Effect of feeding strategy and COD/sulfate ratio on the removal of sulfate in an AnSBBR with recirculation of the liquid phase

The objective of this work was to analyze the effect of the interaction between feeding strategy and COD/sulfate ratio on the removal efficiency of sulfate and organic matter from a synthetic wastewater. An anaerobic sequencing batch reactor with recirculation of the liquid phase and containing immobilized biomass on polyurethane foam (AnSBBR) was used. The AnSBBR with a total volume of 3.7 L, treated 2.0 L synthetic wastewater in 8-h cycles at 30 ± 1 °C and was inoculated with anaerobic biomass from a UASB. Two feeding strategies were assessed: (a) batch and (b) batch followed by fed-batch. In strategy (a) the reactor was fed in 10 min with 2 L wastewater containing sulfate and carbon sources. In strategy (b) 1.2 L wastewater (containing only the sulfate source) was fed during the first 10 min of the cycle and the remaining 0.8 L (containing only the carbon source) in 240 min. The COD/sulfate ratios assessed were 1 and 3. Based on these values and on the concentrations of organic matter (0.5–11.25 gCOD/L) and sulfate (0.5 and 2.5 gSO₄^2?/L), the sulfate and organic matter loading rates applied equaled 1.5 and 4.5 gSO₄^2?/L d for sulfate and 1.5, 4.5 and 13.5 gCOD/L d for organic matter. After stabilization of the system time profiles were run of monitored parameters (COD, sulfate, sulfide and sulfite). In general, the reactor showed to be robust for use in the anaerobic treatment of wastewaters containing sulfate. Gradual feeding (strategy b) of the carbon source favored sulfate reduction, resulting in sulfate removal efficiencies of 84–98% and organic matter removal efficiencies of 48–95%. The best results were observed under COD/sulfate ratio equal to 1 (loading rates of 1.5 and 4.5 gSO₄^2?/L d for sulfate, and 1.5 and 4.5 gCOD/L d for organic matter). When COD/sulfate ratio was 3 (loading rates of 1.5 and 4.5 gSO₄^2?/L d for sulfate, and 4.5 and 13.5 gCOD/L d for organic matter) the effect of feed mode became less significant. These results show that the strategy batch followed by fed-batch is more advantageous for COD/sulfate ratios near the stoichiometric value (0.67) and higher organic matter and sulfate concentrations.     

Effects of deltamethrin on hepatic microsomal cytochrome p450‐dependent monooxygenases in carp

Abstract The in vivo effects of sublethal concentrations of deltamethrin (DM), a pyrethroid insecticide, on the hepatic microsomal cytochrome P450 (Cyt P450) content and the Cyt P450‐dependent monooxygenase activities (para‐nitrophenetole‐O‐deethylase, pNPOD; aminopyrene‐N‐demethylase, APND; ethylmorphine‐N‐demethylase, EMND; 7‐ethoxycoumarin‐O‐deethylase, ECOD; and ethoxyresorufin‐O‐deethylase, EROD) were examined in adult carp (Cyprinus carpió L.).

0.2 μg/1 DM treatment resulted in significant increases in APND, EMND and ECOD activities, whereas 2 μg/1 DM resulted in significant inhibitions of all studied isoenzyme activities with the exceptions of pNPOD and APND after 72 h. EROD was the only enzyme for which a slight increase in activity was observed. On repeated treatment, Cyt P450 could not be detected after 48 h, but the Cyt P420 level increased. All tested isoenzyme activities were inhibited, with the exception ofthat of EROD, which was enhanced.

All these changes in enzyme activities and Cyt P450 content demonstrate the effects of DM on fish. DM treatment at low concentration is presumed to cause induction of the Cyt P450‐dependent monooxygenases which may lead to faster metabolization of the insecticide. In contrast, DM at higher concentration strongly inhibited the activities of the studied enzymes. This finding may be due to the damaging effect of DM on the xenobiotic metabolizing enzyme systems offish.     

Factors determining the fluctuation of fluoride concentrations in PM10 aerosols in the urbanized coastal area of the Baltic Sea (Gdynia, Poland)

Fluoride concentrations were determined in PM10 samples collected in the urbanized coastal area of the Baltic Sea (Gdynia) in the period between 1 August 2008 and 8 January 2010. F^? concentrations remained within the range of 0.4–36.6 ng?·?m^?3. The economic transformations which have taken place in Poland increasing ecological awareness have had an excellent effect on the levels of fluoride pollution in the air of the studied region. In our measurements, fluoride concentrations increased in wintertime, when air temperature dropped, at low wind speeds (<1 m?·?s^?1) and with low dispersion of pollutants originating from local sources (traffic, industry, domestic heating). At times when wind speed grew to >10 m?·?s^?1, fluorides were related to marine aerosols or else brought from distant sources. Apart from wind speed and air temperature, other significant meteorological parameters which determined the variability of F^? turned out to be air humidity and precipitation volume. Aerosols were washed out effectively, even with small precipitation (h?=?4 mm), and if a dry period lasted for several days, their concentrations grew rapidly to over 30.0 ng?·?m^?3.     

Remediation procedure used for contaminated soil and underground water: A case study from the chemical industry

This is a case study of contamination by a non-aqueous phase liquid (NAPL) that leaked from a chemical plant. The remediation procedure adopted for the initial phase of the plume migration was a plastic diaphragm wall coupled with a series of water extraction wells designed to avoid environmental impact on the surrounding ecosystems. Monitoring has shown that the containment is successful, and additional measures that contribute to accelerating remediation have been adopted. The authors wished to investigate how remediation might be further enhanced. The use of in situ aeration coupled with a system of soil vapor extraction (AS/SVE) has been chosen, since the remediation of sites with characteristics similar to those in this study, if based exclusively on dissolved-phase control, would take several decades to be completed. The transport of contaminant plumes has been simulated by using an analytical model to evaluate the effectiveness of the natural attenuation of the contaminant. The results of the simulation have confirmed the limited effectiveness of the natural attenuation of the contaminant, as well as the effective increase of remediation that would occur if the AS/SVE system is applied. A sensitivity analysis that included several combinations of increments of parameters that correspond to the decay rate of the source and the dissolved plume has simulated what might happen if the AS/SVE system is implemented.     

Are either sod and catalase or the polyamines involved in the paraquat resistance of Conyza canadensis ?

Abstract

Paraquat/atrazine coresistant (PqAR) and paraquat resistant (PqR) horseweed (Conyza canadensis /L./ Cronq.) plants showed ‐ in the first hour after 0.5 mM paraquat spraying ‐ a decreased catalase activity followed by a slight increase. However, the enzyme activity remained always below the initial value. Sensitive plants showed a significant increase of catalase activity in the first 4 hour after spraying. The transient character of paraquat inhibition, the recovery of photosyn‐thetic activity of the PqAR Conyza plants (characterized by variable fluorescence) after spraying remained unaffected by the Superoxide dismutase (SOD) inhibitor, diethyldithiocarbamate. This indicates that SOD is not involved in the resistance mechanism. Untreated resistant biotypes showed about 2.5 times higher total polyamine and putrescine level than the sensitive one. 100 μM of exogenously added putrescine was observed as having a protecting effect against paraquat in floated leaves of the sensitive biotype only. The resistant leaves were unaffected probably on account of their higher endogenous polyamine level. It is concluded that polyamines may play a role in the paraquat resistance of Conyza canadensis.     

Use of co-combustion bottom ash to design an acoustic absorbing material for highway noise barriers

The present study aims to determine and evaluate the applicability of a new product consisting of coal bottom ash mixed with Portland cement in the application of highway noise barriers. In order to effectively recycle the bottom ash, the influence of the grain particle size of bottom ash, the thickness of the panel and the combination of different layers with various particle sizes have been studied, as well as some environmental properties including leachability (EN-12457-4, NEN-7345) and radioactivity tests. Based on the obtained results, the acoustic properties of the final composite material were similar or even better than those found in porous concrete used for the same application. According to this study, the material produced presented no environmental risk.     

Effects of feed-supplementation and hide-spray application of two sources of tannins on enteric and hide bacteria of feedlot cattle

Pathogenic bacteria attached to the hide or shed in the feces of cattle at slaughter can contaminate carcasses intended to be processed for human consumption. Therefore, new pre-harvest interventions are needed to prevent the carriage and excretion of foodborne pathogens in cattle presented to the processing plant. The objectives of this study were to examine the antimicrobial effects of hydrolysable tannin-rich chestnut and condensed tannin-rich mimosa extracts on bacterial indicators of foodborne pathogens when applied as a hide-intervention and as a feed additive to feedlot cattle. Water (control) or solutions (3 % wt/vol) of chestnut- and mimosa-extract treatments were sprayed (25 mL) at the left costal side of each animal to a 1000 cm² area, divided in four equal quadrants. Hide-swabs samples obtained at pre-, 2-min, 8-h, and 24-h post-spray application were cultured to enumerate Escherichia coli/total coliforms and total aerobic plate counts. In a second experiment, diets supplemented without (controls) or with (1.5 % of diet dry matter) chestnut- or mimosa-extracts were fed during a 42–day experimental feeding period. Weekly fecal samples starting on day 0, and rumen fluid obtained on days 0, 7, 21 or 42 were cultured to enumerate E.coli/total coliforms and Campylobacter. Tannin spray application showed no effect of treatment or post-application-time (P> 0.05) on measured bacterial populations, averaging 1.7/1.8, 1.5/1.6 and 1.5/1.7 (log₁₀ CFU/cm²) for E. coli/total coliforms, and 4.0, 3.4 and 4.2 (log₁₀CFU/cm²) in total aerobes for control, chestnut and mimosa treatments, respectively. Mean (± SEM) ruminal E. coli and total coliform concentrations (log₁₀ CFU/mL) were reduced (P< 0.01) in steers fed chestnut-tannins (3.6 and 3.8 ± 0.1) in comparison with the controls (4.1 and 4.2 ± 0.1). Fecal E. coli concentrations were affected by treatment (P< 0.01), showing the highest values (log₁₀ CFU/g) in fecal contents from mimosa-fed steers compared to controls (5.9 versus 5.6 ± 0.1 SEM, respectively). Total coliforms (log CFU/g) showed the highest values (P< 0.01) in feces from chestnut- and mimosa-fed steers (6.0 and 6.1 ± 0.1 respectively) in comparison with controls (5.7 ± 0.1). Fecal Campylobacter concentrations (log₁₀CFU/g) were affected by treatment (P< 0.05), day (P< 0.001) and their interaction (P< 0.01) with the controls having lower concentrations than chestnut- and mimosa-fed steers (0.4, 1.0, and 0.8 ± 0.3, respectively). It was concluded that under our research conditions, tannins were not effective in decreasing measured bacterial populations on beef cattle hides. Additionally, chestnut tannin reduced E. coli and total coliforms within the rumen but the antimicrobial effect was not maintained in the lower gastrointestinal tract. Further research is necessary to elucidate the possible antimicrobial effects of tannins at site-specific locations of the gastrointestinal tract in beef cattle fed high-grain and high-forage diets.