Photocatalytic reduction of carbon dioxide over Cu/TiO<Subscript>2</Subscript> photocatalysts

The photocatalytic reduction of CO₂ with H₂O was investigated using Cu/TiO₂ photocatalysts in aqueous solution. For this purpose, Cu/TiO₂ photocatalysts (with 0.2, 0.9, 2, 4, and 6 wt.% of Cu) have been synthesized via sol-gel method. The photocatalysts were extensively characterized by means of inductively coupled plasma optical emission spectrometry (ICP-OES), N₂ physisorption (BET), XRD, UV-vis DRS, FT-IR, Raman spectroscopy, TEM-EDX, and photoelectrochemical measurements. The as-prepared photocatalysts contain anatase as a major crystalline phase with a crystallite size around 13 nm. By increasing the amount of Cu, specific surface area and band gap energy decreased in addition to the formation of large agglomeration of CuO. Results revealed that the photocatalytic reduction of CO₂ decreased in the presence of Cu/TiO₂ in comparison to pure TiO₂, which might be associated to the formation of CuO phase acting as a recombination center of generated electron-hole pair. Decreasing of photoactivity can also be connected with a very low position of conduction band of photocatalysts with high Cu content, which makes H₂ production necessary for CO₂ reduction more difficult.     

Honeybees (<Emphasis Type="Italic">Apis mellifera</Emphasis>) as a biological barrier for contamination of honey by environmental toxic metals

The aim of the study was to investigate the transfer of toxic metals from honeybee workers (Apis mellifera L.) to bee honey in relation to the ecological state of the environment. The materials of the study consisted of samples of honeybee bodies and varietal honeys taken from the same apiary located in three areas: R1—urbanized (16), R2—ecologically clean (16) and R3—industrialized (15) of south-eastern Poland. The contents of 14 elements in all tested samples, including toxic metals (Cd, Pb, Hg, Al, Ni, Tl) as well as bioelements (K, Mg, Ca, Mn, Fe, Zn, Cu, Se), were analysed by the ICP-OES method with prior microwave mineralization. The concentrations of the majority of the studied elements, excluding aluminum and lead, were significantly higher in bee bodies than in honey samples (P?<?0.05). The pollution of bee bodies by toxic metals was dependent on the environmental cleanliness, and the most pollution was observed in the industrialized area. The bee body was the most effective barrier for Cd and Tl transfer to the honey, while the level of Ni was similar in both tested materials. The Al concentration was significantly higher in honey than bee bodies (14.81?±?24.69 and 6.51?±?5.83 mg kg^?1, respectively), which suggests the possibility of secondary contamination of honey. The greatest sensitivity to heavy metal pollution was observed in honeydew honey compared to nectar honeys (P?<?0.05). It was proved for the first time that bees work as biofilters for toxic metals and prevent honey contamination.     

Water quality index for agricultural systems in Northwest Uruguay

Agricultural systems have experienced rapid expansion and intensification in the last several decades. In Uruguay, since the beginning of 2000, the most common cropping systems have included soybeans. Currently, this crop is expanding towards lowlands traditionally occupied by rice in rotation with pastures. However, the environmental effects of agricultural intensification and diversification are not well known. Thus, some indices have been proposed to quantify the changes in agricultural production systems and assess water quality. The main goal of this study was to develop a water quality index (WQI) to assess the impacts of the diversification of rice production systems in northwest Uruguay. The study was carried out in an agricultural basin where other summer crops have been incorporated in the rice-pasture sequence. Agriculture intensification and crop diversification indices were calculated using information provided by farmers. Water samples were collected downstream of the production area before crop sowing and after crop harvest (2008–2009 to 2010–2011 and 2016–2017 to 2017–2018). Biochemical oxygen demand, nitrates, total phosphorus, fecal coliforms, and total suspended solids were the variables that mainly explained the effects of the agricultural activities on water quality. The proposed water quality index included these unweighted variables, which allowed for the pre-sowing and post-harvest to be differentiated, as well as the degree of diversification. Therefore, the proposed WQI constitutes a tool that can be used to evaluate the water quality in an agricultural basin. Likewise, it can be used to select agricultural sequences that generate the least possible impacts on the associated water resources.     

Evaluation of aerosol sources at European high altitude background sites with trajectory statistical methods

This study has investigated the influence of synoptic weather patterns and long-range transport episodes on the concentrations of several compounds related to different aerosol sources (EC, OC, SO₄^2?, Ca²⁺, Na⁺, K⁺, ²¹⁰Pb, levoglucosan and dicarboxylic acids) registered in PM10 or PM2.5 aerosol samples collected at three remote background sites in central Europe. Air mass back-trajectories arriving at these sites have been analysed by statistical methods. Firstly, air mass back-trajectories have been grouped into clusters. Each cluster corresponds to specific meteorological scenarios, which were extracted and discussed. Finally, redistributed concentration fields have been computed to identify the main potential source regions of the different key aerosol components. A marked seasonal pattern is observed in the occurrence of the different clusters, with fast westerly and northerly Atlantic flows during winter and weak circulation flows in summer. Spring and fall were characterised by advection of moderate flows from northeastern and eastern Europe. Significant inter-cluster differences were observed for concentrations of receptor aerosol components, with the highest concentrations of EC, OC, SO₄^2?, K⁺ and ²¹⁰Pb associated with local and mesoscale aerosol sources located over central Europe related to enhanced photochemical processes. Emissions produced by fossil fuel and biomass burning processes from the Baltic countries, Byelorussia, western regions of Russia and Kazakhstan in spring and fall also contribute to elevated levels of EC, OC, SO₄^2?, K⁺ and ²¹⁰Pb. In the summer period long-range transport episodes of mineral dust from North-African deserts were also frequently detected, which caused elevated concentrations of coarse Ca²⁺ at sites. The baseline aerosol concentrations in central Europe at the high altitude background sites were registered in winter, with the exception of coarse Na⁺. While the relatively high concentrations of Na⁺ can be explained by sea salt advected from the Atlantic, the low levels of other aerosol components are caused by efficient aerosol scavenging associated to advections of Atlantic air masses, as well as lower emissions of these species over the Atlantic compared to those over the European continent and very limited vertical air mass exchange over the continent.     

Influence of boundary conditions on CMAQ simulations over the Iberian Peninsula

The influence of chemical boundary conditions (BC) on the response of the Community Multiscale Air Quality (CMAQ) model over the Iberian Peninsula was investigated in this study. Three strategies to supply boundary conditions in the context of the Integrated Assessment Modelling System for the Iberian Peninsula (SIMCA) were tested. Alternative methods consist in providing BC from (1) fixed, time-independent, concentration profiles, (2) concentrations predicted in a CMAQ mother domain (48 km, 1 h resolution) and (3) concentration values from the GEOS-Chem chemical-transport global model (2 × 2.5°, 3 h resolution). High resolution (3 km) simulated concentrations of the main pollutants (NO₂, NO, SO₂, O₃, PM₁₀ and PM_2.5) were compared through a comprehensive statistical analysis including observational data from 165 monitoring stations all over the Iberian Peninsula. It was found that model sensitivity to BC for nitrogen and sulphur oxides was limited, being restricted to the vicinity of model boundaries. However, significant domain-wide differences were found when modelling ozone and PM depending on the BC provided to run the tests. Although model performance was affected by spatial and seasonal factors, the results indicate that model-derived, dynamic BC improved CMAQ predictions when compared to those based on static concentrations prescribed in the boundaries. Aggregated statistics suggest that the GEOS-Chem produced the best results for O₃ and PM_2.5 while NO₂ and PM₁₀ were slightly better predicted under the CMAQ nesting approach. Besides the statistical evaluation some other relevant issues in the context of Integrated Assessment Modelling (IAM) are discussed to gain a better insight into the suitability of the methods analyzed and limitations of downscaling methods. Despite being useful to get a better understanding of the role of BC in SIMCA, this study contributed to highlight model deficiencies and therefore to point out future research needs to improve IAM activities in the Iberian Peninsula.     

Polycyclic aromatic hydrocarbons in air on small spatial and temporal scales – II. Mass size distributions and gas-particle partitioning

Polycyclic aromatic hydrocarbons (PAHs) were measured together with inorganic air pollutants at two urban sites and one rural background site in the Banja Luka area, Bosnia and Hercegovina, during 72 h in July 2008 using a high time resolution (5 samples per day) with the aim to study gas-particle partitioning, aerosol mass size distributions and to explore the potential of a higher time resolution (4 h-sampling).In the particulate phase the mass median diameters of the PAHs were found almost exclusively in the accumulation mode (0.1–1.0 μm of size). These were larger for semivolatile PAHs than for non-volatile PAHs. Gas-particle partitioning of semivolatile PAHs was strongly influenced by temperature. The results suggest that the Junge–Pankow model is inadequate to explain the inter-species variation and another process must be significant for phase partitioning which is less temperature sensitive than adsorption. Care should be taken when interpreting slopes m of plots of the type log K_p = m log p_L⁰ + b based on 24 h means, as these are found sensitive to the time averaging, i.e. tend to be higher than when based on 12 h-mean samples.     

An urban emissions inventory for South America and its application in numerical modeling of atmospheric chemical composition at local and regional scales

This work describes the development of an urban vehicle emissions inventory for South America, based on the analysis and aggregation of available inventories for major cities, with emphasis on its application in regional atmospheric chemistry modeling. Due to the limited number of available local inventories, urban emissions were extrapolated based on the correlation between city vehicle density and mobile source emissions of carbon monoxide (CO) and nitrogen oxides (NOx). Emissions were geographically distributed using a methodology that delimits urban areas using high spatial resolution remote sensing products. This numerical algorithm enabled a more precise representation of urban centers. The derived regional inventory was evaluated by analyzing the performance of a chemical weather forecast model in relation to observations of CO, NOx and O₃ in two different urban areas, São Paulo and Belo Horizonte. The gas mixing ratios simulated using the proposed regional inventory show good agreement with observations, consistently representing their hourly and daily variability. These results show that the integration of municipal inventories in a regional emissions map and their precise distribution in fine scale resolutions are important tools in regional atmospheric chemistry modeling.     

Does intensity of change matter? Factors affecting adoption of agri-environmental schemes in Spain

Agri-environmental schemes (AES) are the main policy instrument currently available in the EU to promote environmentally-friendly farming practices. However, the rate of adoption of these measures is still relatively low in southern Europe, and understanding how these rates can be increased is still an open issue. The goal of this paper is to increase that understanding by testing whether the factors which determine AES sign-up decisions are influenced by the intensity of change in farming practices that are brought about by adopting the scheme. A micro-economic model reflecting farmer AES sign-up decisions is proposed and applied to two schemes in Spain respectively requiring major or minor intensity of change in practices by surveying farmers eligible for both schemes. The results show that farm structural factors play a role when major practice change is required by the scheme, yet when dealing with minor change, individual farmer characteristics play a more determining role. Social capital and farmer attitude are important factors in both the AES surveyed. Therefore, it may be concluded that improving agronomic design would be an important tool to improve farmer participation in AES where major change is involved, whereas improved targeting and extension would help uptake for AES involving a lesser degree of change.     

Decolouration of azo dyes by <Emphasis Type="Italic">Phanerochaete chrysosporium</Emphasis> immobilised into alginate beads

Background, aim and scope  

Because of high discharged volumes and effluent composition, wastewater from the textile industry can be considered as the most polluting amongst all industrial sectors, thus greatly requiring appropriate treatment technologies. Although some abiotic methods for the reduction of several dyes exist, these require highly expensive catalysts and reagents. Biotechnological approaches were proven to be potentially effective in the treatment of this pollution source in an eco-efficient manner. The white-rot fungi are, so far, the most efficient microorganisms in degrading synthetic dyes. This white-rot fungi’s property is due to the production of extracellular lignin-modifying enzymes, which are able to degrade a wide range of xenobiotic compounds because of their low substrate specificity. In this paper, we studied the ability of the white-rot fungus Phanerochaete chrysosporium immobilised into Ca-alginate beads to decolourise different recalcitrant azo dyes such as Direct Violet 51 (DV), Reactive Black 5 (RB), Ponceau Xylidine (PX) and Bismark Brown R (BB) in successive batch cultures. To the best of our knowledge, this is the first study on the immobilisation of P. chrysosporium into Ca-alginate beads for its application in dye decolouration.     

Transfer of pesticides to the brew during mate drinking process and their relationship with physicochemical properties

In order to evaluate the extraction of pesticide residues that are transferred to the brew during mate drinking process of P.U.1 yerba mate leaves (Ilex paraguariensis), a special device to simulate the way in which mate is drunk in Uruguay was developed. The transfer to the brew of 12 organophosphates, 5 synthethic pyrethroids and one organochlorine pesticide from spiked samples was studied. The relationship between the transfer data thus obtained and physicochemical properties like water solubility (Ws), octanol-water coefficient (Kow) and Henry's constant (H) was evaluated. The extractability of the pesticide residues from yerba mate can be correlated with log Ws and log Kow. These transfer values allowed the calculation of ARLs (acceptable residue level) for the pesticides following Food and Agriculture Organization (FAO), World Health Organizaion (WHO) guidelines. These results can help the future establishment of maximum residue levels (MRLs).