Investigation to meet China II emission legislation for marine diesel engine with diesel methanol compound combustion technology

In order to reduce the pollutant emission and alleviate the pressure of petroleum resources shortage and greenhouse gas emission at the same time, the use of clean and renewable alternative fuel for marine engines is a promising option. In this study, a marine diesel engine, which was modified to run in diesel methanol compound combustion (DMCC) mode, was investigated. After the diesel injection parameters were calibrated, and combined with a sample after-treatment device DOC (diesel oxidation catalyst), the engine could meet the requirements of China II legislation. The overall MSP (methanol substitute percent) reached 54.1%. The value of each pollutant emission was much lower than that in China II emission legislation, and there was almost no methanol and formaldehyde emissions. When methanol was injected into the inlet manifold, the intake air temperature decreased a lot, as well as the exhaust gas temperature, which were beneficial to increase engine thermal efficiency and improve engine room environment. Compared with the engine running in pure diesel mode, when the engine ran in diesel/methanol dual fuel mode, the combustion phase was advanced, and the combustion duration became shorter. Therefore, the engine thermal efficiency increased, and fuel consumption decreased significantly.     

Photodegradation of Hexafluoropropylene Oxide Trimer Acid under UV Irradiation

As a novel alternative to traditional perfluoroalkyl substances (PFASs), including perfluorooctanoic acid (PFOA) and perfluorooctane sulfonate (PFOS), hexafluoroproplyene oxide trimer acid (HFPO-TA) has been detected worldwide in surface water. Moreover, recent researches have demonstrated that HFPO-TA has stronger bioaccumulation potential and higher hepatotoxicity than PFOA. To treat these contaminants e.g. PFOA and PFOS, some photochemical techniques by adding exogenous substances had been reported. However, there is still no report for the behavior of HFPO-TA itself under direct UV irradiation. The current study investigated the photo-transformation of HFPO-TA under UV irradiation in aqueous solution. After 72 hr photoreaction, 75% degradation ratio and 25% defluorination ratio were achieved under ambient condition. Reducing active species, i.e., hydrated electrons and active hydrogen atoms, generated from water splitting played dominant roles in degradation of HFPO-TA, which was confirmed by different effects of reaction atmospheres and quenching experiments. A possible degradation pathway was proposed based on the products identification and theoretical calculations. In general, HFPO-TA would be transformed into shorter-chain PFASs, including hexafluoropropylene oxide dimer acid (HFPO-DA), perfluoropropionic acid (PFA) and trifluoroacetate (TFA). This research provides basic information for HFPO-TA photodegradation process and is essential to develop novel remediation techniques for HFPO-TA and other alternatives with similar structures.     

洱海北部入湖河流水质特征及其对北部湖区的影响

基于2016—2018年罗时江、弥苴河、永安江及洱海北部湖区监测数据分析,探讨洱海北部入湖河流污染变化特征及对北部湖区的影响。结果表明:1）"北三江"监测断面总磷、COD、氨氮浓度整体稳定在GB 3838—2002《地表水环境质量标准》Ⅱ—Ⅲ类标准限值内,年内污染物浓度变化表现出典型的农业面源污染特征,且受流域内产业模式等的综合影响;2）研究期间,河流首要污染物为TN,旱季次要污染物为COD,雨季为TP。雨季入湖负荷高于旱季,弥苴河污染负荷大于罗时江、永安江。"北三江"入湖TN和TP污染负荷分别占洱海允许负荷的50.1%和59.7%;3）入湖河流的磷元素输入是洱海北部湖区磷污染的重要来源。北部湖区污染物浓度对氮、磷入湖污染负荷相关性次月强于当月,响应存在延迟。筛选环境友好型种植模式,控制"北三江"氮磷入湖负荷,有利于保护洱海水环境。     

大气压纳秒负脉冲放电对水中大肠杆菌的灭活

采用自行研制的喷嘴-板-筒式反应器,研究了大气压纳秒负脉冲空气放电对水中大肠杆菌（Escherichia coli, E.coli）灭菌率的影响因素及规律。实验中空气自放电喷嘴电极进入反应器,气流带动放电生成的活性粒子流到达并作用于水中大肠杆菌。研究结果表明:本实验装置可有效实现对水中大肠杆菌的灭活,灭菌率随着放电电压和脉冲重复频率的增加、放电处理时间的延长而升高;随着鼓气速率的增大先增大后减小;随着喷嘴电极直径的增加先减小后增大。当采用1.30 mm喷嘴电极,在脉冲峰值电压为-32 kV、重复频率80 Hz,鼓气速率为80 mL/min时,连续放电处理12 min,灭菌率达到91%。     

圆红冬孢酵母利用生物柴油副产物粗甘油产油脂的影响因素分析

以餐饮废油制备生物柴油的副产物粗甘油为碳源,采用圆红冬孢酵母发酵生产微生物油脂。通过对发酵影响因素的优化,确定了最适发酵条件为:种子复苏时长24 h、富集时长10 h、接种量为6%、初始粗甘油浓度为60 g/L、C/N为60、有机氮占总氮比例为75%、发酵体积为100 mL、发酵温度为30 ℃、发酵时间为6 d,在此条件下,获得总产油量为10.56 g/L,油脂产率为0.229。与无机氮源硫酸铵相比,有机氮源蛋白胨的添加显著提高了油脂含量和总产油量。通过测定油脂的脂肪酸成分并利用Hoekman方程估算所得生物柴油的性能指标,表明其符合中国、美国及欧盟标准。该方法既为粗甘油的再利用提供了一条新途径,又为生物柴油的生产提供了廉价的原材料。     

Concentrations and chemical compositions of PM10 during hazy and non-hazy days in Beijing

In order to study the concentrations of major components,characteristics and comparison in hazy and non-hazy days of PM_(10) in Beijing,aerosol samples were collected at urban site in Beijing from December 29,2014 to January 22,2015.Heavy metals like Zn,Pb,Mn,Cu,As,V,Cr and Cd were deeply studied considering their toxic effects on human being;nine water-soluble inorganic ions(SO_4~(2-),NO_3~-,NH_4~+,Na~+,K~+,Cl~-,Ca~(2+) and Mg~(2+)) and carbon fractions(OC and EC) were also analyzed.The concentrations of heavy metals were 1.03–1.98 times higher in hazy days than those in non-hazy days,mainly due to biomass burning and coal burning.The trends in total heavy metals concentrations were basically consistent with the trends in PM concentrations except for two obvious periods(12.29–12.30;1.14–1.15);but when air masses accumulated locally or around Beijing,trends in PM concentrations and heavy metals were opposite.The proportion for NO_3~-/SO_4~(2-) indicated that mobile sources such as automobiles were important reasons for haze in Beijing.Correlation between OC and EC during non-hazy days was strong(R~2= 0.95) but it was low(R~2= 0.67) during hazy days,and large variations for OC/EC values occurred in hazy days.The calculated mass concentration of SOC is 2.58 μg/m~3,which only accounted for 10.1% of the OC concentration.When air masses from the far north-west,they decreased PM concentration in Beijing and they were relatively clean;however,those from the near east,south-east and south of the mainland increased PM concentration and they were dirty.     

镧铝改性凹凸棒粘土对富营养化湖泊有机磷控制效果

通过吸附与原位模拟实验,研究了镧铝改性凹凸棒粘土（La/Al@ACP）对水体有机磷的吸附性能及其覆盖对沉积物磷释放的影响,并通过沉积物磷分级、DGT技术、扫描电镜能谱技术探讨材料覆盖对沉积物磷形态影响机制.结果显示,La/Al@ACP添加后,上覆水及底泥间隙水中磷含量显著下降,并伴随沉积物有效磷通量的减少.有机磷形态分析表明,添加La/Al@ACP后活性态的Lab-P_o不断向稳定态的Hum-P_o转化,有效控制了底泥磷向上覆水释放的风险.La/Al@ACP作为一种控制湖泊富营养化的有效材料,可用于底泥内源磷的固定与控制.     

CeO2形貌结构对催化湿式空气氧化苯酚性能的影响

采用水热法、沉淀法和溶胶凝胶法制备了3种不同形貌的CeO₂催化材料,并将其用于湿式空气氧化苯酚水溶液过程中,探讨了CeO₂形貌结构对催化湿式氧化苯酚水溶液性能的影响.采用扫描电子显微镜（SEM）、透射电子显微镜（TEM）、X射线衍射（XRD）、程序升温还原（TPR）等手段对CeO₂催化材料进行了表征.结果表明,水热法制备的CeO₂催化材料表现出较好催化性能,主要原因是水热法合成的CeO₂呈现交错的纳米棒状结构,主要暴露（220）晶面,且沿着（220）晶向生长.在反应温度为200℃、空气压力为2MPa、苯酚初始浓度500mg/L的条件下,最终（240min）COD的去除率为95.5%.     

沈阳市郊区环境空气中醛酮类化合物的污染特征与来源分析

为探究沈阳市郊区环境空气中醛酮类化合物的污染特征,于2017年8月24日—9月2日采用2,4-二硝基苯肼固相吸附/高效液相色谱方法对沈阳市郊区醛酮类化合物进行观测分析,利用美国环境保护局推荐的人体健康风险评价方法对部分有毒有害醛酮类化合物的人体健康风险进行了评价,并利用比值法对醛酮类化合物的来源进行了初步分析.结果表明:醛酮类化合物质量浓度日均值范围为23.16~38.38 μg/m3;质量浓度最高的4种醛酮类化合物依次是丙酮、甲醛、正丁醛和乙醛,其质量浓度日均值的平均值分别为8.71、5.90、5.48和2.95 μg/m3.对·OH消耗速率(L_OH)贡献较大的醛酮类化合物物种是正丁醛、甲醛和乙醛,臭氧生成潜势贡献(OFP)较大的醛酮类化合物物种是甲醛、正丁醛和乙醛,在研究区影响醛酮类化合物光化学反应活性的物种主要是甲醛、乙醛和正丁醛.研究区观测期间,环境空气中甲醛和乙醛的致癌性风险值分别为1.18×10-5和5.91×10-6,对暴露人群存在潜在的致癌风险;乙醛的非致癌风险值为0.05,对暴露人群不存在非致癌风险.在研究区的一次臭氧轻度污染过程期间,环境空气中的甲醛和乙醛受天然源排放的挥发性有机物二次转化的影响减弱,甲醛、乙醛和丙酮受到炼焦工业和机动车等人为源排放的影响增强,而正丁醛主要受当地精细化工产业排放的影响.研究显示,沈阳市应加大对炼焦工业、精细化工和机动车来源排放醛酮类化合物的管制,以降低环境空气中活性醛酮类化合物及有毒有害醛酮类化合物的浓度.