Evaluation of groundwater quality and its suitability for drinking,domestic, and agricultural uses in the Banana Plain (Mbanga,Njombe, Penja) of the Cameroon Volcanic Line

Groundwater quality of the Banana Plain (Mbanga, Njombe, Penja—Cameroon) was assessed for its suitability for drinking, domestic, and agricultural uses. A total of 67 groundwater samples were collected from open wells, springs, and boreholes. Samples were analyzed for physicochemical properties, major ions, and dissolved silica. In 95% of groundwater samples, calcium is the dominant cation, while sodium dominates in 5% of the samples. Eighty percent of the samples have HCO₃ as major anion, and in 20%, NO₃ is the major anion. Main water types in the study area are CaHCO₃, CaMgHCO₃, CaNaHCO₃, and CaNaNO₃ClHCO₃. CO₂-driven weathering of silicate minerals followed by cation exchange seemingly controls largely the concentrations of major ions in the groundwaters of this area. Nitrate, sulfate, and chloride concentrations strongly express the impact of anthropogenic activities (agriculture and domestic activities) on groundwater quality. Sixty-four percent of the waters have nitrate concentrations higher than the drinking water limit. Also limiting groundwater use for potable and domestic purposes are contents of Ca²⁺, Mg²⁺ and HCO₃ ⁻ and total hardness (TH) that exceed World Health Organization (WHO) standards. Irrigational suitability of groundwaters in the study area was also evaluated, and results show that all the samples are fit for irrigation. Groundwater quality in the Banana Plain is impeded by natural geology and anthropogenic activities, and proper groundwater management strategies are necessary to protect sustainably this valuable resource.     

The utility of electrocardiography and echocardiography in copper deficiency-induced cardiac damage in goats

Environmental Science and Pollution Research - Copper deficiency (CuD) is a common mineral disorder in ruminants, which causes histomorphological changes in the heart due to disturbances in...     

Sensitivity of Landsat‐Scale Energy Balance to Aerodynamic Variability in Mountains and Complex Terrain

The speed and direction of air flow through complex terrain are difficult to define. Both impact sensible and latent heat flux exchanges at the surface. Evapotranspiration (ET) models such as Mapping EvapoTranspiration at high Resolution with Internalized Calibration (METRIC?) estimate ET as a residual of the surface energy process and are thus sensitive to aerodynamics, including terrain‐induced impacts on roughness governing convective heat transfer (H). There is a need to explore the sensitivities of H estimation and thereby ET estimation to wind speed and terrain roughness in mountainous areas and to determine the merit of operating complex mesoscale wind field models in conjunction with the energy balance process. A sensitivity analysis is explored in METRIC where we increased wind speed in proportion to a relative elevation parameter and we increased aerodynamic roughness to assimilate impacts of relative terrain roughness, estimated in proportion to standard deviation of elevation within a 3 km locality. These aerodynamic modifications increased convective heat transfer in complex terrain and reduced estimated ET. In other sensitivity runs, we reduced estimated wind speed on estimated leeward slopes. Estimated ET with and without these sensitivity adjustments is shown for mountainous areas of Montana and Nevada. Changes in ET ranged from little change (<5%) for lower slopes to about 30% reductions on windward slopes and 25% increases on leeward slopes for some mid to high elevations in the Montana application.     

Visual determination of nitrite and nitrate in waters by color band formation method

A spot test for aqueous nitrate and nitrite for controlling nitrogen removal performance in small-scale wastewater treatment facilities is proposed. In this method, NO(2)(-) ion in water samples was allowed to react with sulfanilic acid and 1-naphthol to form an anionic azo dye. The resulting colored solution was introduced onto a mini column (similar to a gas detecting tube) packed with PVC particles coated with benzyl cetyl dimethyl ammonium chloride (BCDMA) and biphenyl. The NO(2)(-)-N concentration was determined visually by measuring the color band length (CBL) in the column. The CBL correlates linearly with nitrite concentration in the 4-20 mg-N l(-1) range. The concentration of nitrite+nitrate was determined after reduction to nitrite with zinc. The concentration of NO(3)(-)-N species was calculated by difference. This method was used to visually determine the concentrations of NO(2)(-)-N and (NO(2)(-)+NO(3)(-))-N in domestic wastewater samples with maximum suspended solid (SS) and chemical oxygen demand (COD) concentrations of 114 mg l(-1) and 73.9 mg l(-1), respectively.     

Zeolite formation from coal fly ash and heavy metal ion removal characteristics of thus-obtained Zeolite X in multi-metal systems

Zeolitic materials have been prepared from coal fly ash as well as from a SiO₂–Al₂O₃ system upon NaOH fusion treatment, followed by subsequent hydrothermal processing at various NaOH concentrations and reaction times. During the preparation process, the starting material initially decomposed to an amorphous form, and the nucleation process of the zeolite began. The carbon content of the starting material influenced the formation of the zeolite by providing an active surface for nucleation. Zeolite A (Na-A) was transformed into zeolite X (Na-X) with increasing NaOH concentration and reaction time. The adsorption isotherms of the obtained Na-X based on the characteristics required to remove heavy ions such as Ni²⁺, Cu²⁺, Cd²⁺ and Pb²⁺ were examined in multi-metal systems. Thus obtained experimental data suggests that the Langmuir and Freundlich models are more accurate compared to the Dubinin–Kaganer–Radushkevich (DKR) model. However, the sorption energy obtained from the DKR model was helpful in elucidating the mechanism of the sorption process. Further, in going from a single- to multi-metal system, the degree of fitting for the Freundlich model compared with the Langmuir model was favored due to its basic assumption of a heterogeneity factor. The Extended-Langmuir model may be used in multi-metal systems, but gives a lower value for equilibrium sorption compared with the Langmuir model.     

An improved method for Kr analysis by liquid scintillation counting and its application to atmospheric Kr determination

Atmospheric ⁸⁵Kr concentration at Fukuoka, Japan was determined by an improved ⁸⁵Kr analytical method using liquid scintillation counting (LSC). An average value of 1.54 ± 0.05 Bq m⁻³ was observed in 2008, which is about two times that measured in 1981 at Fukuoka, indicating a 29 mBq y⁻¹ rate of increase as an average for these 27 years. The analytical method developed involves collecting Kr from air using activated charcoal at liquid N₂ temperature and purifying it using He at dry ice temperature, followed by Kr separation by gas chromatography. An overall Kr recovery of 76.4 ± 8.1% was achieved when Kr was analyzed in 500-1000 l of air. The Kr isolated by gas chromatography was collected on silica gel in a quartz glass vial cooled to liquid N₂ temperature and the activity of ⁸⁵Kr was measured with a low-background LS counter. The detection limit of ⁸⁵Kr activity by the present analytical method is 0.0015 Bq at a 95% confidence level, including all propagation errors, which is equivalent with ⁸⁵Kr in 1.3 l of the present air under the analytical conditions of 72.1% counting efficiency, 0.1597 cps background count rate, and 76.4% Kr recovery.     

Water extraction with CO2 bubbling as pretreatment of melting-furnace fly ash for metal recovery

In Japan, melting-furnace fly ash (MFA) generated from ash melting and gasification/melting plants is considered an “urban mine” due to its high metal content. This study aimed to develop a novel approach to pretreating MFA for metal recovery. Water extraction with CO₂ bubbling was investigated because MFA mainly consists of water-soluble salts containing elements such as Cl, Ca, Na, and K. Instead of acid addition, CO₂ bubbling was applied to maintain the optimal pH for minimizing the release of target metal elements and maximizing the removal of undesirable elements during water extraction. The results revealed that CO₂ bubbling effectively decreased the release of Pb, Zn, and Cd into the treatment water. This was mainly due to coprecipitation with CaCO₃, which was primarily formed by the reaction of Ca²⁺ from the MFA with CO₃ ²⁻ from the CO₂ gas. The bubbling process also helped accelerate the removal of Cl from MFA. Furthermore, the study showed that it is possible to lower the water-to-solid ratio to 5 with only a slight reduction in water extraction effect. Finally, approximately four times the concentration of target metals (rare metals and Cu, Pb, and Zn) was achieved by removing 90% of Cl, 70%–90% of Na and K, and 30%–40% of Ca through water extraction with CO₂ bubbling, resulting in a concentration of target metals that was nearly equal to that of ore.     

Polychlorinated biphenyl levels in the blood of Japanese individuals ranging from infants to over 80 years of age

Individuals’ exposure to various persistent organic pollutants (POPs), including polychlorinated biphenyls (PCBs), and its adverse health effects have been a cause of concern. We measured blood PCB concentrations from samples taken from 507 Japanese individuals ranging from infants to those over 80 years of age. The blood PCB levels increased with age for both male (Spearman’s r?=?0.69, p?<?0.001) and female (Spearman’s r?=?0.70, p?<?0.001) participants. Adult men and nulliparous women showed similar increases with age. However, the PCB levels of multiparous women were lower than those of nulliparous women in their thirties (p?=?0.005), probably because the PCBs were transferred from the mothers to their children during pregnancy and lactation. Among infants (<2 years of age), some had as high levels of accumulated PCB levels as those in adults >30 years of age. In some cases, the PCB levels were over 0.8 ng/g wet weight, similar to levels observed in adults over 50 years of age. In the future, it will be necessary to do research on the health of the children who are exposed by high concentration level of POPs.     

Analysis method for PCBs in reclaimed oil using a fast-GC triple stage quadrupole mass spectrometer with the 13-component quantitation method

It is necessary for companies supplying reclaimed oil to analyze polychlorinated biphenyls (PCBs), because there is a possibility of the presence of contaminants due to trace-level PCBs in the reclaimed oil. However, common analysis methods of PCBs are time-consuming and complicated. Fast-GC triple stage quadrupole mass spectrometer with the 13-component quantitation method is an official method for analyzing PCBs in insulating oil in Japan. This method is extremely fast and simplified. The purpose of this study involves an investigation of the aforementioned fast and simple method for potential use in the analysis of reclaimed oil. Furthermore, it was attempted to combine the method with sample preparation involving only hexane dilution. The effect of sample dilutions corresponding to 100, 300, and 500 times was evaluated for reducing the matrix effect. The matrix effect was suppressed at a dilution ratio equal to or exceeding 300 times. Calibration curves of four points, namely 0.01, 0.05, 0.1, and 0.5 ng/mL, (ignored origin) by using an internal standard method were prepared for the 13 components. The square of regression coefficient (R²) values of all calibration curves exceeded 0.997. This method was adopted for the analysis of reclaimed oil containing 0.5 μg/mL PCBs, which corresponds to the judgment criteria, and accurate quantitation (accuracy value, 94.0–102%) and good repeatability (%RSD, 3.6%) were obtained. Furthermore, the required sensitivity was maintained even when 800 samples were analyzed without a cleaning ion source and an exchanging analysis column.