Seasonal trend and source identification of polycyclic aromatic hydrocarbons associated with fine particulate matters (PM2.5) in Isfahan City,Iran, using diagnostic ratio and PMF model

Environmental Science and Pollution Research - Particulate matters (PMs) and their associated chemical compounds such as polycyclic aromatic hydrocarbons (PAHs) are important factors to evaluate...     

Drought effects on the Iranian economy: a computable general equilibrium approach

Environment, Development and Sustainability - In the last two decades, recurring drought becomes a challenge for Iran’s economy, which is located in a drought-prone area, and it has been...     

A hybrid model for robust design of sustainable closed-loop supply chain in lead-acid battery industry

Environmental Science and Pollution Research - Considering supply chain efficiency during the network design process significantly affect chain performance improvement. In this paper, the design...     

Feasibility Assessment of Basin Solar Stills

The present study assesses the feasibility of exploiting single- and double-basin solar stills in our daily lives. An investigation is carried out to determine the thermal performance and economic viability of making use of solar stills in water desalination. The climatic conditions of Tehran (35°44?N, 51°30?E) are considered to assess the feasibility of the basins. Transient energy and mass balance equations are utilized for modeling the thermal performance. The equations are solved by using fourth-order Runge–Kutta method in FORTRAN. The daily productivities of single- and double-basin solar stills are found to be 5.22 kg/m² and 7.73 kg/m², respectively, while the effect of different water masses (20–100 kg) on the productivity of each system was found to be optimum at 20 kg/m². The results are compared with experimental work performed under different climatic conditions to examine the validity of the feasibility of basins in general. A life cycle cost analysis performed for Tehran, yields that single- and double-basin solar stills have savings-to-investment ratios of 4.2 and 4.8, respectively, indicating that they are economically feasible.     

Organochlorine pesticides in soil under irrigated cotton farming systems in Vertisols of the Namoi Valley, north-western New South Wales, Australia

Organochlorine pesticides (OCPs) such as DDT and DDE have been detected in the surface 0.2 m of Vertisols in the lower Namoi Valley of north western New South Wales, Australia even though they have not been applied to crops since 1982. However, their presence in the deeper soil horizons has not been investigated. The objective of this study was to determine if OCPs were present to a depth of 1.2 m in Vertisols under irrigated cotton farming systems in the lower Namoi Valley of New South Wales. Soil was sampled from the 0-1.2 m depths in three sites, viz. the Australian Cotton Research Institute, ACRI, near Narrabri (149°36′E, 30°12′S), and two cotton farms near Wee Waa (149°27′E, 30°13′S) and Merah North (149°18′E, 30°12′S) in northern New South Wales, Australia. The OCPs detected and their metabolites were α-endosulfan, β-endosulfan, endosulfan sulphate, DDD, DDE, DDT and endrin. The metabolite DDE, a breakdown product of DDT, was the most persistent OCP in all depths analysed. Endosulfan sulphate was the second most persistent followed by endrin > α-endosulfan > β-endosulfan > DDT and DDD. DDT was sprayed extensively in the lower Namoi Valley up to the early 1980s and may explain the persistence of DDE in the majority of soil samples. Dicofol and Dieldrin, two OCPs previously undocumented in Vertisols were also detected. The movement of OCPs into the subsoil of Vertisols may occur when irrigation or rain transports soil colloids and organic matter via preferential flow systems into the deeper layers of a soil profile. Persistence of OCPs was closely correlated to soil organic carbon concentrations. The persistence in soil of OCP’s applied to cotton crops grown more than two decades ago suggests that they could enter the food chain. Their presence at depths of 1.2 m suggests that they could move into groundwater that may eventually be used for domestic and stock consumption.     

Determination of polychlorinated biphenyls and total mercury in two fish species (<Emphasis Type="Italic">Esox lucius</Emphasis> and <Emphasis Type="Italic">Carassius auratus</Emphasis>) in Anzali Wetland,Iran

The Anzali Wetland is one of the most important ecosystems in the north of Iran, and parts of it were registered as a Ramsar site in 1975. However, even though, due to many problems, including eutrophication produced by inflow of excess nutrients and organic materials, the wetland was also listed on the Montreux Record indicating the need to take urgent remedial action. This study was conducted to study the levels of polychlorinated biphenyls (PCBs) and total mercury (THg) in two fish species (Esox lucius and Carassius auratus) as bio-indicators of the ecosystem condition in eastern part of Anzali Wetland. The sampling was carried out in six different periods between years 2009 and 2010. The results showed that the amounts of PCBs in the muscle of northern pike were below the detection limit of gas chromatography, whereas the average concentration in goldfish was 0.449 mg/kg wet weight. Some possible reasons for the higher levels of PCBs in goldfish in comparison with pike have been discussed. No significant (p < 0.05) correlation was observed between PCBs and biological factors (weight, length, lipid content) for both species. On the other hand, the mean concentration of THg in the muscle of pike and goldfish were 182.22 and 75.27 ng/g dry weight, respectively. Although these concentrations were below US-EPA criterion for human consumption (0.3 mg/kg), it pointed up a significant deterioration of the ecosystem condition during the past years. Finally, statistical analysis revealed a significant correlation between THg with weight and an insignificant correlation with length for pike specimens.     

Spatial and temporal variability of fluoride concentrations in groundwater resources of Larestan and Gerash regions in Iran from 2003 to 2010

Environmental Geochemistry and Health - There is discrepancy about intervals of fluoride monitoring in groundwater resources by Iranian authorities. Spatial and temporal variability of fluoride in...     

Spatial analysis of resources and environmental carrying capacity in Iran

Urbanization and mass movement of the population from rural areas and small cities to megacities have led to environmental, economic, and social problems in Iran. In dealing with these challenges, assessing resource and environmental carrying capacity (RECC) is considered an effective method to leverage space and capital to achieve sustainable development. This study aimed to rank the provincial RECC in Iran. Toward this purpose, environmental indices were generated from remotely sensed and statistical census data. Then, the provinces were scored in terms of environmental, economic, and infrastructural carrying capacities, and RECC using the mean variance analysis method. Results demonstrated that in most areas, there is no relationship between economic and infrastructural capacities and development. Statistically, a correlation coefficient of −0.53 between economic and environmental carrying capacities indicated excessive use of environmental capacities. Moreover, the spatial distribution pattern of environmental, economic, and infrastructural carrying capacity was entirely heterogeneous between the provinces; there was a northeast–southwest pattern in terms of infrastructural capacity and an economic pattern from north to south. The distribution pattern of RECC is most consistent with the environmental capacity, pointing at the high weight of the indicators of the RECC model. In conclusion, this research offers a new vision for policymakers and provides a theoretical and applicable framework for implementing sustainable strategies in land-use planning. It is recommended that the RECC concept and tools can be used not only for planning but also for measuring the efficiency of spatial development programs and establishing land balances in the region.     

Carbon dioxide capturing technologies: a review focusing on metal organic framework materials (MOFs)

In this study, a relevant literature has been reviewed focusing on the carbon dioxide capture technologies in general, such as amine-based absorption as conventional carbon dioxide capturing technology, aqueous ammonia-based absorption, membranes, and adsorption material (e.g., zeolites, and activated carbons). In more details, metal organic frameworks (MOFs) as new emerging technologies for carbon dioxide adsorption are discussed. The MOFs section is intended to provide a comprehensive overview of MOFs including material characteristics and synthesis, structural features, CO₂ adsorption capacity, heat of adsorption and selectivity of CO₂.     

A review of combinations of electrokinetic applications

Anthropogenic activities contaminate many lands and underground waters with dangerous materials. Although polluted soils occupy small parts of the land, the risk they pose to plants, animals, humans, and groundwater is too high. Remediation technologies have been used for many years in order to mitigate pollution or remove pollutants from soils. However, there are some deficiencies in the remediation in complex site conditions such as low permeability and complex composition of some clays or heterogeneous subsurface conditions. Electrokinetic is an effective method in which electrodes are embedded in polluted soil, usually vertically but in some cases horizontally, and a low direct current voltage gradient is applied between the electrodes. The electric gradient initiates movement of contaminants by electromigration (charged chemical movement), electro-osmosis (movement of fluid), electrolysis (chemical reactions due to the electric field), and diffusion. However, sites that are contaminated with heavy metals or mixed contaminants (e.g. a combination of organic compounds with heavy metals and/or radionuclides) are difficult to remediate. There is no technology that can achieve the best results, but combining electrokinetic with other remediation methods, such as bioremediation and geosynthetics, promises to be the most effective method so far. This review focuses on the factors that affect electrokinetic remediation and the state-of-the-art methods that can be combined with electrokinetic.