A comparison of hourly with annual air pollutant emissions: Implications for estimating acute exposure and public health risk

Health risks from air pollutants are evaluated by comparing chronic (i.e., an average over 1 yr or greater) or acute (typically 1-hr) exposure estimates with chemical- and duration-specific reference values or standards. When estimating long-term pollutant concentrations via exposure modeling, facility-level annual average emission rates are readily available as model inputs for most air pollutants. In contrast, there are far fewer facility-level hour-by-hour emission rates available for many of these same pollutants. In this report, we first analyze hour-by-hour emission rates for total reduced sulfur (TRS) compounds from eight kraft pulp mill operations. This data set is used to demonstrate discrepancies between estimating exposure based on a single TRS emission rate that has been calculated as the mean of all operating hours of the year, as opposed to reported hourly emission rates. A similar analysis is then performed using reported hourly emission rates for sulfur dioxide (SO₂) and oxides of nitrogen (NO_x) from three power generating units from a U.S. power plant. Results demonstrate greater variability at kraft pulp mill operations, with ratios of reported hourly to average hourly TRS emissions ranging from less than 1 to greater than 160 during routine facility operations. Thus, if fluctuations in hourly emission rates are not accounted for, over- or underestimates of hourly exposure, and thus acute health risk, may occur. In addition to this analysis, we also demonstrate an additional challenge when assessing health risk based on hourly exposures: the lack of human health reference values based on 1-hr exposures.

Implications: Largely due to the lack of reported hourly emission rate data for many air pollutants, an hourly average emission rate (calculated from an annual emission rate) is often used when modeling the potential for acute health risk. We calculated ratios between reported hourly and hourly average emission rates from pulp and paper mills and a U.S. power plant to demonstrate that if not considered, hourly fluctuations in emissions could result in an over- or underestimation of exposure and risk. We also demonstrate the lack of 1-hr human health reference values meant to be protective of the general population, including children.     

Identifying pathways to visions of future land use in Europe

Regional Environmental Change - Plausible scenarios of future land use derived from model projections may differ substantially from what is actually desired by society, and identifying such...     

The role of rhizofiltration and allelopathy on the removal of cyanobacteria in a continuous flow system

Environmental Science and Pollution Research - A continuous flow filtration system was designed to identify and quantify the removal mechanisms of Cyanobacteria (Microcystis aeruginosa) by...     

Impacts of tropical forest disturbance on species vital rates

Tropical forests are experiencing enormous threats from deforestation and habitat degradation. Much knowledge of the impacts of these land-use changes on tropical species comes from studies examining patterns of richness and abundance. Demographic vital rates (survival, reproduction, and movement) can also be affected by land-use change in a way that increases species vulnerability to extirpation, but in many cases these impacts may not be manifested in short-term changes in abundance or species richness. We conducted a literature review to assess current knowledge and research effort concerning how land-use change affects species vital rates in tropical forest vertebrates. We found a general paucity of empirical research on demography across taxa and regions, with some biases toward mammals and birds and land-use transitions, including fragmentation and agriculture. There is also considerable between-species variation in demographic responses to land-use change, which could reflect trait-based differences in species sensitivity, complex context dependencies (e.g., between-region variation), or inconsistency in methods used in studies. Efforts to improve understanding of anthropogenic impacts on species demography are underway, but there is a need for increased research effort to fill knowledge gaps in understudied tropical regions and taxa. The lack of information on demographic impacts of anthropogenic disturbance makes it difficult to draw definite conclusions about the magnitude of threats to tropical ecosystems under anthropogenic pressures. Thus, determining conservation priorities and improving conservation effectiveness remains a challenge.     

Developing a theory of change for a community‐based response to illegal wildlife trade

The escalating illegal wildlife trade (IWT) is one of the most high‐profile conservation challenges today. The crisis has attracted over US$350 million in donor and government funding in recent years, primarily directed at increased enforcement. There is growing recognition among practitioners and policy makers of the need to engage rural communities that neighbor or live with wildlife as key partners in tackling IWT. However, a framework to guide such community engagement is lacking. We developed a theory of change (ToC) to guide policy makers, donors, and practitioners in partnering with communities to combat IWT. We identified 4 pathways for community‐level actions: strengthen disincentives for illegal behavior, increase incentives for wildlife stewardship, decrease costs of living with wildlife, and support livelihoods that are not related to wildlife. To succeed the pathways, all require strengthening of enabling conditions, including capacity building, and of governance. Our ToC serves to guide actions to tackle IWT and to inform the evaluation of policies. Moreover, it can be used to foster dialogue among IWT stakeholders, from local communities to governments and international donors, to develop a more effective, holistic, and sustainable community‐based response to the IWT crisis.     

Effects of bridge construction on songbirds and small mammals at Blennerhassett Island, Ohio River, USA

Construction of man-made objects such as roads and bridges may have impacts on wildlife depending on species or location. We investigated songbirds and small mammals along the Ohio River, WV, USA at a new bridge both before and after construction and at a bridge crossing that was present throughout the study. Comparisons were made at each site over three time periods (1985–1987 [Phase I] and 1998–2000 [Phase II] [pre-construction], 2007–2009 [Phase III] [post-construction]) and at three distances (0, 100, 300 m) from the bridge or proposed bridge location. Overall, 70 songbirds and 10 small mammals were detected during the study. Cliff swallows (Petrochelidon pyrrhonota) and rock pigeons (Columba livia) showed high affinity for bridges (P?<?0.05). Combined small mammal abundances increased between Phases I and II (P?<?0.05), but did not differ between Phases II and III (P?>?0.05). Species richness and diversity for songbirds and small mammals did not differ before and after bridge construction (P?>?0.05). We found that most species sampled did not respond to the bridge crossing, and believe that the bridge is not causing any measurable negative density impacts to the species we investigated. The new bridge does provide habitat for exotic rock pigeons that are adjusted to man-made structures for nesting.     

IMPACT OF COAL SURFACE MINING AND RECLAMATION ON SUSPENDED SEDIMENT IN THREE OHIO WATERSHEDS1

ABSTRACT: Prior to PL95–87 little research had been conducted to determine the impacts of mining and reclamation practices on sediment concentrations and yields on a watershed scale. Furthermore, it was unknown whether sediment yield and other variables would return to undisturbed levels after reclamation. Therefore, three small watersheds, with differing lithologies and soils, were monitored for runoff and suspended sediment concentrations during three phases of watershed disturbances: undisturbed watershed condition, mining and reclamation disturbances, and post‐reclaimed condition. Profound increases in suspended‐sediment concentrations, load rates, and yields due to mining and reclamation activities, and subsequent drastic decreases after reclamation were documented. Even with increases in runoff potential, reductions in suspended‐sediment concentrations and load rates to below or near undisturbed‐watershed levels is possible by using the mulch‐crimping technique and by removing diversions. Maximum concentrations and load rates occurred during times of active disturbances that exposed loose soil and spoil to high‐intensity rains. Sediment concentrations remained elevated compared with the undisturbed watershed when diversions were not well maintained and overtopped, and when they were not removed for final reclamation. Diversions are useful for vegetation establishment, but should be maintained until they are removed for final reclamation after good vegetative cover is established.     

Biodegradation modelling of a dissolved gasoline plume applying independent laboratory and field parameters

Biodegradation of organic contaminants in groundwater is a microscale process which is often observed on scales of 100s of metres or larger. Unfortunately, there are no known equivalent parameters for characterizing the biodegradation process at the macroscale as there are, for example, in the case of hydrodynamic dispersion. Zero- and first-order degradation rates estimated at the laboratory scale by model fitting generally overpredict the rate of biodegradation when applied to the field scale because limited electron acceptor availability and microbial growth are not considered. On the other hand, field-estimated zero- and first-order rates are often not suitable for predicting plume development because they may oversimplify or neglect several key field scale processes, phenomena and characteristics. This study uses the numerical model BIO3D to link the laboratory and field scales by applying laboratory-derived Monod kinetic degradation parameters to simulate a dissolved gasoline field experiment at the Canadian Forces Base (CFB) Borden. All input parameters were derived from independent laboratory and field measurements or taken from the literature a priori to the simulations. The simulated results match the experimental results reasonably well without model calibration. A sensitivity analysis on the most uncertain input parameters showed only a minor influence on the simulation results. Furthermore, it is shown that the flow field, the amount of electron acceptor (oxygen) available, and the Monod kinetic parameters have a significant influence on the simulated results. It is concluded that laboratory-derived Monod kinetic parameters can adequately describe field scale degradation, provided all controlling factors are incorporated in the field scale model. These factors include advective–dispersive transport of multiple contaminants and electron acceptors and large-scale spatial heterogeneities.     

Low waste feed concentrations and destruction removal efficiency

In the early 1980s, the Environmental Protection Agency (EPA) funded research on destruction and removal efficiencies (DREs) at eight hazardous waste incinerators. This research appeared to show that DREs of 99.99% could not be achieved at low waste feed principal hazardous organic constituent (POHC) concentrations. During the mid 1980s and 1990s however, testing at Superfund sites has indicated that DREs of 99.9999% or greater can be achieved at low waste feed POHC concentrations. This paper will summarize testing which includes 32 test runs at five Superfund sites and the EPA's incineration research facility. The tests include POHC concentrations from 6552 parts per million down to 28 parts per million at typical DREs of 6–9 s or greater.     

Study on the mechanical and environmental properties of concrete containing cathode ray tube glass aggregate

Cathode ray tube (CRT) glass is considered a hazardous material due to its lead toxicity. In addition, current disposal practices are being phased out due to their adverse environmental impacts. In this project, CRT glass was used as a fine aggregate replacement in concrete. Life-cycle material characterization was conducted by evaluating the durability and strength of the CRT-Concrete. Leaching tests were also conducted to investigate whether the material meets drinking water limits for Pb. Test results show that the plastic state of the CRT-Concrete was affected by the angularity of the glass particles. Moreover, the compressive strength of CRT-Concrete met and exceeded that of the control specimen. However, CRT-Concrete was susceptible to expansive alkali-silica reactions when more than 10% CRT replacement was used. Environmental leaching results show that lead concentrations from CRT-Concrete are below the drinking water limits depending on the CRT volume replacement and if biopolymers are used.