Leachate characterization in semi-aerobic and anaerobic sanitary landfills: A comparative study

This study analyzes and compares the results of leachate composition at the semi-aerobic Pulau Burung Landfill Site (PBLS) (unaerated pond and intermittently aerated pond) and the anaerobic Kulim Sanitary Landfill in the northern region of Malaysia. The raw samples were collected and analyzed for twenty parameters. The average values of the parameters such as phenols (1.2, 6.7, and 2.6 mg/L), total nitrogen (448, 1200, and 300 mg/L N-TN), ammonia-N (542, 1568, and 538 mg/L NH₃-N), nitrite (91, 49, and 52 mg/L NO₂^?-N), total phosphorus (21, 17, and 19 mg/L), BOD₅ (83, 243, and 326 mg/L), COD (935, 2345, and 1892 mg/L), BOD₅/COD (0.096,0.1124,0.205%), pH (8.20, 8.28, and 7.76), turbidity (1546, 180, and 1936 Formazin attenuation units (FAU)), and color (3334, 3347, and 4041 Pt Co) for leachate at the semi-aerobic PBLS (unaerated and intermittently aerated) and the anaerobic Kulim Sanitary Landfill were recorded, respectively. The obtained results were compared with previously published data and data from the Malaysia Environmental Quality Act 1974. The results indicated that Pulau Burung leachate was more stabilized compared with Kulim leachate. Furthermore, the aeration process in PBLS has a considerable effect on reducing the concentration of several pollutants. The studied leachate requires treatment to minimize the pollutants to an acceptable level prior to discharge into water courses.     

Myco- and phyco-remediation of polychlorinated biphenyls in the environment: a review

Environmental Science and Pollution Research - Polychlorinated biphenyls (PCBs) are toxic organic compounds and pose serious threats to environment and public health. PCBs still exist in different...     

Domestic water conservation potential in Saudi Arabia

Domestic water conservation in arid climates can result in efficient utilization of existing water supplies. The impacts of conservation measures such as the installation of water-saving devices, water metering and pricing schemes, water rationing and public awareness programs, strict plumbing codes, penalties for wasting water, programs designed to reduce leakage from public water lines and within the home, water-efficient landscaping, economic and ethical incentives are addressed in detail. Cost savings in arid climates, with particular reference to Saudi Arabia, in relation to some conservation techniques, are presented. Water conservation technology and tentative demonstration and implementation of water conservation programs are discussed.     

Enrichment and isolation of endosulfan-degrading microorganisms

Endosulfan (6,7,8,9,10,10-hexachloro-1,5,5a,6,9,9a-hexahydro-6,9-methano-2,3,4-benzo-dioxathiepin-3-oxide) is a cyclodiene organochlorine currently used as an insecticide all over the world and its residues are posing a serious environmental threat. This study reports the isolation and identification of enriched microorganisms, capable of degrading endosulfan. Enrichment was achieved by using the insecticide as either the sole source of carbon or sulfur in parallel studies. Two strains each of fungi (F1 and F4) and bacteria (BF2 and B4) were selected using endosulfan as a sole carbon source. A Pandoraea species (Lin-3) previously isolated in our laboratory using lindane (gamma-HCH) as a carbon source was also screened for endosulfan degradation. F1 and F4 (Fusarium ventricosum) degraded alpha-endosulfan by as much as 82.2 and 91.1% and beta-endosulfan by 78.5 and 89.9%, respectively, within 15 d of incubation. Bacterial strains B4 and Lin-3 degraded alpha-endosulfan up to 79.6 and 81.8% and beta-endosulfan up to 83.9 and 86.8%, respectively, in 15 d. Among the bacterial strains isolated by providing endosulfan as a sulfur source, B4s and F4t degraded alpha-endosulfan by as much as 70.4 and 68.5% and beta-endosulfan by 70.4 and 70.8%, respectively, after 15 d. Degradation of the insecticide occurred concomitant with bacterial growth reaching an optical density (OD600) of 0.366 and 0.322 for B4 and Lin-3, respectively. High OD600 was also noted with the other bacterial strains utilizing endosulfan as a sulfur source. Fungal and bacterial strains significantly decreased the pH of the nutrient culture media while growing on endosulfan. The results of this study suggest that these novel strains are a valuable source of potent endosulfan-degrading enzymes for use in enzymatic bioremediation.     

An experimental investigation into micro ball end-milling of silicon

Silicon is a representative operational material for semiconductor and micro-electronics. In certain MEMS applications, it is required to fabricate three dimensional channels and complex pattern on silicon substrate. Such features are typically fabricated by photolithography and chemical etching. These processes have low productivity and have certain other limitations. Therefore, a viable switch-over from non-traditional fabrication processes to traditional machining is highly desired for improved productivity in high-mix low-volume production. However, machining of silicon by traditional process is extremely difficult due to its high brittleness. Even very small forces produced during machining can cause brittle fracture on silicon surface resulting in deteriorated surface quality. The fundamental principle in machining of a brittle material such as silicon is to achieve material removal through plastic deformation rather than crack propagation. This paper presents the experimental results of ductile-mode machining of silicon by micro ball end-milling. The workpiece surface was inclined to the rotational axes of the cutter to improve the surface finish. It was established experimentally that 15-μm deep, fracture-free slots can be machined on silicon wafer by micro ball end-milling if the feed rate is below a certain threshold. The influence of several machining parameters on the roughness of machined-surface was also investigated. Cubic boron nitride (CBN) is presented as much economical alternative tool-material to single-crystal diamond for machining silicon in ductile-mode.     

The global partnership for sustainable development

This paper examines whether foreign aid, together with other economic, social and environmental factors, contributes to sustainable development. It starts with an illustrative theoretical growth model where foreign aid promotes sustainable development by protecting the environment. Using factor analysis and newly developed estimation methods for a dynamic panel data model with endogenous regressors, the empirical section of the paper finds evidence that foreign aid has had a significantly positive influence on sustainable development in aid recipient countries. This effect is very likely to go through channels related to growth and resources as well as a technology channel with respect to energy intensity. This research has important implications for a post‐2015 development framework on international collective action with regard to a sustainable future.     

Kinetic,equilibrium and thermodynamic studies for the sorption of metribuzin from aqueous solution using banana peels,an agro-based biomass

Banana peels were employed for the removal of metribuzin from aqueous solution. Sorption in the batch mode was optimized regarding pH, contact time, sorbent dose, initial pesticide concentrations, and temperature. The sorption data were fitted to pseudo-first-order, pseudo-second-order, intraparticle diffusion, Elovich, and liquid film diffusion model, the pseudo-second-order exhibiting best fit (R² = 0.9803). Of the four most common sorption isotherm models (Langmuir, Freundlich, Tempkin, and Dubinin–Radushkevich), the data followed the Langmuir isotherm with highest correlation. The maximum adsorption capacity was found to be 167 mg g^?1. Gibbs free energy, enthalpy, and entropy showed that the sorption was exothermic and spontaneous.     

Estimation and inter-comparison of dust aerosols based on MODIS, MISR and AERONET retrievals over Asian desert regions

This study presents detailed analysis of spatiotemporal variations and trend of dust optical properties i.e., Aerosol Optical Depth(AOD) and Angstrom component over Asian desert regions using thirteen years of data(i.e., 2001–2013) retrieved from Aerosol Robotic Network(AERONET), Moderate Resolution Imaging Spectroradiometer(MODIS) and Multi-angle Imaging Spectroradiometer(MISR). These regions include Solar Village, Dunhuang and Dalangzadgad and are considered as origin of desert aerosols in Asia. Mann–Kendall trend test was used to show the trend of AOD. The relationship of AOD with weather parameters and general AOD trend over different wavelengths has also been shown. AOD's trend has been observed significant throughout the year in Solar Village, while in Dunhuang and Dalanzadgad the significant trend has been found only in peak period(March–June).Analysis show high values of AOD and low values of angstrom in Solar Village during peak period. In Chinese desert regions, high values of AOD have been found during peak period and low values in pre-peak period. Significant relationship has been observed between AOD and average temperature in Solar Village and Dalanzadgad whereas rainfall and wind speed showed no significant impact on AOD in all desert regions.