New PbO2, Support for the Measurement of Sulfation

Since 1966, the Division of Laboratories of the Department of Health of the City of Montreal is carrying on measurements of gaseous pollutants. In order to efficiently use the technical staff that our administrators wanted to devote to the fight against air pollution, a new lead dioxide support for the determination of sulfur dioxide has been devised. The preparation of candies according to the standard method requires much time and skill from the operator, whereas the technique that is proposed is rapid, easy, and provides plates of a high degree of uniformity. A technician with little experience can coat a great number of plates per day with no difficulty. N. A. Huey working at the National Center for Air Pollution Control in Cincinnati published in the September 1968 issue of this Journal a new technique which consists of coating the inside of a plastic Petri dish with a PbO² paste. His method also has the above mentioned advantages. The plates that are suggested allow a simplification of the preliminary work for several types of analyses such as gra-vimetry,¹ colorimetry,³ turbidimetry,^4,5 titrimetry,⁶ and nephelemetry.⁸     

Cyclic Trends in Los Angeles Fine Participates

Noontime visibilities in downtown Los Angeles, averaged over the smog season of June through November, show two cycles of general deterioration and improvement. The improvement since 1962 is confirmed by available high volume filter data and conditions in 1974/75 are at least as good as at anytime since observations were begun in 1933. The decrease in frequency of “rule 57” days suggests that the improvement of the last decade and perhaps the cyclic variation of the past 40 years has been primarily of meteorological origin.     

Workshop on Primary Sulfate Emissions

This article is a summary report on a workshop, Measurement Technology and Characterization of Primary Sulfur Oxides Emission from Combustion Sources, sponsored by the EPA Environmental Sciences Research Laboratory at Research Triangle Park, NC, held in Southern Pines, NC. The objectives of the workshop were: to review and discuss current measurement methods and problem areas for sulfur oxides emission with attention focused on sulfuric acid, sulfates, and sulfur-bearing particulate matter; to review and discuss emission data from various combustion sources operating under different conditions, which include various pollutant controls, fuel composition, excess boiler oxygen, etc.; to delineate and recommend areas in need of research and development effort. Scientists were invited to present the results of their studies on primary sulfate emissions. The 3-day workshop devoted one day to measurement technology, a second to characterization, and a third to critical assessment of the presented papers and development of summary working group reports on each half-day session of the initial 2 days. Thirty-one papers were presented by 29 participants on measurements and characterization. Four working group reports were developed and summarized in the last day. Highlights of the papers and reports are briefly reviewed. Workshop proceedings are available as an EPA publication.     

experience of the forest products industry in obtaining air quality permits for new and modified sources

A detailed study of the air quality permitting process for 65 different forest products industry projects requiring preconstruction permit approvals from EPA, state, and local air pollution control agencies was conducted. The projects included a wide array of sources including kraft recovery furnaces, lime kilns, fossil fuel and wood residue fired boilers, solid wood products manufacturing facilities, paper coaters, and printing presses. Information concerning the time involved in the permitting process, costs associated with obtaining the permits, use of air quality models and ambient monitoring data, emission control technology determinations, problem areas encountered during the permitting process, perceived benefits and drawbacks of the permitting process, and the effect of permitting requirements on project planning was obtained.

The results indicate that certain permitting requirements such as Best Available Control Technology (BACT) determinations, dispersion modeling results, and use of ambient air quality monitoring data seldom influence the emission limitations ultimately imposed in the final approved permit, with 87% of the final emission limits equivalent to the applicable New Source Performance Standard (NSPS). The 65 permitting case histories also show that obtaining permits for projects subject to Prevention of Significant Deterioration (PSD) requirements takes approximately twice as long and costs twice as much as obtaining permits for projects not subject to PSD requirements.     

Testing and Commercialization of Byproduct Dibasic cids as Buffer Additives for Limestone Flue Gas esulfurization Systems

Pilot plant (0.1 MW) tests and utility boiler full scale demonstration (194 MW) of byproduct organic dibasic acids (DBA) as buffer additives to limestone scrubbers have shown performance improvements equivalent to those achieved by the addition of pure adipic acid. Both SO₂ removal efficiency and limestone utilization increased, and no significant operating problems were observed with three of the four DBA tested. Chemical and biological evaluations of scrubber samples taken during the DBA testing indicated no detectable tOxicity or mutagenicity, and no significant environmental impact is expected as a result of DBA addition. Economic estimates indicate that substitution of DBA for pure adipic acid as a buffer additive will result in additive cost savings of 30 % or greater.     

Use of Energy Scenarios in Addressing the CO2 Question

A reference scenario for CO₂ emissions was developed using a model of world energy supply and demand. In the reference scenario, world GNP and world energy demand increase at average rates of 2.1 percent per year and 1.5 percent per year, respectively during the period 1975-2100. The corresponding annual CO₂ emissions rise to a maximum of 16 gigatons of carbon around 2050 and then decline as a result of a transition to nonfossil fuel energy systems. A modified scenario for high CO₂ emissions was obtained by assuming an abundant supply of low cost coal, thus eliminating the transition. A low case was developed in which the low cost of alternative energy (i.e., solar, nuclear) induces an earlier shift away from fossil fuels.

Annual emissions of the three scenarios were used as input to a global carbon cycle model and the CO₂ buildup in the atmosphere during the period 1980-2100 was determined by the model. All three scenarios showed continuous rises in atmospheric CO₂ concentration. The reference scenario reached 775 ppm by 2100. The high CO₂ case resulted in concentrations of over 1040 ppm, and for the low case the 2100 concentration was just under 700 ppm. If the climate theory is correct, even 700 ppm is sufficient to give significant climate warming, but by experiencing the change gradually over a century, adaptation may not be painful. An early transition to nonfossil fuel supplies makes the problem less severe but does not eliminate it.     

KAPPA-G,A Non-Gaussian Plume Dispersion Model: Description and Evaluation Against Tracer Measurements

This paper presents a mixed methodology for the simulation of atmospheric disperson phenomena in which vertical diffusion is computed using an analytical solution of the K-theory equation, while horizontal diffusion is simulated by the Gaussian formula. This new formulation, while maintaining a simple analytical form for the concentration field, incorporates the effects of power-law vertical profiles of both wind speed and eddy diffusivity. The performance of this approach, which has been implemented into a full computer package (KAPPA-G), is evaluated by comparison with data from SF₆ tracer experiments.