Injuries as a Result of California Earthquakes in the Past Decade

The devastating effects of earthquakes have been demonstrated repeatedly in the past decade, through moderate and major earthquakes such as the October 1987 Whittier Narrows earthquake (5.9 on the Richter scale), the October 1989 Loma Prieta earthquake (7.1) and the January 1994 Northridge earthquake (6.7). While 'official' tallies of injuries and deaths are reported for each event, the numbers vary from report to report. For Northridge, the number of injuries vary between 8,000 and 12,000; the number of deaths from 33 to 73 (Peek-Asa et al., 1997; Durkin, 1996).While official estimates are commonly reported following disasters, the study of actual numbers, types and causes of casualties has not developed. In this paper, we identify the numbers and risk factors for injuries within community-based samples across three earthquakes in urban California. We first report the numbers and types of injuries in each earthquake and then identify risk factors specifically associated with the Northridge earthquake     

Glutathione as a matrix for the synthesis of CdS nanocrystallites

GSH-capped CdS nanocrystallites were synthesized by reacting Cd(II)-GSH with aqueous sodium sulfide using specific initial sulfide/Cd(II) ratios. Spectroscopic analyses of fractions obtained from a size exclusion column showed varying absorption spectra indicating a significant dispersion in size-distribution of nanocrystallites at lower sulfide/Cd(II) ratios. However, size distribution of the nanocrystallites was narrower at initial sulfide/Cd(II) ratios that exceeded 1.0. An ethanol precipitation procedure was used to remove free Cd(II)-GSH complexes and selectively isolate GSH-capped nanocrystallites in a very narrow size range. Size exclusion chromatography indicated similar chemical compositions and overlapping spectral profiles of ethanol-precipitated samples suggesting apparent uniformity in both the size and the cap content. All of the GSH-capped CdS nanocrystallites with varying cap contents degraded p-nitrophenol upon irradiation at 366 nm. However, photocatalytic degradation of p-nitrophenol was significantly higher in samples with higher sulfide/Cd ratio and less capping material. The addition of H2O2 enhanced levels of photo-oxidation of p-nitrophenol.     

Experimental and numerical study of the dispersion of motor vehicle pollutants under idle condition

The aim of the work presented here is to study experimentally and numerically the dispersion characteristics of vehicular exhaust plume at an idle condition in an idealized and simplified environment. The gaseous and particulate concentrations in the exhaust plume of three idling motor vehicles were measured in an isolated environment under calm weather conditions. Despite the difference in the initial concentrations, the pollutants decayed exponentially in all directions.The CFD code PHOENICS 3.3, with the k–ε eddy dissipation sub-model, was used for the numerical simulation. The simulated results match very well with the experimental results close to the source of emission but decay to the ambient concentrations much slower. The effects of the initial emission concentration, exit velocity, exit direction and crosswind intensity have been investigated parametrically. The initial pollutant concentration will increase the local concentrations but the pattern of dispersion remains the same. The exit velocity will increase the momentum of the jet, resulting in a deeper penetration downstream. The exit angle has a stronger influence on pollutant dispersion than both initial pollutant concentration and exit velocity. When the exit angle is 15°, the pollutants tend to spread on the ground region. Crosswind shows a significant effect on the dispersion of the exhaust plume also. It will divert the plume to disperse in the same direction of the wind with limited penetration in the downstream direction.     

Mussel watch: a review of Cu and other metals in various marine organisms in Taiwan, 1991-98

This study presents the distribution of Cu, Zn, Pb, Cd, Hg and As in various marine organisms collected along the western coast of Taiwan from 1991 to 1998, and also evaluates the time variation of Cu in oysters before (1980-85) and after (1986-98) the "green oyster" incident. The results show that relatively high geometric mean (GM) concentrations of Cu, Zn, Pb, Cd, As and Hg were generally found in Crassostrea gigas (Cu=229 microg/g, Zn=783 microg/g), Gomphina aeguialtera (Pb=30.3 microg/g), Tegillarca granosa (Cd=2.85 microg/g), Thais clavigera (As=96.9 microg/g) and Parapenaeopsis cornuta (Hg=1.35 microg/g), respectively. Especially, maximum Cu and Zn concentrations (GM=229 and 783 microg/g, respectively) in oysters (C. gigas) from different culture areas were much higher than those of the other organisms by about 1.13-458 and 2.40-63.7 times, respectively. Similarly, rock-shells (Thais clavigera) had a high capacity for accumulating Cu (GM=202 microg/g) and Zn (GM=326 microg/g) under the same physico-chemical conditions. The highest GM Cu and Zn concentrations of 1108 (range from 113 to 2806) and 1567 (range from 303 to 3593) microg/g were obtained in oysters from the Hsiangshan coastal area, one of the most important oyster culture areas in Taiwan. However, the highest GM Cd and As concentrations of 6.82 and 19.3 microg/g were found in oysters from the Machu Islands. Mean Cu concentrations in the oysters from the Erhjin Chi estuary declined from 2194+/-212 microg/g in 1986-90 to 545 microg/g (GM) in 1991-96. In the Hsiganshan area, GM Cu concentrations of 909 microg/g (1991-96) and 1351 microg/g (1997-98) in oysters were significantly higher than those of 201 microg/g (1980-85) and 682 microg/g (1986-90). The gradually increasing levels of Cu and Zn in the oysters from the Hsiangshan area have been observed year by year.     

On-road motor vehicle emissions and fuel consumption in urban driving conditions

This paper reports on the analysis of on-road vehicle speed, emission, and fuel consumption data collected by four instrumented vehicles. Time-, distance-, and fuel-based average fuel consumption, as well as CO, HC, NOx, and soot emission factors, were derived. The influences of instantaneous vehicle speed on emissions and fuel consumption were studied. It was found that the fuel-based emission factors varied much less than the time- and distance-based emission factors as instantaneous speed changed. The trends are similar to the results obtained from laboratory tests. The low driving speed contributed to a significant portion of the total emissions over a trip. Furthermore, the on-road data were analyzed using the modal approach. The four standard driving modes are acceleration, cruising, deceleration, and idling. It was found that the transient driving modes (i.e., acceleration and deceleration) were more polluting than the steady-speed driving modes (i.e., cruising and idling) in terms of g/km and g/sec. These results indicated that the on-road emission measurement is feasible in deriving vehicle emissions and fuel consumption factors in urban driving conditions.     

The effects of perennial ryegrass and alfalfa on microbial abundance and diversity in petroleum contaminated soil

Enhanced rhizosphere degradation uses plants to stimulate the rhizosphere microbial community to degrade organic contaminants. We measured changes in microbial communities caused by the addition of two species of plants in a soil contaminated with 31,000 ppm of total petroleum hydrocarbons. Perennial ryegrass and/or alfalfa increased the number of rhizosphere bacteria in the hydrocarbon-contaminated soil. These plants also increased the number of bacteria capable of petroleum degradation as estimated by the most probable number (MPN) method. Eco-Biolog plates did not detect changes in metabolic diversity between bulk and rhizosphere samples but denaturing gradient gel electrophoresis (DGGE) analysis of PCR-amplified partial 16S rDNA sequences indicated a shift in the bacterial community in the rhizosphere samples. Dice coefficient matrices derived from DGGE profiles showed similarities between the rhizospheres of alfalfa and perennial ryegrass/alfalfa mixture in the contaminated soil at week seven. Perennial ryegrass and perennial ryegrass/alfalfa mixture caused the greatest change in the rhizosphere bacterial community as determined by DGGE analysis. We concluded that plants altered the microbial population; these changes were plant-specific and could contribute to degradation of petroleum hydrocarbons in contaminated soil.     

Oyster Contamination with Human Noroviruses Impacted by Urban Drainage and Seasonal Flooding in Vietnam

This study investigated the level of norovirus contamination in oysters collected at a lagoon receiving urban drainage from Hue City for 17 months (August 2015–December 2016). We also investigated the genetic diversity of norovirus GI and GII in oyster and wastewater samples by using pyrosequencing to evaluate the effect of urban drainage on norovirus contamination of oysters. A total of 34 oyster samples were collected at two sampling sites (stations A and B) in a lagoon. Norovirus GI was more frequently detected than GII (positive rate 79 vs. 41%). Maximum concentrations of GI and GII were 2.4 × 10⁵ and 2.3 × 10⁴ copies/g, respectively. Co-contamination with GI and GII was observed in 35% of samples. Norovirus GII concentration was higher at station A in the flood season than in the dry season (P = 0.04, Wilcoxon signed-rank test). Six genotypes (GI.2, GI.3, GI.5, GII.2, GII.3, and GII.4) were identified in both wastewater and oyster samples, and genetically similar or identical sequences were obtained from the two types of samples. These observations suggest that urban drainage and seasonal flooding contribute to norovirus contamination of oysters in the study area.     

Nitrate removal and extracellular polymeric substances of autohydrogenotrophic bacteria under various pH and hydrogen flow rates

In recent years there has been an increasing interest in the use of autohydrogenotrophic bacteria to treat nitrate from wastewater. However, our knowledge about the characteristics of extracellular polymeric substances (EPS) releasing by these activities is not yet very advanced. This study aimed to investigate the change in EPS compositions under various pH values and hydrogen flow rates, taking into consideration nitrogen removal. Results showed that pH 7.5 and a hydrogen flow rate of 90 mL/min were the optimal operating conditions, resulting in 100% nitrogen removal after 6 hr of operation. Soluble and bound polysaccharides decreased, while bound proteins increased with increasing pH. Polysaccharides increased with increasing hydrogen flow rate. No significant change of bound proteins was observed at various hydrogen flow rates.     

A dynamic simulation of methane fermentation process receiving heterogeneous food wastes and modelling acidic failure

Microbial response on volatile fatty acids (VFAs) is a key for methane fermentation processes since accumulation of VFAs often causes an acidic failure, especially treating such organics as food wastes composed of mostly readily biodegradable materials. To evaluate the impact of VFA accumulation, a lab-scale continuous experiment was performed for 110 days with sequential feeding of heterogeneous food wastes. When the volumetric loading rate was increased from 6 to 8 kg-COD/m³/day, a sudden decrease of methane production was observed with an accumulation of acetate and propionate in the fermenter. After discontinuation of feeding for 10 days, the digestate in the fermenter was centrifuged and washed with tap water to reduce the VFAs to be acceptable concentration below 1000 mg-COD/L. Nevertheless, no recovery of methane production was observed and VFA concentrations consistently increased. To model the event, a modification of ADM1 was made assuming the methanogens in the fermenter were irreversibly inactivated under very high VFA. Also considering the different nature of the fed food wastes over 11 samples, decomposition kinetics of individual food wastes were manipulated. The modified ADM1 with methanogenic activity decay reasonably reproduced the responses for soluble material concentrations and methane gas production rate over the experimental period.