城镇化过程中的流域面源污染时空变化

以斧头湖流域为研究对象,在野外调查的基础上,借助遥感和GIS技术,对2008年、2015年斧头湖流域土地利用格局、人畜排放进行分析,利用输出系数模型解析斧头湖的面源污染负荷时空分布及主要来源。结果表明:斧头湖流域2008～2015年面源总氮（TN）和总磷（TP）负荷输出分别从由原来的 2 915 和 178 t 增长至 3 252 和 202 t。城镇化发展使得农村耕地面积减少,耕地对TN的输出贡献比例降低,但是耕地化肥使用依然是TN最主要来源。城镇化使得居民区对面源贡献增大,特别是TP的贡献显著增加。随着人们生活水平的提高,畜禽养殖对面源污染的贡献也显著增加,应予以足够重视     

钢渣吸附处理苯酚废水的研究

采用恒温振荡的方法,考察了钢渣粒径、吸附温度、振荡速度、溶液pH值、溶液初始浓度对苯酚去除率的影响。结果表明,在粒径为120~180目、pH=4.0、苯酚溶液浓度在500 mg/L以内、苯酚/钢渣质量比为1∶1 000时吸附效果最好。钢渣对苯酚的吸附能较好地符合Langmuir和Freundlich吸附等温线,线性相关系数分别为0.9971和0.9916,吸附机理为表面吸附。     

铁炭复配修复地下水中NO_3~--N的条件研究

采用了铁炭复配修复地下水中NO3--N,探讨了实验条件对修复效果的影响。结果表明,在pH值近中性条件(初始pH 6.42)下,反应时间为1 h时NO3--N修复率达到60.85%;Fe/C=1∶1时介质最佳用量分别为4~5 g;Fe/C=1/1.5时修复率为72.80%;反应速率在高振荡强度下大于低振荡强度;氧化铜的催化效果最好,可使修复率提高7.5个百分点。铁炭复配介质修复地下水中NO3--N是有效可行的,修复率随反应时间的增加而提高,在Fe/C=1∶1时修复率与介质用量呈正相关,无限减小Fe/C比并不能无限提高修复率,振荡强度对修复具有显著影响,低振荡强度下的修复过程较高强度存在滞后现象,并非所有金属氧化物催化剂对铁炭修复NO3--N均有促进作用。     

以红薯浸泡液为碳源的生物反硝化

为选择低碳氮比污水生物脱氮中合适的碳源,以搅拌罐浸泡淀粉类物质释放碳源,在确定利用红薯浸泡液为碳源后,以浸没式生物滤池为反应器进行生物反硝化实验。实验结果表明:20 g红薯置于2 L自来水中,采用250 r/m in的搅拌速度,搅拌频率为每搅拌3 h停1 h,2 d后得到的浸泡液COD浓度平均为5 921 mg/L,最高可超过7 000 mg/L;将此红薯浸泡液和污水以1∶50的流量比例,采用分别投加的方式进入反应器,污水中总氮、硝酸盐氮、亚硝酸盐氮及氨氮的平均去除率分别为88.6%、91.6%、88.2%和54.8%,出水COD平均在30 mg/L以下;在红薯浸泡液COD浓度为5 700 mg/L左右时,进水中亚硝酸盐氮浓度与硝酸盐氮浓度比为3∶2时总氮去除率为95.3%,当该比例为2∶3时总氮去除率为88.2%。研究表明,红薯浸泡液是一种经济合适的碳源,采用红薯浸泡液作为低碳氮比污水生物处理中反硝化的碳源是可行的。     

废弃轮胎制备中孔炭吸附材料工艺及性能研究

为了解决废弃轮胎造成的资源浪费和环境污染的问题,对以废弃轮胎橡胶为碳的前驱体原料,制备具有高吸附性能中孔炭材料工艺进行了系统的研究。通过XRD、扫描电镜以及比表面积分析,对制备的中孔炭微观结构和性能进行表征,讨论了炭化温度、碱炭比,以及活化温度和活化时间等工艺条件对制备中孔炭的产率、结构和性能的影响。结果表明,通过改变工艺条件制备的中孔炭的孔径分布可以在2~80 nm范围内进行调控。在500℃炭化温度,碱炭比为4∶1,900℃活化1 h的工艺条件下,制备的中孔炭的比表面积为473 m2/g,对甲基橙的最大吸附量达到254 mg/g。     

三元乙丙橡胶超细纤维复合膜的制备及其截留性能

以四氢呋喃和N,N-二甲基甲酰胺为溶剂,配制三元乙丙橡胶(EPDM)纺丝液,通过静电纺丝技术制备了EPDM超细纤维,进而以聚偏氟乙烯(PVDF)微滤膜为基膜制备了EPDM超细纤维复合膜。采用红外光谱(FTIR)和扫描电子显微镜(SEM)对EPDM超细纤维的结构和形态进行了表征。考察了复合膜对苯乙烯废水的截留效果和复合膜通量的变化情况。实验结果表明:EPDM超细纤维具有类似无纺布形式的多孔纤维网状结构,其直径在0.2~2.0μm之间;复合膜在操作压力为0.1MPa的条件下,处理质量浓度为100μg/mL的模拟苯乙烯废水,膜通量约为5.90mL/(cm2.h),苯乙烯去除率可达89.7%。     

Solid phase extraction with pyrenebutyric acid-bonded silica for analysis of polychlorinated biphenyls in sewage water by gas chromatography-mass spectrometry

A solid phase extraction (SPE) method using pyrenebutyric acid-bonded silica (PYB) as sorbent was developed to determine 23 polychlorinated biphenyls (PCBs) in sewage water by gas chromatography-mass spectrometry (GC-MS). Factors were optimized in SPE procedures including elution solvent, pH, and cartridge burden. The recoveries of 23 PCB congeners were 69.44-111.91% under optimized conditions. Comparisons were also conducted among PYB-SPE, C(18)-SPE and United States Environmental Protection Agency 608 (USEPA608) methods in the analysis of PCBs in sewage water samples. The results showed that the performance of PYB-SPE method was similar with USEPA608 method and better than C(18)-SPE method. Both PYB-SPE and USEPA608 methods were then employed to analyze PCBs in real spiked sewage water samples. The recoveries of PCB congeners determined by PYB-SPE method ranged from 70.6% to 92.4% in real spiked sewage water samples which were identified to be in accordance with USEPA608 method. Limits of detection (LOD) were in the range of 0.06-0.22ngL(-1) for PCB congeners. The optimized PYB-SPE method was successfully applied to the determination of PCBs in sewage water samples.     

Persistent organic pollutants and heavy metals in adipose tissues of patients with uterine leiomyomas and the association of these pollutants with seafood diet, BMI, and age

Background, aim, and scope  

Persistent organic pollutants and heavy metals can cause diseases in women, however, the relationships of these pollutants and uterine leiomyomas (UL), which are non-cancerous tumors of the uterus, are unclear. This study focused on the quantification of organochlorine pesticides (OCPs), polychlorinated biphenyls (PCBs), polycyclic aromatic hydrocarbons (PAHs), polybrominated diphenyl ethers (PBDEs), and heavy metals in subcutaneous and visceral fat obtained from patients with UL and in subcutaneous fat of a control group of women without UL to determine if there were any correlations between concentrations of persistent organic pollutants (POPs) and heavy metals and the incidence of UL.     

Properties of alkali-activated systems with stone powder sludge

This article investigates the effects of stone powder sludge on the microstructure and strength development of alkali-activated fly ash and blast furnace slag mixes. Stone powder sludge produced from a crushed aggregate factory was used to replace fly ash and granulated blast furnace slag at replacement ratios of 0%, 10%, 20%, and 30% by mass. The unit weight and compressive strength of the samples were measured, and scanning electron microscopy/energy dispersive spectroscopy and X-ray diffraction (XRD) analyses were performed. The test results indicated that the compressive strength of alkali-activated blast furnace slag mixes using stone powder sludge was higher than that of the alkali-activated blast furnace slag control mix, but the compressive strength of alkali-activated fly ash mixes decreased with increasing replacement ratio of stone powder sludge. Microscopy results indicated that for alkaliactivated blast furnace slag samples, broken surfaces were more evident than for the alkali-activated fly ash samples. For all XRD diagrams, broad and diffuse peaks were observed around 2θ = 35° (d = 2.96–3.03 Å), implying amorphous or short-ordering structure phases.     

生产者责任延伸制与电子废弃物管理——环境法规

日益增加的固体废弃物和工业废弃物已成为主要的社会问题。回收服务相对来说还很不足,导致很多废弃物只能进行简单的填埋、焚烧处理。这将导致严重的环境污染。借鉴国外一些发达国家废物管理领域的政策趋势,我国近年来出台了一系列关于电子废弃物管理的政策法规,但也暴露出正规的废物处理企业无法取得规模收益,入不敷出,电子废弃物处理基金的征收及补贴对象不明确等诸多问题。引入生产者责任延伸制将外部影响内部化,在理念和功能等方面适应了电子废弃物管理的需要。