EM菌处理垃圾渗滤液的微生物生态学及机理分析研究

通过DNA提取,PCR扩增和DGGE分离,用BLAST程序进行相似性比较分析体系中微生物群落多样性。所有序列与数据库中16S rDNA序列的相似性在94%~100%之间。从整个挂膜过程考虑,挂膜时间应在8天左右。渗滤液中污染物的去除与投加EM有很大的关系,但是渗滤液中原始菌种的贡献同样不可忽视。投加EM菌剂促进了渗滤液中群落结构演替和功能优化,并最终通过EM菌剂和渗滤液中原始菌群的共同作用实现渗滤液处理系统效能提高和完善。     

粤桂水源地有机氯农药的污染特征及生态风险

利用固相萃取-气相色谱-质谱联用技术(SPE-GC-MS)检测了粤桂水源地7个采样点水样中16种有机氯农药(OCPs)的浓度,分析了研究区OCPs的污染特征;利用BurrⅢ型分布构建了8种OCPs的物种敏感度分布曲线,并计算出不同OCPs对淡水水生生物的HC5(hazardous concentration for 5%species)值,最后应用安全阈值法评价了OCPs对水生生物的生态风险.结果表明,OCPs的浓度在6.64~34.19 ng·L~(-1)之间,平均值为16.76 ng·L~(-1),HCHs和DDTs及其降解产物在污染物中的贡献比例较大.HCHs主要来自家庭杀虫剂中的林丹,DDTs主要来自三氯杀螨醇的污染或历史残留.脊椎动物对OCPs的耐受性高于无脊椎动物,α-硫丹对水生植物和微生物的影响较大,p,p'-DDT对脊椎动物和无脊椎动物的影响较大.粤桂水源地OCPs对水生生物没有显著的生态风险,但DDTs和α-硫丹对水生生物存在较高的潜在风险,应加以重视.     

某天然气净化厂污水处理装置改造可行性研究

通过多次的现场调研、收集资料和水质监测,分析了引进天然气净化厂生产的产污环节,现有的污水处理装置的有关设计图纸及污水处理的运行情况.在此基础上,采用理论分析与实际问题相结合的方式,针对现有污水处理过程中的不足,提出了该厂的污水处置适应性改造的可行性研究.     

聚硅酸铝铁/羧基壳聚糖复合絮凝剂处理硫化黑染料废水的研究

用聚硅酸铝铁/羧基壳聚糖复合絮凝剂对硫化黑染料废水进行了处理,研究了影响絮凝剂处理硫化黑染料废水的影响因素。结果表明,较佳的条件为转速50 r/min、聚硅酸铝铁和羧基壳聚糖的质量配比为3、废水pH值为9.0、絮凝剂用量为60 mg/L。在该条件下,复合絮凝剂对硫化黑染料废水的COD、色度、浊度去除率分别为92.1%,88.6%,96.3%。     

负载稀土元素活性碳纤维在微型反应器中净化NO废气

以NH3为还原剂,以活性碳纤维（ACF）、HNO,浸渍的ACF、负载CuO的ACF和负载La2O3的ACF为催化剂,在微型反应器中考察各种催化剂对NO催化还原的活性,并进行了差热-热重、扫描电镜分析。实验结果表明,ACF负载La能有效地改善催化剂的活性,且催化活性中心为非晶态的氧化物;当ACF负载20％的La2O3时具有最好的低温活性,NO的去除率最高可达92％以上。     

膜表面形貌对厌氧膜生物反应器膜污染影响的试验研究

在厌氧膜生物反应器处理高浓度食品废水的试验中,借助原子力显微镜分析了四种表面形貌不同的聚醚砜超滤膜的通量衰减规律.结果表明,超滤膜表面形貌愈粗糙,膜通量的衰减速率愈快,且化学清洗后恢复愈困难.     

微生物强化处理与堆制强化处理含油污泥对比试验

为探索含油污泥的高效处理方法,对含油量为12.68%的污泥进行微生物菌剂强化处理和堆制强化处理现场试验.在第1、15、30d分别向微生物强化处理单元投加微生物菌剂和营养液;同时向堆制强化单元投加10kg畜禽粪便来提供共降解物质,强化堆制处理过程.结果表明,微生物强化处理单元含油量持续下降,56d后下降至6.42%,去除率达到47%;强化堆制单元处理效果较好,56d后含油量下降至6.98%,去除率达到31%;对照单元含油量则变化很小,56d后含油量为10.15%.对照单元的pH基本保持不变,最高为8.28,最低为7.93,微生物强化处理单元pH最低达到7.33,一般稳定在7.8左右,菌剂的添加对pH影响明显.堆制强化处理单元温度随着农家肥的添加而剧烈升高,最高达到54℃.试验进行过程中监测了样品中微生物总数的变化情况.通过气谱-质谱分析,可以明显地看出2种方法处理后,含油污泥中石油成分的差异,对碳原子数小于21的烃类有着良好的去除效果.     

玄武湖蓝藻水华成因探讨

为了解南京玄武湖蓝藻水华的成因,对玄武湖长期监测资料进行了分析和现场调查。结果表明,玄武湖鲢鳙急剧减少中断了正常的食物链,使浮游植物的牧食压力降低,在东南湖回水的诱因作用下,发生了以微囊藻为优势种群的蓝藻水华。指出,玄武湖蓝藻水华的发生进程表明,东南湖回水可能是蓝藻水华发生的诱因,生态失衡是蓝藻水华发生的主要原因,蓝藻水华的暴发与富营养化程度无显著相关性,其暴发加重了玄武湖富营养化程度。     

Distribution Characteristics and Implication of n-alkanes in Soils and Plants in Alpine Meadow

Russian Journal of Ecology - The present study was conducted to investigate the n-alkane composition of typical alpine meadows. Plant and soil samples were collected and analyzed to characterize...     

Study on the denitrification performance of FexLayOz/activated coke for NH3-SCR and the effect of CO escaped from activated coke at mid-high temperature on catalytic activity

Currently, activated coke is widely used in the removal of multiple pollutants from industrial flue gas. In this paper, a series of novel Fe_xLa_yO_z/AC catalysts was prepared by the incipient wetness impregnation for NH₃-SCR denitrification reaction. The introduction of Fe-La bimetal oxides significantly improved the denitrification performance of activated coke at mid-high temperature, and 4% Fe_0.3La_0.7O_1.5/AC exhibited a superior NO_x conversion efficiency of 90.1% at 400 °C. The catalysts were further characterized by BET, SEM, XRD, Raman, EPR, XPS, FTIR, NH₃-TPD, H₂-TPR, et al., whose results showed that the perovskite-type oxide of LaFeO₃ and oxygen vacancies were produced on the catalysts’ surfaces during roasting. Fe-La doping enhanced the amount of acid sites (mainly Lewis and other stronger acid sites) and the content of multifarious oxygen species, which were beneficial for NO_x removal at mid-high temperature. Moreover, it was investigated that the effect of released CO from activated coke at mid-high temperature on the NO_x removal through the lifetime test, in which it was found that a large amount of CO produced by pyrolysis of activated coke could promote the NO_x removal, and long-term escaping of CO on the activated coke carrier did not have a significant negative impact on catalytic performance. The results of the TG-IR test showed that volatile matter is released from the activated coke while TG results showed that the weight loss rate of 4% Fe_0.3La_0.7O_1.5/AC only was 0.0015~0.007%/min at 300–400 °C. Hence, 4% Fe_0.3La_0.7O_1.5/AC had excellent thermal stability and denitrification performance to be continuously used at mid-high temperature. Finally, the mechanisms were proposed on the basis of experiments and characterization results.