硫黄联合装置停工密闭吹扫的实现

介绍了中国石化济南分公司硫黄回收联合装置安全环保停工的过程,在硫黄回收联合装置停工前,研究讨论各装置停工密闭吹扫的流程及方法,并确定各装置停工吹扫的顺序、注意事项和前期准备工作。在各装置停工吹扫过程中,严格按照停工方案,采取了分装置吹扫,该装置吹扫完毕后立即加盲板隔离,最后放火炬公用系统采取倒吹扫,实现了装置停工密闭吹扫,达到了各装置停工酸性气系统吹扫不放火炬的要求。     

佛山高明河水环境多环芳烃的分布特征与通量研究

利用液液萃取法和气相色谱-质谱方法对佛山境内高明河水环境多环芳烃（PAHs）进行了测定,并对PAHs的分布特征与通量进行了初步研究.结果表明高明河水环境中16种优控PAHs的浓度范围在41.6～375.6 ng/l之间,从上游到下游总体呈递增的趋势,其下游浓度偏高可能与荷城街道较为密集的工业和人口分布有关.高明河水环境PAHs的总含量高于欧美一些低污染水域,但低于国内一些主要河流.高明河PAHs年通量约为333.8 kg.     

阳澄湖浮游植物群落结构与环境因子的典范对应研究

2013年4月（春季）和10月（秋季）对阳澄湖6个点位的浮游植物群落结构进行了调查,共发现浮游植物8门91属184种,其中硅藻门为阳澄湖的主要优势门类,硅藻门中的小环藻属占主要优势种.对六个点位的浮游植物结构组成与9个环境因子的关系进行典范对应分析,结果表明东湖南与中湖北的浮游植物群落结构与其他4个点位差异性较大,pH、高锰酸盐指数、总磷、氨氮、水温是影响浮游植物分布的主要环境因子.     

明矾石在水体微藻去除中的应用研究

以温州市某大学校区内富营养化水体为研究对象,采用本地明矾石对含藻水体进行混凝除藻、除浊实验研究,分别进行投加量、搅拌强度、搅拌时间、静置时间及pH值对微藻去除效率的影响研究,以获得处理工艺的最佳条件,为恢复河流水体生态自净功能提供理论基础.试验中对投加明矾石前后,水体中浊度、总磷、氨氮和总氮进行了测定,结果表明：明矾石最佳投加量为0.35 g/L,最佳搅拌方式为200 rpm搅拌4 min;最佳静置时间为25 min;在碱性或中性水体的处理效果尤佳.     

黄孢原毛平革菌处理染料废水过程中细胞结构损伤效应研究

利用透射电子显微镜观察分析白腐真菌(黄孢原毛平革菌)在处理染料废水活性艳红X-3B过程中,染料和盐度对黄孢原毛平革菌的细胞结构产生的毒性作用.结果表明:活性艳红X-3B染料对黄孢原毛平革菌产生生物毒性作用,且随着染料浓度的增加,细胞受损伤程度不断加深.加入100 mg/L的染料活性艳红X-3B后,黄孢原毛平革菌菌丝细胞形态发生变化,出现质壁分离现象;染料浓度进一步加大,菌丝细胞超微结构受到损伤逐渐严重.染料废水中的盐度对黄孢原毛平革菌细胞也会造成损伤,且损伤程度随盐度增大而增大.NaCl浓度为3 g/L时,菌丝细胞发生质壁分离;而当NaCl加入量高于8 g/L时,细胞膜受损,线粒体、细胞核呈现空泡化,表现为受到不可逆的损伤.染料和盐双因子对黄孢原毛平革菌细胞的损伤效应表现为其损伤程度与单因子作用一致,且染料的影响作用占主导.     

Seasonal and spatial occurrence and distribution of atmospheric polycyclic aromatic hydrocarbons (PAHs) in rural and urban areas of the North Chinese Plain

Passive air sampling (PAS) was employed to study the occurrence of gaseous and particle-bound PAHs in the North Chinese Plain. The averaged concentrations of gaseous and particle-bound PAHs were 485 ± 209 ng/m³ and 267 ± 161 ng/m³, respectively. The PAHs concentrations at urban sites were generally higher than those at rural ones with ratios <1.5 in spring, summer and fall, but differences between them were not significant for the wintertime and annually averaged concentrations. This urban-rural distribution pattern was related to the PAHs emission sources. PAHs spatial variation can be partially (49%) explained by emission with a simple linear regression method. Both the gaseous and particle-bound PAHs were highest in winter and lowest in summer, with winter/summer ratios of 1.8 and 8, respectively. Emission strength was the most important factor for the seasonality.     

甲胺生产废水中氨氮资源化的试验研究

利用MgSO4·7H2O和Na2HPO4·12H2O作为试验药剂,通过正交试验和单因素优化试验,对化学沉淀法处理甲胺生产废水中氨氮的工艺条件进行优化.结果表明,在pH=9.4、反应时间15 min、搅拌速度150 r/min、Mg:N(摩尔比值)=1.1、P:N(摩尔比值)=1.0时,化学沉淀法处理300 mL甲胺生产废水,氨氮去除率维持在92%以上,COD去除率可达37%以上.同时为验证工艺条件适应性和沉淀物(MgNH4PO4)作为农作物肥料使用的价值性,对最优条件下得到的沉淀物进行研究.与MgNH4PO4纯度为100%相比,沉淀物MgNH4PO4纯度达到86%以上.因此,化学沉淀法处理氨氮不仅具有良好的效果,而且得到的MgNH4PO4含有较高N、P,可以用作农作物肥料.     

Non-aromatic hydrocarbons in surface sediments near the Pearl River estuary in the South China Sea

Surface sediment samples at 4 sites along an offshore transect from outer continental shelf off the Pearl River estuary to the shelf slope region of the northern South China Sea, have been analyzed for total organic carbon (TOC), total nitrogen (TN), solvent extractable organic matter (EOM) and non-aromatic hydrocarbons. TOC, TN and EOM show distinct spatial variations. Their highest values are all recorded at the shelf slope region. EOM varies from 18.70-38.58 microgg(-1) dry sediment and accounts for 0.20-0.72% of the TOC contents. The non-aromatic hydrocarbons are an important fraction of EOM. Their contents range from 3.43-7.06 microgg(-1) dry sediment. n-Alkanes with carbon number ranging from 15-38 are identified. They derive from both biogenic and petrogenic sources in different proportions. Results of isoprenoid hydrocarbons, hopanes and steranes also suggest possible petroleum contamination.     

西部地区加快开发应当克服“资源近视症”

本文从分析我国传统的经济增长方式入手,通过对资源近视症”的表现及后果的分析,提出西部西地区,特别是西部少数民族地区只有树立全面的资源观,立足优势,面向市场,抓住机遇,合理开发资源和利用资源,才能走出一条符合本民族,本地区实际的可持续发展之路。     

Effects of Compounded Curing Agents on Properties and Performance of Urea Formaldehyde Resin

The effects of three compounded curing agents on the properties and performance of the urea-formaldehyde (UF) resin were investigated in this study. The compounded curing agents were prepared by mixing ammonium chloride with hexamethylenetetramine, citric acid, and oxalic acid respectively at a ratio of 1:1, named N-H, N–CA, and N–OA, respectively. The curing process, crystallinity, and physical properties were measured, and the three-ply plywood was fabricated to measure its prepress strength, wet shear strength, and formaldehyde emission. Results showed that the compounded curing agents N–CA and N–OA enhanced the initial viscosity, crosslinking density and thermal stability of UF resin. Additionally, the prepress strength of the plywood bonded by UF resin with N–CA and N–OA increased by 82 and 111% respectively compared to the UF resin with NH₄Cl, and the wet shear strength increased by 14 and 16%, the formaldehyde emission decreased by 19 and 42% respectively. However, owing to the short pot-life of these curing agent limited their storage time, the curing agents N–CA and N–OA should be applied to fabricate plywood in winter for obtaining a better bond strength and a lower formaldehyde emission. While the UF resin with N–HT showed a suitable pot-life, so it could be applied to fabricate plywood in summer for long time storage and avoiding procuring problem.