Characteristics of atmospheric carbonyls and VOCs in Forest Park in South China

The diurnal variation of atmospheric carbonyls and VOCs in a forest in south China were studied in summer 2004. Twenty kinds of carbonyls and eight kinds of VOCs were identified and quantified. Formaldehyde and acetaldehyde were the two most abundant carbonyls, while the most abundant VOCs were isoprene, followed by o-xylene. Most C₃-C₁₀ carbonyls had higher concentrations from 09:00 to 15:00, and their levels were lower during night-time and often reached the lowest in early morning. Formaldehyde and acetaldehyde, however, showed two high levels in their diurnal patterns partly due to their different sources and sinks. The VOCs had different diurnal patterns compared to most carbonyls. The highest concentrations were observed from 03:00 to 06:00 for 1-butene, from 06:00 to 12:00 for isoprene, and from 12:00 to 15:00 for α-pinene. The highest levels for aromatic hydrocarbons occurred during midnight and the lowest in late afternoon. According to the study, emissions from vegetation and photo-oxidation of gas-phase hydrocarbons were the main sources for some carbonyls and VOCs in this region. Other compounds, such as formaldehyde, acetaldehyde and BTEX, showed anthropogenic sources.     

Status and habitat preferences for endemic inhabitants of fiddler crab Uca formosensis in Hsiang-Shan wetland, Taiwan

This article reports on soil samples collected from Hsiang-Shan wetland, Taiwan. Canonical discriminant analysis (CDA) was applied to identify an existing habitat type's scheme by identifying the physico-chemical properties of sediment in Hsiang-Shan wetland. The three constructed discriminant functions (CDFs) showed a marked contribution by most of the discriminant variables, and the recognition capacities in these three CDFs were 49.5, 32.8 and 17.7%. Our study revealed that the most important latent factors in Hsiang-Shan wetland are soil texture-caused factor, ocean current-caused factor, nutrient-caused factor, and the redox reaction-caused factor. And the most sensitivity parameters in this habitat followed the descending order: OBD, EC, Eh, sand, TN, porosity, STP, silt, VCP and pH. And the inhabited sediment properties for U. formosensis in terms of soil texture are sand, silt, and clay (34.05, 29.72, and 32.35%, respectively): that is clay loam soil. We also found that U. formosensis preferred to inhabit the upper intertidal zone, spending 8.41% of the time submerged. Vegetation coverage on the ground was less than 2.20%, showing that it preferred to live in a bare intertidal habitat. Concerning nest choosing, excavating burrows is more difficult when a high soil penetration force is required, and in this study the soil penetration force for 20 cm was found to be is 45.98 N/cm(2). The results will be helpful in developing a methodology for use by the government in refining its management programs.     

便携式GC/MS热脱附法直接测定环境空气中挥发性有机物

采用便携式气相色谱/质谱联用热脱附法直接测定环境空气中的挥发性有机物,优化了试验条件。方法在5×10-9~100×10-9范围内线性良好,39种化合物的检出限为1.1μg/m3~19μg/m3,标准气体平行测定的RSD≤11.0%,回收率在80%~120%之间。     

改性沸石分离富集-火焰原子吸收光谱法测定长江水中镉

采用改性沸石分离富集-火焰原子吸收光谱法测定长江水中微量镉,优化了富集和洗脱条件,讨论了干扰离子的影响。方法在0μg~4.00μg范围内线性良好,检出限为0.214μg/L,长江水平行测定的RSD为1.8%,加标回收率为99.0%~104%。     

Polycyclic aromatic hydrocarbons in surface sediments from drinking water sources of Taihu Lake, China: sources, partitioning and toxicological risk

Sources, partitioning and toxicological risk of 15 priority polycyclic aromatic hydrocarbons (PAHs) in surface sediments from drinking water sources of Taihu Lake, with an area of 2428 km(2) located in the most developed and populated area of China, were studied, and the results were compared with those in other lakes of China and the USA. Concentrations of the 15 PAHs in sediments ranged from 436.6 to 1334.9 ng g(-1) (dw). Gasoline combustion, coal combustion, diesel combustion from shipping and spillage of petroleum were apportioned to be the main sources of PAHs in this area by principal component analysis, which contributed 35.19%, 26.43%, 25.41% and 12.97% to the PAH sources estimated by further multiple linear regression. Levels of PAHs in sediments were negatively correlated with contents of clay and fine silt (<16 μm), while positively with contents of medium silt, coarse silt and sand (>16 μm). Humin with size larger than 16 μm contained the largest part of the burden of PAHs in sediments, but the specific partitioning domain (bound humic acid, lipid or insoluble residue) depended on properties of organic matter reflected by optical absorbance at 465 and 665 nm. Total toxic benzo[a]pyrene equivalent (TEQ(carc)) of the carcinogenic PAHs in sediments varied from 31.8 to 209.3 ngTEQ(carc) g(-1). Benzo[a]pyrene and dibenzo[a,h]anthracene contributed 45.36 and 25.31% to total TEQ(carc), posing high toxicological risk to this area.     

The backend design of an environmental monitoring system upon real-time prediction of groundwater level fluctuation under the hillslope

The groundwater level represents a critical factor to evaluate hillside landslides. A monitoring system upon the real-time prediction platform with online analytical functions is important to forecast the groundwater level due to instantaneously monitored data when the heavy precipitation raises the groundwater level under the hillslope and causes instability. This study is to design the backend of an environmental monitoring system with efficient algorithms for machine learning and knowledge bank for the groundwater level fluctuation prediction. A Web-based platform upon the model-view controller-based architecture is established with technology of Web services and engineering data warehouse to support online analytical process and feedback risk assessment parameters for real-time prediction. The proposed system incorporates models of hydrological computation, machine learning, Web services, and online prediction to satisfy varieties of risk assessment requirements and approaches of hazard prevention. The rainfall data monitored from the potential landslide area at Lu-Shan, Nantou and Li-Shan, Taichung, in Taiwan, are applied to examine the system design.     

Chemical forms and ecological risk of arsenic in the sediment of the Daliao River System in China

The chemical forms and ecological risk of As were characterized in the sediment of the Daliao River System (DRS), which has been affected by long-term intensive industrial, urban, and agricultural activities. Twenty-seven samples of surface sediment were collected and analyzed for total As content and that of its chemical forms. The results indicated that the average total As content in the sediment was 9.83 mg kg^− 1 but that the levels ranged from 1.57 to 83.09 mg kg^− 1. At the sites near cities, mining sites, and the estuary of the DRS, it is likely that adverse effects on aquatic organisms occur, due to As levels in the sediment that are often higher than the threshold effect level and occasionally higher than the probable effect level. A selectively sequential extraction indicated that the majority of As in the sediment was bound to Fe oxides (62.1%), with moderate proportions of residual As (19.8%), specifically adsorbed As (17.9%), and a low proportion of non-specifically adsorbed As (1.1%). In addition, the content of Fe in the sediment was positively and significantly correlated with the contents of amorphous and crystalline Fe oxide-bound As, confirming the crucial role of Fe oxides in immobilizing high amounts of As in superficial environments. The average molar ratio of As to Fe was 1.18 × 10^− 4 in the surface sediment of the DRS, similar to that of natural Fe oxides, but much lower than that of synthesized Schwertmannite. Therefore, the release of As under reduced and low pH conditions can cause serious problems for water resources and for living organisms.     

Characterizing hydrochemical properties of springs in Taiwan based on their geological origins

This study was performed to characterize hydrochemical properties of springs based on their geological origins in Taiwan. Stepwise discriminant analysis (DA) was used to establish a linear classification model of springs using hydrochemical parameters. Two hydrochemical datasets—ion concentrations and relative proportions of equivalents per liter of major ions—were included to perform prediction of the geological origins of springs. Analyzed results reveal that DA using relative proportions of equivalents per liter of major ions yields a 95.6% right assignation, which is superior to DA using ion concentrations. This result indicates that relative proportions of equivalents of major hydrochemical parameters in spring water are more highly associated with the geological origins than ion concentrations do. Low percentages of Na⁺ equivalents are common properties of springs emerging from acid-sulfate and neutral-sulfate igneous rock. Springs emerging from metamorphic rock show low percentages of Cl⁻ equivalents and high percentages of HCO₃^-_{3}^{-} equivalents, and springs emerging from sedimentary rock exhibit high Cl⁻/SO₄^2-_{4}^{2-} ratios.     

Estimation of phosphorus flux in rivers during flooding

Reservoirs in Taiwan are inundated with nutrients that result in algal growth, and thus also reservoir eutrophication. Controlling the phosphorus load has always been the most crucial issue for maintaining reservoir water quality. Numerous agricultural activities, especially the production of tea in riparian areas, are conducted in watersheds in Taiwan. Nutrients from such activities, including phosphorus, are typically flushed into rivers during flooding, when over 90 % of the yearly total amount of phosphorous enters reservoirs. Excessive or enhanced soil erosion from rainstorms can dramatically increase the river sediment load and the amount of particulate phosphorus flushed into rivers. When flow rates are high, particulate phosphorus is the dominant form of phosphorus, but sediment and discharge measurements are difficult during flooding, which makes estimating phosphorus flux in rivers difficult. This study determines total amounts of phosphorus transport by measuring flood discharge and phosphorous levels during flooding. Changes in particulate phosphorus, dissolved phosphorus, and their adsorption behavior during a 24-h period are analyzed owing to the fact that the time for particulate phosphorus adsorption and desorption approaching equilibrium is about 16 h. Erosion of the reservoir watershed was caused by adsorption and desorption of suspended solids in the river, a process which can be summarily described using the Lagmuir isotherm. A method for estimating the phosphorus flux in the Daiyujay Creek during Typhoon Bilis in 2006 is presented in this study. Both sediment and phosphorus are affected by the drastic discharge during flooding. Water quality data were collected during two flood events, flood in June 9, 2006 and Typhoon Bilis, to show the concentrations of suspended solids and total phosphorus during floods are much higher than normal stages. Therefore, the drastic changes of total phosphorus, particulate phosphorus, and dissolved phosphorus in rivers during flooding should be monitored to evaluate the loading of phosphorus more precisely. The results show that monitoring and controlling phosphorus transport during flooding can help prevent the eutrophication of a reservoir.     

Total petroleum hydrocarbon distribution in soils and groundwater in Songyuan oilfield, Northeast China

In order to investigate the distribution of the total petroleum hydrocarbons (TPH) in groundwater and soil, a total of 71 groundwater samples (26 unconfined groundwater samples, 37 confined groundwater samples, and 8 deeper confined groundwater samples) and 80 soil samples were collected in the Songyuan oilfield, Northeast China, and the vertical variation and spatial variability of TPH in groundwater and soil were assessed. For the groundwater from the unconfined aquifer, petroleum hydrocarbons were not detected in three samples, and for the other 23 samples, concentrations were in the range 0.01–1.74 mg/l. In the groundwater from the confined aquifer, petroleum hydrocarbons were not detected in two samples, and in the other 35 samples, the concentrations were 0.04–0.82 mg/l. The TPH concentration in unconfined aquifer may be influenced by polluted surface water and polluted soil; for confined aquifer, the injection wells leakage and left open hole wells may be mainly responsible for the pollution. For soils, the concentrations of TPH varied with sampling depth and were 0–15 cm (average concentration, 0.63 mg/g), >40–55 cm (average concentration, 0.36 mg/g), >100–115 cm (average concentration, 0.29 mg/g), and >500–515 cm (average concentration, 0.26 mg/g). The results showed that oil spillage and losses were possibly the main sources of TPH in soil. The consequences concluded here suggested that counter measures such as remediation and long-term monitoring should be commenced in the near future, and effective measures should be taken to assure that the oilfields area would not be a threat to human health.