曝气强度对膜污染的影响

混合液浓度的高低及其粒度分布特性是影响膜生物反应器膜污染的重要因素。在一定污泥浓度下,主要考察了曝气强度对污泥絮体粒度分布的影响,以及不同粒度下的膜污染特性。试验结果表明,曝气强度提高,可以起到减缓污泥颗粒在膜表面的沉积作用,但高的错流流速产生的剪切效应使得污泥颗粒变得琐碎,导致细小胶体粒子和溶解性部分增多,增加了膜孔吸附和堵塞的机会,加剧了膜污染的进程。膜污染速率在曝气强度提高初期阶段迅速降低,接着又随曝气强度增加而缓慢升高,在污泥质量浓度为8 g/L的试验条件下,对应的最适曝气强度为84 m3/(m2.h)。     

Anaerobic degradation of diethyl phthalate, di-n-butyl phthalate, and di-(2-ethylhexyl) phthalate from river sediment in Taiwan

We investigated anaerobic degradation rates for three phthalate esters (PAEs), diethyl phthalate (DEP), di-n-butyl phthalate (DBP), and di-(2-ethylhexyl) phthalate (DEHP), from river sediment in Taiwan. The respective anaerobic degradation rate constants for DEP, DBP, and DEHP were observed as 0.045, 0.074, and 0.027 1/day, with respective half-lives of 15.4, 9.4, and 25.7 days under optimal conditions of 30 °C and pH 7.0. Anaerobic degradation rates were enhanced by the addition of the surfactants brij 35 and triton N101 at a concentration of 1 critical micelle concentration (CMC), and by the addition of yeast extract. Degradation rates were inhibited by the addition of acetate, pyruvate, lactate, FeCl₃, MnO₂, NaCl, heavy metals, and nonylphenol. Our results indicate that methanogen, sulfate-reducing bacteria, and eubacteria are involved in the degradation of PAEs.     

反硝化除磷的影响特性试验

采用SBR反应器（厌氧/缺氧/好氧工艺）,分别研究了乙酸盐及硝酸盐浓度变化对反硝化除磷的影响特性.试验结果表明,当进水COD浓度＞230 mg/L时,乙酸盐浓度的变化对释磷、除磷速率等影响并不显著.在硝酸盐浓度＜30 mg/L时,硝酸盐浓度越高,缺氧段除磷速率也就越高.在C/P＞23,C/N＞5条件下,SBR系统对磷、氮去除率在90%以上.     

农林生物质在含铬废水处理中的应用

农林生物质作为低成本吸附剂在环境污染治理中日益受到重视。综述了农林生物质在含铬废水处理中的应用研究进展，分析了生物质处理含铬废水的机理、影响因素，指出了生物质法处理含铬废水的发展方向。     

微囊藻毒素污染控制技术的研究进展

主要对水环境中微囊藻毒素污染的产生、毒性和去除方法进行了综述,在如何高效去除MCs方面具有重要意义.     

γ-射线辐照法改善城市污水厂剩余污泥厌氧消化特性的研究

采用γ-射线辐照法对城市污水厂剩余污泥进行预处理，从固体组分、可溶性组分及厌氧产气量等角度来探讨γ-射线辐照法改善城市污水厂剩余污泥厌氧消化特性的可行性。结果表明，经γ-射线辐照处理后，污泥的平均粒径减小，在辐照剂量为6．51-30．75kGy范围内，粒径的减小率达30％-50％；可溶性有机组分随着辐照剂量升高而增加，当辐照剂量为19．4kGy时，SCOD增加率达552．5％；与未辐照相比，污泥经2．48、6．51、11．24kGy辐照处理后，厌氧消化累计产气量分别增加8．89％、19．74％和35．81％。γ-射线辐照法是一种有效的改善污泥厌氧消化特性的方法，11．24kGy左右的剂量可作为污泥预处理的最佳剂量。     

生物质废弃物催化裂解制备富氢燃气实验研究

由生物质废弃物催化裂解制取氢气是一种可再生的制氢方法，本研究采用2段加热管式反应器，前段装生物质，后段装催化剂，用以研究生物质催化裂解制取氢气的特性，并提出潜在氢产率的概念对生物质制氢的经济技术可行性进行深入的分析。测试的3种生物质废弃物为：松木粉、木质素和纤维素，测试温度为600～700℃。实验结果表明，加入催化剂后3种物料的产氢率从5．48～15．06g／kg增加到12．94～37．73g／kg；催化剂对潜在产氢率的影响较小，加入催化剂前后的变化范围为：36、25～98、86g／kg到37．40～116．98g／kg。生物质废弃物催化裂解产氢率与相同温度下空气-水蒸气气化的氢产率相当，实验结果证明，生物质废弃物催化裂解是一种有效的制氢方法。     

Reductive dechlorination of non-ortho substituted polychlorinated biphenyls by ultraviolet irradiation in alkaline 2-propanol

The photodechlorination pathways of 3,3′,4,5,5′-pentachlorobiphenyl (3,3′,4,5,5′-PentaCB) and the related lower polychlorinated biphenyl congeners irradiated at 254 nm in alkaline 2-propanol were elucidated. Steric effect is the most important factor for controlling the dechlorination pattern of these substrates. Electronic effect also influences the photoreactivity of chlorine substituents.     

Biodegradation of benzene, toluene; and other aromatic compounds by Pseudmonas sp. D8

Pseudmonas sp. D8 strain, which has the potential to utilize toluene as a sole carbon source, was isolated. At a concentration of 100 mg/l, this strain was found to efficiently degrade toluene and benzene (both individually and in mixture) in culture medium at 30°C and pH7. Following a two-hour lag phase, complete biodegradation of 100 mg/l toluene or benzene occurred within 6 to 8 hours. The addition of nitrate, phosphate, or sulfate at various concentrations were found to have significant influence on both toluene and benzene degradation. In addition, results show that the D8 strain has the ability to degrade monochlorophenols, nitrophenols, and phenol, but not aliphatic compounds. Inoculation of groundwater samples containing 100 mg/1 toluene or benzene with Pseudmonas sp. D8 resulted in rapid degradation within 24 33 hours.     

高位铁皮水箱供水质量及影响因素

我们于１９９５年３月￣４月调查了武汉市高位铁皮水箱的供水质量。结果表明：高层住宅水箱近年虽曾清洗消毒，但高层用户龙头水及水箱水中游离性全氯未达标比例较大，分别为７３．３％和６６．７％。个别底层住户水样中铁超标。高位水箱水样中细菌总数超标比例为２０％。反映了高层住宅二次供水中在水的输送、贮存过程中有二次污染存在。经水样监测指标相关性和灰色关联性分析，认为游离性余氯可作为常规监测高层住宅二次供水质量的