三峡库区干支流落干期消落带土壤可转化态氮含量及分布特征

为探明三峡支流水体富营养化频发与库岸消落带土壤氮素"源-库"关系转化之间的内在关系,采用分级浸提法,分析了三峡库区长江万州段干流、苎溪河支流、密溪河支流消落带落干期土壤可转化态氮含量和分布特征.结果表明,与三峡库区万州段干流相比,支流消落带落干期土壤有机质和总氮含量较高,而阳离子交换量(CEC)和p H值较低.三峡干支流消落带土壤可转化态氮(TF-N)以OSF-N(有机态和硫化物结合态)为主,且含量上OSF-NIMOF-N(铁锰氧化物结合态氮)IEF-N(离子交换态氮)CF-N(碳酸盐结合态氮);而空间分布上,TF-N表现为:密溪河苎溪河长江干流,4种TF-N形态中IEF-N和OSF-N在干支流间无显著差异,而CF-N和IMOF-N分布与TF-N相反,是造成干支流消落带TF-N差异的主要因素.     

象山港国华电厂强增温海域浮游动物群落结构和多样性的时空特征

为探明电厂强增温海域浮游动物群落结构和多样性的时空特征,于2011年在象山港国华电厂附近海域,采用浮游生物Ⅱ型网(网目160μm)进行10站位2重复的浮游动物季节性采样.结果表明,共识别出62种浮游动物(含幼体),平均丰度为9 531.1 ind.m-3.该海域浮游动物群落主要由桡足类和浮游幼体类组成,且以浮游幼体类为主,比例高达66.6%.相似性分析显示,各月间浮游动物群落结构差异极显著(P<0.01),控制群落结构的优势种有18种,最重要的判别种有瘦尾胸刺水蚤Centropages tenuiremis、大同长腹剑水蚤Oithona similis、伪长腹剑水蚤Oithona fallax、克氏纺锤水蚤Acartia clausi、长尾基齿哲水蚤Clausocalanus furcatus、针刺拟哲水蚤Paracalanus aculeatus和小拟哲水蚤Paracalanus parvus.GLM分析显示,月份间的多样性指数也存在极显著差异(P<0.01),经计算,各多样性指数随水温增加而下降的拐点水温范围为20.31～22.31℃.在断面上,离排水口0.2 km断面(D02)的平均水温比2 km断面高2.16℃.受温度影响,主要优势种如瘦尾胸刺水蚤和大同长腹剑水蚤倾向于向D02断面移动,克氏纺锤水蚤、尤其是大型浮游动物倾向于远离排水口,并向1.2 km断面聚集,使D02断面的种类数最少(33种)、丰度最低(5 522.8 ind.m-3),而1.2 km断面的种类数(53种)和丰度(16 491.0 ind.m-3)最高;同时,D02断面的多样性指数也明显低于其它断面.经线性回归分析,海域增温使多样性指数极显著下降(P<0.01),每增温1℃浮游动物丰富度下降12.3%.     

应用WRF/Chem模拟河南冬季大气颗粒物的区域输送特征

基于WRF/Chem模式,设置多组区域排放源的情景实验定量估算河南、京津冀、山东、山西、安徽和江苏、湖北6个区域人为源排放对河南省2015年12月PM_(2.5)和PM_(10)浓度贡献率,并结合气象资料研究3个代表性城市的污染输送特征.结果表明:河南省冬季PM_(2.5)和PM_(10)主要来源为本省排放,平均贡献率分别为54.83%、61.32%.区域污染输送对河南颗粒物的贡献也占有很大比例,京津冀、安徽和江苏、山东、山西以及湖北对PM_(2.5)平均贡献率分别为11.95%、11.69%、7.95%、7.40%、4.30%,对PM_(10)平均贡献率分别为10.42%、10.03%、7.00%、6.89%、3.80%.PM_(2.5)外来输送率比PM_(10)要高,表明细颗粒物比粗颗粒物更易跨区域长距离输送.冬季长持续时间的污染过程大多受静风或小风控制,省内污染贡献最大,过程结束时伴随着大风,周边区域的污染贡献有所增加.不同城市的颗粒物来源与其地理位置、风速、风向等气象条件密切相关.区域污染来源具有复杂性,改善河南省空气质量是需要整个区域共同面对和解决的问题.     

山仔水库沉积物蓝藻复苏试验研究

采用正交试验考察了温度、光照、营养盐和物理扰动4个因素对山仔水库冬季沉积物中蓝藻复苏的影响,每个因素设置两个水平,培养周期为6 d,并以蓝藻复苏量为考察指标.结果表明,温度和光照为蓝藻复苏的主要影响因子,上覆水体的营养盐、物理扰动对沉积物中蓝藻门复苏的影响作用不显著,不同的蓝藻种属对温度和光照条件的响应程度不完全一致,蓝藻门微囊藻属(Microcystis)对温度和光照的复苏响应显著,颤藻属(Oscillatoria)仅对温度的复苏响应显著.同时,通过设置6.0~16.0 ℃之间6个温度梯度及50和2000 lx两个光照梯度,进行了沉积物柱状样复苏模拟实验.结果显示,山仔水库冬季沉积物微囊藻属和颤藻属在10 ℃左右开始复苏,微囊藻属对光的敏感性使其更容易处于优势地位.     

可见光驱动微生物光电化学池处理剩余污泥同步产氢

氢气是一种理想的清洁能源.太阳能驱动的微生物光电化学池(Microbial photoelectrochemical cell, MPEC)因可同时实现废物处理与自发产氢而受到人们的关注.本文以剩余污泥为底物,构建了一种由无定型硫化钼改性硅纳米线(MoS_3/SiNWs)光阴极和生物阳极组成的MPEC系统,研究了3组MPEC在不同的酸性阴极液pH和外加电压条件下的产氢及污泥减量效果.研究结果表明,MPEC在阴极液pH为1和3的条件下均能在无外加电压下自发产氢;pH=1的MPEC-1实验中平均产氢速率为(0.66±0.02) mL·h~(-1),约是pH=3的MPEC-2实验平均产氢速率的1.5倍,但阴极过酸的条件限制了其实际应用; pH为3、外加0.2 V电压的MPEC-3与MPEC-2相比,产氢周期由15 h增加到40 h,平均产氢速率由(0.44±0.05) mL·h~(-1)提高到(0.52±0.04) mL·h~(-1),污泥TCOD、SCOD、TSS、VSS的降解率分别可达53.96%、70.18%、38.21%和61.76%.可见本文构建的MPEC系统是一种有前景的利用太阳能进行废物处理和资源化的新技术.     

Emissions of SO2, NO and N2O in a circulating fluidized bed combustor during co-firing coal and biomass

This paper presents the experimental investigations of the emissions of SO2, NO and N2O in a bench scale circulating fluidized bed combustor for coal combustion and co-firing coal and biomass. The thermal capacity of the combustor is 30 kW. The setup is electrically heated during startup. The influence of the excess air, the degree of the air staging, the biomass share and the feeding position of the fuels on the emissions of SO2, NO and N2O were studied. The results showed that an increase in the biomass shares resulted in an increase of the CO concentration in the flue gas, probably due to the high volatile content of the biomass. In co-firing, the emission of SO2 increased with increasing biomass share slightly, however, non-linear increase relationship between SO2 emission and fuel sulfur content was observed. Air staging significantly decreased the NO emission without raising the SO2 level. Although the change of the fuel feeding position from riser to downer resulted in a decrease in the NO emission level, no obvious change was observed for the SO2 level. Taking the coal feeding position R as a reference, the relative NO emission could significantly decrease during co-firing coal and biomass when feeding fuel at position D and keeping the first stage stoichiometry greater than 0.95. The possible mechanisms of the sulfur and nitrogen chemistry at these conditions were discussed and the ways of simultaneous reduction of SO2, NO and N2O were proposed.     

二氧化硫/水/空气体系气溶胶成核实验研究

以X-射线为辐射电离源对二氧化硫/水/空气体系的气溶胶成核过程进行了研究.实验结果表明,新生粒子来源于离子诱导成核与均相成核两种机制,前者产生带电颗粒,后者产生中性颗粒.离子对粒子成核有着重要的贡献,对粒子生长作用不明显,SO2对粒子成核与生长均有贡献.成核粒子谱分布呈双峰模式,其峰值会随着气体流速发生偏移.在低SO2浓度情况下,离子诱导成核占主导地位,随着SO2浓度的增加,均相成核的作用越来越明显.     

Variations of dominant microbial populations in groundwater in response to the leachate from Laogang Landfill

Temporal changes of dominant microbial populations in groundwater in response to the leachate from Shanghai Laogang Landfill were investigated. Concentrations of dissolved redox-relevant species in groundwater suggested that the dominating redox process had changed from denitrification to methane-production/sulfate-reduction due to landfilling. Dominant microbial populations were determined using restriction fragment length polymorphism(RFLP) analyses of 16S rRNA gene libraries, which were further studied by sequencing and phylogenetic analyses. The results indicated that obvious shifts of dominant microbial populations had occurred in groundwater in response to the pollution of leachate. The closest relatives of some dominant clones are accordant with the dominating redox processes determined by hydrochemical analyses, based on the GenBank‘s indications on the ability to perform redox reactions.     

Development of analytical methods for polycyclic aromatic hydrocarbons （PAHs） in airborne particulates： A review

In the present work, the different sample collection, pretreatment and analytical methods for polycyclic aromatic hydrocarbons （PAHs） in airborne particulates is systematacially reviewed, and the applications of these pretreatment and analytical methods for PAHs are compared in detail. Some comments on the future expectation are also presented.     

AMD铁絮体改性生物炭对重金属吸附机理研究 ——以Pb(II)为例

以酸性矿山废水生成的铁絮体和秸秆生物炭为原料,采用化学改性和紫外辐射联用技术制备改性生物炭,并通过正交试验确定最佳改性条件,同时利用FTIR、SEM和BET等方法对吸附材料的形貌特征、孔隙结构及其表面化学性质进行表征.结果表明,通过改性使吸附材料比表面积增大,吸附位点增多,在25℃、pH为7时,吸附材料改性后比表面积为295.71 m²·g^-1,对Pb（II）的拟合吸附量可达278 mg·g^-1.改性材料对Pb（II）的吸附过程符合Langmuir吸附等温线模型和准二级动力学模型,主要为单分子层吸附,受化学吸附控制.