A large-scale fumigation system for investigating interactions between air pollution and cold stress on plants

A new large-scale closed chamber fumigation system with cooling facilities is described for studying effects of low concentrations of SO(2), NO(2) and O(3) and low temperatures on woody species and herbaceous plants. The system is based on modified hemispherical greenhouses with a forced air ventilation system. This provides a chamber environment with low spatial variability of pollutant gas concentrations and rapid air circulation which allows exposure of plants at near ambient temperatures and relative humidity. Large capacity cooling units come into operation when ambient temperatures fall below 0 degrees C, and these allow chamber temperatures to be lowered by an additional 4 to 8 degrees C in experiments designed to test whether exposure to pollutants enhances the frost sensitivity of plants.     

Convergent validity between willingness to pay elicitation methods: an application to Grand Canyon whitewater boaters

We directly compare trip willingness to pay (WTP) values between dichotomous choice contingent valuation (DCCV) and discrete choice experiment (DCE) stated preference surveys of private party Grand Canyon whitewater boaters. The consistency of DCCV and DCE estimates is debated in the literature, and this study contributes to the body of work comparing the methods. Comparisons were made of mean WTP estimates for four hypothetical Colorado River flow-level scenarios. Boaters were found to most highly value mid-range flows, with very low and very high flows eliciting lower WTP estimates across both DCE and DCCV surveys. Mean WTP precision was estimated through simulation. No statistically significant differences were detected between the two methods at three of the four hypothetical flow levels.     

Quantifying the relative irreplaceability of important bird and biodiversity areas

World governments have committed to increase the global protected areas coverage by 2020, but the effectiveness of this commitment for protecting biodiversity depends on where new protected areas are located. Threshold‐ and complementarity‐based approaches have been independently used to identify important sites for biodiversity. We brought together these approaches by performing a complementarity‐based analysis of irreplaceability in important bird and biodiversity areas (IBAs), which are sites identified using a threshold‐based approach. We determined whether irreplaceability values are higher inside than outside IBAs and whether any observed difference depends on known characteristics of the IBAs. We focused on 3 regions with comprehensive IBA inventories and bird distribution atlases: Australia, southern Africa, and Europe. Irreplaceability values were significantly higher inside than outside IBAs, although differences were much smaller in Europe than elsewhere. Higher irreplaceability values in IBAs were associated with the presence and number of restricted‐range species; number of criteria under which the site was identified; and mean geographic range size of the species for which the site was identified (trigger species). In addition, IBAs were characterized by higher irreplaceability values when using proportional species representation targets, rather than fixed targets. There were broadly comparable results when measuring irreplaceability for trigger species and when considering all bird species, which indicates a good surrogacy effect of the former. Recently, the International Union for Conservation of Nature has convened a consultation to consolidate global standards for the identification of key biodiversity areas (KBAs), building from existing approaches such as IBAs. Our results informed this consultation, and in particular a proposed irreplaceability criterion that will allow the new KBA standard to draw on the strengths of both threshold‐ and complementarity‐based approaches.     

Modelling pesticide volatilization after soil application using the mechanistic model Volt'Air

Volatilization of pesticides participates in atmospheric contamination and affects environmental ecosystems including human welfare. Modelling at relevant time and spatial scales is needed to better understand the complex processes involved in pesticide volatilization. Volt'Air-Pesticides has been developed following a two-step procedure to study pesticide volatilization at the field scale and at a quarter time step. Firstly, Volt'Air-NH₃ was adapted by extending the initial transfer of solutes to pesticides and by adding specific calculations for physico-chemical equilibriums as well as for the degradation of pesticides in soil. Secondly, the model was evaluated in terms of 3 pesticides applied on bare soil (atrazine, alachlor, and trifluralin) which display a wide range of volatilization rates. A sensitivity analysis confirmed the relevance of tuning to K_h. Then, using Volt'Air-Pesticides, environmental conditions and emission fluxes of the pesticides were compared to fluxes measured under 2 environmental conditions. The model fairly well described water temporal dynamics, soil surface temperature, and energy budget. Overall, Volt'Air-Pesticides estimates of the order of magnitude of the volatilization flux of all three compounds were in good agreement with the field measurements. The model also satisfactorily simulated the decrease in the volatilization rate of the three pesticides during night-time as well as the decrease in the soil surface residue of trifluralin before and after incorporation. However, the timing of the maximum flux rate during the day was not correctly described, thought to be linked to an increased adsorption under dry soil conditions. Thanks to Volt'Air's capacity to deal with pedo-climatic conditions, several existing parameterizations describing adsorption as a function of soil water content could be tested. However, this point requires further investigation. Practically speaking, Volt'Air-Pesticides can be a useful tool to make decision about agricultural practices such as incorporation or for the estimation of overall pesticide volatilization rates, and it holds promise for time specific dynamics.     

Rice straw ash extract, an efficient solvent for regioselective hydrothiolation of alkynes

Environmental Chemistry Letters - Herein, we describe a simple and inexpensive protocol for the hydrothiolation of alkynes. In this context, water extract of rice straw ash (WERSA) has been proven...     

Putting the ‘E’ into LSPs: Representing the Environment within Local Strategic Partnerships (LSPs) in the UK

Abstract

This article reports the findings of a qualitative study with residents living in six deprived neighbourhoods in the UK and the front-line workers and local policymakers responsible for the renewal of these areas. The study was an attempt to raise awareness of local environmental concerns in the context of a national and local policy agenda, which has, until recently, largely overlooked the impacts of degraded environments on the lives and activities of the people who live in them. A key aim for the study was to raise people's concerns with local decision-makers and examine how far these might be addressed through the existing financial, administrative and legislative arrangements for neighbourhood renewal in the UK, namely Local Strategic Partnerships. The research was designed to provide practical lessons and policy recommendations for others wishing to raise the profile of environmental justice in the context of neighbourhood level regeneration projects, in both the UK and elsewhere in the ‘developed’ world.     

Evaluation of combustion by-products of MTBE as a component of reformulated gasoline

Methyl tertiary-butyl ether (MTBE) is a gasoline oxygenate that is widely used throughout the US and Europe as an octane-booster and as a means of reducing automotive carbon monoxide (CO) emissions. The combustion by-products of pure MTBE have been evaluated in previous laboratory studies, but little attention has been paid to the combustion by-products of MTBE as a component of gasoline. MTBE is often used in reformulated gasoline (RFG), which has chemical and physical characteristics distinct from conventional gasoline. The formation of MTBE by-products in RFG is not well-understood, especially under "worst-case" vehicle emission scenarios such as fuel-rich operations, cold-starts or malfunctioning emission control systems, conditions which have not been studied extensively. Engine-out automotive dynamometer studies have compared RFG with MTBE to non-oxygenated RFG. Their findings suggest that adding MTBE to reformulated gasoline does not impact the high temperature flame chemistry in cylinder combustion processes. Comparison of tailpipe and exhaust emission studies indicate that reactions in the catalytic converter are quite effective in destroying most hydrocarbon MTBE by-product species. Since important reaction by-products are formed in the post-flame region, understanding changes in this region will contribute to the understanding of fuel-related changes in emissions.