Study of fractionation and potential mobility of metal in sludge from pyrite mining and affected river sediments: changes in mobility over time and use of artificial ageing as a tool in environmental impact assessment

Sludge from mining exploitation can be a source of land and water contamination in the adjacent zone. Accidents such as the break of waste mining pools in the Aznalcollar Mine (Seville, Spain) in 1998 produce important ecological disasters. In this work is presented a study of the evolution of aqua regia leachable concentration and mobility of metals in sediment samples of Guadiamar River basin from the accident date up to 2001. The application of BCR standard extraction procedures provides valuable information about the mobility and toxicity of the spill and the metal mobility in Guadiamar River polluted sediments. As a rule, themobility of several metals in the initial sludge (sulphides) is low, except for copper. Otherwise, the results of aqua regia leachable concentration and mobility of metal obtained for sediments samples indicate that the cleaning and inertisation works carried out in the zone have been adequate but insufficient, being the metal levels observed in the zone are higher than natural levels. To establish the initial impact of the spill and the mobility changes with time, mineralogical composition of the pyritic sludge and its evolution after the natural weathering and after the induction, of accelerated ageing processes by light and temperature was studied in the laboratory. Oxidation of initial sulphides to sulphates was observed. Both environmental and laboratory oxidation of the metallic sulphides increase the mobility of all metals, especially of copper, zinc and lead. The proposed laboratory procedure allows to predict the changes in mobility and therefore in toxicity that can occur at short or long term after exposure of sludge at environ-mental conditions. The mobility results in sludge and sediment samples are interpreted in terms of the mineral composition of the samples.     

Dioxins and furans in the atmosphere of São Paulo City, Brazil

Air samples were collected simultaneously at three urban sites in São Paulo City, Brazil, in winter, spring, summer and fall (in 2000 and 2001). Andersen PUF samplers were used for gas and particles sequential sampling. Samples were analyzed using HRGC/HRMS according to US EPA Method 8290. The greater metropolitan area of São Paulo is the largest industrialized region of Latin America and has a highly polluted atmosphere. Concentrations of dioxins and furans, which are well-known toxic chemicals, ranged from 1.14 pg m⁻³ to 13.8 pg m⁻³ (0.047 pg I-TEQ m⁻³ to 0.751 pg I-TEQ m⁻³). Principal component analysis showed that all the variables are highly correlated with one another except the 2,3,7,8-TCDD one. This is consistent with the similar concentration profiles observed for the tetra, penta, hexa, hepta and octa-homologous groups of the three sampling sites studied. At all sites, the most abundant compounds were the hepta and octa congeners. The 2,3,4,7,8-PeCDF accounted for 37–46% of the total toxicity and the 2,3,7,8-TCDD accounted for 7–16%. Highest mass concentrations of PCDD/Fs were found in the site where there is influence of industrial activities and heavy vehicular traffic fueled by gasohol, diesel, and ethanol.     

The contribution of azo dyes to the mutagenic activity of the Cristais River

To verify whether dyes emitted within the discharge of a dye processing plant were contributing to the mutagenicity repeatedly found in the Cristais River, Sao Paulo, Brazil, we chemically characterized the following mutagenic samples: the treated industrial effluent, raw and treated water, and the sludge produced by a Drinking Water Treatment Plant (DWTP) located approximately 6 km from the industrial discharge. Considering that 20% of the dyes used for coloring activities might be lost to wastewaters and knowing that several dyes have mutagenic activity, we decided to analyze the samples for the presence of dyes. Thin layer chromatographic analysis indicated the presence of three prevalent dyes in all samples, except for the drinking water. This combination of dyes corresponded to a commercial product used by the industry, and it tested positive in the Salmonella assay. The structures of the dye components were determined using proton magnetic resonance and mass spectrometric (MS) methods, and the dyes were tested for mutagenicity. The blue component was identified as the C.I. Disperse Blue 373, the violet as C.I. Disperse Violet 93, and the orange as C.I. Disperse Orange 37. The dyes showed mutagenic responses of 6300, 4600, and 280 revertants/microg for YG1041 with S9 respectively. A bioassay-directed fractionation/chemical analysis showed that the C.I. Disperse Blue 373 contributed 55% of the mutagenic activity of the DWTP sludge. We showed that these dyes contributed to the mutagenic activity found in the Cristais River environmental samples analyzed and are indirectly affecting the quality of the related drinking water. Therefore, we believe that this type of discharge should be more thoroughly characterized chemically and toxicologically. Additionally, human and ecological risks associated with the release of dye processing plant effluents should be more fully investigated, especially where the resultant water is taken for human consumption.     

Detection of herbicides in water bodies of the Samambaia River sub-basin in the Federal District and eastern Goiás

Abstract

The objective of this study was to identify and quantify herbicide residues in water samples of rain, cisterns, streams, ponds, springs, semi-artesian wells, dams and a river in the Rio Samambaia sub-basin in the Federal District and eastern Goiás. A total of 287 samples were collected from 20 farms in the sub-basin in the rainy (February, summer) and dry (August, winter) seasons in 2016. Aminomethylphosphonic acid (AMPA, a glyphosate metabolite), clethodim, chlorimuron-ethyl, diuron, fluazifop acid (a fluazifop-p-butyl metabolite and the active ingredient), haloxyfop acid (a haloxyfop-methyl metabolite and the active ingredient), imazamox, mesotrione, metsulfuron, nicosulfuron and pendimethalin were not identified in any water sample. In the rainy season, approximately 99% of the samples contained residues at least one of the evaluated herbicides; in the dry season (, 100% of the samples contained residues of at least one of the evaluated herbicides. When considering only detection frequency, metribuzin, atrazine, clomazone and haloxyfop-methyl were the main herbicides found in the water of the Samambaia River sub-basin. In turn, based on levels higher than the limit of quantification, the main compounds detected were atrazine, clomazone, haloxyfop-methyl and glyphosate. In both seasons, the highest relative concentrations of herbicides for the rainy and dry seasons were found in spring water, 25% and 56%, respectively, and dam water, 23% and 16%, respectively.     

Heterogeneous photocatalysis of aromatic and chlorinated volatile organic compounds (VOCs) for non-occupational indoor air application

The current study evaluated the technical feasibility of applying TiO2 photocatalysis to the removal of low-ppb concentrations of volatile organic compounds (VOCs) commonly associated with non-occupational indoor air quality issues. A series of experiments was conducted to evaluate five parameters (relative humidity (RH), hydraulic diameter (HD), feeding type (FT) for VOCs, photocatalytic oxidation (PCO) reactor material (RM), and inlet port size (IPS) of PCO reactor) in relation to the PCO destruction efficiencies of the selected target VOCs. None of the target VOCs exhibited any significant dependence on the RH, which is inconsistent with a previous study where, under conditions of low humidity and a ppm toluene inlet level, a drop in the PCO efficiency was reported with a decreasing humidity. However, the other four parameters (HD, RM, FT, and IPS) were found to be important for better VOC removal efficiencies as regards the application of TiO2 photocatalytic technology for cleansing non-occupational indoor air. The PCO destruction of VOCs at concentrations associated with non-occupational indoor air quality issues was up to nearly 100%, and the CO generated during PCO was a negligible addition to indoor CO levels. Accordingly, a PCO reactor would appear to be an important tool in the effort to improve non-occupational indoor air quality.     

Utilization of coal fly ash as a slow-release granular medium for soil improvement

This work proposes a new potential application of waste coal fly ash as a K fertilizer support. Fly ash was reacted with KOH to facilitate the impregnation of K as well as to enhance the bonding force. In particular, the applied process resulted in a significant slow-releasing characteristic of fertilizer elements. To examine the effect of K impregnation, a few detailed leaching tests were carried out in terms of process variables such as reaction time and temperature, sintering time and temperature, and KOH concentration. The current experiment presented an optimum preparation condition that is competitive with conventional commercial fertilizers. The manufactured ash fertilizers inhibited release of the K elements. It was also found through the continuous leaching test with pure water that the ash fertilizer had excellent moisture absorbability. However, the effects of some trace elements in fly ash on soil health and crop productivity as well as environmental considerations need to be established with long-term studies.     

A fair comparison between the spatial scan and the Besag–Newell Disease clustering tests

Routine surveillance of a large geographic region for clusters of adverse health events, particularly cancers, often involves small area health data, possibly controlling for exposure information. Many different methods have been proposed to test for the presence of geographical clusters. Two of the most popular methods are the spatial scan method proposed by Kulldorff and that using a fixed number of cases within scanning circles proposed by Besag and Newell. Although the second test is very popular, it has some difficulties. While the scan test controls for the multiple testing problem, the Besag and Newell test does not. Additionally, the latter method requires the setting of several tuning parameters whose values affect the test performance and are subjectively chosen by the user. This creates a difficulty to make a fair comparison between the two methods and it explains why there have been few formal studies evaluating their relative performances. In this paper, we modify the Besag and Newell test allowing for the control of the error type I probability and compare its power with respect to that of the spatial scan test. We used data sets from a publicly available simulated benchmark. We found that the two methods have similar results, except for clusters located in sparsely populated regions, where the spatial scan method presented a better performance.     

Site-Specific Characterization of Castromil Brownfield Area Related to Gold Mining Activities

Castromil is one of the gold mining areas in Portugal that has been abandoned since 1940. This area, which was first mined in Roman times, is located within a Hercynian granite body near the contact with Silurian metasediments. Gold is essentially disseminated along veins in the silicified granite, running NW-SE, related with a shear zone and frequently associated with sulphides (arsenopyrite and basically pyrite). In paragenetic terms, three stages of mineralization are considered: ferro-arseniferous (quartz + arsenopyrite I + pyrite I + pyrrhotite + bismuth), zinciferous (sphalerite + chalcopyrite), and remobilization (arsenopyrite II + galena + gold). Due to the lack of laws and environmental education, Castromil is today a gold mining heritage site where we can detect the consequences of an incautious exploration (tailings, wells and adits located in the old explored zone) and where a residential area is located. In order to characterize the actual state of the old mining area the trace metal contamination of soils and waters by mining activities was investigated. In the studied area 106 soil samples, 15 waters and 20 plants were sampled and analysed. The soil samples were analysed for 32 elements by ICP-AES. Waters were analysed by ionic chromatography and ICP-MS for major and trace elements. Plants were analysed for As, Fe and Pb by AAS. The results are discussed taking into account the risk-based standards for soils and groundwater's (target and intervention values) proposed by Swartjes (1999). The results show elevated concentration of As and Pb which were found in soils collected from agricultural areas. Foodstuff plants species collected in the Castromil agricultural area show high concentrations of As in the leaves (cabbage and lettuce) and in the tubers (potatoes). Groundwaters in the mining area contain high concentrations of As that exceeds the intervention values. The area must to be subject to a remediation process, considering the actual risks to humans and ecosystems and the risks due to contaminant migration.     

Genetic sub-structure and intermediate optimal outcrossing distance in the marine angiosperm <Emphasis Type="Italic">Zostera marina</Emphasis>

The spatial distribution of genetic variability depends on the spatial patterns of clonal and sexual reproduction, gene flow, genetic drift and natural selection. Species with restricted dispersal may exhibit genetic structuring within populations with immediate neighbours being close relatives, and may show differentiation among populations. Genetic structuring of a species may have important genetic, evolutionary and ecological consequences including distance-dependent mating success. In this study we used microsatellite markers to show that clones of Zostera marina in a population in the Ria Formosa, Portugal, were aggregated and covered distances of up to 3–4 m. Clones within 4 m of each other exhibited significant and positive coancestry values, reflecting the limited seed dispersal of this species. Hand-pollinations between near (0–10.9 m), intermediate (11–32 m) and far (15 km) individuals resulted in similar levels of seed set, although the near pollinations had higher, although not statistically significant, levels of seed abortion during maturation. Seeds from intermediate-distance pollinations had a significantly higher proportion of seeds germinate and shorter germination time than both the near and far seeds. Similarly, the average number of seedlings produced per pollination, used as an overall estimate of fitness, was significantly greater for the intermediate distance when compared to both near and far pollinations. These results suggest that the genetic structuring observed may result in both inbreeding and outbreeding depression, which gives rise to an intermediate optimal outcrossing distance.