煤粉炉掺烧干化污泥的污染物排放研究

结合某电厂420 t/h四角煤粉炉掺烧污泥项目的实验室分析测试,了解煤粉掺烧不同含水率不同比例的干化污泥条件下烟气中污染物和灰渣中重金属的排放特性。结果表明,在实验研究配比和燃烧的条件下,大部分重金属元素Pb、Cu、Cr和Ni残留在灰渣中,Zn、Cd部分残留在灰渣中,As、Hg和Se等易挥发元素释放到烟气中,在灰渣中的含量很小。掺烧污泥后,灰渣中的重金属含量较单烧单煤都有了一定幅度的升高,Zn的含量是单煤的2倍,其余重金属是单煤的1.1~1.2倍。3种不同的掺混比例之间的污染气体排放浓度基本相似。烟气中主要污染物及重金属浓度可以满足现行国家标准。与单烧单煤相比,CO、HCl以及其他有机气体排放浓度基本相同;NH3的排放浓度较单煤有所升高;SO2、NOx和CO2排放浓度略有降低;飞灰浓度有所升高。烟气中的重金属,Hg含量升高了30%,Pb含量约为单煤的4.3~4.8倍。以上研究结果可为环保达标和飞灰利用提供基础数据。     

Behavior and mechanism of arsenate adsorption on activated natural siderite: evidences from FTIR and XANES analysis

Activated natural siderite (ANS) was used to investigate its characteristics and mechanisms of As(V) adsorption from aqueous solution. Batch tests were carried out to determine effects of contact time, initial As(V) concentration, temperature, pH, background electrolyte, and coexisting anions on As(V) adsorption. Arsenic(V) adsorption on ANS well-fitted pseudo-second-order kinetics. ANS showed a high-adsorption capacity of 2.19 mg/g estimated from Langmuir isotherm at 25 °C. Thermodynamic studies indicated that As(V) adsorption on ANS was spontaneous, favorable, and endothermic. ANS adsorbed As(V) efficiently in a relatively wide pH range between 2.0 and 10.0, although the removal efficiency was slightly higher in acidic conditions than that in basic conditions. Effects of background electrolyte and coexisting anions were not significant within the concentration ranges observed in high As groundwater. Results of XRD and Fe K-edge XANES analysis suggested ANS acted as an Fe(II)/(III) hybrid system, which was quite effective in adsorbing As from aqueous solution. There was no As redox transformation during adsorption, although Fe(II) oxidation occurred in the system. Two infrared bands at 787 and 872 cm^?1 after As(V) adsorption suggested that As(V) should be predominantly adsorbed on ANS via inner-sphere bidendate binuclear surface complexes.     

Formation of indoor nitrous acid (HONO) by light-induced NO<Subscript>2</Subscript> heterogeneous reactions with white wall paint

Gaseous nitrogen dioxide (NO₂) represents an oxidant that is present in relatively high concentrations in various indoor settings. Remarkably increased NO₂ levels up to 1.5 ppm are associated with homes using gas stoves. The heterogeneous reactions of NO₂ with adsorbed water on surfaces lead to the generation of nitrous acid (HONO). Here, we present a HONO source induced by heterogeneous reactions of NO₂ with selected indoor paint surfaces in the presence of light (300 nm?<?λ?<?400 nm). We demonstrate that the formation of HONO is much more pronounced at elevated relative humidity. In the presence of light (5.5 W m^?2), an increase of HONO production rate of up to 8.6?·?10⁹ molecules cm^?2 s^?1 was observed at [NO₂]?=?60 ppb and 50 % relative humidity (RH). At higher light intensity of 10.6 (W m^?2), the HONO production rate increased to 2.1?·?10¹⁰ molecules cm^?2 s^?1. A high NO₂ to HONO conversion yield of up to 84 % was observed. This result strongly suggests that a light-driven process of indoor HONO production is operational. This work highlights the potential of paint surfaces to generate HONO within indoor environments by light-induced NO₂ heterogeneous reactions.     

Scanning electron microscopic investigations of root structural modifications arising from growth in crude oil-contaminated sand

The choice of plant for phytoremediation success requires knowledge of how plants respond to contaminant exposure, especially their roots which are instrumental in supporting rhizosphere activity. In this study, we investigated the responses of plants with different architectures represented by beetroot (Beta vulgaris), a eudicot with a central taproot and many narrower lateral roots, and tall fescue (Festuca arundinacea), a monocot possessing a mass of threadlike fibrous roots to grow in crude oil-treated sand. In this paper, scanning electron microscopy was used to investigate modifications to plant root structure caused by growth in crude oil-contaminated sand. Root structural disorders were evident and included enhanced thickening in the endodermis, increased width of the root cortical zone and smaller diameter of xylem vessels. Inhibition in the rate of root elongation correlated with the increase in cell wall thickening and was dramatically pronounced in beetroot compared to the roots of treated fescue. The latter possessed significantly fewer (p?<?0.001) and significantly shorter (p?<?0.001) root hairs compared to control plants. Possibly, root hairs that absorb the hydrophobic contaminants may prevent contaminant absorption into the main root and concomitant axile root thickening by being sloughed off from roots. Tall fescue exhibited greater root morphological adaptability to growth in crude oil-treated sand than beetroot and, thus, a potential for long-term phytoremediation.     

Estimating and comparing greenhouse gas emissions with their uncertainties using different methods: A case study for an energy supply utility

Energy supply utilities release significant amounts of greenhouse gases (GHGs) into the atmosphere. It is essential to accurately estimate GHG emissions with their uncertainties, for reducing GHG emissions and mitigating climate change. GHG emissions can be calculated by an activity-based method (i.e., fuel consumption) and continuous emission measurement (CEM). In this study, GHG emissions such as CO₂, CH₄, and N₂O are estimated for a heat generation utility, which uses bituminous coal as fuel, by applying both the activity-based method and CEM. CO₂ emissions by the activity-based method are 12–19% less than that by the CEM, while N₂O and CH₄ emissions by the activity-based method are two orders of magnitude and 60% less than those by the CEM, respectively. Comparing GHG emissions (as CO₂ equivalent) from both methods, total GHG emissions by the activity-based methods are 12–27% lower than that by the CEM, as CO₂ and N₂O emissions are lower than those by the CEM. Results from uncertainty estimation show that uncertainties in the GHG emissions by the activity-based methods range from 3.4% to about 20%, from 67% to 900%, and from about 70% to about 200% for CO₂, N₂O, and CH₄, respectively, while uncertainties in the GHG emissions by the CEM range from 4% to 4.5%. For the activity-based methods, an uncertainty in the Intergovernmental Panel on Climate Change (IPCC) default net calorific value (NCV) is the major uncertainty contributor to CO₂ emissions, while an uncertainty in the IPCC default emission factor is the major uncertainty contributor to CH₄ and N₂O emissions. For the CEM, an uncertainty in volumetric flow measurement, especially for the distribution of the volumetric flow rate in a stack, is the major uncertainty contributor to all GHG emissions, while uncertainties in concentration measurements contribute a little to uncertainties in the GHG emissions.

Implications:Energy supply utilities contribute a significant portion of the global greenhouse gas (GHG) emissions. It is important to accurately estimate GHG emissions with their uncertainties for reducing GHG emissions and mitigating climate change. GHG emissions can be estimated by an activity-based method and by continuous emission measurement (CEM), yet little study has been done to calculate GHG emissions with uncertainty analysis. This study estimates GHG emissions and their uncertainties, and also identifies major uncertainty contributors for each method.     

Relationship between carbon emissions and economic development: case study of six countries

There is much discussion within the sustainable development community regarding climate stabilization and particularly, finding environmentally equitable ways to address emission reductions. Knowing the current level of emission is only one variable in this complex picture. While the rate of emissions is clearly a problem, the overall increase in GHG concentration in the atmosphere is ultimately the main driver of anthropogenic warming. Therefore, it is also important to understand the cumulative emissions, those which have taken us to the current condition. This research presents a case study of six countries to compare the emissions per capita and cumulative emissions during the past 200 years. It is known that carbon emissions are closely related to economic activities, but here we show that some countries have reached per capita emissions plateaus at different levels while others are still rising. Specifically, one approach toward socioeconomic development, in terms of energy–economy, reaches a plateau at 10 Mt carbon per person, which the United Kingdom and South Korea have attained. The US occupies another emission regime at 20 Mt carbon per person. Developing economies such as India and China are considerably below these levels, and unless they follow other integrated economic/environmental solutions, they will continue to increase their per capita emissions during development.     

Comparison of marginal abatement cost curves for 2020 and 2030: longer perspectives for effective global GHG emission reductions

This study focuses on analyses of greenhouse gas (GHG) emission reductions, from the perspective of interrelationships among time points and countries, in order to seek effective reductions. We assessed GHG emission reduction potentials and costs in 2020 and 2030 by country and sector, using a GHG emission reduction-assessment model of high resolution regarding region and technology, and of high consistency with intertemporal, interregional, and intersectoral relationships. Global GHG emission reduction potentials relative to baseline emissions in 2020 are 8.4, 14.7, and 18.9 GtCO₂eq. at costs below 20, 50, and 100 $/tCO₂eq., corresponding to +19, −2, and −7 %, respectively, relative to 2005. The emission reduction potential for 2030 is greater than that for 2020, mainly because many energy supply and energy-intensive technologies have long lifetimes and more of the current key facilities will be extant in 2020 than in 2030. The emission reduction potentials in 2030 are 12.6, 22.0, and 26.6 GtCO₂eq. at costs below 20, 50, and 100 $/tCO₂eq., corresponding to +19, −2, and −7 %, respectively, relative to 2005. The emission reduction potential for 2030 is greater than that for 2020, mainly because many energy supply and energy-intensive technologies have long lifetimes and more of the current key facilities will be extant in 2020 than in 2030. The emission reduction potentials in 2030 are 12.6, 22.0, and 26.6 GtCO₂eq. at costs below 20, 50, and 100 /tCO₂eq., corresponding to +33, +8, and −3 %, respectively, relative to 2005. Global emission reduction potentials at a cost below 50 $/tCO₂eq. for nuclear power and carbon capture and storage are 2.3 and 2.2 GtCO₂eq., respectively, relative to baseline emissions in 2030. Longer-term perspectives on GHG emission reductions toward 2030 will yield more cost-effective reduction scenarios for 2020 as well.     

The effect of natural and anthropogenic disturbance in forest canopy and its effect on species richness in forests of Uttarakhand Himalaya,India

Pinus roxburghii (chir-pine) and Quercus leucothchophora (banj-oak) are dominant forests of mountainous part of the Uttarakhand Himalaya. The continued anthropogenic disturbance is opening the canopy, forming canopy gaps and as a result forest fragments are developing. Thus, the present study aims to analyze variations in species richness and vegetational parameters in relation to canopy gaps in forests. Total species richness was greater in open canopied forest compared to moderate and close canopied forests. In comparison between oak and pine forest, it was greater in oak forest while the proportion of common species was low between oak—pine forests. Mean species richness did not significantly vary from one canopy gap to another as well as in oak and pine dominated forest. This indicated that dominant forest types played an important role to form the community structure. The shrubs richness were greater in closed canopy and between the forests it was greater in pine forest. Tree and shrub density was low in open canopy while herb density was high in moderate canopy. Thus, this study indicated that the dominant canopy species play an important role in deciding the community structures especially the distribution of under canopy species. These parameters should be considered for conservation and maintenance of plant biodiversity of a region.     

Challenges posed by climate change: is environmental protection an ethical issue?

Climate is one of the more complex physical systems in nature, its behaviour being fundamentally non-linear and chaotic. In assessing the potential risks from climate change and the costs of averting it, researchers and policymakers encounter pervasive uncertainty. Sceptics demand to get rid of the inherent uncertainties, and some experts, on the other end, keep sending out messages of catastrophic scenarios hoping that this will increase people’s awareness of the danger we face. The recent admission of a mistake in IPCC’s Climate change 2007 report (promptly broadcast by all the major media groups and newspapers from Jan. 20th 2010 onwards) made by the head of the Intergovernmental Panel on Climate Change—that Himalayan glaciers could melt away by 2035 (the IPCC claim of 2035 is wrong by over 300 years.)—has already brought a damage to the IPCC’s reputation that is likely to be considerable. But in this paper, perhaps risking being provocative and paradoxical, instead of looking for the right answers to what we think are inevitable uncertainties, we intend to search for new questions that may lead to a new way of thinking and may bring about new lifestyles and behaviour for citizens and firms.     

Development impact of advocacy initiatives in solid waste management in Nigeria

Solid waste management (SWM) in many low- and middle-income countries is sometimes driven by the informal sector. Unfortunately, contributions of the sector to SWM are not acknowledged in many developing countries. This situation often arises from inadequate awareness and lack of advocacy for these development contributions. This article reports on the impact of a study conducted by final-year geography undergraduates on the informal waste management sector in Nsukka urban area, Nigeria. The purposes of this exercise were to stimulate development intervention on behalf of the sector to improve perceptions, attitudes and performance, to impart a range of development research skills and to expose the students to the business opportunities provided by SWM and recycling. Informal waste sector workers and government officials responsible for SWM were interviewed, and some commercial data on recycling operations were collected. Findings of this study indicate that such advocacy initiatives were effective in increasing students’ awareness of opportunities and interest in working in the informal waste sector to promote better SWM and development in Nigeria. Lessons from this university case study are also drawn for other developing countries struggling to achieve the poverty reduction and job creation Millennium Development Goals (MDGs).