氨氮废水,可循环使用6次,氨氮去除率80%以上,出水磷浓度小于8 mg/L。     

改性油页岩灰渣对水中DNBP吸附去除效果

采用PDMDAAC改性方法对油页岩灰渣进行改性,确定最佳改性方案,并研究了环境因素对改性油页岩灰渣吸附DNBP的影响。实验研究结果表明,油页岩灰渣经20 g/L 的PDMDAAC处理时,对DNBP的吸附能力最强。在吸附温度为30℃,初始溶液pH值为4的条件下,0.3 g 的改性油页岩灰渣对30.0 mg/L DNBP溶液50 mL,吸附120 min时,其吸附率达到94.48%以上。在实验条件下,改性油页岩灰渣对DNBP的吸附符合Langmuir和Freundlich等温吸附方程,相关系数分别为0.9985和0.9776,其对DNBP的理论饱和吸附量达到6.196 mg/g。改性油页岩灰渣对DNBP的吸附主要归因于离子交换和表面吸附作用。     

CS-Fe和CS-Fe/Ni的制备及其用于去除钴离子

以氯化铁为铁源,硼氢化钠为还原剂,壳聚糖为稳定剂,采用液相还原法制备壳聚糖稳定纳米铁（CS-Fe）;并以氯化铁为铁源,硫酸镍为镍源,硼氢化钠为还原剂,壳聚糖为稳定剂,采用液相还原共沉淀法制备壳聚糖稳定纳米铁镍（CS-Fe/Ni）。通过SEM、EDS、XRD、FT-IR等表征手段,对所制备的CS-Fe和CS-Fe/Ni的形貌及微观结构进行表征,并以Co²⁺为目标去除物评价CS-Fe和CS-Fe/Ni的反应活性。初步研究表明,制成的CS-Fe含有单质纳米铁,颗粒多数以30~90 nm球形颗粒为主;而CS-Fe/Ni材料中含有纳米铁镍,颗粒多数以30~60 nm球形颗粒为主;在相同的实验条件下,反应60 min,CS-Fe/Ni对Co²⁺的去除率高达100%,但是CS-Fe仅为88%,即CS-Fe/Ni对Co²⁺的去除率比CS-Fe高。     

餐厨垃圾和绿化废弃物混合堆肥的试用

以餐厨垃圾和绿化废弃物堆肥作为种植基质,研究了其不同堆肥比例对黑麦草(Lolium perenne L.)生长的影响。结果表明,将不同基质组分别施用后,黑麦草各项生长指标(植株高度、盖度、地上和地下生物量(干重))均良好,其中2#基质(80%土壤+20%堆肥)施用效果优于1#(90%土壤+10%堆肥)和3#(70%土壤+30%堆肥)基质。对比不同堆肥对黑麦草生长的影响发现,(80%+20%)堆肥6处理的黑麦草地上和地下生物量最大,分别约为40 g和28 g,第三茬草地上生物量(干重)与对照组相比增幅为164.3%,盖度达到了98%。本研究确定了堆肥和土壤的最佳配比以及最佳堆肥类型,不但可以解决其资源化再利用的问题,而且植物生长良好,表明该技术在城市绿化中具有一定的应用前景。     

Study on preparation method of <Emphasis Type="Italic">Zanthoxylum bungeanum</Emphasis> seeds kernel oil with zero trans-fatty acids

The seed of Zanthoxylum bungeanum (Z. bungeanum) is a by-product of pepper production and rich in unsaturated fatty acid, cellulose, and protein. The seed oil obtained from traditional producing process by squeezing or extracting would be bad quality and could not be used as edible oil. In this paper, a new preparation method of Z. bungeanum seed kernel oil (ZSKO) was developed by comparing the advantages and disadvantages of alkali saponification-cold squeezing, alkali saponification-solvent extraction, and alkali saponification-supercritical fluid extraction with carbon dioxide (SFE-CO₂). The results showed that the alkali saponification-cold squeezing could be the optimal preparation method of ZSKO, which contained the following steps: Z. bungeanum seed was pretreated by alkali saponification under the conditions of adding 10 %NaOH (w/w), solution temperature was 80 °C, and saponification reaction time was 45 min, and pretreated seed was separated by filtering, water washing, and overnight drying at 50 °C, then repeated squeezing was taken until no oil generated at 60 °C with 15 % moisture content, and ZSKO was attained finally using centrifuge. The produced ZSKO contained more than 90 % unsaturated fatty acids and no trans-fatty acids and be testified as a good edible oil with low-value level of acid and peroxide. It was demonstrated that the alkali saponification-cold squeezing process could be scaled up and applied to industrialized production of ZSKO.     

Enhanced excess sludge hydrolysis and acidification in an activated sludge side-stream reactor process with single-stage sludge alkaline treatment: a pilot scale study

A pilot-scale side-stream reactor process with single-stage sludge alkaline treatment was employed to systematically investigate characteristics of excess sludge hydrolysis and acidification with alkaline treatment and evaluate feasibility of recovering a carbon source (C-source) from excess sludge to enhance nutrient removal at ambient temperature. The resulting C-source and volatile fatty acid specific yields reached 349.19 mg chemical oxygen demand (COD)/g volatile suspended solids (VSS) d⁻¹ and 121.3 mg COD/g VSS d⁻¹, respectively, the process had excellent C-source recovery potential. The propionic-to-acetic acid ratio of the recovered C-source was 3.0 times that in the influent, which beneficially enhanced biological phosphorus removal. Large populations and varieties of hydrolytic acid producing bacteria cooperated with alkaline treatment to accelerate sludge hydrolysis and acidification. Physicochemical characteristics indicated that recovered C-source was derived primarily from extracellular polymeric substances hydrolysis rather than from cells disruption during alkaline treatment. This study showed that excess sludge as carbon source was successfully recycled by alkaline treatment in the process.

     

A comparative study of metal pollution and potential eco-risk in the sediment of Chaohu Lake (China) based on total concentration and chemical speciation

Total and extractable concentrations of Cu, Pb, and Zn were determined in surface sediments of west Chaohu Lake (China) by HCl-HNO₃-HF-HClO₄ digestion and an optimized BCR sequential extraction procedure, respectively. The metal pollution was evaluated by the enrichment factor approach, and the potential eco-risk was evaluated by the sediment quality guideline (SQG) and risk assessment code (RAC) assessments. The results indicated that both total and extractable metal concentrations were highly variable and were affected by sediment properties, even though the sediments were predominantly composed of <63-μm particles (>89 %). Enrichment factors of the metals based on the total and extractable concentrations all showed higher values in the northern lake area and decreasing values towards the south. This distribution indicated an input of anthropogenic metals via the Nanfei River. Anthropogenic Cu, Pb, and Zn in surface sediments showed comparable values for each metal based on the total and extractable concentrations, suggesting that anthropogenic Cu, Pb, and Zn resided predominantly in the extractable fractions. Sediment Cu had low eco-risk, and Pb and Zn had medium eco-risk by the SQG assessment, whereas the eco-risk rankings of Cu, Pb, and Zn were medium, low, and low–high, respectively, by the RAC assessment. Referencing to the labile (dilute acid soluble) metal concentrations, we deduced that the eco-risk of Cu may be largely overestimated by the RAC assessment, and the eco-risk of Pb may be largely overestimated by the SQG assessment. Overall, sediments Cu and Pb may pose low eco-risk, and Zn may pose low–high eco-risk.