Chromium removal from water by activated carbon developed from waste rubber tires

Because of the continuous production of large amount of waste tires, the disposal of waste tires represents a major environmental issue throughout the world. This paper reports the utilization of waste tires (hard-to-dispose waste) as a precursor in the production of activated carbons (pollution-cleaning adsorbent). In the preparation of activated carbon (AC), waste rubber tire (WRT) was thermally treated and activated. The tire-derived activated carbon was characterized by means of scanning electron microscope, energy-dispersive X-ray spectroscopy, FTIR spectrophotometer, and X-ray diffraction. In the IR spectrum, a number of bands centred at about 3409, 2350, 1710, 1650, and 1300–1000 cm^?1 prove the present of hydroxyl and carboxyl groups on the surface of AC in addition to C═C double bonds. The developed AC was tested and evaluated as potential adsorbent removal of chromium (III). Experimental parameters, such as contact time, initial concentration, adsorbent dosage and pH were optimized. A rapid uptake of chromium ions was observed and the equilibrium is achieved in 1 h. It was also found that the adsorption process is pH dependent. This work adds to the global discussion of the cost-effective utilization of waste rubber tires for waste water treatment.     

Kinetic behavior of anti-inflammatory drug ibuprofen in aqueous medium during its degradation by electrochemical advanced oxidation

The electrochemical abatement of the drug ibuprofen (2-(4-isobutylphenyl)propionic acid) from aqueous solution has been carried out by anodic oxidation. The electrolyses have been performed at constant current using a small, undivided cell equipped with a Pt or thin-film boron-doped diamond (BDD) anode and a carbon-felt cathode. The results have shown that ibuprofen has been destroyed under all the conditions tested, following pseudo-first-order kinetics; however, BDD enables higher removal rates than Pt, because the former produces greater quantity of ^?OH. Using BDD anode, the pseudo-first-order rate constant increased with applied current and when NaCl replaced Na₂SO₄ as supporting electrolyte, while it is almost unaffected by ibuprofen concentration. Mineralization of ibuprofen aqueous solutions was followed by total organic carbon (TOC) measurements. After 8 h of electrolysis, TOC removal varied from 91 % to 96 % applying a current in the range of 50–500 mA. The reaction by-products were quantified by chromatographic techniques, and in particular, aliphatic acids (oxalic, glyoxylic, formic, acetic, and pyruvic) have been the main intermediates formed during the electrolyses. The absolute rate constant for the oxidative degradation of ibuprofen have also been determined, by competition kinetic method, as 6.41?×?10⁹ M^?1?s^?1.     

Thermodynamic and kinetic studies of As(V) removal from water by zirconium oxide-coated marine sand

Arsenic contamination of groundwater is a major threat to human beings globally. Among various methods available for arsenic removal, adsorption is fast, inexpensive, selective, accurate, reproducible and eco-friendly in nature. The present paper describes removal of arsenate from water on zirconium oxide-coated sand (novel adsorbent). In the present work, zirconium oxide-coated sand was prepared and characterised by infrared and X-ray diffraction techniques. Batch experiments were performed to optimise different adsorption parameters such as initial arsenate concentration (100–1,000 μg/L), dose (1–8 g/L), pH of the solution (2–14), contact time (15–150 min.), and temperature (20, 30, 35 and 40 °C). The experimental data were analysed by Langmuir, Freundlich, Temkin and Dubinin–Radushkevich isotherm models. Furthermore, thermodynamic and kinetic parameters were evaluated to know the mode of adsorption between ZrOCMS and As(V). The maximum removal of arsenic, 97 %, was achieved at initial arsenic concentration of 200 μg/L, after 75 min at dosage of 5.0 g/L, pH?7.0 and 27?±?2 °C. For 600 μg/L concentration, the maximum Langmuir monolayer adsorption capacity was found to be 270 μg/g at 35 °C. Kinetic modelling data indicated that adsorption process followed pseudo-second-order kinetics. The mechanism is controlled by liquid film diffusion model. Thermodynamic parameter, ΔH°, was ?57.782, while the values of ΔG° were ?9.460, ?12.183, ?13.343 and ?13.905 kJ/mol at 20, 30, 35 and 40 °C, respectively, suggesting exothermic and spontaneous nature of the process. The change in entropy, ΔS°?=??0.23 kJ/mol indicated that the entropy decreased due to adsorption of arsenate ion onto the solid adsorbent. The results indicated that the reported zirconium oxide-coated marine sand (ZrOCMS) was good adsorbent with 97 % removal capacity at 200 μg/L concentration. It is interesting to note that the permissible limit of arsenic as per World Health Organization is 10 μg/L, and in real situation, this low concentration can be achieved through this adsorbent. Besides, the adsorption capacity showed that this adsorbent may be used for the removal of arsenic from any natural water resource.     

The potential of epiphytic hydrocarbon-utilizing bacteria on legume leaves for attenuation of atmospheric hydrocarbon pollutants

The leaves of two legumes, peas and beans, harbored on their surfaces up to 9×10? cells g?1 of oil-utilizing bacteria. Less numbers, up to 5×10? cells g?1 inhabited leaves of two nonlegume crops, namely tomato and sunflower. Older leaves accommodated more of such bacteria than younger ones. Plants raised in oily environments were colonized by much more oil-utilizing bacteria than those raised in pristine (oil-free) environments. Similar numbers were counted on the same media in which nitrogen salt was deleted, indicating that most phyllospheric bacteria were probably diazotrophic. Most dominant were Microbacterium spp. followed by Rhodococcus spp., Citrobacter freundii, in addition to several other minor species. The pure bacterial isolates could utilize leaf tissue hydrocarbons, and consume considerable proportions of crude oil, phenanthrene (an aromatic hydrocarbon) and n-octadecane (an alkane) in batch cultures. Bacterial consortia on fresh (but not on previously autoclaved) leaves of peas and beans could also consume substantial proportions of the surrounding volatile oil hydrocarbons in closed microcosms. It was concluded that phytoremediation through phyllosphere technology could be useful in remediating atmospheric hydrocarbon pollutants.     

Environmental monitoring of complex hydrocarbon mixtures in water and soil samples after solid phase microextraction using PVC/MWCNTs nanocomposite fiber

A novel nanocomposite based on incorporation of multiwalled carbon nanotubes (MWCNTs) in polyvinyl chloride (PVC) was prepared. Proposed nanocomposite was coated on stainless steel wire by deep coating. Composition of nanocomposite was optimized based on results of morphological studies using scanning electron microscopy. The best composition (83% MWCNTs:17% PVC) was applied as a solid phase microextraction fiber. Complex mixture of aromatic (BTEX) and aliphatic hydrocarbons (C₅–C₃₄) were selected as model analytes, and performance of proposed fiber in extraction of the studied compounds from water and soil samples was evaluated. Analytical merits of the method for water samples (LODs = 0.10–1.10 ng L⁻¹, r² = 0.9940–0.9994) and for soil samples (LODs = 0.10–0.77 ng kg⁻¹, r² = 0.9946–0.9994) showed excellent characteristics of it in ultra trace determination of petroleum type environmental pollutants. Finally, the method was used for determination of target analytes in river water, industrial effluent and soil samples.     

Evolution of a Mediterranean Coastal Zone: Human Impacts on the Marine Environment of Cape Creus

This study presents an integrated analysis of the evolution of the marine environment and the human uses in Cape Creus, a Mediterranean coastal area where intense commercial fisheries and recreational uses have coexisted over the last fifty years. The investigation synthesizes the documented impacts of human activities on the marine environment of Cap de Creus and integrates them with new data. In particular, the evolution of vulnerable, exploited species is used to evaluate the fishing impacts. The effects of area protection through the establishment of a marine reserve in the late 1990s and the potential climate change impacts are also considered. The evolution of the human uses is marked by the increasing socioeconomic importance of recreational activities (which affect species and habitats) in detriment to artisanal and red coral fisheries (which principally affect at a species level). Overall, populations of sedentary, vulnerable exploited species, hard sessile benthic invertebrates, and ecologically fragile habitats, such as seagrass meadows, the coralligenous and infralittoral algal assemblages have been the most negatively impacted by anthropogenic activities. Albeit human uses currently constitute the largest negative impact on the marine environment of Cap de Creus, climate change is emerging as a key factor that could have considerable implications for the marine environment and tourism activities. The establishment of the marine reserve appears to have had little socioeconomic impact, but there is some evidence that it had some positive biological effects on sedentary, littoral fishes. Results demonstrate that the declaration of a marine reserve alone does not guarantee the sustainability of marine resources and habitats but should be accompanied with an integrated coastal management plan.     

Making Capacity Building Meaningful: A Framework for Strategic Action

This paper aims to give practical meaning to ‘capacity building’ through (a) identifying a suite of practical measures, such as mentoring or best practice guidelines, that have been shown to or are considered to build human, social, institutional, and economic capital; (b) placing these measures within a broader systems framework; and (c) exploring stakeholder feedback on specific measures to inform framework implementation. The 29 measures described provide actors, whether government or nongovernment, with a suite of practical investment choices for building capacity. These measures are then clustered into eight groups according to their primary purpose and placed within a systems framework. The framework provides a tool for actors with responsibilities for or an interest in capacity building to inform more holistic and strategic targeting of effort and investment. Stakeholder feedback gathered through surveys and workshops is subsequently reported to further inform implementation of specific measures within the framework’s eight groupings. The framework presented may be built upon through the identification and inclusion of further capacity building measures. The research is conducted within the context of decentralized governance arrangements for natural resource management (NRM), with specific focus on Australia’s recently formalized 56 NRM regions and their community-based governing boards as an informative arena of learning. Application of the framework is explored in the Australian setting through the identification and comparison of measures supported and most preferred by four major stakeholder groups, namely board members, regional NRM organization staff, policy/research interests, and Indigenous interests. The research also examines stakeholder perceptions of capacity issues, and whether these issues are likely to be addressed through implementing their preferred measures.

Influences on Wood Load in Mountain Streams of the Bighorn National Forest,Wyoming, USA

We documented valley and channel characteristics and wood loads in 19 reaches of forested headwater mountain streams in the Bighorn National Forest of northern Wyoming. Ten of these reaches were in the Upper Tongue River watershed, which has a history of management including timber harvest, tie floating, and road construction. Nine reaches were in the North Rock Creek watershed, which has little history of management activities. We used these data to test hypotheses that (i) valley geometry correlates with wood load, (ii) stream gradient correlates with wood load, and (iii) wood loads are significantly lower in managed watersheds than in otherwise similar unmanaged watersheds. Statistical analyses of the data support the first and third hypotheses. Stream reaches with steeper valley side slopes tend to have higher wood loads, and reaches in managed watersheds tend to have lower wood loads than reaches in unmanaged watersheds. Results do not support the second hypothesis. Shear stress correlated more strongly with wood load than did stream gradient, but statistical models with valley-scale variables had greater explanatory power than statistical models with channel-scale variables. Wood loads in stream reaches within managed watersheds in the Bighorn National Forest tend to be two to three times lower than wood loads in unmanaged watersheds.     

River-Stream Connectivity Affects Fish Bioassessment Performance

Stream fish bioassessment methods assume that fish assemblages observed in sample sites reflect responses to local stressors, but fish assemblages are influenced by local factors as well as regional dispersal to and from connected streams. We hypothesized that fish movement to and from refugia and source populations in connected rivers (i.e., riverine dispersal) would weaken or decouple relations between fish community metrics and local environmental conditions. We compared fish-environment relations between streams that flow into large rivers (mainstem tributaries) and streams that lack riverine confluences (headwater tributaries) at multiple spatial grains using data from the USEPA's Environmental Monitoring and Assessment Program in the mid-Atlantic highlands, USA (n = 157 sites). Headwater and mainstem tributaries were not different in local environmental conditions, but showed important differences in fish metric responses to environmental quality gradients. Stream sites flowing into mainstem channels within 10 fluvial km showed consistently weaker relations to local environmental conditions than stream sites that lacked such mainstem connections. Moreover, these patterns diminished at longer distances from riverine confluences, consistent with the hypothesis of riverine dispersal. Our results suggest that (1) the precision of fish bioassessment metrics may be improved by calibrating scoring criteria based on the spatial position of sites within stream networks and (2) the spatial grain of fish bioassessment studies may be manipulated to suit objectives by including or excluding fishes exhibiting riverine dispersal.     

Detecting Temporal Change in Watershed Nutrient Yields

Meta-analyses reveal that nutrient yields tend to be higher for watersheds dominated by anthropogenic uses (e.g., urban, agriculture) and lower for watersheds dominated by natural vegetation. One implication of this pattern is that loss of natural vegetation will produce increases in watershed nutrient yields. Yet, the same meta-analyses also reveal that, absent land-cover change, watershed nutrient yields vary from one year to the next due to many exogenous factors. The interacting effects of land cover and exogenous factors suggest nutrient yields should be treated as distributions, and the effect of land-cover change should be examined by looking for significant changes in the distributions. We compiled nutrient yield distributions from published data. The published data included watersheds with homogeneous land cover that typically reported two or more years of annual nutrient yields for the same watershed. These data were used to construct statistical models, and the models were used to estimate changes in the nutrient yield distributions as a result of land-cover change. Land-cover changes were derived from the National Land Cover Database (NLCD). Total nitrogen (TN) yield distributions increased significantly for 35 of 1550 watersheds and decreased significantly for 51. Total phosphorus (TP) yield distributions increased significantly for 142 watersheds and decreased significantly for 17. The amount of land-cover change required to produce significant shifts in nutrient yield distributions was not constant. Small land-cover changes led to significant shifts in nutrient yield distributions when watersheds were dominated by natural vegetation, whereas much larger land-cover changes were needed to produce significant shifts when watersheds were dominated by urban or agriculture. We discuss our results in the context of the Clean Water Act.