NITRATE CONTAMINATION IN OREGON WELL WATER: GEOLOGIC VARIABILITY AND THE PUBLIC'S PERCEPTION1

ABSTRACT: Approximately 4.5 million people in the United States who rely on well water are exposed to nitrate‐N concentrations exceeding the 10 mg/l standard. In this study in the Southern Willamette Valley in Oregon we reassessed nitrate‐N in rural wells sampled in 2000–2001, compared nitrate‐N concentrations among geological units, and surveyed residents about their perceptions of well water quality. Nitrate‐N concentrations were again sampled in 2002 and found to have increased significantly from the previous period. With rapid population growth in the area, the potential health risk in drinking well water that exceeds 10 mg/l nitrate‐N warrants continued public education. Nitrate‐N concentrations were found to be higher in the Holocene alluvium of the Willamette River and the Pleistocene sand and gravel post‐Missoula Flood deposits. Researchers conducting future studies may choose to stratify and monitor wells by geologic unit and by other parameters that estimate input of nutrients to the environment. Opinions differed between agricultural landowners and nonagricultural landowners with regard to the impact that agricultural fertilizers may have on water quality. Participants were supportive of a range of regulatory actions that might be used by homeowners or landowners to address ground water contamination. Given that the area is now designated a Groundwater Management Area, understanding local stakeholders’perceptions is critical and strategic and has the potential to help public agencies manage potential conflicts of opinion among stakeholders, build consensus, and help guide the approach to restoring ground water quality.     

Effects of calibration on L-THIA GIS runoff and pollutant estimation

Urbanization can result in alteration of a watershed's hydrologic response and water quality. To simulate hydrologic and water quality impacts of land use changes, the Long-Term Hydrologic Impact Assessment (L-THIA) system has been used. The L-THIA system estimates pollutant loading based on direct runoff quantity and land use based pollutant coefficients. The accurate estimation of direct runoff is important in assessing water quality impacts of land use changes. An automated program was developed to calibrate the L-THIA model using the millions of curve number (CN) combinations associated with land uses and hydrologic soil groups. L-THIA calibration for the Little Eagle Creek (LEC) watershed near Indianapolis, Indiana was performed using land use data for 1991 and daily rainfall data for six months of 1991 (January 1-June 30) to minimize errors associated with use of different temporal land use data and rainfall data. For the calibration period, the Nash-Sutcliffe coefficient was 0.60 for estimated and observed direct runoff. The calibrated CN values were used for validation of the model for the same year (July 1-December 31), and the Nash-Sutcliffe coefficient was 0.60 for estimated and observed direct runoff. The Nash-Sutcliffe coefficient was 0.52 for January 1, 1991 to December 31, 1991 using uncalibrated CN values. As shown in this study, the use of better input parameters for the L-THIA model can improve accuracy. The effects on direct runoff and pollutant estimation of the calibrated CN values in the L-THIA model were investigated for the LEC. Following calibration, the estimated average annual direct runoff for the LEC watershed increased by 34%, total nitrogen by 24%, total phosphorus by 22%, and total lead by 43%. This study demonstrates that the L-THIA model should be calibrated and validated prior to application in a particular watershed to more accurately assess the effects of land use changes on hydrology and water quality.     

Visitor-induced changes in the chemical composition of soils in backcountry areas of Mt Robson Provincial Park, British Columbia, Canada

Balancing recreation and conservation is an important issue in Canada's parks and protected areas. Increased levels of visitation to parks, especially to backcountry areas, create undue pressure on natural resources, resulting in a variety of ecological impacts. This paper illustrates the issue of visitor-induced changes on the chemical composition of soils in Mt Robson Provincial Park, British Columbia. Soil samples were collected from dish wash stations and fire pits (disturbed sites) at seven campgrounds located along two popular backcountry trails, and were compared to samples obtained from adjacent undisturbed control sites. Analysis of soil samples suggest that the lower amounts of aluminum, potassium, magnesium and sodium in many of the 'disturbed' samples can be related to intense leaching in dish wash stations, and can be attributed to frequent disposal of waste water from washing and cooking activities. Soils in wash stations generally had higher phosphorus, copper and zinc contents as compared to controls. Soils in fire pits were elevated in copper, relative to controls. Results of this study support park regulations that waste water disposal and camp fires be restricted to designated areas. Informing the public of scientific studies helps them understand the consequences of their activities; this may help persuade them to observe park rules and regulations.     

Managing disposal of water produced with petroleum in Kuwait

Disposal of water produced with petroleum has been of great interest in Kuwait for the last 20 years. The current problem arose when the Burgan oil field, which is the second largest field in the world, experienced successive increases in the water content of the produced oil. This study introduces a decision-making analysis of the considered alternatives for the disposal of the produced water. Four alternative solutions exist for the industry as practical solutions for the disposal of water produced in Kuwait. The first method utilizes a large number of pits to discharge water. The second alternative depends on discharging water into sealed pits. The third approach to dispose water is by injecting the water underground. The last method is similar to the previous one, but takes into consideration the recovery of reservoir pressure to maintain the rate of oil production. A questionnaire was distributed to 48 experts at the top management level of the petroleum companies and the governmental authority. The data collected considered cost, efficiency, and environmental parameters. Based on the data, a statistical analysis was conducted using the factor analysis method to reduce the number of investigated variables. The analysis concluded that the optimal solution is to use the effluent injection method to discharge water produced with oil in Burgan and similar fields in Kuwait.     

Recycling of an industrial sludge and marine clay as light-weight aggregates

The geographical limitations of Singapore, its restricted natural resources and voluminous municipal and industrial waste streams, make environmental management a major challenge for the island state. In an attempt to find ways to reduce importation of raw materials and the waste sent to landfill, light weight aggregates were produced from marine clay and a CaF(2)-rich semiconductor industry sludge. Aggregates were produced in a bench-scale rotary kiln with three clay/sludge loadings (90/10, 70/30 and 50/50%). All three mixtures showed good bloating behavior during firing and the ceramic pellets (1-1.5cm diameter) had densities well below that required for light-weight aggregates. In the initial tests, the pore sizes of the aggregates were in general too large resulting in high water absorption. Comparisons between the composition of the two waste products and the aggregates showed a significant loss of fluorine (40-60%) during processing; a problem which may require flue gas treatment. Leach testing showed that the formed aggregates would not pose a human or environmental hazard in terms of fluorine mobilization.     

Sympatric sexual signal divergence among North American Calopteryx damselflies is correlated with increased intra- and interspecific male–male aggression

Divergence of sexual signals in sympatry can arise as a consequence of (1) interspecific competition for resources, (2) selection against maladaptive hybridization, or (3) as a result of selection to reduce the cost of interspecific aggression; termed agonistic character displacement (ACD). Calopterygid damselflies have emerged as a model system for studying the evolution of divergent sexual signals due to the repeated evolution of sympatric species pairs with fully and partially melanized wings. Damselfly wing patterns function during both courtship and territory defense. However, the relative contributions of natural and sexual selection to phenotypic divergence and enhanced isolation in sympatry remain unclear in many cases. Here, we investigated the hypothesis that interference competition, in the form of increased interspecific male–male aggression, drives the evolution of character displacement in sympatry between two species of North American damselflies, Calopteryx aequabilis and Calopteryx maculata, that show no evidence of ecological divergence or ongoing hybridization. In paired behavioral trials, we found that interspecific male aggression related to territory defense varied between site, species, and as a function of the relative abundance of con- vs. hetero-specific males. Specifically, we found that large-spotted C. aequabilis males received increased intra- and interspecific aggression but that aggression against large-spotted males declined during the middle of the flight season when both species were equally abundant. Based on these results, we suggest that ACD leads to enhanced species recognition, and may be a common outcome of the antagonism between interspecific male–male competition and the countervailing force of intraspecific sexual selection favoring increased wing melanization among territorial damselfly species.     

Integrating Top-Down with Bottom-Up Conservation Policy in Africa

Abstract:  Developed nations intervened in conservation policy across Africa during the 20th century to address needs to protect species and biodiversity that were based on their own perceptions and priorities. In the 21st century, conservationists in Africa have revised these perceptions and begun the process of identifying conservation priorities from an African perspective and in consideration of Africans' priorities. Although foreign conservation interveners struggled to identify mechanisms to which local people would respond, African conservationists are now demonstrating how to integrate the continent's unique socioeconomic circumstances into efforts to protect biodiversity. In Africa effective conservation policy must include the generation of wealth, reduction of disease and hunger, and support of traditional land-use practices.     

Modelling plant species richness using functional groups

Conservation biologists increasingly rely on spatial predictive models of biodiversity to support decision-making. Therefore, highly accurate and ecologically meaningful models are required at relatively broad spatial scales. While statistical techniques have been optimized to improve model accuracy, less focus has been given to the question: How does the autecology of a single species affect model quality? We compare a direct modelling approach versus a cumulative modelling approach for predicting plant species richness, where the latter gives more weight to the ecology of functional species groups. In the direct modelling approach, species richness is predicted by a single model calibrated for all species. In the cumulative modelling approach, the species were partitioned into functional groups, with each group calibrated separately and species richness of each group was cumulated to predict total species richness. We hypothesized that model accuracy depends on the ecology of individual species and that the cumulative modelling approach would predict species richness more accurately. The predictors explained plant species richness by ca. 25%. However, depending on the functional group the deviance explained varied from 3 to 67%. While both modelling approaches performed equally well, the models of the different functional groups highly varied in their quality and their spatial richness pattern. This variability helps to improve our understanding on how plant functional groups respond to ecological gradients.     

Development of an analytical method for analysis of flubendiamide,des-iodo flubendiamide and study of their residue persistence in tomato and soil

Flubendiamide is a new insecticide that has been found to give excellent control of lepidopterous pests of tomato. This study has been undertaken to develop an improved method for analysis of flubendiamide and its metabolite des-iodo flubendiamide and determine residue retention in tomato and soil. The analytical method developed involved extraction of flubendiamide and its metabolite des-iodo flubendiamide with acetonitrile, liquid-liquid partitioning into hexane-ethyl acetate mixture (6:4, v v^?1) and cleanup with activated neutral alumina. Finally the residues were dissolved in gradient high pressure liquid chromatography (HPLC) grade acetonitrile for analysis by HPLC. The mobile phase, acetonitrile-water at 60:40 (v v^?1) proportion and the wavelength of 235 nm gave maximum peak resolution. Using the above method and HPLC parameters described, nearly 100 % recovery of both insecticides were obtained. There was no matrix interference and the limit of quantification (LOQ) of the method was 0.01 mg kg^?1. Initial residue deposits of flubendiamide on field-treated tomato from treatments @ 48 and 96 g active ingredient hectare^?1 were 0.83 and 1.68 mg kg^?1,respectively. The residues of flubendiamide dissipated at the half-life of 3.9 and 4.4 days from treatments @ 48 and 96 g a.i. ha^?1, respectively and persisted for 15 days from both the treatments. Des-iodo flubendiamide was not detected in tomato fruits at any time during the study period. Residues of flubendiamide and des-iodo flubendiamide in soil from treatment @ 48 and 96 g a.i. ha^?1 were below detectable level (BDL, < 0.01 mg kg^?1) after 20 days. Flubendiamide completely dissipated from tomato within 20 days when the 480 SC formulation was applied at doses recommended for protection against lepidopterous pests.