COALBED METHANE PRODUCT WATER CHEMISTRY IN THREE WYOMING WATERSHEDS1

ABSTRACT: The Powder River Basin in Wyoming has become one of the most active areas of coalbed methane (CBM) development in the western United States. Extraction of methane from coalbeds requires pumping of aquifer water, which is called product water. Two to ten extraction wells are manifolded into one discharge point and product water is released into nearby unlined holding ponds. The objective of this study was to evaluate the chemistry, salinity, and sodicity of CBM product water at discharge points and associated holding ponds as a function of watershed. The product water samples from the discharge points and associated holding ponds were collected from the Cheyenne River (CHR), Belle Fourche River (BFR), and Little Powder River (LPR) watersheds during the summers of 1999 and 2000. These samples were analyzed for pH, electrical conductivity (EC), total dissolved solids (TDS), alkalinity, sodium (Na), calcium (Ca), magnesium (Mg), potassium (K), sulfate (SO₄^2‐), and chloride (C^1‐). From the chemical data, practical sodium adsorption ratio (SARp) and true sodium adsorption ratio (SARt) were calculated for the CBM discharge water and pond water. The pH, EC, TDS, alkalinity, Na, Ca, Mg, K, SARp, and SARt of CBM discharge water increased significantly moving north from the CHR watershed to the LPR watershed. CBM discharge water in associated holding ponds showed significant increases in EC, TDS, alkalinity, Na, K, SARp, and SARt moving north from the CHR to the LPR watershed. Within watersheds, the only significant change was an increase in pH from 7.21 to 8.26 between discharge points and holding ponds in the LPR watershed. However, the LPR and BFR exhibited larger changes in mean chemistry values in pH, salinity (EC, TDS), and sodicity (SAR) between CBM product water discharges and associated holding ponds than the CHR watershed. For instance, the mean EC and TDS of CBM product water in LPR increased from 1.93 to 2.09 dS/m, and froml,232 to 1,336 mg/L, respectively, between discharge and pond waters. The CHR exhibited no change in EC, TDS, Na, or SAR between discharge water and pond water. Also, while not statistically significant, mean alkalinity of CBM product water in BFR and LPR watersheds decreased from 9.81 to 8.01 meq/L and from 19.87 to 18.14 meq/L, respectively, between discharge and pond waters. The results of this study suggest that release of CBM product water onto the rangelands of BFR and LPR watersheds may precipitate calcium carbonate (CaCO₃) in soils, which in turn may decrease infiltration and increase runoff and erosion. Thus, use of CBM product water for irrigation in LPR and BFR watersheds may require careful planning based on water pH, EC, alkalinity, Na, and SAR, as well as local soil physical and chemical properties.     

Book reviews

Earth Politics. Ernst Ulrich von Weizsacker, 1994, London, Zed Books, 234 pp. ISBN 1 85649 174 9, pb £14.95; hb £36.95

Greening Your Local Authority. Janice Morphet (Ed.), 1994, London, Pitman Publishing (originally Harlow, Longman), 144 pp. ISBN 0582 229 065, pb £32.50

Ecology and Society: an introduction. Luke Martell, 1994 London, Polity Press, 250 pp. ISBN 0 7456 1022 6, hb £39.50, ISBN 0 7456 1023 4, pb £11.95

The Politics of the Environment. Robert E. Goodin, 1994. Cheltenham, Edward Elgar, 599 pp. ISBN 1 85278 872 0, hb £115.00

Introduction to Environmental Impact Assessment John Glasson, Riki Therivel & Andrew Chadwick, 1994, London, UCL Press, 352 pp. ISBN 1 85728 117 9, hb £45.00, ISBN 1 85728 118 7, pb £14.95

Planning for the Planet: sustainable development strategies for local and strategic plans. Friends of the Earth, 1994, London, FoE, 104 pp. ISBN 1 85750 224 8, £12.00

Environmental Strategy and Sustainable Development: the corporate challenge for the 21st century. Richard Welford, 1995, London, Routledge, 240 pp. ISBN 0 415 10551 X, hb £40.00, ISBN 0 415 10552 8, pb £12.99

Housing and the Environment: a new agenda. Mark Bhatti, Jane Brooke & Mike Gibson (Eds), 1994, Foreword by Jonathon Porritt, Coventry, Chartered Institute of Housing, 210 pp. ISBN 0 901 607 738, £14.95     

Applying metabolic fingerprinting to ecology: The use of Fourier-transform infrared spectroscopy for the rapid screening of plant responses to N deposition

The potential for metabolic fingerprinting via Fourier-transform infrared (FT-IR) spectroscopy to provide a novel approach for the detection of plant biochemical responses to N deposition is examined. An example of spectral analysis using shoot samples taken from an open top chamber (OTC) experiment simulating wet ammonium deposition is given. Sample preparation involved oven drying and homogenisation via mill grinding. Slurries of a consistent dilution were then prepared prior to FT-IR analysis. Spectra from control, 8 and 16 kg N ha^–1 yr^–1 treatments were then subjected to cross-validated discriminant function analysis. Ordination diagrams showed clear separation between the three N treatments examined. The potential for using Calluna vulgaris (L.) Hull as a bioindicator of N deposition is further evident from these results. The results also clearly demonstrate the power of FT-IR in discriminating between subtle phenotypic alterations in overall plant biochemistry as affected by ammonium pollution.     

Quantifying dry NH3 deposition to an ombrotrophic bog from an automated NH3 field release system

Providing an accurate estimate of the dry component of N deposition to low N background, semi-natural habitats, such as bogs and upland moors dominated by Calluna vulgaris is difficult, but essential to relate nitrogen deposition to effects in these communities. To quantify the effects of NH₃ inputs to moorland vegetation growing on a bog at a field scale, a field release NH₃ fumigation system was established at Whim Moss (Scottish Borders) in 2002. Gaseous NH₃ from a line source was released along of a 60 m transect, when meteorological conditions (wind speed >2.5 m s^?1 and wind direction in the sector 180–215°) were met, thereby providing a profile of decreasing NH₃ concentration with distance from the source. In a complementary study, using a NH₃ flux chamber system, the relationships between NH₃ concentrations and cuticular resistances were quantified for a range of NH₃ concentrations and micrometeorological conditions for moorland vegetation. Cuticular resistances increased with NH₃ concentration from 11 s m^?1 at 3.0 μg m^?3 to 30 s m^?1 at 30 μg m^?3. The NH₃ concentration data and the concentration-dependent canopy resistance are used to calculate NH₃ deposition taking into account leaf surface wetness. The implications of using an NH₃ concentration-dependent cuticular resistance and the importance for refining critical loads are discussed.     

Who changes consumption following residential energy evaluations? local programs need all income groups to achieve kyoto targets

The government of Canada ratified the Kyoto Protocol on 17 December 2002, but over 100 Canadian municipalities had joined the International Council for Local Environmental Intitatives' (ICLEI) Cities for Climate Protection (CCP) campaign up to a decade earlier. A low-cost home energy rating system (HERS) evaluation and individualized energy plan was provided to 420 households in Kitchener, Ontario, from September 2000 to August 2001. To assess the impact of the energy efficiency program, natural gas consumption in the year prior to the evaluation was compared with that in the year following. Overall, a 5% reduction was achieved, but individual responses varied widely. Situational and psychological factors were evaluated for three groups of households: the conservers, the consumers and the steady middle group. Conservers (30% of households) had higher initial energy consumption levels and achieved two-thirds of the potential savings identified by the energy evaluation. Consumers (12% of households) had higher ownership rates of high-efficiency furnaces and water heaters and demonstrated the rebound effect of increased demand for energy services following the evaluation. Low-income groups were the most likely to behave as conservers (42%) while high-income groups were the least likely to be conservers (13%) and the most likely to be consumers. Local programs need to be inclusive of all income groups to increase participation and implementation rates by systematically reducing barriers (financial, knowledge, trust) or increasing incentives (financial, regulatory or social) if the desired goal (e.g. Kyoto target) is to be achieved.     

The acetochlor registration partnership surface water monitoring program for four corn herbicides

A surface drinking water monitoring program for four corn (Zea mays L.) herbicides was conducted during 1995-2001. Stratified random sampling was used to select 175 community water systems (CWSs) within a 12-state area, with an emphasis on the most vulnerable sites, based on corn intensity and watershed size. Finished drinking water was monitored at all sites, and raw water was monitored at many sites using activated carbon, which was shown capable of removing herbicides and their degradates from drinking water. Samples were collected biweekly from mid-March through the end of August, and twice during the off-season. The analytical method had a detection limit of 0.05 microg L(-1) for alachlor [2-chloro-N-(2,6-diethylphenyl)-N-(methoxymethyl)-acetamide] and 0.03 microg L(-1) for acetochlor [2-chloro-N-(ethoxymethyl)-N-(2-ethyl-6-methylphenyl)-acetamide], atrazine [6-chloro-N-ethyl-N'-(1-methylethyl)-1,3,5-triazine-2,4-diamine], and metolachlor [2-chloro-N-(2-ethyl-6-methylphenyl)-N-(2-methoxy-1-methylethyl)-acetamide]. Of the 16528 drinking water samples analyzed, acetochlor, alachlor, atrazine, and metolachlor were detected in 19, 7, 87, and 53% of the samples, respectively. During 1999-2001, samples were also analyzed for the presence of six major degradates of the chloroacetanilide herbicides, which were detected more frequently than their parent compounds, despite having higher detection limits of 0.1 to 0.2 microg L(-1). Overall detection frequencies were correlated with product use and environmental fate characteristics. Reservoirs were particularly vulnerable to atrazine, which exceeded its 3 microg L(-1) maximum contaminant level at 25 such sites during 1995-1999. Acetochlor annualized mean concentrations (AMCs) did not exceed its mitigation trigger (2 microg L(-1)) at any site, and comparisons of observed levels with standard measures of human and ecological hazards indicate that it poses no significant risk to human health or the environment.     

Toward Cyborg PPGIS: exploring socio-technical requirements for the use of web-based PPGIS in two municipal planning cases,Stockholm region,Sweden

Web-based Public Participation Geographic Information Systems (PPGIS) are increasingly used for surveying place values and informing municipal planning in contexts of urban densification. However, research is lagging behind the rapid deployment of PPGIS applications. Some of the main opportunities and challenges for the uptake and implementation of web-based PPGIS are derived from a literature review and two case studies dealing with municipal planning for urban densification in the Stockholm region, Sweden. A simple clustering analysis identified three interconnected themes that together determine the performance of PPGIS: (i) tool design and affordances; (ii) organisational capacity; and (iii) governance. The results of the case studies augment existing literature regarding the connections between the different socio-technical dimensions for the design, implementation and evaluation of PPGIS applications in municipal planning. A cyborg approach to PPGIS is then proposed to improve the theoretical basis for addressing these dimensions together.     

Molten carbonate fuel cells fed with biogas: Combating H2S

The use of biomass and waste to produce alternative fuels, due to environmental and energy security reasons, is a high-quality solution especially when integrated with high efficiency fuel cell applications. In this article we look into the coupling of an anaerobic digestion process of organic residues to electrochemical conversion to electricity and heat through a molten carbonate fuel cell (MCFC). In particular the pathway of the exceedingly harmful compound hydrogen sulphide (H₂S) in these phases is analysed. Hydrogen sulphide production in the biogas is strongly interrelated with methane and/or hydrogen yield, as well as with operating conditions like temperature and pH. When present in the produced biogas, this compound has multiple negative effects on the performance and durability of an MCFC. Therefore, there are important issues of integration to be solved.Three general approaches to solve the sulphur problem in the MCFC are possible. The first is to prevent the formation of hydrogen sulphide at the source: favouring conditions that inhibit its production during fermentation. Secondly, to identify the sulphur tolerance levels of the fuel cell components currently in use and develop sulphur-tolerant components that show long-term electrochemical performance and corrosion stability. The third approach is to remove the generated sulphur species to very low levels before the gas enters the fuel cell.