Feasibility of Applying a Stable Isotopic Tracer for Direct Determination of Dry Particulate Deposition to Soybean Plants

ABSTRACT

A stable rare-earth isotopic tracer was used to measure the deposition of KNO₃ particles on soybean leaves by direct measurement of the tracer on the plant surfaces by thermal-ionization mass spectrometry. Submicrometer particles, made from a solution containing 3 |mg mL^-1 neodymium isotope (¹⁴⁸Nd, 87.9%) and 1,000 mg mL^-1 KNO₃, were dispersed with a two-fluid nozzle and released upwind of a soybean field. Total suspended- and size-fractionated-aerosol particles were collected on an open-face filter and in a micro-orifice impactor, respectively, at a distance of 40 m from the release point. Soybean leaves exposed to the plume were collected at distances ranging from 25 to 100 m. As little as 5.5 pg of the tracer (i.e., excess ¹⁴⁸Nd) was detected in soybean leaves at signal-to-noise ratios ranging from 7,500 to 240,000, in the presence of 200 to 2,700 pg of naturally occurring Nd. The dry-particle deposition velocity, determined from the ratio of the aerial concentration and directly deposited aerosol (geometric mass mean diameter, 0.20 mm) flux, and its corresponding analytical uncertainty were 0.30 cm sec^-1 and 2.5%, respectively.     

Variation of the Relative Humidity of Air Released from Canisters after Ambient Sampling

ABSTRACT

Dalton's law of partial pressures and the hypothesis that water vapor equilibrium in a canister is identical to that established above liquid water are used to predict the variation of the percent relative humidity (%RH) of air released from canisters used in ambient air sampling, typically 6-L canisters pressurized with 18 L of air. When (and if) the water vapor partial pressure in a canister exceeds its saturation vapor pressure, water vapor condensation begins and the condensation rate equals the sampling rate of water vapor into the canister. Under constant temperature conditions, the air subsequently released from the canister is less humid than the original sample, following the relationship %RH = 100% (6 L/V_s) for V_s> V_r, where V_s is the residual air volume (referenced to atmospheric pressure), and V_r is shown to depend on the %RH of the ambient air sample. V_r is the residual air volume at which water is completely removed (except for adsorbed water vapor) from the canister wall. For V_s < V_r, the predicted %RH is constant and equal to its value at V_r. Experimental values agree reasonably well with predictions at both high (90%) and low (34%) RH. However, experimental values are often slightly displaced (usually towards lower values of %RH) for mid-range %RH (61%) and variations in %RH near V_r change from canister to canister.     

Estimating Maximum Concentrations for Open Path Monitoring Along a Fixed Beam Path

ABSTRACT

Researchers have applied open path optical sensing techniques to a variety of workplace and environmental monitoring problems. Usually these data are reported in terms of a path-average (or path-integrated) concentration. When assessing potential human exposures along a beam path, this path-average value is not always informative, since concentrations along the path can vary substantially from the beam average. The focus of this research is to arrive at a method for estimating the upper-bound in contaminant concentrations over a fixed open beam path. The approach taken here uses a statistical model to estimate an upper-bound concentration based on a combination of the path-average and a measure of the spatial variability computed from point samples along the beam path. Results of computer simulations and experimental testing in a controlled ventilation chamber indicate that the model produced conservative estimates for the maximum concentration along the beam path. This approach may have many applications for open path monitoring in workplaces or wherever maximum concentrations are a concern.     

Innovative Approach for Estimating Fugitive Gaseous Fluxes Using Computed Tomography and Remote Optical Sensing Techniques

ABSTRACT

This paper presents a new approach to quantify emissions from fugitive gaseous air pollution sources. The authors combine Computed Tomography (CT) with Path-Integrated Optical Remote Sensing (PI-ORS) concentration data in a new field beam geometry. Path-integrated concentrations are sampled in a vertical plane downwind from the source along several radial beam paths. An innovative CT technique, which applies the Smooth Basis Function Minimization method to the beam data in conjunction with measured wind data, is used to estimate the total flux from the fugitive source. The authors conducted a synthetic data study to evaluate the proposed methodology under different meteorological conditions, beam geometry configurations, and simulated measurement errors. The measurement errors were simulated based on data collected with an Open-Path Fourier Transform Infra-Red system. This approach was found to be robust for the simulated errors and for a wide range of fluctuating wind directions. In the very sparse beam geometry examined (eight beam paths), successful emission rates were retrieved over a 70° range of wind directions under extremely large measurement error conditions.     

Patterns and Concentrations of PM10 in a Mountainous Basin Region

ABSTRACT

In this study, continuous data of PM₁₀ (particles with aerodynamic diameter <10 u,m) concentration measurements for a 4-yr period were analyzed. These measurements have been carried out in the Eordea Basin, an industrial area in the northwestern mountainous region of Greece. The annual, monthly, and diurnal patterns are presented and investigated regarding the prevailing meteorological conditions and atmospheric processes that affect the ambient concentrations of PM₁₀. The effect of wind on controlling PM₁₀ concentration is also discussed. Based on the data analysis, an attempt is made to provide useful information about air quality levels, taking into account U.S. Environmental Protection Agency air quality standards.     

Development and characterization of cell line from the gill tissue of Catla catla (Hamilton, 1822) for toxicological studies

Catla gill cell line (ICG) was established from gill tissue of Indian major carp (Catla catla), a freshwater fish cultivated in India. The cell line was maintained in Leibovitz’s L-15 supplemented with 10% fetal bovine serum. These cells have been sub-cultured more than 55 passages over a period of 2 years. The ICG cell line consists predominantly of epithelial-like cells. The cells were able to grow at a wide range of temperatures from 24 °C to 32 °C with an optimum temperature of 28 °C. The growth rate of gill cells increased as the fetal bovine serum (FBS) proportion increased from 2% to 20% at 28 °C with optimum growth at the concentrations of 10% or 15% FBS. Amplification of mitochondrial gene 12s rRNA using primers specific to C. catla confirmed the origin of this cell line from C. catla. The cells were successfully cryopreserved and revived at passage numbers 25, 35, 45 and 55. The cytotoxicity of three metal salts (ZnCl₂, CuSO₄ and CdCl₂) was assessed in ICG cell line using multiple endpoints such as MTT, Neutral Red assay, Alamar Blue assay and Coomassie Blue protein assay. Acute toxicity assay on fish were conducted by exposing C. catla for 96 h to three metal salts under static conditions. Statistical analysis revealed good correlation with r² = 0.908–0.985 for all combinations between endpoints employed. Linear correlations between each in vitro EC₅₀ and the in vivo LC₅₀ data were highly significant.     

Arsenic in marine sediments from French Mediterranean ports: Geochemical partitioning,bioavailability and ecotoxicology

This work investigates arsenic mobility, bioavailability and toxicity in marine port sediments using chemical sequential extraction and laboratory toxicity tests. Sediment samples were collected from two different Mediterranean ports, one highly polluted with arsenic and other inorganic and organic pollutants (Estaque port (EST)), and the other one, less polluted, with a low arsenic content (Saint Mandrier port (SM)). Arsenic distribution in the solid phase was studied using a sequential extraction procedure specifically developed for appraising arsenic mobility in sediments. Toxicity assessment was performed on sediment elutriates, solid phases and aqueous arsenic species as single substance using the embryo-toxicity test on oyster larvae (Crassostrea gigas) and the Microtox test with Vibrio fischeri. Toxicity results showed that all sediment samples presented acute and sub-chronic toxic effects on oyster larvae and bacteria, respectively. The Microtox solid phase test allow to discriminate As-contaminated samples from the less contaminated ones, suggesting that toxicity of whole sediment samples is related to arsenic content. Toxicity of dissolved arsenic species as single substance showed that Vibrio fischeri and oyster larvae are most sensitive to As(V) than As(III). The distribution coefficient (Kd) of arsenic in sediment samples was estimated using results obtained in chemical sequential extractions. The Kd value is greater in SM (450 L kg^?1) than in EST (55 L kg^?1), indicating that arsenic availability is higher for the most toxic sediment sample (Estaque port). This study demonstrates that arsenic speciation play an important role on arsenic mobility and its bioavailability in marine port sediments.