Study of transportation and distribution of PCBs using an ecologically simulated growth chamber

This study was designed to investigate the transportation, distribution, and bioaccumulation of PCBs in various environmental media and compartments using an ecologically simulated growth chamber. Spatial and temporal trends of PCBs in the growth chamber were discussed. The release of PCB congeners in soil was affected by the amount of rainfall with the transporting direction moving away from PCBs contaminated point. Two pathways of PCBs accumulation in plants were the uptake of roots and the deposition on shoots/leaves. There were 29 PCB congeners been found in the lalang grass. Higher concentrations of lower chlorinated PCBs were identified than higher chlorinated PCBs because of relatively higher vapor pressure for lower chlorinated congeners. After 10months of monitoring, PCBs were detected in water samples which were contributed by the release of PCBs from leached soil. Analysis of sediment showed that the percentages of low- and mid-chlorinated biphenyls were decreased 1% and 13%, respectively compared to the increase (14%) of high-chlorinated biphenyls. The increase of high-chlorinated PCBs was possibly caused by their low hydrophilicity which had resulted higher adsorption rate in sediment. All of five species of fish had been found significant amount of PCBs accumulation ( summation operatorPCBs: 21.7-102.1 microg/g-lipid). The concentrations of PCBs in fish were varied significantly among species. The range of bioaccumulation factors (BAFs) among different species of fish could be as much as 5 times depending on the consumption habits of fish. The mass balance of PCBs distribution in the growth chamber was also discussed.     

High average daily intake of PCDD/Fs and serum levels in residents living near a deserted factory producing pentachlorophenol (PCP) in Taiwan: influence of contaminated fish consumption

An abandoned pentachlorophenol plant and nearby area in southern Taiwan was heavily contaminated by dioxins, impurities formed in the PCP production process. The investigation showed that the average serum PCDD/Fs of residents living nearby area (62.5 pg WHO-TEQ/g lipid) was higher than those living in the non-polluted area (22.5 and 18.2 pg WHO-TEQ/g lipid) (P<0.05). In biota samples, average PCDD/F of milkfish in sea reservoir (28.3 pg WHO-TEQ/g) was higher than those in the nearby fish farm (0.15 pg WHO-TEQ/g), and Tilapia and shrimp showed the similar trend. The average daily PCDD/Fs intake of 38% participants was higher than 4 pg WHO-TEQ/kg/day suggested by the world health organization. Serum PCDD/F was positively associated with average daily intake (ADI) after adjustment for age, sex, BMI, and smoking status. In addition, a prospective cohort study is suggested to determine the long-term health effects on the people living near factory.     

Growth and nutritive quality of Poa pratensis as influenced by ozone and competition

Interspecific plant competition has been hypothesized to alter effects of early-season ozone (O3) stress. A phytometer-based approach was utilized to investigate O3 effects on growth and nutritive quality of Poa pratensis grown in monoculture and in mixed cultures with four competitor-plant species (Anthoxanthum odoratum, Achillea millefolium, Rumex acetosa and Veronica chamaedrys). Mesocosms were exposed during April/May 2000-2002 to charcoal-filtered air+25 ppb O3 (control) or non-filtered air+50 ppb O3 (elevated O3). Biomass production was not affected by O3, but foliar injury symptoms were observed in May 2002. Early-season O3 exposure decreased relative food value of P. pratensis by an average of 8%, which is sufficient to have nutritional implications for its utilization by herbivores. However, forage quality response to O3 was not changed by interspecific competition. Lack of injury and nutritive quality response in P. pratensis harvested in September may reflect recovery from early-season O3 exposure.     

Enhanced photocatalysis of pentachlorophenol by metal-modified titanium (IV) oxide

The effects of four metals (Ag, Au, Pt, and Cu) doped on TiO2 on the photocatalysis of pentachlorophenol (PCP) were investigated. The results of this study indicated that all four metals-doped TiO2 catalysts were able to enhance the efficiency of PCP photocatalysis with an optimum metallic content of 0.1 wt%. For the metal-doped TiO2 samples (Au, Pt, and Cu), the patterns of light absorption were significantly extended toward visible light spectra in the wavelengths between 400 and 800 nm. The photocatalysis of PCP was pH dependent with the maximum degradation rate achieved in the solution at pH 3. The formation of chloride ion corresponded with the concentration of PCP degraded which confirmed that dechlorination was the major pathway of PCP photocatalysis. The overall toxicities of PCP samples were reduced with the extension of light exposure using the microtox test. The results of PCP photocatalysis are also discussed based on the characteristics of metal/TiO2 including X-ray differential (XRD) patterns, Brunquer Emmett Teller (BET) specific area analysis, and Ultra Violet (UV)-Vis absorption spectra.     

Adsorption characteristics of benzene on biosolid adsorbent and commercial activated carbons

This study selected biosolids from a petrochemical waste-water treatment plant as the raw material. The sludge was immersed in 0.5-5 M of zinc chloride (ZnCl2) solutions and pyrolyzed at different temperatures and times. Results indicated that the 1-M ZnCl2-immersed biosolids pyrolyzed at 500 degrees C for 30 min could be reused and were optimal biosolid adsorbents for benzene adsorption. Pore volume distribution analysis indicated that the mesopore contributed more than the macropore and micropore in the biosolid adsorbent. The benzene adsorption capacity of the biosolid adsorbent was 65 and 55% of the G206 (granular-activated carbon) and BPL (coal-based activated carbon; Calgon, Carbon Corp.) activated carbons, respectively. Data from the adsorption and desorption cycles indicated that the benzene adsorption capacity of the biosolid adsorbent was insignificantly reduced compared with the first-run capacity of the adsorbent; therefore, the biosolid adsorbent could be reused as a commercial adsorbent, although its production cost is high.     

Pozzolanic reactivity of the synthetic slag from municipal solid waste incinerator cyclone ash and scrubber ash

This study investigates the pozzolanic reactions and compressive strength of the blended cement manufactured using synthetic slag obtained from municipal solid waste incinerator (MSWI) cyclone ash and scrubber ash as partial replacement of portland cement. The synthetic slag was made by co-melting the MSWI scrubber ash and cyclone ash mixtures at 1400 degrees C for 30 min. Following pulverization, the different types of slag were blended with cement as cement replacement at ratios ranging from 10 to 40 wt %. The synthetic slag thus obtained was quantified, and the characteristics of the slag-blended cement pastes were examined. These characteristics included the pozzolanic activity, compressive strength, hydration activity, crystal phases, species, and microstructure at various ages. The 90-day compressive strength developed by slag-blended cement pastes with 10 and 20 wt % of the cement replaced by the synthetic slag outperformed ordinary portland cement by 1-7 MPa. X-ray diffraction species analyses indicated that the hydrates in the slag-blended cement pastes were mainly portlandite, the calcium silicate hydrate gels, and calcium aluminate hydrate salts, similar to those found in ordinary portland cement paste. Differential thermal and thermogravimetric analysis also indicated that the slag reacted with portlandite to form calcium silicate hydrate gels.     

造船用双角钢式脚手架的危险点电测

对角钢式脚手架进行应力测试和理论计算研究.采用电测法测试了危险截面的应力大小及分布规律.结果表明,2、4测点是危险点;采用斜弯曲理论进行理论计算,所得结论与实验测试是一致的,其中2点受拉应力作用.上述分析为脚手架的设计、制作和安全使用提供了强度分析依据.同时还对脚手架其他安全问题进行了讨论.     

Quantitative indicator of homeostatic risk perception in car following

Driving behavior is largely affected by the risk perception of drivers. On the basis of risk homeostasis theory, we regard that drivers may adjust car movement according to the perceived risks fluctuating around a target level. However, the manner by which risk perception is quantified remains unclear. We propose assumptions on the quantitative indicators of risk perception and identify a suitable quantitative indicator of risk perception in car-following process. Three risk indicators are discussed, i.e. time-to-collision (TTC), time headway (TH), and safety margin (SM). Using homeostatic features as bases, we found that SM more suitably quantifies homeostatic risk perception than TTC or TH does. Data collected from video drive recorders installed in taxis operating in Beijing are used to analyze the target risk level of SM (desired SM, or DSM) of professional drivers during the car-following process. The data collected by Ahn et al. (2004) to verify Newell’s model are converted into DSM data to further analyze the target risk level of general drivers. The DSM histogram of professional drivers shows that the standard deviation of the DSM value is 0.115, with a mean value of 0.862 and a total distribution close to the normal distribution. For a general driver, the mean value of DSM is 0.896, which is higher than that of professional drivers. This research may shed lights on the understanding of driving behavior.     

Biohydrogen production using waste activated sludge as a substrate from fructose-processing wastewater treatment

Biohydrogen production by dark fermentation in a series of batch tests under different environmental control conditions was evaluated to determine the optimal initial cultivation pH and temperature for a continuous-flow kinetic test to validate the kinetic model system. The waste activated sludge (WAS) from fructose-processing manufacturing was used as the model substrate for biohydrogen production. The batch experiments for biohydrogen production were conducted in a 6 l bioreactor. Fifteen batch kinetic tests were investigated when pH was controlled at 6, 7, 8 and 9 as well as the temperature was controlled at 37 °C, 45 °C and 55 °C, respectively. The experimental results indicated that the optimal operational condition for hydrogen production occurred while pH was 7 and temperature was 55 °C with the highest hydrogen production of 7.8 mmol. The optimal recovery time for hydrogen was 25 h in the batch experiments. Furthermore, the kinetic test of biohydrogen production was performed by anaerobic mixed microbial culture in the continuous-flow experiment when pH and temperature was maintained at 7 and 55 °C. Approximately 60% and 7% of substrate solution was converted into acetate and hydrogen, respectively, at the steady state. Roughly only 0.77% and 2.7% of substrate solution was converted into propionate and butyrate, respectively, at a steady-state condition. The experimental and modeling approaches presented in this study could be employed for the design of pilot-scale and full-scale anaerobic biohydrogen fermentors using food-processing waste activated sludge (WAS) as a substrate solution.     

基于满意度的热风炉变论域模糊控制

针对热风炉具有参数时变、强干扰、非线性等特点,其最佳空燃比难以确定的问题,提出一种基于模糊满意度的变论域模糊控制方法。首先通过在线获得加热过程的状态参数,采用满意度函数对空燃比进行评价,并将该评价结果和炉温变化作为变论域模糊控制方法的输入来实时获取最优的空燃比值,从而保证热风炉炉温的温度控制。实际运行结果证实了该系统的有效性。