Composting of waste algae: A review

Although composting has been successfully used at pilot scale to manage waste algae removed from eutrophied water environments and the compost product applied as a fertiliser, clear guidelines are not available for full scale algae composting. The review reports on the application of composting to stabilize waste algae, which to date has mainly been macro-algae, and identifies the peculiarities of algae as a composting feedstock, these being: relatively low carbon to nitrogen (C/N) ratio, which can result in nitrogen loss as NH₃ and even N₂O; high moisture content and low porosity, which together make aeration challenging; potentially high salinity, which can have adverse consequence for composting; and potentially have high metals and toxin content, which can affect application of the product as a fertiliser. To overcome the challenges that these peculiarities impose co-compost materials can be employed.     

废旧冰箱拆解聚氨酯泡沫塑料制备PU/PP复合材料

利用废旧冰箱拆解的聚氨酯泡沫塑料(PU)和聚丙烯(PP)、聚丙烯接枝马来酸酐(PP-g-MAH)为原料,采用物理化学回收技术制备PU/PP复合材料。用正交实验法分析PU填充量、PU粒径和PP-g-MAH 3个因素对PU/PP复合材料力学性能影响的显著性。结果表明,PU填充量对PU/PP复合材料拉伸性能有显著影响,对冲击性能和弯曲性能没有显著影响;在本文的实验范围内,PU粒径对PU/PP复合材料的力学性能影响不大;而PP-g-MAH投加量对PU/PP复合材料具有一定的影响。确定的优化工艺配方为:PU 40%;PU粒径选择2.00 mm;PP-g-MAH投加量10%。采用优化工艺制备的PU/PP复合材料的密度为1 042.88 kg/m3;冲击强度为2.9 kJ/m2;拉伸强度为10.30 MPa;拉伸模量为1 100 MPa;弯曲强度为18.5 MPa;弯曲模量为733 MPa。     

共代谢膜生物反应器法处理二甲基亚砜废水

采用蔗糖作为共代谢基质与一体式好氧膜生物反应器（MBR）工艺相结合处理二甲基亚砜（DMSO）废水。考察了装置的污泥驯化效果、DMSO去除率、污泥的性能、HRT和冲击负荷对DMSO去除率的影响。试验结果表明：驯化第29天,DMSO去除率达98.5%,表明MBR内的污泥已驯化成功;在MBR运行的正式期,当DMSO处于高负荷状态时,DMSO去除率较低;随蔗糖加入量的增加,DMSO去除率逐渐提高,最终恢复到DMSO高负荷冲击前的DMSO去除效果;正常运行时,装置进水ρ（DMSO）=257~1 448 mg/L（平均值为718 mg/L）、出水ρ（DMSO）=6~22 mg/L（平均值为7 mg/L）,DMSO去除率为96.4%~99.6%（平均值为98.9%）;在MBR运行的正式期,污泥体积指数小于100 mL/g,表明污泥的沉降性能较好,MLVSS/MLSS较高,表明污泥的活性高,MBR内MLSS的平均值为5.52 g/L,MLVSS的平均值为4.78 g/L;MBR适宜的HRT为12 h。     

电催化氧化处理除草剂异噁草酮废水的效能

为有效处理含异噁草酮除草剂废水,以Sb掺杂Ti／SnO2电极为阳极,不锈钢板为阴极,采用电催化氧化技术对异噁草酮废水进行降解,研究了不同影响因素对异噁草酮去除率的影响,并分析了异噁草酮的降解效果。结果表明,当异噁草酮初始浓度为100mg／L、电流密度为20mA／cm2、电解质投加量为0．10mol／L,反应120min后,异噁草酮去除率达到94％,此时TOC去除率为57．9％,能耗为25kWh／m2,且废水的可生化性能显著提高。     

内源电子受体产生及其在抑制富磷剩余污泥释磷行为中的应用

根据生物脱氮除磷系统产生的富磷剩余污泥含有硝化细菌和生产废水含有高浓度氨氮的特点,将生产废水中的氨氮转化为硝酸盐(内源电子受体),并将获得的内源电子受体利用在富磷剩余污泥浓缩过程,同步实现内源电子受体反硝化及其抑制富磷剩余污泥释磷行为。结果表明,将富磷剩余污泥(excess activated sludge,EAS。EAS1是在好氧方式下添加,EAS2是在缺氧方式下添加)与生产废水(reject water)按4种比例(Ⅰ、生产废水∶EAS1∶EAS2=15%∶85%∶0%;Ⅱ、生产废水∶EAS1∶EAS2=15%∶80%∶5%;Ⅲ、生产废水∶EAS1∶EAS2=15%∶75%∶10%;Ⅳ、生产废水∶EAS1∶EAS2=15%∶65%∶20%)混合曝气用于产生内源电子受体时,最佳硝化时间均为12 h,可将液相中的氨氮分别由初始的(113.16±0.85)mg/L、(117.18±4.39)mg/L、(129.48±4.85)mg/L及(142.53±0)mg/L降至(0.74±0.41)mg/L、(0.45±0.15)mg/L、(0.41±0.15)mg/L及(0.38±0.08)mg/L;同时,硝酸盐氮分别由初始的(7.48±7.91)mg/L、(12.87±5.81)mg/L、(12.87±5.81)mg/L及(13.55±6.18)mg/L升为(128.37±11.03)mg/L、(141.43±12.71)mg/L、(148.01±14.84)mg/L及(146.22±7.53)mg/L。内源电子受体可将重力浓缩过程中释磷量分别削减85%、63%、64%及83%,同时使得由生产废水回流引起的氨氮积累量分别减少89.25%、69.93%、74.31%及85.40%。在整个内源电子受体产生及其应用于抑制污泥释磷阶段,TN去除率分别为39.59%、44.54%、51.86%及57.33%。上述内源电子受体胁迫条件下的浓缩过程中,不仅可以有效降低由重力浓缩释磷引起的磷积累量,且可同步实现减少由生产废水回流引起的氨氮积累量。     

磷酸活化-微波热解改性污泥对镉的吸附性能

以城市污水处理厂剩余污泥为原料,利用磷酸活化-微波热解制取改性污泥。以此污泥作为吸附剂,对含Cd2+废水进行了吸附实验研究。考察了溶液反应时间、Cd2+浓度、pH值和吸附剂用量对镉吸附去除效果的影响;利用等温吸附实验作出吸附等温线,并考察了改性污泥吸附剂吸附Cd2+的动力学方程。实验结果表明,改性污泥对Cd2+有良好的吸附性能,吸附最佳pH值为6.0,吸附较好地符合一级动力学吸附模型和Langmuir-Freundlich等温吸附方程,吸附为物理吸附,吸附反应发生12 h后达到吸附平衡。     

重庆主城区秋冬季逆温对空气质量影响的观测分析

2013年9—11月利用RPG-HATPRO地基多通道微波辐射计对重庆主城区大气进行连续探测,统计了大气逆温情况,并对典型重污染天气下大气逆温与空气质量状况进行综合分析。结果表明,逆温出现的频率为63.3%,基本为接地逆温类型,逆温层厚度为953 m,逆温强度为0.3℃/hm;逆温的存在为气溶胶的积聚和凝聚创造了有利条件。     

酸改性泥炭对含亚甲基蓝废水的吸附净化作用

采用稀硝酸对泥炭进行改性处理获得酸改性泥炭,并将其用于处理亚甲基蓝废水。考察初始溶液pH、接触时间、酸改性泥炭投加量和亚甲基蓝溶液初始浓度等因素对酸改性泥炭吸附效果影响。结果表明,初始溶液pH、接触时间、酸改性泥炭投加量和亚甲基蓝溶液初始浓度对酸改性泥炭吸附性能都有一定的影响。在最佳的反应条件下(接触时间为60 min,反应温度为35℃,初始溶液pH为7.12,酸改性泥炭投加量为2 g),亚甲基蓝去除率可达90.88%,其吸附较好地符合Freundlich和Langmuir等温方程,拟合相关系数均大于0.9。通过热力学计算发现,ΔG<0、ΔS>0,表明该吸附反应是自发的、吸热反应。且该吸附过程符合准二级动力学方程(R2=0.98)。     

Dioxin-like activity in sediments from Tai Lake, China determined by use of the H4IIE-luc bioassay and quantification of individual AhR agonists

Deterioration of the general ecosystem and specifically quality of the water in Tai Lake (Ch: Taihu), the third largest freshwater in China, is of great concern. However, knowledge on status and trends of dioxin-like compounds in Tai Lake was limited. This study investigated AhR-mediated potency and quantified potential aryl hydrocarbon receptor (AhR) agonists in sediments from four regions (Meiliang Bay, Zhushan Lake, Lake Center, Corner of Zhushan Lake, and Meiliang Bay) of Tai Lake by use of the in vitro H4IIE-luc, cell-based, transactivation, reporter gene assay, and instrumental analysis. Concentrations of 2,3,7,8-tetrachlorodibenzo-p-dioxin equivalents (Bio-TEQs) in sediments ranged from less than the limit of detection to 114.5 pg/g, dry weight, which indicated that organic extracts of sediments exhibited significant AhR-mediated potencies. Results of the potency balance analysis demonstrated that acid-labile, dioxin-like compounds represented a greater proportion of concentrations of Bio-TEQs in sediments from Tai Lake. Concentrations of 2,3,7,8-tetrachlorodibenzo-p-dioxin equivalents calculated as the sum of the product of concentrations of individual congeners and their respective relative potencies (Chem-TEQs) based on polycyclic aromatic hydrocarbons and/or polychlorinated biphenyls represented no more than 10 % of the total concentrations of Bio-TEQs.     

石英砂滤料表面润湿改性

采用硅烷偶联剂、钛酸酯偶联剂和铝酸酯偶联剂对石英砂进行表面改性,以制备亲油疏水性滤料。研究得出,钛酸酯偶联剂改性石英砂的最佳工艺条件为:偶联剂用量15%,反应温度90℃,搅拌时间15 min;硅烷偶联剂和铝酸酯偶联剂改性石英砂的最佳工艺条件均为:偶联剂用量15%,反应温度110℃,搅拌时间15 min。水对钛酸酯偶联剂改性石英砂滤料的润湿重量由改性前的1.5589 g降低到0.0282 g,水对硅烷偶联剂改性石英砂滤料的润湿重量降低到0.0607 g,水对铝酸酯改性石英砂滤料的润湿重量降低到0.2664 g。静态吸附实验表明,硅烷偶联剂、钛酸酯偶联剂和铝酸酯偶联剂改性石英砂滤料对油的吸附容量分别增加了33.67%、42.87%和22.30%。XPS和FT-IR分析表明,偶联剂均以化学键的方式包覆在石英砂滤料表面,结合稳定。