Strontium-90 in Canada goose eggshells and reed canary grass from the Columbia River,Washington

Strontium-90 (⁹⁰SR) released to the ground near the N Reactor at the U.S. Department of Energy's Hanford Site enters the Columbia River through shoreline seeps. The ⁹⁰Sr is then potentially available for uptake by plants and animals. The life history and foraging behavior of nesting Canada geese is such that female geese could ingest ⁹⁰Sr while foraging on shoreline plants. Radichemical analyses showed that goose eggshells taken from an island, downstream from the N Reactor, contained more ⁹⁰Sr than did eggshells collected from other downstream islands. Reed canary grass samples taken from shoreline areas immediately downstream from the N Reactor contained higher concentrations of ⁹⁰Sr than samples from other downstream areas. All goose eggshells did not contain enhanced levels of ⁹⁰Sr, and all reed canary grass samples did not contain enhanced levels of ⁹⁰Sr, but a relationship exists between the releases of ⁹⁰Sr to the Columbia River and the enhanced levels of ⁹⁰Sr in some of the environmental samples analyzed.Pacific Northwest Laboratory is operated by Battelle Memorial Institute for the U.S. Department of Energy under contract DE-ACO6-76RLO 1830.     

Water quality test based on dielectrophoretic measurements of fresh water algae Selenastrum capricornutum

A method is described whereby dielectrophoresis of algal cells is used to perform rapid water quality analysis, specifically detecting the presence of CuSO4. The dielectric collection spectrum of the fresh water alga Selenastrum capricornutum was determined for a range of concentrations of CuSO4 from 25 mg L(-1) to 0.25 mg L(-1) for exposure times of 15 min and 18 h. In all cases increasing the concentration of CuSO4 reduced cell collection, but a step reduction was observed in collection between 2 mg L(-1) and 5 mg L(-1). This method has potential for forming a rapid, low-cost test for water quality with broad specificity and significantly reduced analysis time compared to current methods.     

A new device for measuring fluctuations in plant stem diameter: Implications for monitoring plant responses

An electrical device capable of continuously measuring micronsized changes in stem diameter of woody and herbaceous plants is described. Fumigation of sunflowers with automotive exhaust was used to test the ability of the device to detect short-term plant responses.     

Determination of biomass burning emission factors: Methods and results

Biomass burning, in a broad sense, encompasses different burning practices, including open and confined burnings, and different types of vegetation. Emission factors of gaseous or particulate trace compounds are directly dependent both on the fuel type and the combustion process. Emission factors are generally calculated by stoichiometric considerations using the carbon mass balance method, applied either to combustion chamber experiments or to field experiments based on ground-level measurements or aircraft sampling in smoke plumes. There have been a number of experimental studies in the last 10 years to investigate wildfires in tropical, temperate, or boreal regions. This article presents an overview of measurement methods and experimental data on emission factors of reactive or radiatively active trace compounds, including trace gases and particles. It focuses on fires in tropical regions, that is, forest and savanna fires, agricultural burns, charcoal production, use of fuelwood, and charcoal combustion.     

Further studies using X-ray fluorescence to sample lead contaminated carpeted surfaces

The sampling of carpeted surfaces to test for lead contamination primarily focuses upon vacuum techniques. Vacuum sampling techniques, however, require time-consuming, expensive laboratory analysis of the dusts obtained and are unable to determine total lead load on the carpet. X-ray fluorescence (XRF) analysis is an on-site, inexpensive, non-destructive, quick technique for predicting metals levels in a variety of media, such as water, soil, filter paper and painted surfaces. A 1992 study of the feasibility of XRF to analyze for lead and soil loadings on carpeted surfaces indicated that XRF can detect lead at a low enough level to warrant further study. This paper expands this earlier study and developes lead and soil loading calibration curves for three different carpet types based upon XRF lead L-beta peak areas and XRF iron and barium K-alpha peak and background areas. Results indicate that variation in the data can be reduced through modifications of the XRF analysis technique, thus reducing the statistically determined detection level, and that carpet type does affect the calibration. Detection levels of approximately 70 mg/m² for lead and 5 g/m² for soil were obtained. Overall, good agreement was found between results of this study and the earlier one. XRF shows excellent potential for quantitative analysis of lead on carpeted surfaces.     

Characterizing soils for hazardous waste site assessments

This paper provides a review and justification of the minimum data needed to characterize soils for hazardous waste site assessments and to comply with the Comprehensive Environmental Response, Compensation and Liability Act (CERCLA). Scientists and managers within the regulatory agency and the liable party need to know what are the important soil characteristics needed to make decisions about risk assessment, what areas need remediation and what remediation options are available. If all parties involved in characterizing a hazardous waste site can agree on the required soils data set prior to starting a site investigation, data can be collected in a more efficient and less costly manner. Having the proper data will aid in reaching decisions on how to address concerns at, and close-out, hazardous waste sites.This paper was prepared to address two specific concerns related to soil characterization for CERCLA remedial response. The first concern is the applicability of traditional soil classification methods to CERCLA soil characterization. The second is the identification of soil characterization data type required for CERCLA risk assessment and analysis of remedial alternatives. These concerns are related, in that the Data Quality Objective (DQO) process addresses both. The DQO process was developed in part to assist CERCLA decision-makers in identifying the data types, data quality, and data quantity required to support decisions that must be made during the remedial investigation/feasibility study (RI/FS) process. Data Quality Objectives for Remedial Response Activities: Development Process (US EPA, 1987a) is a guidebook on developing DQOs. This process as it relates to CERCLA soil characterization is discussed in the Data Quality Objective Section of this paper.     

Use of cluster and principal component analyses to profile areas in California where ground water has been contaminated by pesticides

An empirical approach to profiling areas of ground water contamination by pesticides was devised that did not rely upon determining the level of vulnerability between land areas and that did not assume any particular pathway for ground water contamination. Climatic and soil data were obtained for 1-square mile sections of land in California where pesticide residues had been found in well water samples and the detection was attributed to legal agricultural applications. These sections were designated as known contaminated (KC) sections. Climate and soil data were also obtained for sections which lacked either well sampling data or a positive pesticide detection. These sections were designated as candidate sections. Statistical procedures were used to cluster groups of KC sections first with respect to climate characteristics and then with respect to soil characteristics. Principal components analysis (PCA) was used to construct a statistical profile of soil variables for each cluster of KC sections. A method based on the PCA was developed to compare the similarity of soil profiles derived for each KC section cluster to individual candidate sections. Since the profiling scheme was based only on data from KC sections, candidate sections that did not match any KC cluster profile could only be considered dissimilar to contaminated sections, receiving a status of not-classified. This profiling method is flexible and it can be revised to incorporate updated well sampling information.     

Patchy distributions: Optimising sample size

A method for estimating sample size which does not require an a priori definition of desired precision, or the assumption that the population is normally distributed with constant variance, has recently been proposed. This paper discusses this method and presents five modifications which make the method easier to use and reduce the probability of estimating a larger sample size than is actually required. The method is extended and used to estimate the mean abundance of patchily distributed benthic organisms. The technique can be used to guide the design of any environmental sampling programme, be it physical, chemical or biological, where comparisons between times and/or locations are required. Trade-offs between numbers of replicates and numbers of levels/sites are discussed.     

Chromium redox speciation in natural waters

Dissolved hexavalent chromium concentrations were determined in river, estuarine and coastal waters of the Humber catchment in north-east England. Samples were collected, filtered, extracted on site and after storage for up to eight days. Hexavalent chromium concentrations did not change by more than 0.05 microg l(-1) (not significant, p = 0.05) over this period. Total chromium concentrations in the catchment were less than 1.0 microg l(-1). This is low in relation to the proposed Environmental Quality Standard. Hexavalent chromium accounted for between 27% and 100% of the total dissolved concentration, with an average of approximately 50%. The proportion of Cr(III) and Cr(VI) in the rivers and estuary were of the same range as previously measured in 1993. The addition of Cr(III) and Cr(VI) to fresh and saline water samples illustrates the complexity of the factors controlling chromium speciation in natural waters. The presence of oxidisable organic matter and the stabilising role of complexing organic ligands are proposed as the main controlling influences of redox speciation in filtered samples.     

Emissions of gaseous and particulate pollutants in a port and harbour region in India

Ports can generate large quantity of pollutants in the atmosphere due to various activities like loading and unloading,transportation, and construction operations. Determination of the character and quantity of emissions from individual sources is an essential step in any project to control and minimize the emissions.In this study a detailed emission inventory of total suspendedparticulate matter (TSP), particulate matter less than 10 m(PM₁₀), sulfur dioxide (SO₂) and nitrogen oxides (NO_x) for a port and harbour project near Mumbai is compiled. Results show that the total annual average contributions of TSP and PM₁₀ from all the port activitieswere 872 and 221 t yr^-1, respectively. Annual average emissions of gaseous pollutants SO₂ and NO_xwere 56 and 397 t yr^-1, respectively, calculatedby using emission factors for different port activities. The maximum TSP emission (419 t yr ^-1) was from paved roads, while the least (0.4 t yr^-1) was from bulk handling activity. The maximum PM₁₀ emission (123 t yr^-1) was from unpaved roads and minimum (0.2 t yr^-1) from bulk handling operations. Similarly the ratio of TSP and PM₁₀ emission was highest (5.18) from paved roads and least (2.17) from bulk handling operations. Regression relation was derivedfrom existing emission data of TSP and PM₁₀ from variousport activities. Good correlation was observed between TSP andPM₁₀ having regression coefficient >0.8.