福建省热带气旋暴雨型地质灾害特征分析

福建是受热带气旋影响较严重的省份,又是一个多山的省份,每年都有因热带气旋暴雨诱发滑坡等地质灾害造成巨大人员伤亡和经济损失的事例发生.通过分析福建省1990～2006年热带气旋暴雨诱发的地质灾害个例,发现热带气旋暴雨型地质灾害的规模和强度均比雨季暴雨诱发的地质灾害大;它的发生与热带气旋路径、过程雨量和当日雨量关系密切,地质灾害主要发生在强降水后的48 h内;热带气旋登陆前后,若有偏东急流、西南季风、冷空气、暖式切变等系统共同作用,对暴雨具有增幅作用,极易引发地质灾害.     

20世纪长江的3次巨洪

分析了形成20世纪长江3次巨洪的3个遥相关因子：（1）太阳黑子活动;（2）厄尔尼诺事件,（3）青藏高原南部大震。依据长江巨洪和遥相关因子的基本事实,讨论了长江发生巨洪的统计规律。指出当3个因子的出现时间互相重叠时,长江很可能发生巨洪,这对长江巨洪的超长期预测具有重要的指导作用。     

TMA改性粘土矿物对模拟地下水中苯系物的吸附

用短链季铵盐阳离子表面活性剂四甲基铵离子（ＴＭＡ）改性膨润土和凹凸棒土,研究它们对模拟地下水中苯系物的吸附作用。二种ＴＭＡ改性粘土矿物均可以有效地吸附模拟地下水中的苯系物,吸附机理较复杂,主要以表面吸附为主。     

Modeling porosity reductions caused by mineral fouling in continuous-wall permeable reactive barriers

A study was conducted to assess key factors to include when modeling porosity reductions caused by mineral fouling in permeable reactive barriers (PRBs) containing granular zero valent iron. The public domain codes MODFLOW and RT3D were used and a geochemical algorithm was developed for RT3D to simulate geochemical reactions occurring in PRBs. Results of simulations conducted with the model show that the largest porosity reductions occur between the entrance and mid-plane of the PRB as a result of precipitation of carbonate minerals and that smaller porosity reductions occur between the mid-plane and exit face due to precipitation of ferrous hydroxide. These findings are consistent with field and laboratory observations, as well as modeling predictions made by others. Parametric studies were conducted to identify the most important variables to include in a model evaluating porosity reduction. These studies showed that three minerals (CaCO3, FeCO3, and Fe(OH)2 (am)) account for more than 99% of the porosity reductions that were predicted. The porosity reduction is sensitive to influent concentrations of HCO3-, Ca2+, CO3(2-), and dissolved oxygen, the anaerobic iron corrosion rate, and the rates of CaCO3 and FeCO3 formation. The predictions also show that porosity reductions in PRBs can be spatially variable and mineral forming ions penetrate deeper into the PRB as a result of flow heterogeneities, which reflects the balance between the rate of mass transport and geochemical reaction rates. Level of aquifer heterogeneity and the contrast in hydraulic conductivity between the aquifer and PRB are the most important hydraulic variables affecting porosity reduction. Spatial continuity of aquifer hydraulic conductivity is less significant.     

铜氰溶液的电子束辐照降解

研究了铜氰溶液中总氰初始浓度、pH、铜浓度等对总氰降解效率的影响,比较了KCN溶液和铜氰溶液的总氰降解率,初步推断了铜氰溶液在辐照过程中的降解机制.实验结果表明,在同样的辐照剂量下,随着总氰初始浓度的增加,总氰降解率降低,相应的总氰降解G值增大;铜浓度越低,总氰降解率越高;pH越小的铜氰溶液总氰降解率越高.电子束辐照KCN溶液和铜氰溶液的总氰降解反应属于表观一级反应.在相同的辐照剂量下,KCN溶液的总氰降解率比铜氰溶液要高得多.铜氰溶液的电子束辐照降解过程非常复杂,主要是铜氰络合离子逐步离解出的CN-与·OH的反应.     

负载型纳米TiO2光催化降解水中微量溶解性间二甲苯

以高压汞灯为光源 ,采用浸涂 -烧结法制备的负载型纳米TiO2 作为光催化剂 ,通过对水中微量溶解性间二甲苯的光催化氧化过程的研究表明 ,初始浓度在 6 .6 8— 17.36mg/L的范围内 ,间二甲苯的光催化反应遵循表观一级反应动力学规律 ,反应的表观速率常数随溶液初始浓度的增大而减小 ,半衰期则随初始浓度的增大而增加 ,经 1.5h反应后 ,溶液中间二甲苯的去除率从 17.36mg/L的 5 4 .4 4 %增加到 6 .6 8mg/L的 75 .90 %。     

炭纤维载体固定床厌氧发酵启动运行效果实验

以开发高效率、抗冲击性能强的高浓度有机废水沼气发酵技术为目的,用传统的 UASB反应器作为对照,研究了以炭纤维为生物膜载体的固定床厌氧反应器的启动运行效果。反应器进口废水 COD 为 5 000 mg/L, 水力停留时间 (HRT) 由213 h 逐步缩短为35 h,进水有机容积负荷(OLR)由0.56 kg COD/ (m³·d)提到3.45 kg COD/(m³·d)。结果表明,固定床反应器厌氧发酵的效率比对照高,出水 pH 值也比对照稳定;运行到第 50 d 时,固定床厌氧反应器和对照的 COD去除率分别由第 7 d 的36.56%和33.58%上升到87.9%和62.6%;固定床厌氧反应器的容积比产气率最高为1.16 m³/(m³·d),累计产气量为415.59 L,而对照的容积比产气率最高值仅为0.31 m³ /(m³·d),累计产气量为 71.66 L,前者最高容积比产气率和累计产气量分别是后者的3.74倍和5.78倍。固定床厌氧反应器的启动速度、COD 去除率和产甲烷效率显著地高于对照反应器。     

Improvements of nano-SiO2 on sludge/fly ash mortar

Sewage sludge ash has been widely applied to cementitious materials. In this study, in order to determine effects of nano-SiO(2) additives on properties of sludge/fly ash mortar, different amounts of nano-SiO(2) were added to sludge/fly ash mortar specimens to investigate their physical properties and micro-structures. A water-binding ratio of 0.7 was assigned to the mix. Substitution amounts of 0%, 10%, 20%, and 30% of sludge/fly ash (1:1 ratio) were proposed. Moreover, 0%, 1%, 2%, and 3% of nano-SiO(2) was added to the mix. Tests, including SEM and compressive strength, were carried out on mortar specimens cured at 3, 7, and 28 days. Results showed that sludge/fly ash can make the crystals of cement hydration product finer. Moreover, crystals increased after nano-SiO(2) was added. Hence, nano-SiO(2) can improve the effects of sludge/fly ash on the hydration of mortar. Further, due to the low pozzolanic reaction active index of sludge ash, early compressive strengths of sludge/fly ash mortar were decreased. Yet, nano-SiO(2) could help produce hydration crystals, which implies that the addition of nano-SiO(2) to mortar can improve the influence of sludge/fly ash on the development of the early strength of the mortar.     

Variations of metal distribution in sewage sludge composting

In the study, the variations of heavy metal distributions (of Cu, Mn, Pb, and Zn) during the sewage sludge composting process were investigated by sequential extraction procedures. The total content of Cu and Zn in the composted mixture increased after the composting process. Mn and Zn were mainly found in mobile fractions (exchangeable fraction (F1), carbonate fraction (F2), and Fe/Mn oxide fraction (F3)). Cu and Pb were strongly associated with the stable fractions (organic matter/sulfides fraction (F4) and residual fraction (F5)). These five metal fractions were used to calculate the metal mobility (bioavailability) in the sewage sludge and composted mixture. The mobility (bioavailability) of Mn, Pb, and Zn (but not Cu) increased during the composting process. The metal mobility in the composted mixture ranked in the following order: Mn>Zn>Pb>Cu.     

三种偶氮染料降解历程在紫外-可见光谱上的表现

本文对基本结构相似的三种偶氮染料橙黄Ⅱ、活性艳红Ｘ－３Ｂ和活性黑Ｋ－ＢＲ水溶液在铁粉还原－光氧化两步法处理中的紫外－可见光谱图作对比分析,依据其结构与特征吸收的关系,初步推测还原铁粉－光氧化法降解染料的历程。