Matrix effect on the performance of headspace solid phase microextraction method for the analysis of target volatile organic compounds (VOCs) in environmental samples

Solid phase microextraction (SPME) is a fast, cheap and solvent free methodology widely used for environmental analysis. A SPME methodology has been optimized for the analysis of VOCs in a range of matrices covering different soils of varying textures, organic matrices from manures and composts from different origins, and biochars. The performance of the technique was compared for the different matrices spiked with a multicomponent VOC mixture, selected to cover different VOC groups of environmental relevance (ketone, terpene, alcohol, aliphatic hydrocarbons and alkylbenzenes). VOC recovery was dependent on the nature itself of the VOC and the matrix characteristics. The SPME analysis of non-polar compounds, such as alkylbenzenes, terpenes and aliphatic hydrocarbons, was markedly affected by the type of matrix as a consequence of the competition for the adsorption sites in the SPME fiber. These non-polar compounds were strongly retained in the biochar surfaces limiting the use of SPME for this type of matrices. However, this adsorption capacity was not evident when biochar had undergone a weathering/aging process through composting. Polar compounds (alcohol and ketone) showed a similar behavior in all matrices, as a consequence of the hydrophilic characteristics, affected by water content in the matrix. SPME showed a good performance for soils and organic matrices especially for non-polar compounds, achieving a limit of detection (LD) and limit of quantification (LQ) of 0.02 and 0.03 ng g⁻¹ for non-polar compounds and poor extraction for more hydrophilic and polar compounds (LD and LQ higher 310 and 490 ng g⁻¹). The characteristics of the matrix, especially pH and organic matter, had a marked impact on SPME, due to the competition of the analytes for active sites in the fiber, but VOC biodegradation should not be discarded in matrices with active microbial biomass.     

Analyzing the cost effectiveness of Santiago, Chile's policy of using urban forests to improve air quality

Santiago, Chile has the distinction of having among the worst urban air pollution problems in Latin America. As part of an atmospheric pollution reduction plan, the Santiago Regional Metropolitan government defined an environmental policy goal of using urban forests to remove particulate matter less than 10 microm (PM(10)) in the Gran Santiago area. We used cost effectiveness, or the process of establishing costs and selecting least cost alternatives for obtaining a defined policy goal of PM(10) removal, to analyze this policy goal. For this study, we quantified PM(10) removal by Santiago's urban forests based on socioeconomic strata and using field and real-time pollution and climate data via a dry deposition urban forest effects model. Municipal urban forest management costs were estimated using management cost surveys and Chilean Ministry of Planning and Cooperation documents. Results indicate that managing municipal urban forests (trees, shrubs, and grass whose management is under the jurisdiction of Santiago's 36 municipalities) to remove PM(10) was a cost-effective policy for abating PM(10) based on criteria set by the World Bank. In addition, we compared the cost effectiveness of managing municipal urban forests and street trees to other control policies (e.g. alternative fuels) to abate PM(10) in Santiago and determined that municipal urban forest management efficiency was similar to these other air quality improvement measures.     

Multiscale analysis of heavy metal contents in Spanish agricultural topsoils

This study characterized and mapped the spatial variability patterns of seven topsoil heavy metals (Cr, Ni, Pb, Cu, Zn, Hg and Cd) within the Ebro river basin (9.3 million ha) by Multivariate Factorial Kriging. The variograms and cross-variograms of heavy metal concentrations showed the presence of multiscale variation that was modeled using three variogram models with ranges of 20km (short-range), 100km (medium-range) and 225km (long-range). Our results indicate that the heavy metal concentration is influenced by bedrock composition and dynamics at all the spatial scales, while human activities have a notorious effect only at the short- and medium-range scale of variation. Sources of Cu, Pb and Zn (and secondary Cd) are associated with agricultural practices (at the short-range scale of variation), whereas Hg variation at the short- and medium-range scale of variation is related to atmospheric deposition.     

Traffic and catalytic converter - related atmospheric contamination in the metropolitan region of the city of Rio de Janeiro, Brazil

In this work, 24-h PM10 samples were collected in Rio de Janeiro, Brazil, and analysed for trace elements (Cd, Ce, Cu, La, Mo, Ni, Pb, Pd, Rh, Sb and Sn). The sampling was carried out at five locations (Bonsucesso; Centro, downtown city; Copacabana; Nova Igua?u and Sumaré) with different traffic densities and anthropogenic activities. An analytical method based on the EPA method for the determination of trace elements in airborne particulate matter (PM), using ultrasonic-assisted extraction and inductively coupled plasma mass spectrometry (ICP-MS) was applied. Our results suggest that vehicular traffic is the most important source of environmental pollution at the studied sites. The presence of Mo, Pd and Rh in the analysed filters reflects an additional source of pollution caused by the erosion and deterioration of automotive catalytic converters.     

Coupled solar photo-Fenton and biological treatment for the degradation of diuron and linuron herbicides at pilot scale

A coupled solar photo-Fenton (chemical) and biological treatment has been used to remove biorecalcitrant diuron (42 mg l(-1)) and linuron (75 mg l(-1)) herbicides from water at pilot plant scale. The chemical process has been carried out in a 82 l solar pilot plant made up by four compound parabolic collector units, and it was followed by a biological treatment performed in a 40 l sequencing batch reactor. Two Fe(II) doses (2 and 5 mg l(-1)) and sequential additions of H2O2 (20 mg l(-1)) have been used to chemically degrade the initially polluted effluent. Next, biodegradability at different oxidation states has been assessed by means of BOD/COD ratio. A reagent dose of Fe=5 mg l(-1) and H2O2=100 mg l(-1) has been required to obtain a biodegradable effluent after 100 min of irradiation time. Finally, the organic content of the photo-treated solution has been completely assimilated by a biomass consortium in the sequencing batch reactor using a total suspended solids concentration of 0.2 g l(-1) and a hydraulic retention time of 24h. Comparison between the data obtained at pilot plant scale (specially the one corresponding to the chemical step) and previously published data from a similar system performing at laboratory scale, has been carried out.     

Use of electrochemical technology to increase the quality of the effluents of bio-oxidation processes. A case studied

In this work, it has been studied the use of conductive-diamond electrochemical oxidation (CDEO) as a refining technology to assure the quality of the effluents of door manufacturing processes (DMP). To do this, the raw effluents of these factories have been treated by a combination of physicochemical, biological and CDEO treatments. CDEO was found to be a feasible alternative to the refinement of a wooden DMP waste. It can successfully decrease the organic load of the effluents of the biological oxidation with low energy requirements. In addition, in case of incidents in the biological process, CDEO can treat successfully the effluents of the coagulation process. The effluents of the biological treatment have also been treated by CDEO in order to check the possible use of electrochemical technology to increase the biodegradability of the effluents and their possible recycle to the biological treatment. Unfortunately, electrochemical technology was found to be not adequate to increase the biodegradability of the effluents of a biological treatment. The hard oxidation conditions generated during CDEO do not lead to the accumulation of intermediates but to the almost direct formation of carbon dioxide. Lowering the current density or changing the electrodes can not enhance the biodegradability of the effluents of an electrochemical cell.     

Analysis of land suitability for the siting of inter-municipal landfills in the Cuitzeo Lake Basin, Mexico

This paper presents three spatial decision-support models (Boolean logic, binary evidence and overlapping index of multiple class maps) to perform a land suitability analysis for sanitary landfill siting. The study was carried out in the basin of Lake Cuitzeo, Mexico, with the objective of locating areas that comply with environmental regulations and with the inter-municipality criterion, i.e., that are accessible by at least two municipalities. Biophysical and socio-economic data were processed in a Geographic Information System (GIS). The three models differ in their complexity and restrictiveness. The Boolean logic model is easier to apply and more restrictive than the other two, because it is based on the assessment of single attributes. On the other hand, the binary data and overlapping index methods are relatively more complex because they require attribute weighting. The results showed that 23 of the 28 municipalities included in the basin have at least one area that was classified as highly suitable. The most suitable areas covered from 63.8 to 204.5 km(2) (from 1.5% to 5%), and they are not distributed homogeneously, but clustered around four main sites. The larger and most suitable of these sites is located in the central part of the basin, and it can be accessed by five of the most densely populated municipalities. The proposed approach represents a low-cost alternative to support a common spatial decision-making process in developing countries.     

The Bias of Complementarity Hotspots toward Marginal Populations

Abstract: It has been suggested that using complementarity to identify networks of important areas for conserving biodiversity may preferentially select areas within the margins of species ranges. We tested this idea by examining the location of complementarity hotspots in relation to two measures of range core-periphery. The first measures patterns of aggregation among records within each species' range to identify areas within the core (i.e., areas with aggregated distributions) and periphery (i.e., areas with scattered distributions) of the range. The second measures spatial turnover among species to identify areas with a high density of range edges. For three selected groups of terrestrial vertebrates in Europe—mammals, birds, and herptiles—areas chosen based on complementarity were located within the margins of species' ranges more often than expected by chance. This pattern was consistent for the two measures of core-periphery we used. The bias of complementarity hotspots toward marginal populations is especially important for species with restricted range sizes. If extinctions are determined mainly by demographic factors, then selecting areas at the peripheries of species' ranges might be a poor option. But if extinctions are determined mainly by extrinsic factors, then peripheral populations might be important to ensure the long-term persistence of species.     

阿尔罕伯拉宫和格拉纳达：旅游业与可持续性

和其它文化旅游胜地一样,阿尔罕伯拉宫和格拉纳达的旅游业也面临着在文化遗产的保存、管理和合理利用等方面进行战略革新的挑战 .改革基本参照《对阿尔罕伯拉宫和阿里哈雷斯特别规划修正案的预先研究》中的观点和举措 .其中包括旅游的可持续性、对参观者动机的考虑、“阿尔罕伯拉宫地区”的独特性、把参观按文化性质和生活经历性质进行分类、寻求在阿尔罕伯拉宫和格拉纳达及其周边环境之间建立一种良好关系的模式 .……     

Groundwater contamination evolution in the Guadiamar and Agrio aquifers after the Aznalcóllar spill: assessment and environmental implications

In 1998, the Agrio and Guadiamar rivers underwent an enormous environmental disaster caused by the rupture of the Aznalcóllar tailings dam and the release of 6 hm³ of pyrite sludge and acidic water. Both rivers run over recent alluvial materials which form a small-sized aquifer which is however important because underground water feeds the flow of the rivers. This work analyzes the state of groundwater 10 years after the spill. Before the dam failure, this aquifer was already contaminated in the zone nearest to the mine, to which the impact of the spill was added. Contamination levels in the alluvial aquifer of the Agrio River have decreased remarkably. However, they are still important, with acidic pH values and high concentrations of toxic elements (maximum values of 16 mg/L of Zn and 15 mg/L of Al). There are also important levels of contamination in the Guadiamar alluvial area closest to the mine, as well as in specific zones located further south. The concentration of toxic elements is mainly controlled by pH. The evolution of contaminant levels show a sharp decrease after the first years following the spill, followed by a subsequent stabilization. It is necessary to take measures for the recovery of the aquifer because, otherwise, groundwater will continue contributing contaminants into the Agrio and Guadiamar rivers.