Periphyton Developed on Artificial Substrates: Effect of Substrate Type and Incubation Depth

The aim of this study was to assess the effect of substrate type and incubation depth on periphyton that had developed on artificial substrates. Uniform rectangular tiles made out of artificial substrates: glass, ceramic, willow tree and yew tree, were fixed on a floating buoy and deployed at three different depths in a photic zone of the Sava Lake (Belgrade, Serbia). Non-taxonomic attributes in the developed biofilm were estimated week-by-week from the start of the experiment in July, until its end in September 2014. Through assessment of substrate type and depth of incubation effect we concluded that these parameters for the fact influence periphyton development and composition. Glass was preferred by autotrophic component over ceramic and wooden substrates. In general, substrate type effect was diminished by increasing incubation depth. When non-taxonomic parameters are to be used in biomonitoring studies, our results suggest that glass substrate and shallow layer of water column (up to 50 cm) for incubation should be preferred.     

Effect of ferrate on green algae removal

Green algae Cladophora aegagropila, present in cooling water of thermal power plants, causes many problems and complications, especially during summer. However, algae and its metabolites are rarely eliminated by common removal methods. In this work, the elimination efficiency of electrochemically prepared potassium ferrate(VI) on algae from cooling water was investigated. The influence of experimental parameters, such as Fe(VI) dosage, application time, pH of the system, temperature and hydrodynamics of the solution on removal efficiency, was optimized. This study demonstrates that algae C. aegagropila can be effectively removed from cooling water by ferrate. Application of ferrate(VI) at the optimized dosage and under the suitable conditions (temperature, pH) leads to 100% removal of green algae Cladophora from the system. Environmentally friendly reduction products (Fe(III)) and coagulation properties favour the application of ferrate for the treatment of water contaminated with studied microorganisms compared to other methods such as chlorination and use of permanganate, where harmful products are produced.

     

Characterisation of secondary metal-bearing phases in used dental amalgam and assessment of gastric solubility

Detailed SEM/EDS investigation of used dental amalgams was carried out in order to characterise morphology and chemical composition of secondary metal-bearing phases resulting from long-term exposure of dental amalgam to oral environment, and assess their solubility in gastric environment. The investigation revealed numerous secondary phases, represented by compositionally and morphologically complex Hg-, Cu-, Sn-, Ag-, Zn-bearing sulphides and oxides/hydroxides, while sulphates and phosphates are scarce. Secondary metal-bearing phases mostly occur at the amalgam/tooth interface; however, some phases were found only on the occlusal surfaces of amalgam. Secondary phases mostly form porous aggregates of minute crystallites and micro- or nanocrystalline crusts. In oral environment, these phases are mostly stable and represent trapping media for dissolved potentially toxic metals released during amalgam corrosion. Simplified PHREEQC calculations of solubility of secondary metal-bearing phases in aqueous environment under conditions similar to those in gastric environment showed that secondary phases are more soluble in gastric environment than in oral solutions, which is mostly due to their forms of occurrence. Secondary phases in gastric environment thus act as secondary sources of potentially toxic metals, particularly Sn, Zn and also Cu, which are released both under reducing and oxidising conditions especially in acidic environment. Only very small amounts of Hg are potentially released and should not represent serious threat. Secondary phases that contribute the most to bioaccessibility of these metals are Sn hydroxychlorides, Sn oxides/hydroxides, Sn sulphates/hydroxysulphates, Sn oxides, Zn sulphides and Cu sulphides (Cu₂S).

     

Polychlorinated dibenzo-p-dioxins/furans and dioxin-like polychlorinated biphenyls in food and feed in the Lithuanian market

Foods and feeds were analyzed during the period of 2007–2014 employing validated and accredited methods based on gas chromatography–high-resolution mass spectrometry. Sampling has been carried out in-line with national monitoring programs as well as during import controls into Lithuania. Food samples such as eggs, milk, beef, pork, poultry, fats of plant and animal origin, fish, cod liver, and feed samples such as premixes, feeds of plant origin, compound feed, mineral feed, vegetable oil, and fish meals were analyzed. Most of the samples exhibited concentrations below maximum limits, except cod liver. Health impacts were assessed in respect to human daily intakes. Data between groups are compared.     

Plant species richness of riverbed elevations—the Pripyat river valley case study

Flora of the still unchanged or slightly modified floodplains is particularly valuable. Such are the natural, periodically flooded riparian ecosystems within the Mid-Pripyat river valley in Belarus. Distinctive elements of that area are ‘periodic islands’, which arise from the most elevated parts of the riverbed during flooding and have a specific microtopography. The aim of the research was to recognize floristic composition and ecological conditions of the ‘islands.’ Noted plants were mainly photophilous, by clearly varied in soil moisture, acidity and fertility requirements.     

Impact of industrial pollution on Scots pine (Pinus sylvestris L.) radial growth in the areas of mineral fertilizer factory “Achema”

The aim of research was to assess the changes of annual radial increment of Scots pine forests in the vicinity of intensive and moderate industrial pollution of “Achema” factory producing mineral fertilizers. Our results indicate that the radial growth of the pine tree can be divided into three different periods: growth promotion, growth inhibition and growth recovery. Low levels of nitrogen emissions were beneficial for tree growth: the radial increment in the intensive and moderate pollution zones increased by 15–25% and 10%, respectively compared to control. During the growth inhibition period, the total annual industrial emission was 37–40 kt, and 40–45% radial growth loss was observed for the closest and 15–20% for the most distant stands. The radial growth decrease slowed down and the recovery of damaged stands began in 1990–1992 then air pollution was considerably reduced. The rate of forest recovery was high for the most damaged stands: their radial growth was close to control in 2000–2011.     

Highly active photocatalytic coatings prepared by a low-temperature method

Photocatalytic properties of titanium (IV) oxide (TiO₂) in anatase form can be used for various purposes, including photocatalytic purification of water. For such an application, suspended or fixed photocatalytic reactors are used. Those with fixed phase seem to be preferred due to some advantages, one of which is the avoidance of photocatalyst filtration. To avoid leaching and exfoliation of the fixed phase, an immobilization procedure leading to a good adhesion of a catalyst to a substrate is crucial. Within this work, we present physical and photocatalytic characterization results of five commercially available TiO₂ photocatalysts (P25, P90, PC500, KRONOClean 7000, VPC-10) and one pigment (Hombitan LO-CR-S-M), which were successfully immobilized on glass slides by a “sol suspension” procedure. Different mechanical tests and characterization methods were used to evaluate the stability and morphology of the layers. Evaluation of photocatalytic activity was done by tests under UVA and UV–vis irradiation, using a method based on the detection of the fluorescent oxidation product of terephthalic acid (TPA), i.e., hydroxyterephthalic acid (HTPA). Aeroxide® P90 incorporated into the silica-titania binder was the most photocatalytically active layer and, unlike the others, showed significant increase of photocatalytic activity through the entire range of tested UVA irradiation intensities (2.3 mW/cm²–6.1 mW/cm²). The high mechanical stability of some photocatalytic layers allows using them in water photocatalytic purification reactions.     

Alterations in the rabbit lymphoid tissue after bendiocarb administration

Various pesticides have immuno-suppressive effects, and thus the organisms become responsive to viral, bacterial and parasitic diseases and neoplasm. The aim of the study was to observe the structure of the small intestine (height of enterocytes and crypts), mucosal lymphoid tissue (Payer's patches, lymphocytes in lamina propria) and a lymph node after administration of bendiocarb (2,2-dimethyl-1,3-benzodioxol-4-yl-methylcarbamate) on days 3, 10, 20, 30 and 60 of the experiment. The height of the observed enterocytes showed an increasing tendency. On days 20, 30 and 60 we also observed an increase in diameter of crypts located in intestinal epithelium. The number of cells in lamina propria mucosae was significantly reduced on days 20 and 30 after administration of bendiocarb. Observations of the lymph node showed that on days 10 and 20 there was a significant increase in relative volume of medulla at the expense of the relative volume of the cortex and a decrease in the number of lymphocytes. However, we recorded an increase in diameter of lymphocytes. The intracellular parasite Toxoplasma gondii (T. gondii) belongs to the most common pathogenic parasites in the world and it can cause serious health complications in pregnant and immunodeficient individuals. DNA isolation, standard polymerase chain reaction (PCR) and visualization in a 2.5 % agarose gel, the presence of DNA T. gondii was detected in no examined rabbit brain samples. Using real time PCR T. gondii DNA was detected and quantified in the three rabbit brain samples (10 %).     

Evaluation and validation of two different chromatographic methods (HPLC and LC-MS/MS) for the determination and confirmation of ochratoxin A in pig tissues

This study was undertaken to compare two different analytical methods for the determination and confirmation of ochratoxin A (OTA) in blood serum, kidney and liver of pigs. Sample clean-up was based on liquid-liquid phase extraction. The detection of OTA was accomplished with high-performance liquid chromatography (HPLC) combined either with fluorescence detection (FL) or electro spray ionization (ESI+) tandem mass spectrometry (MS–MS). Comparative method evaluation was based on the investigation of 90 samples of blood serum, kidney and liver per animal originating from different regions of Serbia. The analytical results are discussed in view of the respective method validation data and the corresponding experimental protocols. In general, analytical data obtained with (LC–MS–MS) liquid chromatography electro spray tandem mass spectro metry detection offered comparable good results at the sub-ppb concentration level. The results indicate that the liquid chromatography electro spray tandem mass spectrometric (LC-MS/MS) method was more specific and sensitive for the analysis and confirmation of ochratoxin A in pig tissues then high pressure liquid chromatography (HPLC) method after methylation of OTA.