SnAgCu焊料中Sn元素在模拟土壤溶液中的浸出行为

研究了Sn-3.5Ag-0.75Cu无铅焊料及其与Cu基板的钎焊接头在模拟土壤的NaCl,NaCl-Na2SO4和NaCl-Na2SO4-Na2CO3溶液中Sn元素的浸出行为.结果表明:焊料在NaCl-Na2SO4-Na2CO3溶液中Sn的浸出相对严重;而接头在NaCl溶液中Sn的浸出量最多.在Sn浸出量多的焊料和接头表面形成厚而疏松的腐蚀产物,XRD分析表明其产物主要由SnO,SnO2和Sn4(OH)6Cl2组成.动电位极化测试分析表明接头中Cu基板与焊料合金之间的电偶腐蚀是焊料合金与接头在同种溶液中Sn元素浸出差异的主要原因.     

Novel Co-Mg-Al-Ti-O catalyst derived from hydrotalcite-like compound for NO storage/decomposition

Catalysts of Co_1.5Mg_1.5/Al_0.9Ti_0.1O and Co_1.5Mg_1.5/AlO were successfully prepared by calcinations of corresponding hydrotalcite-like compounds at 800℃ for 4 hr. The derived oxides were of spinel phase and a small quantity of Ti substitution did not change the crystal purity. Their catalytic performance for the NO storage/decomposition was investigated. Ti incorporation enhanced the NO decomposition activity while has an opposite effect on the storage capacity of catalyst. In situ FT-IR spectra of the catalysts showed that the final adsorption species on the catalysts was coordinated nitrates/nitrites. In addition, NO storage/decomposition mechanism has been discussed on the basis of these observations.     

Rapid decolorization of Acid Orange II aqueous solution by amorphous zero-valent iron

Some problems including low treatment capacity, agglomeration and clogging phenomena, and short working life, limit the application of pre-treatment methods involving zero-valent iron (ZVI). In this article, ZVI was frozen in an amorphous state through a melt-spinning technique, and the decolorization effect of amorphous ZVI on Acid Orange II solution was investigated under varied conditions of experimental variables such as reaction temperature, ribbon dosage, and initial pH. Batch experiments suggested that the decolorization rate was enhanced with the increase of reaction temperature and ribbon dosage, but decreased with increasing initial solution pH. Kinetic analyses indicated that the decolorization process followed a first order exponential kinetic model, and the surface-normalized decolorization rate could reach 2.09 L/(m². min) at room temperature, which was about ten times larger than any previously reported under similar conditions. Recycling experiments also proved that the ribbons could be reused at least four times without obvious decay of decolorization rate and efficiency. This study suggests a tremendous application potential for amorphous ZVI in remediation of groundwater or wastewater contaminated with azo dyes.     

Three-dimensional hydrodynamic and water quality model for TMDL development of Lake Fuxian, China

Lake Fuxian is the largest deep freshwater lake in China. Although its average water quality meets Class I of the China National Water Quality Standard (CNWQS), i.e., GB3838-2002, monitoring data indicate that the water quality approaches the Class II threshold in some areas. Thus it is urgent to reduce the watershed load through the total maximum daily load (TMDL) program. A three-dimensional hydrodynamic and water quality model was developed for Lake Fuxian, simulating flow circulation and pollutant fate and transport. The model development process consists of several steps, including grid generation, initial and boundary condition configurations, and model calibration processes. The model accurately reproduced the observed water surface elevation, spatiotemporal variations in temperature, and total nitrogen (TN), total phosphorus (TP), and chemical oxygen demand (COD) concentrations, suggesting a reasonable numerical representation of the prototype system for further TMDL analyses. The TMDL was calculated using two interpretations of the water quality standards for Class I of the CNWQS based on the maximum instantaneous surface and annual average surface water concentrations. Analysis of the first scenario indicated that the TN, TP and COD loads should be reduced by 66%, 68% and 57%, respectively. Water quality was the highest priority; however, local economic development and cost feasibility for load reduction can pose significant issues. In the second interpretation, the model results showed that, under the existing conditions, the average water quality meets the Class I standard and therefore load reduction is unnecessary. Future studies are needed to conduct risk and cost assessments for realistic decision-making.     

Aerosol structure and vertical distribution in a multi-source dust region

The vertical distribution of aerosols was directly observed under various atmospheric conditions in the free troposphere using surface micro-pulse lidar (MPL4) at the Zhangye Station (39.08°N, 100.27°E) in western China in the spring of 2008. The study shows that the aerosol distribution over Zhangye can be vertically classified into upper, middle and lower layers with altitudes of 4.5 to 9 km, 2.5 to 4.5 km, and less than 2.5 km, respectively. The aerosol in the upper layer originated from the external sources at higher altitude regions, from far desert regions upwind of Zhangye or transported from higher atmospheric layers by free convection, and the altitude of this aerosol layer decreased with time; the aerosols in the middle and lower layers originated from both external and local sources. The aerosol extinction coefficients in the upper and lower layers decreased with altitude, whereas the coefficient in the middle layer changed only slightly, which suggests that aerosol mixing occurs in the middle layer. The distribution of aerosols with altitude has three features: a single peak that forms under stable atmospheric conditions, an exponential decrease with altitude that occurs under unstable atmospheric conditions, and slight change in the mixed layer. Due to the impact of the top of the atmospheric boundary layer, the diurnal variation in the aerosol extinction coefficient has a single peak, which is higher in the afternoon and lower in the morning.     

碳源对工业污染场地土壤中HCHs和DDTs降解的促进作用

我国对有机氯农药的大量需求使得在农药生产、加工和分装等过程中造成了许多城镇中存在有机氯农药污染场地,限制了土地的后续开发利用.本研究选取3种类型的碳源组成有机修复剂A、B、C,添加到受有机氯工业污染场地土壤中进行微生物降解试验,并对比了3种修复剂的效果.试验过程中,反应体系水分含量为50％,添加零价金属调节氧化还原电位,采用好氧/厌氧交替循环方式进行生物降解.实验结果表明:3种修复剂对HCHs和DDTs的降解都有显著促进作用.与DDTs相比,HCHs较易降解.90 d内,添加修复剂(A、B、C)的处理中∑HCH的浓度分别从73.37~85.71 mg·kg^-1降解到了15.88~38.21 mg·kg^-1.与未添加修复剂的对照相比较,∑HCH的降解率提高了19%~52%,90 d内,ΣHCH的降解率最高可达81%.添加修复剂(A、B、C)的处理中ΣDDT的浓度分别从91.68~119.79 mg·kg^-1降解到了45.1~60.7 mg·kg^-1,相对未添加修复剂的对照试验,∑DDT的降解率提高了39%~45%,30 d内∑DDT的降解率最高可达到51%,但30 d后降解效率无明显增加.就不同类型碳源的促进作用来看,C/N最高,而含水率最低的修复剂B的效果最好,而C/N比最低而含水率最高的修复剂A效果最差.     

基于支持向量机的湖泊生态系统健康评价研究

利用支持向量机在处理分类问题、小样本问题和泛化推广方面的优势,构建了基于支持向量机的湖泊生态系统健康评价模型.同时,对广州市最大的人工湖——白云湖的水质及生物群落情况进行了监测,最后运用该模型对白云湖生态系统健康状况进行了评价.评价结果表明,白云湖生态系统处于病态状态,不能达到其净化水质的设计作用.建议从提高进水水质、实施湖区截污和丰富生物量3方面改善白云湖生态系统健康水平.与传统熵权综合健康指数法和熵权模糊综合评价法相比,所建模型更加客观、科学地评价了湖泊生态系统健康状况,能够为湖泊生态系统健康管理提供一定依据,具有广阔的应用前景.     

二维砂箱溶质示踪实验的图像分析法

有色示踪剂在砂箱溶质运移实验中有着广泛的应用,因此,本文介绍了一种通过对数字图像进行分析以确定多孔介质中有色示踪剂浓度分布的方法.在实验过程中,通过建立有色示踪剂浓度与图像颜色要素之间的定量关系,从而能够利用数字图像迅速确定某一时刻砂箱内部的示踪剂浓度分布.结果发现,与传统定点采样方法相比,图像分析法可以达到更高的空间和时间分辨率,从而观察到有可能被忽视的重要溶质运移过程,能够为地下水溶质运移实验研究提供了一种经济实用和高空间分辨率的数据采集手段.但由于色彩空间变化范围的限制,图像分析法只能在一定溶质浓度范围内适用.     

基于地表水源热泵尾水排放的江河热环境容量研究

运用FLUENT软件对重庆市洪崖洞水源热泵系统尾水排入受纳水域的过程进行二维数值模拟,选取FLUENT中非耦合、隐式求解器对模型内的定常流动进行求解,得出受纳水域受水源热泵系统温排水影响后的温度梯度和温升面积。在温排水流量为4 500 m3/h、温差为6℃的条件下,得出受纳水域温升值超过1℃的水域面积约为1 600 m2,为模拟江河水域面积的2.0%。选取1℃温升值作为温升带边界控制值,在热泵系统最大负荷工况下,计算得出受纳水域的热环境容量为312.5(m.3℃)/s,剩余热环境容量为306.25(m.3℃)/s。根据地表水环境质量标准,该工程温排水量小于受纳水域的热承载力,不会对受纳水域生态环境造成热污染。     

Cd/Sb/Pb复合污染对竺麻生长及吸收富集特征的影响

通过盆栽试验,分析了不同浓度Cd/Sb/Pb复合作用下苎麻的生长响应及重金属吸收、富集和迁移特征变化。结果表明,低浓度Cd/Sb/Pb复合处理对苎麻生长及生物量没有产生明显影响,而高浓度条件下则产生明显抑制效应,株高变矮,茎粗变细及生物量明显减少。苎麻体内Cd、Pb和Sb吸收量与污染土壤具有直接相关性,随复合处理浓度增加明显增大。至最高污染浓度处理时,苎麻体内重金属吸收量以Cd>Sb>Pb,地上部含量分别达335.74 mg/kg、157.55 mg/kg和92.31 mg/kg。复合处理下苎麻地上部对Cd、Sb和Pb的富集系数分别在0.67~0.88、0.13~0.17和0.05~0.06之间,均表现为随复合处理浓度增加而减少变化。苎麻Cd、Sb和Pb的转运系数分别为0.81~0.92、0.38~0.46和0.53~0.73,其中Cd、Sb的转运系数随复合处理浓度增加而增大,Pb则随复合处理浓度增加而减少。苎麻对重金属Cd/Sb/Pb复合污染具有较好吸收累积及转运能力,相比生物量小的植物而言,是目前修复重金属Cd/Sb/Pb复合污染的理想植物。