碱激发胶凝材料及其固化Pb^2＋的试验研究

对碱激胶凝材料（碱-偏高岭土、碱-矿渣和碱-粉煤灰）与水-水泥体系固化Ph^2＋进行了试验研究,其中水-水泥体系为对比样。结果表明：对于相同稠度的碱激发胶凝材料,即使Pb^2＋含量达到2．4％,除了碱-粉煤灰的抗压强度略低外,其他都达到30MPa以上,满足填埋或做建筑基材的使用要求;与水泥相比,碱激发胶凝材料能显著降低重金属离子（Ph^2＋）浸出浓度,其规律性与其NH4交换容量大小的规律性一致,与其固化体的抗压强度的大小没有相关性。     

Air pollutant concentrations near three Texas roadways,Part I: Ultrafine particles

Vehicular emitted air pollutant concentrations were studied near three types of roadways in Austin, Texas: (1) State Highway 71 (SH-71), a heavily traveled arterial highway dominated by passenger vehicles; (2) Interstate 35 (I-35), a limited access highway north of Austin in Georgetown; and (3) Farm to Market Road 973 (FM-973), a heavily traveled surface roadway dominated by truck traffic. Air pollutants examined include carbon monoxide (CO), oxides of nitrogen (NO_x), and carbonyl species in the gas-phase. In the particle phase, ultrafine particle (UFP) concentrations (diameter < 100 nm), fine particulate matter (PM_2.5, diameter < 2.5 μm) mass and carbon content and several particle-bound organics were examined. All roadways had an upwind stationary sampling location, one or two fixed downwind sample locations and a mobile monitoring platform that characterized pollutant concentrations fall-off with increased distance from the roadways. Data reported in this paper focus on UFP while other pollutants and near-roadway chemical processes are examined in a companion paper. Traffic volume, especially heavy-duty traffic, wind speed, and proximity to the road were found to be the most important factors determining UFP concentrations near the roadways. Since wind directions were not consistent during the sampling periods, distances along wind trajectories from the roadway to the sampling points were used to study the decay characteristics of UFPs. Under perpendicular wind conditions, for all studied roadway types, particle number concentrations increased dramatically moving from the upwind side to the downwind side. The elevated particle number concentrations decay exponentially with increasing distances from the roadway with sharp concentration gradients observed within 100–150 m, similar to previously reported studies. A single exponential decay curve was found to fit the data collected from all three roadways very well under perpendicular wind conditions. No consistent pattern was observed for UFPs under parallel wind conditions. However, regardless of wind conditions, particle concentrations returned to background levels within a few hundred meters of the roadway. Within measured UFP size ranges, smaller particles (6–25 nm) decayed faster than larger ones (100–300 nm). Similar decay rates were observed among UFP number, surface, and volume.     

Concentrations,seasonal variations,and transport of carbonaceous aerosols at a remote Mountainous region in western China

Carbonaceous aerosol concentrations were determined for total suspended particle samples collected from Muztagh Ata Mountain in western China from December 2003 to February 2006. Elemental carbon (EC) varied from 0.004 to 0.174 μg m^?3 (average = 0.055 μg m^?3) while organic carbon (OC) ranged from 0.12 to 2.17 μg m^?3 and carbonate carbon (CC) from below detection to 3.57 μg m^?3. Overall, EC was the least abundant fraction of carbonaceous species, and the EC concentrations approached those in some remote polar areas, possibly representing a regional background. Low EC and OC concentrations occurred in winter and spring while high CC in spring and summer was presumably due to dust from the Taklimakan desert, China. OC/EC ratios averaged 10.0, and strong correlations between OC and EC in spring–winter suggest their cycles are coupled, but lower correlations in summer–autumn suggest influences from biogenic OC emissions and secondary OC formation. Trajectory analyses indicate that air transported from outside of China brings ～0.05 μg m^?3 EC, ～0.42 μg m^?3 OC, and ～0.10 μg m^?3 CC to the site, with higher levels coming from inside China. The observed EC was within the range of loadings estimated from a glacial ice core, and implications of EC-induced warming for regional climate and glacial ice dynamics are discussed.     

沸石改性及其去除水中氨氮的实验研究

通过实验研究了沸石改性条件及其对水中氨氮吸附去除的影响。结果表明,加热改性与无机酸改性不能显著提高沸石对氨氮的吸附量。利用NaOH改性的最佳浓度为1 mol/L,此条件下对氨氮吸附量可提高到650.68 mg/kg,为天然沸石的2.82倍。利用无机盐改性时,对氨氮吸附效果最好的是NaCl改性沸石,其次为KCl改性沸石与CaCl₂改性沸石。随着NaCl溶液浓度和改性时间的增加,改性沸石对氨氮的吸附量显著增加,可达天然沸石的3～4倍;在NaCl浓度为150 g/L与改性时间为18 h条件下,改性沸石对氨氮吸附量可达887.35 mg/kg,为天然沸石的3.84倍。     

生活垃圾加载介质层填埋法对初期渗滤液污染抑制效果研究

以传统卫生填埋柱R2为对照,通过往生物反应器填埋柱R1内加载可渗透反应介质层1和2进行模拟试验,主要探讨了填埋柱R1垃圾渗滤液COD、总氮、氨氮及总磷的变化趋势,探索一种新型的加载介质层垃圾填埋处理方法。试验结果表明,填埋20周后, R1柱COD浓度基本维持在40 000～45 000 mg/L间,约为R2柱的20%～30%;第24周,R1柱总氮和氨氮分别为206.5 mg/L和167.3 mg/L,在16～24周内,R1总氮和氨氮分别约为R2的14.5%～17.5%和36.2%～43.6%;18周时,R1柱总磷达最大值1.704 mg/L,至第24周降为0.673 mg/L, 整个实验过程R1柱总磷约为R2的0.15%～0.56%。     

活性污泥体系中聚糖菌的富集与鉴定

活性污泥体系中,聚糖菌(GAOs)在厌氧环境下与聚磷菌(PAOs)形成对底物的竞争关系,对聚糖菌的研究对于优化生物除磷工艺有重要意义。以葡萄糖为惟一碳源,在磷限制条件下,利用特殊运行方式对活性污泥进行驯化培养出了稳定的聚糖菌颗粒污泥,厌氧阶段磷释放量与有机物吸收量浓度(mg/L)比从7.4%下降为0.25%。从培养好的活性污泥反应器中分离获得2株聚糖菌,经菌落PCR和16S rRNA序列分析确定了所得聚糖菌菌株G1和菌株G2分别是枯草芽孢杆菌(Bacillus subtilis)和解鸟氨酸克雷伯氏菌(Klebsiella ornithinolytica)。     

三氯生在碳纳米管上的吸附

药品和个人护理用品(PPCPs)已成为一个引起广泛关注的新的环境问题。采用碳纳米管（CNTs）对水溶液中的三氯生进行吸附处理,考察了碳纳米管粒径及用量、温度、pH、振荡时间等因素对三氯生去除率的影响。研究结果表明,碳纳米管能快速吸附水中的三氯生,粒径较小的碳纳米管可获得较高的三氯生去除率;低温有利于吸附反应的进行;pH在6.5～7.0时,三氯生的去除率可达97%。三氯生在碳纳米管上的吸附可以很好地用Langmuir和Freundlich吸附等温方程进行描述。     

碱激发胶凝材料及其固化Pb~(2+)的试验研究

对碱激胶凝材料(碱-偏高岭土、碱-矿渣和碱-粉煤灰)与水-水泥体系固化Pb2+进行了试验研究,其中水-水泥体系为对比样.结果表明:对于相同稠度的碱激发胶凝材料,即使Pb2+含量达到2.4%,除了碱-粉煤灰的抗压强度略低外,其他都达到30 MPa以上,满足填埋或做建筑基材的使用要求;与水泥相比,碱激发胶凝材料能显著降低重金属离子(Pb2+)浸出浓度,其规律性与其NH4+交换容量大小的规律性一致,与其固化体的抗压强度的大小没有相关性.     

基于生态安全的DAT-IAT城市污水处理工艺改进研究

通过正交试验,得到了DAT-IAT工艺和A/DAT-IAT工艺处理城市污水的常规指标去除和生态毒理指标削减的最优运行条件。结果表明,在正交试验的同一工艺中,COD去除最优运行条件的出水COD值优于生态毒性削减最优运行条件的出水COD值,但前者出水的生态毒性较大。由于厌氧池的水解酸化作用,A/DAT-IAT工艺对COD和生态毒性的处理效果均优于DAT-IAT工艺,并且回流总能耗低于DAT-IAT工艺,但是出水COD仍不达标。为了降低进入工艺的COD的总量,以絮凝沉淀做为预处理工艺,并采用Al残留量最小的絮凝剂投药量以降低出水中残留Al带来的生态风险。结果表明,在COD去除最优运行条件下,具有絮凝预处理的工艺对COD的去除效果优于没有絮凝预处理的工艺。絮凝-A/DAT-IAT工艺在COD去除最优运行条件下出水COD为104.46 mg/L,满足排放标准。在毒性削减最优运行条件下,具有絮凝预处理的工艺的出水生态毒性有所上升,但是污染物的总量得到了大幅削减。絮凝-A/DAT-IAT工艺与DAT-IAT工艺相比,在污染物去除效率得到大幅增加的同时,生态毒性得到有效控制,生态安全得到了有效的保障。     

壳聚糖复合絮凝剂处理造纸废水的实验研究

研究并考察了壳聚糖复合絮凝剂对造纸污水中COD和SS的絮凝效果,结果表明,当复合絮凝剂的配方和处理条件为：聚合硫酸铁（PFS）60 mg/L聚丙烯酰胺（PAM）2 mg/L壳聚糖（CTS）0.4 mg/L,pH为7.5时,其絮凝效果最佳,此时它对水中COD与SS的去除率分别达到57.4%和97.6%, 与传统絮凝剂PAC/PAM相比,COD与SS的去除率分别提高了10.1%和5.2%,药剂成本下降了21.1%,具有明显的经济效益与环境效益。