Arsenic and major cation hydrogeochemistry of the Central Victorian (Australia) surface waters

This paper reports on the major cations（Ca, Mg, Na and K） and arsenic（As） compositions of surface waters collected from major creeks, rivers and lakes in Central Victoria （Australia）. The surface waters were found to be neutral to alkaline （pH 6.7-9.4）, oxidised （average redox potential （Eh） about 130 mV） and showed variable concentrations of dissolved ions （EC, about 51-4386 /μS/cm）. The concen- trations of dissolved major cations in surface waters were found to be in the order of Na〉〉Mg〉Ca〉K and in soils the contents of metals followed an order of abundance as： Ca〉Mg〉〉K〉Na. While Na was the least abundant in soils, it registered the highest dissolved cation in surface waters. Of the four major cations, the average concentration ofNa（98.7 mg/L） was attributed to the weathering of feldspars and atmospheric input. Relatively highly dissolved concentrations of Na and Mg compared with the world average values of rivers reflected the weathering of rock and soil minerals within the catchments. The As soil level is naturally high（linked to lithology） as reflected by high background soil values and mining operations are also considered to be a contributory factor. Under relatively alkaline-oxidative conditions low mobility of dissolved As （average about 7.9 μg/L） was observed in most of the surface waters with a few higher values（〉15 μg/L） around a sewage disposal site and mine railings. Arsenic in soils is slowly released into water under alkaline and/or lower Eh conditions. The efficient sink of Fe, AI and Mn oxides acts as a barrier against the As release under near neutral-oxidising conditions. High As content （average about 28.3 mg/kg） in soils was found to be associated with Fe-hydroxides as revealed by XRD and SEM analysis. The dissolved As concentration was found to be below the recommended maximum levels for recreational water in all surface waters（lakes and rivers） in the study area. Catchment lithology exerted the fundamental control on surface water chemistry. Sites impacted by mining waste dumps showed a decline in water quality.     

The adsorption characteristics of heavy metals by various particle sizes of MSWI bottom ash

The incineration rate of municipal solid waste (MSW) has been increased because of difficulty in securing a proper disposal site for MSW in Korea. The advantage of incineration is reduction of the volume of waste; however, significant amounts of bottom ash and fly ash were generated in the incineration process. Their treatment has attracted growing interest because of the potential toxicity of hazardous heavy metals. Generally, heavy metals are less released from bottom ash than from fly ash. In this study the adsorption characteristics of heavy metals were investigated using various particle sizes of MSWI bottom ash. Since bottom ash has a broad particle size distribution, it was sieved to size classes of +20, -20, -48, -80, -100 mesh. Cation exchange capacity (CEC) was analyzed by the ammonium acetate method to evaluate the potential as an adsorbent. The CEC values and surface areas increase as the range of particle size becomes finer. The adsorption experiment was conducted using synthetic (Cu and Ni) and plating rinse water as a function of reaction time (10-180 min), liquid/solid ratio (2-100) and particle size (+20 to -100 mesh), respectively. The adsorption rate increased with decreasing particle size and with increasing liquid/solid ratio; however, the removal efficiency of Cu was higher than that of Ni. In the case of plating rinse water, the adsorption rate decreased sharply at high liquid/solid ratio, and it showed over 80% of adsorption rates for Cu and Ni at an initial pH of 3.     

Influence of calcium chloride on the thermal behavior of heavy and alkali metals in sewage sludge incineration

In order to separate and reuse heavy and alkali metals from flue gas during sewage sludge incineration, experiments were carried out in a pilot incinerator. The experimental results show that most of the heavy and alkali metals form condensed phase at temperature above 600 degrees C. With the addition of 5% calcium chloride into sewage sludge, the gas/solid transformation temperature of part of the metals (As, Cu, Mg and Na) is evidently decreased due to the formation of chloride, while calcium chloride seems to have no significant influence on Zn and P. Moreover, the mass fractions of some heavy and alkali metals in the collected fly ash are relatively high. For example, the mass fractions for Pb and Cu in the fly ash collected by the filter are 1.19% and 19.7%, respectively, which are well above those in lead and copper ores. In the case of adding 5% calcium chloride, the heavy and alkali metals can be divided into three groups based on their conversion temperature: Group A that includes Na, Zn, K, Mg and P, which are converted into condensed phase above 600 degrees C; Group B that includes Pb and Cu which solidify when the temperature is above 400 degrees C; and Group C that includes As, whose condensation temperature is as low as 300 degrees C.     

Life cycle assessment of selective non-catalytic reduction (SNCR) of nitrous oxides in a full-scale municipal solid waste incinerator

Selective non-catalytic reduction (SNCR) of nitrous oxides in a full-scale municipal solid waste incinerator was investigated using LCA. The relationship between NO_x-cleaning and ammonia dosage was measured at the plant. Un-reacted ammonia - the ammonia slip - leaving the flue-gas cleaning system adsorbed to fly-ash or in the effluent of the acidic scrubber was quantified from the stoichiometric reaction of NO_x and ammonia assuming no other reaction products was formed. Of the ammonia slip, 37% was associated with the fly-ash and 63% was in the effluent of the acidic scrubber. Based on NO_x-cleaning efficiency, the fate of the ammonia slip as well as the environmental impact from ammonia production, the potential acidification and nutrient enrichment from NO_x-cleaning was calculated as a function of ammonia dosage. Since the exact fate of the ammonia slip could not be measured directly, a number of scenarios were set up ranging from “best case” with no ammonia from the slip ending up in the environment to “worst case” where all the ammonia slip eventually ended up in the environment and contributed to environmental pollution. In the “best case” scenario the highest ammonia dosage was most beneficial demonstrating that the environmental load associated with ammonia production is of minor importance. In contrast, in a “worst case” scenario” NO_x-cleaning using SNCR is not recommendable at all, since the impacts from the ammonia slip exceed the saved impacts from the NO_x removal. Increased dosage of ammonia for removal of NO_x is recommendable as long as less than 10-20% of the ammonia slip to the effluent of the acidic scrubber ends up in the environment and less than 40% of the slip to the fly-ash ends up in the environment. The study suggests that the actual fate of the ammonia slip is crucial, but since the release of the ammonia may take place during transport and at the facilities that treat the wastewater and treat the fly-ash this factor depends strongly on local conditions and may be hard to determine. Thus, LCA-modeling proved useful in assessing the balance between ammonia dosage and NO_x-removal in flue-gas cleaning from waste incineration.     

Comparative studies on toluene removal and pressure drop in biofilters using different packing materials

To select the best available packing material for malodorous organic gases such as toluene and benzene, biofilter performance was compared in biofilters employed different packing materials including porous ceramic (celite), Jeju scoria (lava), a mixture of granular activated carbon (GAC) and celite (GAC/celite), and cubic polyurethane foam (PU). A toluene-degrading bacterium, Stenotrophomonas maltophilia T3-c, was used as the inoculum. The maximum elimination capacities in the celite, lava, and GAC/celite biofilters were 100, 130, and 110 gm(-3) hr(-1), respectively. The elimination capacity for the PU biofilter was approximately 350 g m(-3) hr(-1) at an inlet loading of approximately 430 g m(-3) hr(-1), which was 2 to 3.5 times higher than for the other biofilters. The pressure drop gradually increased in the GAC/ celite, celite and lava biofilters after 23 day due to bacterial over-growth, and the toluene removal efficiency remarkably decreased with increasing pressure drop. Backwashing method was not effective for the control of biomass in these biofilters. In the PU biofilter however, backwashing allowed maintenance of a pressure drop of 1 to 3 mm H2O m(-1) and a removal efficiency of > 80%, indicating that the PU was the best packing material for toluene removal among the packing materials tested.     

Reductive dechlorination and biodegradation of 2,4,6-trichlorophenol using sequential permeable reactive barriers: laboratory studies

The reductive dechlorination and biodegradation of 2,4,6-trichlorophenol (2,4,6-TCP) was investigated in a laboratory-scale sequential barrier system consisting of a chemical and biological reactive barrier. Palladium coated iron (Pd/Fe) was used as a reactive barrier medium for the chemical degradation of 2,4,6-TCP, and a sand column seeded with anaerobic microbes was used as a biobarrier following the chemical reactive barrier in this study. Only phenol was detected in the effluent from the Pd/Fe column reactor, indicating that the complete dechlorination of 2,4,6-TCP was achieved. The residence time of 30.2-21.2h was required for the complete dechlorination of 2,4,6-TCP of 100 mg l(-1) in the column reactor. The surface area-normalized rate constant (k(SA)) is 3.84 (+/-0.48)x10(-5)lm(-2)h(-1). The reaction rate in the column tests was one order of magnitude slower than that in the batch test. In the operation of the biobarrier, about 100 microM of phenol was completely removed with a residence time of 7-8d. Consequently, the dechlorination prior to biodegradation turns out to increase the overall treatability. Moreover, the sequential permeable reactive barriers, consisting of iron barrier and biobarrier, could be recommended for groundwater contaminated with toxic organic compounds such as chlorophenols.     

Assessment of water quality and trace metal contaminations in Mondolkiri province in the Northeastern part of Cambodia

Environmental Geochemistry and Health - The aim of the present study is to investigate water quality and potential trace metal contaminations in the Northeastern part of Cambodia. Tube well...     

Drying characteristics of thickened sewage sludge in oil vacuum evaporation system

Journal of Material Cycles and Waste Management - In the current work, drying characteristics of thickened sludge was investigated with respect to drying conditions in oil vacuum evaporation...     

Effects of diet on fatty acid composition of body zones in larvae of the sea bass Dicentrarchus labrax: a chemometric study

Larvae of the sea bass Dicentrachus labrax were fed four Artemia sp. diets for 28 d. Three were nauplii enriched with emulsions of polyunsaturated fatty acids, and the fourth nauplii enriched with baker's yeast. At the end of the experimental period, the fatty acids of the bodies, heads and eyes of the larvae were analysed. A multivariate statistical method (discriminant analysis, DA) applied to the data revealed anatomical as well as dietary fatty acid pattern-discrimination. We propose here the use of discriminant analysis as a pattern-recognition method that will help to integrate the fatty acid information obtained in nutritional studies.     

First-trimester screening for Down syndrome; the role of nasal bone assessment in the Korean population

Objectives The aim of this study was to evaluate the role of nasal bone assessment in first-trimester screening for Down syndrome (DS) in the Korean population. Methods From July 2004 to March 2006, we prospectively evaluated the fetal nasal bones at 11–14 weeks' gestation in the Korean population. Results A successful evaluation was possible in 6490 of 6787 fetuses (95.6%). Absent, hypoechoic, and short nasal bones were seen in 4 (26.7%), 4 (26.7%), and 1 (6.7%) of 15 fetuses with DS, respectively, whereas in 5 (0.1%), 11 (0.2%), and 246 (3.8%) of 6456 normal fetuses. The incidence of absent and hypoechoic nasal bone showed significant differences between normal fetuses and fetuses with DS (P < 0.0005, both). Screening for DS using an absent or hypoechoic nasal bone resulted in a sensitivity of 53.3%, a specificity of 99.8%, a positive likelihood ratio of 215.2, and a negative likelihood ratio of 0.5. Conclusion Our study showed that nasal bone abnormality at 11–14 weeks of gestation had a high association with DS in the Korean population. This suggests that nasal bone assessment can be used to supplement the current first-trimester screening for DS in the Korean population. Copyright © 2007 John Wiley & Sons, Ltd.