Rapid metal extractability tests from polluted mining soils by ultrasound probe sonication and microwave-assisted extraction systems

Ultrasonic probe sonication (UPS) and microwave-assisted extraction (MAE) were used for rapid single extraction of Cd, Cr, Cu, Ni, Pb, and Zn from soils polluted by former mining activities (Mónica Mine, Bustarviejo, NW Madrid, Spain), using 0.01 mol L^?1 calcium chloride (CaCl₂), 0.43 mol L^?1 acetic acid (CH₃COOH), and 0.05 mol L^?1 ethylenediaminetetraacetic acid (EDTA) at pH 7 as extracting agents. The optimum extraction conditions by UPS consisted of an extraction time of 2 min for both CaCl₂ and EDTA extractions and 15 min for CH₃COOH extraction, at 30% ultrasound (US) amplitude, whereas in the case of MAE, they consisted of 5 min at 50 °C for both CaCl₂ and EDTA extractions and 15 min at 120 °C for CH₃COOH extraction. Extractable concentrations were determined by inductively coupled plasma atomic emission spectrometry (ICP-AES). The proposed methods were compared with a reduced version of the corresponding single extraction procedures proposed by the Standards, Measurements and Testing Programme (SM&T). The results obtained showed a great variability on extraction percentages, depending on the metal, the total concentration level and the soil sample, reaching high values in some areas. However, the correlation analysis showed that total concentration is the most relevant factor for element extractability in these soil samples. From the results obtained, the application of the accelerated extraction procedures, such as MAE and UPS, could be considered a useful approach to evaluate rapidly the extractability of the metals studied.     

The application of regenerable sorbents for mercury capture in gas phase

Mercury is a well-known toxic element, and flue gas streams emitted from coal-fired utilities are one of the largest anthropogenic sources of this element. This study briefly reviews the proposed technologies for reducing mercury emissions from coal combustion, focusing on an emerging process which involves the use of regenerable sorbents and especially those loaded with noble metals. Among the mercury species formed during coal combustion, elemental mercury is the most difficult to remove from the flue gases due to its low reactivity and insolubility in water. The widespread interest in using regenerable sorbents with metals is due to their ability to retain elemental mercury. With this technology, not only can efficiencies of 100 % be reached in the retention of elemental mercury but also a way to avoid the generation of new wastes loaded with mercury. This study considers the main aspects that must be taken into account when developing effective regenerable sorbents for mercury capture, with special attention to sorbents containing noble metals. The characteristics of this process are compared with those of other processes in a more advanced state of development.     

Source apportionment of PM2.5 for supporting control strategies in the Monterrey Metropolitan Area,Mexico

The Monterrey Metropolitan Area (MMA) in Northeast Mexico has shown high PM_2.5 concentrations since 2003. The data shows that the annual average concentration exceeds from 2 to 3 times the Mexican PM_2.5 annual air quality standard of 12 µg/m³. In a previous work we studied the chemical characterization of PM_2.5 in two sites of the MMA during the winter season. Among the most important components we found ammonium sulfate and nitrate, elemental and organic carbon, and crustal matter. In this work we present the results of a second chemical characterization study performed during the summer time and the application of the chemical mass balance (CMB) model to determine the source apportionment of air pollutants in the region. The chemical analysis results show that the chemical composition of PM_2.5 is similar in both sites and periods of the year. The results of the chemical analysis and the CMB model show that industrial, traffic, and combustion activities in the area are the major sources of primary PM_2.5 and precursor gases of secondary inorganic and organic aerosol (SO₂, NOx, NH₃, and volatile organic compounds [VOCs]). We also found that black carbon and organic carbon are important components of PM_2.5 in the MMA. These results are consistent with the MMA emission inventory that reports as major sources of particles and SO₂ a refinery and fuel combustion, as well as nitrogen oxides and ammonium from transportation and industrial activities in the MMA and ammonium form agricultural activities in the state. The results of this work are important to identify and support effective actions to reduce direct emissions of PM_2.5 and its precursor gases to improve air quality in the MMA. Implications: The Monterrey Metropolitan Area (MMA) has been classified as the most air-polluted area in Mexico by the World Health Organization (WHO). Effective actions need to be taken to control primary sources of PM_2.5 and its precursors, reducing health risks on the population exposed and their associated costs. The results of this study identify the main sources and their estimated contribution to PM_2.5 mass concentration, providing valuable information to the local environmental authorities to take decisions on PM_2.5 control strategies in the MMA.     

Present and future climate conditions for winegrowing in Spain

This study deals with the question of how winegrowing in Spain may be altered by anthropogenic climate change. The present state and expected future development of three bioclimatic indices relevant for winegrowing were assessed by observation, and four regional climate models from the EU-ENSEMBLES project were investigated. When comparing the 2061–2090 scenario period to the 1961–1990 reference period, the models unanimously indicate a significant increase in the mean of the two considered thermal indices over the entire study region. However, for the index based on temperature and precipitation, the models are heavily biased when verified against observations and generally disagree on the size of the projected future change. For this index, unanimous model agreement was only found for northwestern Spain where all models indicated a significant decrease in the mean. From these results, regional climate change is expected to negatively affect the quality of wine in the growing regions of central and southern Spain, and the Ebro valley, whereas positive effects should be expected in the northwest. No significant changes in the risk of mildew infestation are to be expected except for the northwest, where this risk is projected to decrease.     

A review of potential physical impacts on harbours in the Mediterranean Sea under climate change

Regional Environmental Change - The potential impact of climate change on port operations and infrastructures has received much less attention than the corresponding impact for beach systems....     

Levels of PCDD/F in adipose tissue on non-occupationally exposed subjects living near a hazardous waste incinerator in Catalonia, Spain

The potential adverse effects on human health of hazardous waste incinerators (HWIs) are a subject of concern. The construction of the first and till now only HWI in Spain finished in 1999. In 2007, after approximately 9 years of regular operations in the facility, the concentrations of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/F) were determined by HRGC/HRMS in samples of adipose tissue of 15 autopsied subjects living in the area under potential impact of the HWI (Constantí, Tarragona County, Catalonia). These data were compared with the levels found in two previous surveys performed in 1998 (baseline) and 2002. The current mean PCDD/F concentration in adipose tissue was 14.6 pg WHO-TEQ/g of fat (range: 3.3–55.4 pg WHO-TEQ/g of fat). It means significant changes (a reduction of 64% and an increase of 47%) in the mean PCDD/F levels in comparison to those found in 1998 and 2002: 40.1 and 9.9 pg WHO-TEQ/g of fat, respectively. Women showed higher levels of PCDD/F than men (23.8 vs 11.2 pg WHO-TEQ/g of fat). The increase in the last 5 years would not be directly attributable to exposure to PCDD/F emitted by the HWI, as other biological monitors such as human plasma and milk decreased during the same period.     

Oxidative properties of ambient PM2.5 and elemental composition: Heterogeneous associations in 19 European cities

We assessed the extent to which constituents of PM_2.5 (transition metals, sodium, chloride) contribute to the ability to generate hydroxyl radicals (OH) in vitro in PM_2.5 sampled at 20 locations in 19 European centres participating in the European Community Respiratory Health Survey. PM_2.5 samples (n = 716) were collected on filters over one year and the oxidative activity of particle suspensions obtained from these filters was then assessed by measuring their ability to generate OH in the presence of hydrogen peroxide. Associations between OH formation and the studied PM constituents were heterogeneous. The total explained variance ranged from 85% in Norwich to only 6% in Albacete. Among the 20 centres, 15 showed positive correlations between one or more of the measured transition metals (copper, iron, manganese, lead, vanadium and titanium) and OH formation. In 9 of 20 centres OH formation was negatively associated with chloride, and in 3 centres with sodium. Across 19 European cities, elements which explained the largest variations in OH formation were chloride, iron and sodium.     

Characterization and sources assignation of PM2.5 organic aerosol in a rural area of Spain

The results from a year-long study of the organic composition of PM2.5 aerosol collected in a rural area influenced by a highway of Spain are reported. The lack of prior information related to the organic composition of PM2.5 aerosol in Spain, concretely in rural areas, led definition of the goals of this study. As a result, this work has been able to characterize the main organic components of atmospheric aerosols, including several compounds of SOA, and has conducted a multivariate analysis in order to assign sources of particulate matter. A total of 89 samples were taken between April 2004 and April 2005 using a high-volume sampler. Features and abundance of n-alkanes, polycyclic aromatic hydrocarbons (PAHs), alcohols and acids were separately determined using gas chromatography/mass spectrometry and high performance liquid chromatography analysis. The Σn-alkane and ΣPAHs ranged from 3 to 81 ng m^?3 and 0.1 to 6 ng m^?3 respectively, with higher concentrations during colder months. Ambient concentrations of Σalcohols and Σacids ranged from 21 to 184 ng m^?3 and 39 to 733 ng m^?3, respectively. Also, several components of secondary organic aerosol have been quantified, confirming the biogenic contribution to ambient aerosol. In addition, factor analysis was used to reveal origin of organic compounds associated to particulate matter. Eight factors were extracted accounting more than 83% of the variability in the original data. These factors were assigned to a typical high pollution episode by anthropogenic particles, crustal material, plant waxes, fossil fuel combustion, temperature, microbiological emissions, SOA and dispersion of pollutants by wind action. Finally, a cluster analysis was used to compare the organic composition between the four seasons.     

Assessing spatial variability of SO2 field as detected by an air quality network using Self-Organizing Maps,cluster, and Principal Component Analysis

In Bilbao (Spain), an air quality network measures sulphur dioxide levels at 4 locations. The objective of this paper is to develop a practical methodology to identify redundant sensors and evaluate a network's capability to correctly follow and represent SO₂ fields in Bilbao, in the frame of a continuous network optimization process.The methodology is developed and tested at this particular location, but it is general enough to be useable at other places as well, since it is not tied neither to the particular geographical characteristics of the place nor to the phenomenology of the air quality over the area.To assess the spatial variability of SO₂ measured at 4 locations in the area, three different techniques have been used: Self-Organizing Maps (SOMs), cluster analysis (CA) and Principal Component Analysis (PCA). The results show that the three techniques yield the same results, but the information obtained via PCA can be helpful not only for that purpose but also to throw light on the major mechanisms involved. This might be used in future network optimization stages. The main advantage of cluster analysis and SOMs is that they provide readily interpretable results. All the calculations have been carried out using the freely available software R.