Fenton试剂氧化苯酚过程中Fe（Ⅱ）浓度的变化

考察了Fenton试剂氧化降解苯酚过程中Fe(Ⅱ)浓度的变化,并通过实验探讨了其变化的原因.实验结果表明,在Fenton反应发生的第1 rain内,Fe(Ⅱ)浓度可降低到初始浓度的60%左右,随着反应的继续Fe(Ⅱ)浓度在大约20min降低到最小值,然后开始增大,说明了Fe(Ⅲ)还原作用的存在;Fenton试剂氧化降解苯酚的中间产物包括对苯二酚、邻苯二酚、间苯二酚和苯醌等,其中前三者能对Fe(Ⅲ)有效还原,是Fenton试剂氧化降解苯酚过程中Fe(Ⅲ)还原的主要途径之一.     

大型浮顶储罐雷击事故分析及防雷技术研究

通过对典型大型浮顶储罐雷击事故分析,总结了这些事故的共性问题。结合浮顶储罐雷击形式及雷电火花放电研究,分析了大型浮顶储罐雷击火灾事故的机理。岚山输油站在等电位连接、一次密封形式结构等方面进行技术改造,经过验证这些措施有效减少了大型浮顶储罐火灾事故的发生。     

A new process to improve short-chain fatty acids and bio-methane generation from waste activated sludge

As an important intermediate product, short-chain fatty acids(SCFAs) can be generated after hydrolysis and acidification from waste activated sludge, and then can be transformed to methane during anaerobic digestion process. In order to obtain more SCFA and methane,most studies in literatures were centered on enhancing the hydrolysis of sludge anaerobic digestion which was proved as un-efficient. Though the alkaline pretreatment in our previous study increased both the hydrolysis and acidification processes, it had a vast chemical cost which was considered uneconomical. In this paper, a low energy consumption pretreatment method, i.e. enhanced the whole three stages of the anaerobic fermentation processes at the same time, was reported, by which hydrolysis and acidification were both enhanced, and the SCFA and methane generation can be significantly improved with a small quantity of chemical input. Firstly, the effect of different pretreated temperatures and pretreatment time on sludge hydrolyzation was compared. It was found that sludge pretreated at 100°C for 60 min can achieve the maximal hydrolyzation. Further, effects of different initial p Hs on acidification of the thermal pretreated sludge were investigated and the highest SCFA was observed at initial p H 9.0with fermentation time of 6 d, the production of which was 348.63 mg COD/g VSS(6.8 times higher than the blank test) and the acetic acid was dominant acid. Then, the mechanisms for this new pretreatment significantly improving SCFA production were discussed. Finally,the effect of this low energy consumption pretreatment on methane generation was investigated.     

煤矸石的环境危害与综合利用途径

本文主要介绍了我国煤矸石的现状,分析了煤矸石对自然环境的危害。探讨了利用煤矸石的有效途径。     

Purification and molecular weight distribution of a key exopolysaccharide component of Bacillus megaterium TF10

Extracellular polymeric substances (EPS) are organic metabolic compounds excreted by microorganisms. They largely impact microbial aggregate structures and functions. Extracellular polysaccharides (EP) in EPS are responsible for the formation of microbial aggregates. In this work, we successfully separated and characterized EP from EPS of the bacterium Bacillus megaterium TF10. Extraction of EP from EPS was optimized using Sevag''s reagent. Chemical characteristics, functional groups, and molecular weight (MW) distribu-tion of EP were compared with the harvested EPS and soluble microbial products (SMP). We found that the polymers of lower MW and free proteins were successfully removed by Sevag''s reagent. The higher MW components of EPS were predominantly polysaccharides, while the polymers of lower MW tended to secrete to the supernatant and were described as SMP. A part of the proteins in the EP was polysaccharide-bonded. Our results can be further used in elucidating the complex flocculation mechanisms in which EP play a major role.     

聚丙烯酰胺对紫色土中磷素吸附特征的影响

通过等温吸附实验分别研究了特定磷质量浓度下系列PAM用量和系列磷质量浓度下特定PAM用量对磷素在土壤中吸附特征的影响.试验表明,土壤经过PAM处理后其对磷素的吸附性能发生了明显改变.施用PAM使紫色土磷的吸附量降低,PAM用量较低时,吸附量随PAM用量的增加而减少,并且在0.1%～0.5%PAM内两者之间达到极显著负相关.紫色土磷最大吸附量为277.8 靏穏-1 ,0.1%、0.2%、0.4%PAM处理后紫色土对磷的最大吸附量均降低,分别为263.28 靏穏-1、227.38 靏穏-1、212.88 靏穏-1,但吸附强度却没减弱,甚至得到加强.PAM通过改变土壤集结状态和表面性质对土壤磷慢速吸附阶段产生了显著影响,但对快吸附阶段无明显影响.     

Utilization of MSWI fly ash as partial cement or sand substitute with focus on cementing efficiency and health risk assessment

• Washed MSWI fly ash was used as partial cement or sand substitute. • Sand replacing is beneficial for strength, while cement replacement reduces strength. • Cementing efficiency factor and mortar pore structure explain the strength results. • Health risk assessment was conducted for MSWI fly ash blended cement mortar. • CR and HI contributed by different exposures and heavy metals were analyzed. The strength of cement substituted mortar decreases with the increase in fly ash amount, whereas the strength increases when the fly ash is blended as sand substitute. A mortar with highest strength (compressive strength= 30.2 Mpa; flexural strength= 7.0 Mpa) was obtained when the sand replacement ratio was 0.75%. The k value (cementing efficiency) of fly ash varied between 0.36 and 0.15 for the fly ash fraction in binder between 5% and 25%. The k values of fly ash used for sand replacement were all significantly above that used for cement substitution. The macropores assigned to the gaps between particles decreased when the fly ash was used as sand replacement, providing an explanation for the strength enhancement. The waste-extraction procedure (toxicity-sulphuric acid and nitric acid method (HJ/T 299-2007)) was used to evaluate metal leaching, indicating the reuse possibility of fly ash blended mortar. For the mortar with the mass ratio of fly ash to binder of 0.5%, the carcinogenic risks (CR) and non-carcinogenic hazard quotient (HQ) in sensitive scenario for blended mortar utilization were 9.66 × 10^-7 and 0.06, respectively; these results were both lower than the threshold values, showing an acceptable health risk. The CR (9.89 × 10^-5) and HQ (3.89) of the non-sensitive scenario for fly ash treatment exceeded the acceptable threshold values, indicating health risks to onsite workers. The main contributor to the carcinogenic and non-carcinogenic risk is Cr and Cd, respectively. The CR and HQ from inhalation was the main route of heavy metal exposure.     

基于臭氧-麸皮工艺深度处理煤制气废水的研究

以河南省某化工企业生产过程中煤制气废水为研究对象,通过絮凝、臭氧-麸皮协同催化氧化、A/O生化处理的组合工艺改善废水的可生化性,能显著降低煤制气废水中的污染物浓度,COD由2 800 mg/L降至46 mg/L,氨氮质量浓度降至2.1 mg/L,总酚去除率达到99%,整个流程简单易操作,不产生二次污染,且能实现麸皮的高价值利用,达到GB 8978—1996的一级排放标准。     

Escherichia coli inactivation by pressurized CO2 treatment methods at room temperature: Critical issues

This study aims to increase the inactivation efficiency of CO_2 against Escherichia coli under mild conditions to facilitate the application of pressurized CO_2 technology in water disinfection. Based on an aerating-cycling apparatus, three different treatment methods(continuous aeration, continuous reflux, and simultaneous aeration and reflux) were compared for the same temperature, pressure(0.3–0.7 MPa), initial concentration, and exposure time(25 min). The simultaneous aeration and reflux treatment(combined method) was shown to be the best method under optimum conditions, which were determined to be 0.7 MPa, room temperature, and an exposure time of 10 min. This treatment achieved 5.1-log reduction after 25 min of treatment at the pressure of 0.3 MPa and 5.73-log reduction after 10 min at 0.7 MPa. Log reductions of 4.4 and 5.0 occurred at the end of continuous aeration and continuous reflux treatments at 0.7 MPa, respectively.Scanning electron microscopy(SEM) images suggested that cells were ruptured after the simultaneous aeration and reflux treatment and the continuous reflux treatment. The increase of the solubilization rate of CO_2 due to intense hydraulic conditions led to a rapid inactivation effect. It was found that the reduction of intracellular p H caused by CO_2 led to a more lethal bactericidal effect.     

Pollution characteristics of ambient volatile organic compounds (VOCs) in the southeast coastal cities of China

With the rapid urbanization, the southeast coastal cities of China are facing increasing air pollution in the past decades. Large emissions of VOCs from vehicles and petrochemical factories have contributed greatly to the local air quality deterioration. Investigating the pollution characteristics of VOCs is of great significance to the environmental risk assessment and air quality improvement. Ambient VOC samples were collected simultaneously from nine coastal cities of southeast China using the Tedlar bags, and were subsequently preprocessed and analyzed using a cryogenic preconcentrator and a gas chromatography–mass spectrometry system, respectively. VOC compositions, spatial distributions, seasonal variations and ozone formation potentials (OPFs) were discussed. Results showed that methylene chloride, toluene, isopropyl alcohol and n-hexane were most abundant species, and oxygenated compounds, aromatics and halogenated hydrocarbons were most abundant chemical classes (62.5–95.6 % of TVOCs). Both industrial and vehicular exhausts might contribute greatly to the VOC emissions. The VOC levels in the southeast coastal cities of China were sufficiently high (e.g., 6.5 μg?m^?3 for benzene) to pose a health risk to local people. A more serious pollution state was found in the southern cities of the study region, while higher VOC levels were usually observed in winter. The B/T ratio (0.26?±?0.09) was lower than the typical ratio (ca. 0.6) for roadside samples, while the B/E (1.6–7.6) and T/E (7.2–26.8) ratios were higher than other cities around the world, which indicated a unique emission profile in the study region. Besides, analysis on ozone formation potentials (OFPs) indicated that toluene was the most important species in ozone production with the accountabilities for total OFPs of 22.6 to 59.6 %.