Real-Time Measurements of Jet Aircraft Engine Exhaust

Abstract

Particulate-phase exhaust properties from two different types of ground-based jet aircraft engines—high-thrust and turboshaft—were studied with real-time instruments on a portable pallet and additional time-integrated sampling devices. The real-time instruments successfully characterized rapidly changing particulate mass, light absorption, and polycyclic aromatic hydrocarbon (PAH) content. The integrated measurements included particulate-size distributions, PAH, and carbon concentrations for an entire test run (i.e., “run-integrated” measurements). In all cases, the particle-size distributions showed single modes peaking at 20–40nm diameter. Measurements of exhaust from high-thrust F404 engines showed relatively low-light absorption compared with exhaust from a turboshaft engine. Particulate-phase PAH measurements generally varied in phase with both net particulate mass and with light-absorbing particulate concentrations. Unexplained response behavior sometimes occurred with the real-time PAH analyzer, although on average the real-time and integrated PAH methods agreed within the same order of magnitude found in earlier investigations.     

A Monte-Carlo Simulation of the Ozone Attainment Process

A Monte-Carlo simulation of the approach to attainment of the National Ambient Air Quality Standard for ozone has been performed for the California Bay Area Air Quality Management District. Four compliance tests together with different design values are used in the simulation. The results show that the present compliance test requiring a zero-percent chance of violation and the design value represented by the fourth highest value in three years makes both the standard and the control requirement much more stringent than generally assumed. In fact, to attain the standard on a long-term basis would require annual means and annual second-highest values that are close to those of the rural background ozone. The simulation also shows that by taking into account the fluctuation of ozone concentrations in the compliance test, such as a t test, and by using a design value consistent with the test, a standard defined in terms of the three-year mean of the annual second-highest values not only is more consistent with the currently- perceived stringency of the present standard, but may also be attainable with a more reasonable control requirement.     

Ecotoxicity and biodegradability of antielectrostatic dicephalic cationic surfactants

Four series of dicephalic cationic surfactants, considered as new antielectrostatic agents have been investigated in order to establish their toxicity and biodegradability. Among them N,N-bis[3,3′-(dimethylamine)propyl]alkylamides, N,N-bis[3,3′-(dimethylamine)propyl]alkylamide dihydrochlorides, N,N-bis[3,3′-(trimethylammonio)propyl]alkylamide dibromides and N,N-bis[3,3′-(trimethylammonio)propyl]alkylamide dimethylsulphates with different hydrophobic chain length (n-C₉H₁₉ to n-C₁₅H₃₁) and type of counterion (chloride, bromide and methylsulfate) have been studied. The inhibitory effect against microorganisms has been examined using model gram-positive and gram-negative bacteria, and yeasts. None of the tested surfactants have shown antimicrobial activity against gram-negative bacteria (Escherichia coli, Pseudomonas putida) and yeasts (Saccharomyces cerevisiae, Rhodotorula glutinis) at a concentration below 1000 μg mL⁻¹, however some of them were moderately active against gram-positive bacteria (Staphylococcus aureus, Bacillus subtilis). The Microtox® test was successfully applied to measure EC₅₀ values of the studied dicephalic cationic surfactants. Their toxicity to Vibrio fischeri depended upon the alkanoyl chain length with the EC₅₀ values in a range of 2.6-980 mg L⁻¹. N,N-bis[3,3′-(dimethylamine)propyl]alkylamide dihydrochlorides 2a-b and N,N-bis[3,3′-(trimethylammonio)propyl]alkylamide dibromides 3a-b comprising n-decanoyl and n-dodecanoyl hydrophobic tails appeared to be the least toxic. Furthermore, the biodegradability under aerobic conditions of 2a-b, 3a-b was evaluated using OECD Method 301F. According to the obtained results 2a, 3a-3b can be considered as almost readily biodegradable and they are not expected to be persistent in the environment. Additionally, partial biodegradation was observed for 2b, indicating its possible biodegradation in wastewater treatment systems.     

Response of two terrestrial green microalgae (Chlorophyta, Trebouxiophyceae) isolated from Cu-rich and unpolluted soils to copper stress

Some algae inhabit Cu-polluted soils. Intracellular Cu-accumulation and production of non-protein thiols in response to copper stress were compared in Stichococcus minor and Geminella terricola isolated from Cu-polluted and unpolluted soils, respectively. Cu-exposed (0.5 μM) S. minor accumulated lower amounts of copper (0.38 mM) than G. terricola (4.20 mM) and maintained 8.5-fold higher level of glutathione (GSH) than G. terricola. The ratio GSH/0.5 GSSG in the Cu-treated S. minor (7.21) was 7-times higher than in G. terricola. Reduced and oxidized forms of phytochelatins were found in both algae. Under copper stress (5 μM) the ratio -SH_total/Cu_{intracellular} in S. minor ranged from 2.3 to 6.2, while it was lower than 1.0 in G. terricola. Low intracellular Cu-accumulation and maintenance of high GSH level concomitant with PCs production seem to be responsible for a higher Cu-resistance of S. minor than G. terricola.     

Kinetics of the tropospheric formaldehyde loss onto mineral dust and urban surfaces

The kinetics of the heterogeneous reaction between gaseous HCHO and TiO₂/SiO₂ mineral coatings were investigated using a coated-wall flow tube to mimic HCHO loss on mineral aerosol and TiO₂ coated depolluting urban surfaces. The measured uptake kinetics were strongly enhanced when the flow tube was irradiated with 340–420 nm UV light with an irradiance of 1.45 mW cm^?2. The associated BET uptake coefficients ranged from (3.00 ± 0.45) × 10^?9 to (2.26 ± 0.34) × 10^?6 and were strongly dependent on HCHO initial concentration, relative humidity, temperature, and TiO₂ content in the mineral coating, which ranged from 3.5 to 32.5 ppbv, 6–70%, 278–303 K, and 1–100 %wt, respectively. The measured kinetics were well described using a Langmuir–Hinshelwood type formalism. The estimated uptake coefficients were used to discuss the importance of heterogeneous HCHO surface loss, in terms of deposition lifetimes, as compared to major homogeneous gas-phase losses such as OH reaction and photolysis. It is found that deposition may compete with gas-phase removal of HCHO in a dense urban environment if more than 10% of the urban surface is covered with TiO₂ treated material.     

Correction methods for organic carbon artifacts when using quartz-fiber filters in large particulate matter monitoring networks: the regression method and other options

Sampling and handling artifacts can bias filter-based measurements of particulate organic carbon (OC). Several measurement-based methods for OC artifact reduction and/or estimation are currently used in research-grade field studies. OC frequently is not artifact-corrected in large routine sampling networks (e.g., U.S. Environmental Protection Agency (EPA)'s Chemical Speciation Network). In some cases, the OC artifact has been corrected using a regression method (RM) for artifact estimation. In this method, the gamma-intercept of the regression of the OC concentration on the fine particle (PM2.5) mass concentration is taken to be an estimate of the average OC sampling artifact (net of positive and negative artifacts). This paper discusses options for artifact correction in large routine sampling networks. Specifically, the goals are to (1) articulate the assumptions and limitations inherent to the RM, (2) describe other artifact correction approaches, and (3) suggest a cost-effective method for artifact correction in large monitoring networks. The RM assumes a linear relationship between measured OC and PM mass: a constant slope (OC mass fraction) and a constant intercept (RM artifact estimate). These assumptions are not always valid. Additionally, outliers and other individual data points can have a large influence on the RM artifact estimates. The RM yields results within the range of measurement-based methods for some datasets and not for others. Given that the adsorption of organic gases increases with atmospheric concentrations of organics, subtraction of an average artifact from all samples (e.g., across multiple sites) will underestimate OC for lower-concentration samples (e.g., clean sites) and overestimate OC for higher-concentration samples (e.g., polluted sites). For relatively accurate, simple, and cost-effective artifact OC estimation in large networks, the authors suggest backup filter sampling on at least 10% of sampling days at all sites with artifact correction on a sample-by-sample basis as described herein.     

Humic acid in ice: Photo-enhanced conversion of nitrogen dioxide into nitrous acid

Laboratory studies on the heterogeneous conversion of nitrogen dioxide into nitrous acid on irradiated ice films containing humic acid are described. It was found that the presence of light in the visible range of the solar spectrum significantly enhances the rate of nitrous acid release from a humic acid doped ice film. This process might contribute to observed HONO production in snow, where the NO₂ is thought to originate from nitrate photolysis. Analysis of the experimental data based on the Langmuir Hinshelwood model framework allowed quantification of the observed dependencies of the nitrous acid production rate on nitrogen dioxide concentration. The observed dependencies on the humic acid concentration as well as on the irradiation intensity were used to estimate light-driven HONO fluxes for environmental snow covers.     

Increasing seat belt use through PI&E and enforcement: The Thumbs Up campaign

Campaigns to increase seat belt use have been effective in controlled environments, in small geographic areas, in primary enforcement states, and when conducted in conjunction with the enactment of seat belt legislation. The Thumbs Up project was undertaken to determine if belt use could be facilitated in less advantageous conditions. A 3-month campaign to increase seat belt use was conducted in two sites, each consisting of two Florida counties. At its conclusion, the Thumbs Up project did not yield an overall increase in seat belt use across the two sites. However, observed seat belt use and the number of seat belt citations issued increased significantly in one site. The results are discussed in terms of the two components necessary for a successful campaign: public information and education, and enforcement. Further, recommendations for conducting successful community-based seat belt interventions are offered.     

ASSESSMENT OF POSSIBLE IMPACTS OF CLIMATE CHANGE IN AN URBAN CATCHMENT1

ABSTRACT: Stationarity of rainfall statistical parameters is a fundamental assumption in hydraulic infrastructure design that may not be valid in an era of changing climate. This study develops a framework for examining the potential impacts of future increases in short duration rainfall intensity on urban infrastructure and natural ecosystems of small watersheds and demonstrates this approach for the Mission/Wagg Creek watershed in British Columbia, Canada. Nonstationarities in rainfall records are first analyzed with linear regression analysis, and the detected trends are extrapolated to build potential future rainfall scenarios. The Storm Water Management Model (SWMM) is used to analyze the effects of increased rainfall intensity on design peak flows and to assess future drainage infrastructure capacity according to the derived scenarios. While the framework provided herein may be modified for cases in which more complex distributions for rainfall intensity are needed and more sophisticated stormwater management models are available, linear regressions and SWMM are commonly used in practice and are applicable for the Mission/Wagg Creek watershed. Potential future impacts on stream health are assessed using methods based on equivalent total impervious area. In terms of impacts on the drainage infrastructure, the results of this study indicate that increases in short duration rainfall intensity may be expected in the future but that they would not create severe impacts in the Mission/Wagg Creek system. The equivalent levels of imperviousness, however, suggest that the impacts on stream health could be far more damaging.     

Potential and Shortcomings of Numerical Weather Prediction Models in Providing Meteorological Data for Urban Air Pollution Forecasting

The last decade progress in numericalweather prediction (NWP) modelling and studies of urbanatmospheric processes for providing meteorological data forurban air pollution forecasting is analysed on examples ofseveral European meteorological centres. Modern nested NWP models are utilising land-use databasesdown to 1 km resolution or finer, and are approaching thenecessary horizontal and vertical resolution suitable forcity scale. The recent scientific developments in the fieldof urban atmospheric physics and the growing availabilityof high-resolution urban surface characteristics datapromise further improvements of the capability of NWPmodels for this aim. A strategy to improve NWP data forthe urban air pollution forecasting is suggested.