青萍(Lemna minor L.)对氮磷的吸收特征

以西部地区优势浮萍品种青萍为实验对象,研究了青萍对不同浓度硝态氮和磷酸盐的吸收特征。结果表明,硝态氮浓度在1～10 mg/L范围内,青萍对硝态氮有较好的吸收效果,M-M方程可以较好地描述硝态氮浓度与青萍对硝态氮的吸收速率之间的关系,通过M-M方程拟合得到青萍对硝态氮的最大吸收速率为0.1167 mg/(g FW.h),亲和力常数为6.9274。磷酸盐浓度在0.1～1.0 mg/L范围内,青萍对磷酸盐也有较好的吸收效果,二次多项式回归可以较好地描述青萍吸收速率与磷酸盐浓度的关系,回归方程得到青萍对磷酸盐的最大吸收速率为0.0193 mg/(g FW.h),对应磷酸盐浓度为0.6 mg/L。     

耐低温贫营养好氧反硝化菌群脱氮特性及安全性

针对微污染水体强化原位生物脱氮技术同时面临低温、贫营养及好氧问题,对实验室已分离筛选的贫营养好氧反硝化菌和耐低温好氧反硝化菌进行菌源重组,构建出高效耐低温贫营养好氧脱氮功能菌群T1(Y3+F3+H8)和T2(Y3+F4)。研究不同投菌量条件下菌群的脱氮特性,结果表明,投菌量对T1脱氮效果有一定影响,0.1、0.2和1.0 mg/L投量对NO3--N去除率为71%、91%和100%,总氮去除率为56%、34%和52%;T2菌群,当投量为0.2 mg/L时,对NO3--N、总氮去除率最大可达66%和59.48%。对菌群T1、T2进行生物安全性分析,采用次氯酸钠进行消毒,其生物灭活率均达到99.9%以上。     

氧化物催化剂对非热等离子体催化降解甲苯的影响

考察了在干燥气氛下不同氧化物催化剂对非热等离子体催化降解甲苯的影响。从甲苯降解率、碳平衡、CO2选择性和O3去除4个方面,对比了氧化物催化剂的介电性能、表面供氧能力和比表面积与多孔结构对反应产生影响的强弱。结果表明,催化剂的介电性能有利于甲苯降解率、碳平衡和O3产量的提高,但对CO2选择性和O3去除的影响极小;一定能量密度下,催化剂比表面积与多孔结构对CO2选择性和O3去除所产生的影响要强于介电性能;催化剂表面供氧能力可明显促进反应的进行,其对反应所产生的影响要强于比表面积与多孔结构。     

变压吸附技术的应用及其发展简述

文章分析了变压吸附技术存在的问题,并提出解决措施。通过对变压吸附技术应用现状的总结,对该技术未来的发展方向进行预测与评价。指出变压吸附技术能够经济高效地实现物质的分离,有望成为分离技术未来的发展方向,为环保和工业生产做出更大贡献。     

微生物法处理海上钻井废钻井液

微生物法适用于海上钻井含油废弃物的处理。通过多次对菌株采集、分离、纯化和培养驯化,选育得到了3株对石油烃类有很好降解效果的石油类降解菌;确定了石油类降解菌适宜的生化处理条件:最佳生长及原油降解温度为50℃、最佳生长及原油降解酸碱性环境为pH=6.0、最佳菌株接种量2%、最佳原油初始浓度为500mg/L。处理后的含油废弃钻井液含油量基本稳定在2mg/L以下,降解率达98%以上。     

回收与降解聚驱采出水的工艺探讨

含聚污水的处理是困扰石油行业的难题之一。基于聚驱采出水的特点,围绕聚合物的回收利用和降解理论及技术,探讨国内外含聚污水处理技术的研究与应用现状,对比分析现有处理技术存在的问题及适应性,提出采用化学混凝、气浮和水质改性等技术来回收利用PAM(聚丙烯酰胺)的新思路,打破了降解PAM的传统思维,同时分析含聚污水处理与利用技术的可行性与应用前景,有望实现含聚污水的循环利用。     

Cornmeal-induced resistance to ciprofloxacin and erythromycin in enterococci

Triclosan is used as an antibacterial agent in household items and personal care products. Since this compound is found in maternal milk of humans and bodies of wild animals, there is growing concern among some consumer groups and scientific community that triclosan is adverse for humans and wild animals. In order to estimate adverse actions of triclosan, the effects of triclosan on intracellular Zn²⁺ concentration and cellular thiol content were studied in rat thymocytes by the use of flow cytometer with appropriate fluorescent probes. Triclosan at 1-3 μM (sublethal concentrations) increased the intensity of FluoZin-3 fluorescence (intracellular Zn²⁺ concentration) and decreased the intensity of 5-chloromethylfluorescein (5-CMF) fluorescence (cellular thiol content). Negative correlation (r = −0.985) between triclosan-induced changes in FluoZin-3 and 5-CMF fluorescences was found. Removal of external Zn²⁺ did not significantly affect the triclosan-induced augmentation of FluoZin-3 fluorescence, suggesting an intracellular Zn²⁺ release by triclosan. These actions of triclosan were similar to those of H₂O₂ and triclosan significantly potentiated the cytotoxicity of H₂O₂. Therefore, the results may suggest that triclosan at sublethal concentrations induces oxidative stress that decreases cellular thiol content, resulting in an increase in intracellular Zn²⁺ concentration by Zn²⁺ release from intracellular store(s). Since recent studies show many physiological roles of intracellular Zn²⁺ in cellular functions, the triclosan-induced disturbance of cellular Zn²⁺ homeostasis may induce adverse actions on the cells.     

Catalytic destruction of pentachlorobenzene in simulated flue gas by a V2O5-WO3/TiO2 catalyst

Pentachlorobenzene (PeCB) in simulated flue gas was destructed by a commercial V₂O₅-WO₃/TiO₂ catalyst in this study. The effects of reaction temperature, oxygen concentration, space velocity and some co-existing pollutants on PeCB conversion were investigated. Furthermore, a possible mechanism for the oxidation of PeCB over the vanadium oxide on the catalysts was proposed. Results show that the increase of gas hourly space velocity (GHSV) and the decrease of operating temperature both resulted in the decrease of PeCB removal over the catalyst, while the effect of the oxygen content in the range of 5-20% (v/v) on PeCB conversion was negligible. PeCB decomposition could be obviously affected by the denitration reactions under the conditions because of the positive effect of NO but negative effect of NH₃. The introduction of SO₂ caused the catalyst poisoning, probably due to the sulfur-containing species formed and deposited on the catalyst surface. The PeCB molecules were first adsorbed on the catalyst surface, and then oxidized into the non-aromatic acyclic intermediates, low chlorinated aromatics and maleic anhydride.     

Historical change of mercury pollution in remote Yongle archipelago, South China Sea

We collected three ornithogenic coral sand sedimentary profiles from Jinyin Island, Jinqing Island and Guangjin Island of Yongle archipelago, South China Sea and reconstructed the deposition flux of anthropogenic Hg over the past 700 years in the study area. On the whole, the anthropogenic Hg flux is relatively low; it remained at a low level before the Industrial Revolution with a small peak at about 1450-1550 AD, which may record the enhanced metallurgy activity in Ming Dynasty of China. During the 20th century, the deposition flux of anthropogenic Hg increased rapidly, but two troughs occurred during the periods around 1940s and 1970s, corresponding to the economic depression caused by World War II, Civil War in China (1945-1949), and the Culture Revolution (1966-1976) in China. Since the 1970s the deposition flux of anthropogenic Hg has been persistently increasing, apparently the result of fast economic development in East and Southeast Asia countries around South China Sea.     

Transformation of tetrabromobisphenol A in the presence of different solvents and metals

Solvent-based separation method is presumably an efficient and environmentally beneficial approach for elimination of brominated flame retardants (BFRs) from waste electrical and electronic equipment (WEEE). The overall goal of this study was to evaluate possible effects of organic solvent on the behavior of BFRs during solvent-based processing of WEEE. We initiated a set of batch experiments for examining the rates and possible pathways of transformation of a representative BFR (tetrabromobisphenol A, TBBPA) using acetone, toluene, and methanol as the solvents. Our results showed that toluene and methanol had no effect on the transformation of TBBPA, but approximately 20% of TBBPA (100 mg L⁻¹) was transformed by acetone within 2 h at 50 °C. Analysis of the products with GC-MS showed that two high-molecular-weight products (MW = 586) were major products of the transformation reactions. The role of acetone as a reactant in the transformation of TBBPA was further validated with dueterated acetone. In addition, the effects of co-existing metals in WEEE (i.e., Zn, Cu, and Ni) on the transformation of TBBPA in the solvent systems were investigated. These metals tested were found to greatly enhance the rates of TBBPA transformation. The metal facilitated solvent reactions with TBBPA may lower the extractability of TBBPA by formation of larger and less soluble products, hence potentially increasing the cost for separating the chemical from WEEE.