Mechanism and Characterization of Polyamide 4 Degradation by <Emphasis Type="Italic">Pseudomonas</Emphasis> sp.

We identified a biodegrading microorganism of polyamide (nylon) 4, a linear polymer of γ-aminobutyric acid (GABA). From activated sludge, the biodegrading bacteria strains of Pseudomonas sp. were isolated and identified by their taxonomic characteristics and nucleotide sequences of 16S rDNA. One strain, ND-11, was grown on a minimal medium containing polyamide 4 (PA4) as the sole carbon source. The strain produced GABA as a degradation intermediate, as identified by analyzing the NMR spectra of degraded products. The culture supernatant of strain ND-11 degraded the emulsified PA4 completely within one day. These results suggest that the ND-11 strain degraded PA4 using its extracellular enzymes to hydrolyze amide bonds.     

The effects of pH on fluoxetine in Japanese medaka (Oryzias latipes): acute toxicity in fish larvae and bioaccumulation in juvenile fish

Recent detection of fluoxetine in the aquatic environment and fish suggests a possibly high accumulation of fluoxetine; however, no report is available on the bioaccumulation of fluoxetine in aquatic organisms. Since bioaccumulation of fluoxetine was probably dependent on pH near the pK(a) value of 10.1, experiments were conducted approximately at pH 7, 8, and 9. Distribution coefficients between 1-octanol and water (D(ow)), and those between synthetic membrane vesicles (liposomes) and water (D(lip-wat)) were determined at pH 7, 8, and 9. The D(ow) and D(lip-wat) values increased significantly with increasing pH. Acute toxicity tests were performed using Japanese medaka (Oryzias latipes) prior to the bioaccumulation test, and 96-h LC(50) values were 5.5, 1.3, and 0.20mgl(-1) at pH 7, 8, and 9, respectively. In the bioaccumulation test, concentrations of fluoxetine and its major metabolite, norfluoxetine, in the fish body and liver were measured. The bioconcentration factors (BCF) of fluoxetine for Japanese medaka were 8.8, 3.0x10, and 2.6x10(2) in the body and 3.3x10(2), 5.8x10(2), and 3.1x10(3) in the liver at pH 7, 8, and 9, respectively. The BCF values were lower at pH 7 and higher at pH 9 mainly because of the increase in nonionized species with significantly higher hydrophobicity than the ionized species at pH values closer to pK(a). A similar trend was obtained for the concentration of norfluoxetine in the fish but the pseudo-BCF values (the ratio of the norfluoxetine concentration in the fish and the fluoxetine concentration in test water) were higher than the BCF value of fluoxetine at all pH conditions.     

Postembryonic development of the bone-eating worm Osedax japonicus

Bone-eating worms of the genus Osedax exclusively inhabit sunken vertebrate bones on the seafloor. The unique lifestyle and morphology of Osedax spp. have received much scientific attention, but the whole process of their development has not been observed. We herein report the postembryonic development and settlement of Osedax japonicus Fujikura et al. (Zool Sci 23:733–740, 2006). Fertilised eggs were spawned into the mucus of a female, and the larvae swam out from the mucus at the trochophore stage. Larvae survived for 10 days under laboratory conditions. The larvae settled on bones, elongated their bodies and crawled around on the bones. Then they secreted mucus to create a tube and the palps started to develop. The palps of O. japonicus arose from the prostomium, whereas the anterior appendages of other siboglinids arose from the peristomium. The recruitment of dwarf males was induced by rearing larvae with adult females. Females started to spawn eggs 6 weeks after settlement.     

Inactivation effect of pressurized carbon dioxide on bacteriophage Qβ and ΦX174 as a novel disinfectant for water treatment

The inactivation effects of pressurized CO2 against bacteriophage Qβ and ΦX174 were investigated under the pressure of 0.3–0.9 MPa, initial concentration of 107–109PFU/mL, and temperature of17.8°C–27.2°C. The optimum conditions were found to be 0.7 MPa and an exposure time of 25 min. Under identical treatment conditions, a greater than 3.3-log reduction in bacteriophage Qβ was achieved by CO2, while a nearly 3.0 log reduction was observed for phage ΦX174. The viricidal effects of N2O(an inactivation gas with similar characteristics to CO2), normal acid(HCl), and CO2 treatment with phosphate buffered saline affirmed the chemical nature of CO2 treatment. The pumping cycle, depressurization rate, and release of intracellular substances caused by CO2 were its viricidal mechanisms. The results indicate that CO2 has the potential for use as a disinfectant without forming disinfection by-products.     

Post furnace formation of PCDDs and PCDFs in MSWI: Observations in an incinerator installed with quench reactor

Reduction of dioxin emission by a quench reactor with lime spray was investigated in relation to post furnace formation pathways. Results showed that the quench reactor performed to supress post furnace reaction of precursor molecules to form selected congeners of PCDD and PCDF.     

Life cycle assessment of integrated recycling schemes for plastic containers and packaging with consideration of resin composition

Many life cycle assessment studies have evaluated and compared the environmental performance of various technologies for recycling plastic containers and packaging in Japan and other countries. However, no studies have evaluated the combination of recycling technologies in consideration of the resin composition in terms of the quantity of each recycled product so as to maximize their environmental potential. In this study, 27 scenarios of recycling schemes for household waste plastic containers and packaging are developed through integrating a conventional recycling scheme with additional recycling schemes. The conventional recycling scheme involves municipal curbside collection and either the material recycling or feedstock recycling of waste plastics. The additional recycling schemes are feedstock recycling in steel works of the residue from conventional material recycling processes, and corporate voluntary collection and independent material recycling of specific types of plastic trays. Life cycle assessment based on the modeling of recycling processes considering the resin composition in terms of the quantity of each recycled product is applied to evaluate and compare these scenarios from the viewpoints of fossil resource consumption and CO₂ emission. The results show that the environmental loads are reduced in all scenarios including the additional recycling schemes compared with the conventional recycling scheme. However, the independent plastic tray recycling scheme exhibits lower additional environmental savings when the residue recycling scheme is integrated with the conventional material recycling scheme. This is because both additional recycling schemes aim to utilize polystyrene and polyethylene terephthalate, which would otherwise be incinerated as residue from material recycling processes. The evaluation of the environmental loads of plastic recycling with consideration of the resin composition in terms of the quantity of each recycled product makes it possible to investigate recycling schemes that integrate different technologies to maximize their environmental potential.