Can nuclear aquatic environmental DNA be a genetic marker for the accurate estimation of species abundance?

The Science of Nature - We present the first study that compares phenological variation in parasite load and inflammatory response in a lizard with asynchronous male and female gonadal cycles....     

Changes in Age-Related Reproductive Tactics in the Female of the Butterfly, Eurema hecabe

The occurrence of mate solicitation by virgin females was investigated in the butterfly Eurema hecabe. Young (1-day-old) virgin females rarely showed mate solicitation to male model, however, old (at least 6-day-old) virgin females frequently showed such flight. The duration of solicitation was significantly longer in older females than in younger ones. The age-related behavioral change occurs with female oogenesis (Hiroki and Kato 1996), and such behavior may thus be a result of female adaptation to maximize their fecundity. Received: 6 November 1997 / Accepted in revised form: 29 June 1998     

Spiroplasma infection causes either early or late male killing in <Emphasis Type="Italic">Drosophila</Emphasis>, depending on maternal host age

Symbiont-induced male-killing phenotypes have been found in a variety of insects. Conventionally, these phenotypes have been divided into two categories according to the timing of action: early male killing at embryonic stages and late male killing at late larval stages. In Drosophila species, endosymbiotic bacteria of the genus Spiroplasma have been known to cause early male killing. Here, we report that a spiroplasma strain normally causing early male killing also induces late male killing depending on the maternal host age: male-specific mortality of larvae and pupae was more frequently observed in the offspring of young females. As the lowest spiroplasma density and occasional male production were also associated with newly emerged females, we proposed the density-dependent hypothesis for the expression of early and late male-killing phenotypes. Our finding suggested that (1) early and late male-killing phenotypes can be caused by the same symbiont and probably by the same mechanism; (2) late male killing may occur as an attenuated expression of early male killing; (3) expression of early and late male-killing phenotypes may be dependent on the symbiont density, and thus, could potentially be affected by the host immunity and regulation; and (4) early male killing and late male killing could be alternative strategies adopted by microbial reproductive manipulators.     

Framework for estimating potential wastes and secondary resources accumulated within an economy – A case study of construction minerals in Japan

Material stocks in economic society are considered to represent a reserve for wastes and secondary resources. From the viewpoints of proper disposal and reutilization of stocked materials, accurate estimation of the amount of materials that will emerge as wastes or secondary resources in the future is important. We defined materials that have a high probability of emerging as wastes or secondary resources as “potential wastes and secondary resources” and estimated that amount for construction minerals in Japan as a case study. The following conclusions were drawn. (1) We classified materials that are input into economic society into four categories: potential wastes and secondary resources, potential dissipated materials, dissipatively used materials, and permanent structures. By clarifying the latter three non-potential wastes and secondary resources, we performed a more accurate assessment of the wastes and secondary resources that will emerge in the future. (2) The share of potential wastes and secondary resources was estimated to be about 30% of all construction minerals that have been input into and accumulated in Japanese economic society. (3) Information related to potential dissipated materials and dissipatively used materials will provide fundamental knowledge to support analyses of the environmental impacts and resource losses which these materials might generate.     

Assessment of current status of zinc in wastewater treatment plants to set effluent standards for protecting aquatic organisms in Japan

New environmental standards for protecting aquatic organisms for zinc (e.g., 0.03 mg/L) in surface waters were set in Japan in 2003. Although wastewater effluent might be one of the major pathways of zinc to public water bodies in Japan, current status of concentration of zinc in wastewater effluent was not clear due to higher detection limits (e.g., 0.5 mg/L) than the level required by the new regulations. This study aims at assessing current status of zinc in wastewater effluent in Japan to revise wastewater effluent standards for protecting aquatic organisms. Survey of zinc in wastewater treatment plants (WWTPs) was carried out in Japan in 2005, setting the detection limits at least 0.01 mg/L. The results of the survey suggested the difficulty to remove zinc (especially dissolved zinc) with conventional activated sludge treatment if concentration of zinc in influent was relatively low. And it was suggested that high concentration of dissolved zinc might be derived from some industries discharging high concentration of zinc. The concentration of zinc in wastewater influent without industrial discharges was about 0.1 mg/L which might be lower than that in wastewater from industries discharging high concentration of zinc. Finally, effluent standards for point sources including WWTPs to public water bodies were set at 2 mg/L in 2006. Based on the results of the survey that it was difficult to remove dissolved zinc discharged from industries at WWTPs, the effluent standards from industries to sewerage were set at the same value of the effluent standards from WWTPs to public water bodies.     

Where will large amounts of materials accumulated within the economy go? – A material flow analysis of construction minerals for Japan

For all countries analyzed so far, Material Flow Analysis/Accounting (MFA) studies indicate that the overall stock of materials within the economy is growing. Most are construction minerals such as asphalt, cement, sand and gravel, crushed stone, and other aggregates. In the analyses described in this paper, flows and stocks of construction minerals were estimated for Japan from the past to the future to elucidate: (1) the mechanisms by which construction minerals become waste, and (2) the future supply of and demand for recycled crushed stone. The following conclusions were drawn: (1) The amounts of waste construction minerals generated have been and will be at much lower levels than the domestic demand for construction minerals. These differences might indicate consistent growth of the stock of construction minerals, which will become waste in the future. However, certain amounts of materials that we account for as stock can be interpreted already in the environment as dead stock or dissipated waste; such materials can be called "missing stock" or "dissipated stock". Capturing that missing or dissipated stock is very important because it provides information that clarifies the environmental impacts and loss of resources that these materials cause; it allows estimation of appropriate future waste generation. (2) The amount of construction minerals that are recognized as waste was estimated to increase in the future. An imbalance in the supply of and demand for recycled crushed stone will likely occur in the near future if an expected decline in future road construction is considered.     

The Effect of Local Biomass Projects on Energy Balance and GHG Emission: A Life Cycle Approach

Emerging attention has been given to the use of biomass in local areas for its contribution to reducing fossil fuel dependence and mitigating global warming. The objective of the present study is to develop a method that quantitatively assesses the effects of local biomass projects on fossil fuel consumption and greenhouse gas (GHG) emission. A practical method based on a life cycle approach is proposed and applied to a case of bioethanol project in Miyako Islands of Japan. The project is aiming to produce bioethanol from molasses within the islands, and to replace the entire gasoline consumed in the islands to E3 fuel (i.e., a mixture of 3% ethanol and 97% gasoline by volume). The assessment using the developed method revealed that, first, the complete shift from gasoline to E3 fuel allows for decreases in fossil fuel consumption and GHG emission. Second, the performance of the project is improved by the integration of the ethanol plant and the sugar factory. Moreover, the assessment found that, in small-scale bioethanol projects, the contribution of capital goods to life cycle fuel consumption and GHG emission is not negligible.     

Debromination of hexabromobenzene by its co-grinding with CaO

A hexabromobenzene (HBB, C6Br6) powder was subjected to co-grinding with excess CaO powder in air using a planetary ball mill to investigate mechanochemical debromination of the HBB sample. The reaction proceeds smoothly with an increase in both grinding time and molar ratio of CaO addition. The co-grinding enables us to debrominate HBB, forming CaBr2, C and CaCO3 besides excess CaO in the product. CaBr2 in the product tends to absorb moisture from the atmosphere to form CaBr2 x nH2O. The reaction yield is quantitatively evaluated by measuring the amount of water-soluble bromide through water washing and the amount of unreacted HBB through toluene washing. It is found that almost 100% of debromination is achieved by 6 h grinding with the molar ratio kept constant at 2:1. Radicals are detected in the ground products, possibly due to rupture in the covalent bonds of C-C and C-Br in HBB.