Spatiotemporal distribution of arsineic species of oysters (Crassostrea gigas) in the coastal area of southwestern Taiwan

This study investigated total arsenic (As) and As species contents of oysters (Crassostrea gigas) in different production areas, seasons and sea locations on the southwestern coast of Taiwan. Analytical results indicate that contents of total As, arsenite, arsenate, dimethylarsinic acid, monomethylarsonic acid and arsenobetaine in oysters are 9.90 ± 3.68, 0.091 ± 0.104, 0.033 ± 0.038, 0.529 ± 0.284, 0.037 ± 0.046 and 3.94 ± 1.33 mg/g (dry wt), respectively. A ratio of inorganic As concentrations to total As concentrations is 1.26%. Total As contents of oysters cultured in the outer sea are statistically significantly lower than those of oysters cultured in the inner sea. The total As contents of oysters is the highest in Putai, where the blackfoot disease prevails. The low As contents in oysters is attributed to the low temperature in winter, which slows the metabolism of oysters. A maximum value is 33.37 μg/g (dry) in Putai in spring, because a considerable amount of aquacultural waste water with high As contents is discharged into adjacent drainage channels and rivers there during that season.     

Source attribution for mercury deposition in the contiguous United States: regional difference and seasonal variation

Quantifying the contribution of emission sources responsible for mercury deposition in specific receptor regions helps develop emission control strategies that alleviate the impact on ecosystem and human health. In light of the maximum available control technology (MACT) rules proposed by U.S. Environmental Protection Agency (EPA) and the ongoing intergovernmental negotiation coordinated by United Nations Environmental Programme (UNEP) for mercury, the Community Multiscale Air Quality Modeling System (CMAQ-Hg) was applied to estimate the source contribution in six subregions of the contiguous United States (CONUS). The considered source categories include electric generating units (EGU), iron and steel industry (IRST), other industrial point sources excluding EGU and IRST (OIPM), the remaining anthropogenic sources (RA), natural processes (NAT), and out-of-boundary transport (BC). It is found that, on an annual basis, dry deposition accounts for two-thirds of total annual deposition in CONUS (474 Mg yr(-1)), mainly contributed by reactive gaseous mercury (about 60% of total deposition). The contribution from large point sources can be as high as 75% near the emission sources (< 100 km), indicating that emission reduction may result in direct deposition decrease near the source locations. Out-of-boundary transport contributes from 68% (Northeast) to 91% (West Central) of total deposition. Excluding the contribution from out-of boundary transport, EGU contributes to about 50% of deposition in the Northeast, Southeast, and East Central regions, whereas emissions from natural processes are more important in the Pacific and West Central regions (contributing up to 40% of deposition). This suggests that the implementation of the new EPA MACT standards will significantly benefit only these three regions. Emission speciation is a key factor for local deposition. The source contribution exhibits strong seasonal variation. Deposition is greater in warm seasons due to stronger Hg0 oxidation. However, the contribution from anthropogenic sources is smaller in warm seasons because of larger emissions from natural processes and stronger vertical mixing that facilitates transport.     

A modeling study of coarse particulate matter pollution in Beijing: regional source contributions and control implications for the 2008 Summer Olympics

In the last 10 yr, Beijing has made a great effort to improve its air quality. However, it is still suffering from regional coarse particulate matter (PM10) pollution that could be a challenge to the promise of clean air during the 2008 Olympics. To provide scientific guidance on regional air pollution control, the Mesoscale Modeling System Generation 5 (MM5) and the Models-3/Community Multiscale Air Quality Model (CMAQ) air quality modeling system was used to investigate the contributions of emission sources outside the Beijing area to pollution levels in Beijing. The contributions to the PM10 concentrations in Beijing were assessed for the following sources: power plants, industry, domestic sources, transportation, agriculture, and biomass open burning. In January, it is estimated that on average 22% of the PM10 concentrations can be attributed to outside sources, of which domestic and industrial sources contributed 37 and 31%, respectively. In August, as much as 40% of the PM10 concentrations came from regional sources, of which approximately 41% came from industry and 31% from power plants. However, the synchronous analysis of the hourly concentrations, regional contributions, and wind vectors indicates that in the heaviest pollution periods the local emission sources play a more important role. The implications are that long-term control strategies should be based on regional-scale collaborations, and that emission abatement of local sources may be more effective in lowering the PM10 concentration levels on the heavy pollution days. Better air quality can be attained during the Olympics by placing effective emission controls on the local sources in Beijing and by controlling emissions from industry and power plants in the surrounding regions.     

Probability-based classifications for spatially characterizing the water temperatures and discharge rates of hot springs in the Tatun Volcanic Region,Taiwan

Accurately classifying the spatial features of the water temperatures and discharge rates of hot springs is crucial for environmental resources use and management. This study spatially characterized classifications of the water temperatures and discharge rates of hot springs in the Tatun Volcanic Region of Northern Taiwan by using indicator kriging (IK). The water temperatures and discharge rates of the springs were first assigned to high, moderate, and low categories according to the two thresholds of the proposed spring classification criteria. IK was then used to model the occurrence probabilities of the water temperatures and discharge rates of the springs and probabilistically determine their categories. Finally, nine combinations were acquired from the probability-based classifications for the spatial features of the water temperatures and discharge rates of the springs. Moreover, various combinations of spring water features were examined according to seven subzones of spring use in the study region. The research results reveal that probability-based classifications using IK provide practicable insights related to propagating the uncertainty of classifications according to the spatial features of the water temperatures and discharge rates of the springs. The springs in the Beitou (BT), Xingyi Road (XYR), Zhongshanlou (ZSL), and Lengshuikeng (LSK) subzones are suitable for supplying tourism hotels with a sufficient quantity of spring water because they have high or moderate discharge rates. Furthermore, natural hot springs in riverbeds and valleys should be developed in the Dingbeitou (DBT), ZSL, Xiayoukeng (XYK), and Macao (MC) subzones because of low discharge rates and low or moderate water temperatures.     

应用Models-3/CMAQ研究长三角区域大气污染及输送

选用美国国家环保局第3代空气质量模式（Models-3，／CMAQ），配合中尺度气象模式（MM5）进行研究，模拟了2001年1、7月份长江三角洲区域冬夏季典型天气条件下大气层二次污染物臭氧及颗粒物的浓度分布及输送状况。采用2001年冬．夏季各10d的小时监测数据对模式验证。结果表明，Models-3／CMAQ对O3、PM10的模拟相关系数分别为0．77和052；一致性指数分别达到081和0．99。模型对于O3略微低估，标准偏差为-31％，而对于PM10则有所高估，标准偏差为46％。对长三角7月份O3浓度及1月份PM10的模拟结果显示，7月份长三角区域16个主要城市O3日均浓度集中在0．043～0．086mg／m^3之间，其中，泰州、扬州．湖州、镇江O3月日均浓度相对较高，均超过0．064mg／m3o模拟时段内O3最高小时浓度达0．276mg／m^3。1月份整个模拟区域PM10月日均浓度为O056mg／m^3，其中，南京市PM10日均浓度最高，达0．080mg／m^3模拟时段内PM10最高小时浓度达0.432mg／m^3研究表明，长三角地区存在明显的污染物输送现象，大气污染已经从局地污染转化为区域污染。     

Toxicity and biodegradation of diamines

Phytotoxicity and cytotoxicity of 2,4-diaminotoluene (2,4-D), 4,4'-methylenedianiline (4,4-D), and 1,6-hexanediamine (1,6-D) were investigated by observing the germination of young radish seeds and the viability of HeLa cells, respectively. 2,4-D showed the highest, 4,4-D intermediate, and 1,6-D lowest cytotoxicity. However, the phytotoxicity decreased in the order of 4,4-D > 2,4-D > 1,6-D. Contrary to the results previously reported, in the modified Sturm test the activated sludge degraded 2,4-D and 4,4-D as well as 1,6-D without any pre-acclimation. Ochrobacterium antropi was isolated for degradation of 2,4-D and 4,4-D and Pseudomonas citronellolis for 1,6-D degradation. Thielevia sp. was isolated as 2,4-D degrading fungus and Aspergillus sp. as 4,4-D and 1,6-D degrading fungus. The fungi degraded the diamines faster than the bacteria.     

Contamination potential of nitrogen compounds in the heterogeneous aquifers of the Choushui River alluvial fan, Taiwan

This study aimed to analyze the contamination potential associated with the reactive transport of nitrate-N and ammonium-N in the Choushui River alluvial fan, Taiwan and to evaluate a risk region in developing a groundwater protection policy in 2021. In this area, an aquifer redox sequence provided a good understanding of the spatial distributions of nitrate-N and ammonium-N and of aerobic and anaerobic environments. Equiprobable hydraulic conductivity (K) fields reproduced by geostatistical methods characterized the spatial uncertainty of contaminant transport in the heterogeneous aquifer. Nitrogen contamination potential fronts for high and low threshold concentrations based on a 95% risk probability were used to assess different levels of risk. The simulated result reveals that the spatial uncertainty of highly heterogeneous K fields governs the contamination potential assessment of the nitrogen compounds along the regional flow directions. The contamination potential of nitrate-N is more uncertain than that for ammonium-N. The high nitrate-N concentrations (> or =3 mg/L) are prevalent in the aerobic environment. The low concentration nitrate-N plumes (0.5-3 mg/L) gradually migrate to the mid-fan area and to a maximum distance of 15 km from the aerobic region. The nitrate-N plumes pose a potential human health risk in the aerobic and anaerobic environments. The ammonium-N plumes remain stably confined to the distal-fan and partial mid-fan areas.     

长江三角洲地区大气O3和PM10的区域污染特征模拟

以TRACE-P污染源资料及上海市地方排放清单为基础,采用Models-3/CMAQ环境空气质量模型和中尺度气象模式MM5,模拟研究了2001-01和2001-07长三角近地面二次污染物O3及PM 10的浓度分布及输送状况,并以上海市国控点2001年冬、夏季各10 d的小时监测数据对模型进行了验证.验证结果显示,Models-3/CMAQ对O3和PM10的模拟结果与监测值的相关系数分别为0.77和0.52;一致性指数分别达到0.81和0.99.模型对O3小时最高浓度的估算偏低27%,标准偏差为-3.1%;对PM10小时平均浓度的估算偏低10%,标准偏差为46%.模型已具备再现和模拟长三角大气污染输送过程的能力,且误差落在可接受的范围之内.模拟结果显示,2001-07长三角区域16个主要城市中,有14个城市O3小时最大浓度超过国家二级标准,高浓度O3可覆盖苏南和浙北广大区域.2001-01泰州、扬州、南京、镇江、常州等城市受本地排放源和北部大气污染输送的影响显著,大气PM10日均浓度超过PM10国家二级标准.长三角地区环境空气质量与污染类型受大气污染传输与化学转化的影响十分明显.夏季太阳辐射较强时,南部城市排放的污染物常以二次污染物的形式影响下风向城市;太阳辐射较弱的情况下,则以一次污染物输送为主的形式影响周边地区.冬季长三角区域颗粒物污染总体水平较高,这与我国北方地区排放的颗粒物在西北风作用下向长三角输送造成的影响密切相关.长三角地区的大气污染已逐渐从局地转为区域问题.     

Assessment of air quality benefits from national air pollution control policies in China. Part I: Background,emission scenarios and evaluation of meteorological predictions

Under the 11th Five Year Plan (FYP, 2006–2010) for national environmental protection by the Chinese government, the overarching goal for sulfur dioxide (SO₂) controls is to achieve a total national emissions level of SO₂ in 2010 10% lower than the level in 2005. A similar nitrogen oxides (NO_x) emissions control plan is currently under development and could be enforced during the 12th FYP (2011–2015). In this study, the U.S. Environmental Protection Agency (U.S.EPA)’s Community Multi-Scale Air Quality (Models-3/CMAQ) modeling system was applied to assess the air quality improvement that would result from the targeted SO₂ and NO_x emission controls in China. Four emission scenarios — the base year 2005, the 2010 Business-As-Usual (BAU) scenario, the 2010 SO₂ control scenario, and the 2010 NO_x control scenario—were constructed and simulated to assess the air quality change from the national control plan. The Fifth-Generation NCAR/Penn State Mesoscale Model (MM5) was applied to generate the meteorological fields for the CMAQ simulations. In this Part I paper, the model performance for the simulated meteorology was evaluated against observations for the base case in terms of temperature, wind speed, wind direction, and precipitation. It is shown that MM5 model gives an overall good performance for these meteorological variables. The generated meteorological fields are acceptable for using in the CMAQ modeling.