Seasonal variations in species composition,abundance, biomass and production rate of tintinnids (Ciliata: Protozoa) along the Hooghly (Ganges) River Estuary,India: a multivariate approach

The study is the first documentation of seasonal variations in species composition, abundance and diversity of tintinnid (Ciliata: Protozoa), in relation to water quality parameters along the stretch of the Hooghly (Ganges) River Estuary (HRE), eastern coastal part of India. A total of 26 species (22 agglomerated and 4 non-agglomerated) belonging to 8 genera has been identified from 8 study sites where Tintinnopsis (17 species) represented the most dominant genera, contributing up to 65 % of total tintinnid community followed by Tintinnidium (2 species), Leprotintinnus (2 species) and Dadayiella, Favella, Metacylis, Eutintinnus and Helicostomella (each with solitary species). The maximum (1,666 ind.?l^?1) and minimum (62 ind.?l^?1) abundance of tintinnids was recorded during post-monsoon and monsoon, respectively. A distinct seasonal dynamics in terms of biomass (0.005–2.465 μg C l^?1) and daily production rate (0.04–3.13 μg C l^?1 day^?1) was also noticed, accounting highest value during pre-monsoon. Chlorophyll a and nitrate were found to be potential causative factors for the seasonal variations of tintinnids as revealed by a stepwise multiple regression model. The result of ANOVA showed a significant variation between species abundance and months (F?=?2.36, P?≤?0.05). k-dominance curves were plotted to determine the comparison of tintinnid dominance between the investigated stations. Based on a principal component analysis (PCA), three main groups were delineated with tintinnid ciliates and environmental parameters. The changes in lorica morphology in terms of temperature and salinity, recorded for three dominant species, provided information on the ecological characteristics of the species assemblage in this estuarine system.     

Influence of microbial community on degradation of flubendiamide in two Indian soils

Degradation of flubendiamide as affected by microbial population count in two Indian soils (red and alluvial) varying in physicochemical properties was studied under sterile and non-sterile conditions. Recovery of flubendiamide in soil was in the range of 94.7–95.9 % at 0.5 and 1.0 μg g^?1, respectively. The DT₅₀ of flubendiamide at the level of 10 μg g^?1 in red soil under sterile and non-sterile conditions was found to be 140.3 and 93.7 days, respectively, and in alluvial soil under sterile and non-sterile condition was 181.1 and 158.4 days, respectively. Residues of flubendiamide dissipated faster in red soil (non-sterile followed by sterile) as compared to alluvial (non-sterile soil followed by sterile soil). A wide difference in half-life of red and alluvial soil under sterile and non-sterile conditions indicated that the variation in physicochemical properties of red and alluvial soil as well as the presence of microbes play a great role for degradation of flubendiamide. The results revealed that slower-degrading alluvial soil possessed microbes with degradative capacity. The degradation rate in this soil was significantly reduced by some of its physicochemical characteristics, despite sterile and non-sterile conditions, which was faster in red soil.     

Hazard assessment of metals in invasive fish species of the Yamuna River,India in relation to bioaccumulation factor and exposure concentration for human health implications

Monitoring of heavy metals was conducted in the Yamuna River considering bioaccumulation factor, exposure concentration, and human health implications which showed contamination levels of copper (Cu), lead (Pb), nickel (Ni), and chromium (Cr) and their dispersion patterns along the river. Largest concentration of Pb in river water was 392 μg L^?1; Cu was 392 μg L^?1 at the extreme downstream, Allahabad and Ni was 146 μg L^?1 at midstream, Agra. Largest concentration of Cu was 617 μg kg^?1, Ni 1,621 μg kg^?1 at midstream while Pb was 1,214 μg kg^?1 at Allahabad in surface sediment. The bioconcentration of Cu, Pb, Ni, and Cr was observed where the largest accumulation of Pb was 2.29 μg kg^?1 in Oreochromis niloticus and 1.55 μg kg^?1 in Cyprinus carpio invaded at Allahabad while largest concentration of Ni was 174 μg kg^?1 in O. niloticus and 124 μg kg^?1 in C. carpio in the midstream of the river. The calculated values of hazard index (HI) for Pb was found more than one which indicated human health concern. Carcinogenic risk value for Ni was again high i.e., 17.02?×?10^?4 which was larger than all other metals studied. The results of this study indicated bioconcentration in fish due to their exposures to heavy metals from different routes which had human health risk implications. Thus, regular environmental monitoring of heavy metal contamination in fish is advocated for assessing food safety since health risk may be associated with the consumption of fish contaminated through exposure to a degraded environment.     

Porous material based on modified carbon and the effect of pore size distribution on the adsorption of methylene blue dye from an aqueous solution

Environmental Science and Pollution Research - Carbon porous materials obtained through KOH activation of a furfural?+?hydroquinone?+?urotropine mixture were applied as...     

Impact of riverbank filtration on treatment of polluted river water

The impact of riverbank filtration (RBF) on the treatment of water from the River Yamuna at Mathura, which has disagreeable visual properties, has been investigated. The dissolved organic carbon (DOC) and colour of the river water were 4.0–6.8 mg/L and 40–65 colour units (CU), respectively. Pre-chlorination is in practice to improve raw water quality. Chlorine doses as high as 60 mg/L ahead of the water treatment units reduced colour by about 78%. Removal of DOC and UV-absorbance was less than 18%. In comparison to direct pumping of the river water, collection of water through RBF resulted in the reduction of DOC, colour, UV-absorbance and fecal coliforms by around 50%. However, riverbank filtrate did not conform to the drinking water quality standards. Therefore, riverbank-filtered water along with the Yamuna water were ozonated for different durations. To reduce DOC to the desired level, the dose of ozone required for the riverbank filtrate was found to be considerably less than the ozone required for the river water. RBF as compared to direct pumping of Yamuna water appears to be effective in improving the quality of the raw water.     

Utilization of molasses spentwash for production of bioplastics by waste activated sludge

Present study describes the treatment of molasses spentwash and its use as a potential low cost substrate for production of biopolymer polyhydroxybutyrate (PHB) by waste activated sludge. Fluorescence microscopy revealed the presence of PHB granules in sludge biomass which was further confirmed by fourier transform-infra-red spectroscopy (FT-IR) and ¹³C nuclear magnetic resonance (NMR). The processing of molasses spentwash was carried out for attaining different ratios of carbon and nitrogen (C:N). Highest chemical oxygen demand (COD) removal and PHB accumulation of 60% and 31% respectively was achieved with raw molasses spentwash containing inorganic nitrogen (C:N ratio = 28) followed by COD removal of 52% and PHB accumulation of 28% for filtered molasses containing inorganic nitrogen (C:N ratio = 29). PHB production yield (Y_p/s) was highest (0.184 g g^?1 COD consumed) for deproteinized spentwash supplemented with nitrogen. In contrast, the substrate consumption and product formation were higher in case of raw spentwash. Though COD removal was lowest from deproteinized spentwash, evaluation of kinetic parameters suggested higher rates of conversion of available carbon to biomass and PHB. Thus the process provided dual benefit of conversion of two wastes viz. waste activated sludge and molasses spentwash into value-added product-PHB.     

Co-composting of green waste and food waste at low C/N ratio

In this study, co-composting of food waste and green waste at low initial carbon to nitrogen (C/N) ratios was investigated using an in-vessel lab-scale composting reactor. The central composite design (CCD) and response surface method (RSM) were applied to obtain the optimal operating conditions over a range of preselected moisture contents (45–75%) and C/N ratios (13.9–19.6). The results indicate that the optimal moisture content for co-composting of food waste and green waste is 60%, and the substrate at a C/N ratio of 19.6 can be decomposed effectively to reduce 33% of total volatile solids (TVS) in 12 days. The TVS reduction can be modeled by using a second-order equation with a good fit. In addition, the compost passes the standard germination index of white radish seed indicating that it can be used as soil amendment.     

How Should Support for Climate-Friendly Technologies Be Designed?

Stabilizing global greenhouse gas concentrations at levels to avoid significant climate risks will require massive “decarbonization” of all the major economies over the next few decades, in addition to the reduced emissions from other GHGs and carbon sequestration. Achieving the necessary scale of emissions reductions will require a multifaceted policy effort to support a broad array of technological and behavioral changes. Change on this scale will require sound, well-thought-out strategies. In this article, we outline some core principles, drawn from recent social science research, for guiding the design of clean technology policies, with a focus on energy. The market should be encouraged to make good choices: pricing carbon emissions and other environmental damage, removing distorting subsidies and barriers to competition, and supporting RD&D broadly. More specific policies are required to address particular market failures and barriers. For those technologies identified as being particularly desirable, some narrower RD&D policies are available.     

Radon level in dwellings and its correlation with uranium and radium content in some areas of Himachal Pradesh,India

LR- 115 plastic track detectors have been used to measure indoor radon level in some dwellings of Una district, Himachal Pradesh, India. The annual average radon concentration in dwellings in most of the villages falls in the range of the action level recommended by the International Commission on Radiological Protection. The radon values in some of the dwellings exceed the action level and may be unsafe from the health hazard point of view. The indoor radon values are in general higher in winter than in summer. Uranium, radium and radon exhalation studies have also been carried out in soil samples collected from these areas. A good correlation is obtained between uranium concentration in the soil and indoor radon in dwellings. The soil radon exhalation rate also correlates with the uranium concentration in soil.