Anatomical localization and stereoisomeric composition of <Emphasis Type="Italic">Tribolium castaneum</Emphasis> aggregation pheromones

We report that the abdominal epidermis and associated tissues are the predominant sources of male-produced pheromones in the red flour beetle, Tribolium castaneum and, for the first time, describe the stereoisomeric composition of the natural blend of isomers of the aggregation pheromone 4,8-dimethyldecanal (DMD) in this important pest species. Quantitative analyses via gas chromatography–mass spectrometry showed that the average amount of DMD released daily by single feeding males of T. castaneum was 878 ± 72 ng (SE). Analysis of different body parts identified the abdominal epidermis as the major source of aggregation pheromone; the thorax was a minor source, while no DMD was detectable in the head. No internal organs or obvious male-specific glands were associated with pheromone deposition. Complete separation of all four stereoisomers of DMD was achieved following oxidation to the corresponding acid, derivatization with (1R, 2R)- and (1S, 2S)-2-(anthracene-2,3-dicarboximido)cyclohexanol to diastereomeric esters, and their separation on reversed-phase high-performance liquid chromatography at −54°C. Analysis of the hexane eluate from Porapak-Q-collected volatiles from feeding males revealed the presence of all four isomers (4R,8R)/(4R,8S)/(4S,8R)/(4S,8S) at a ratio of approximately 4:4:1:1. A walking orientation bioassay in a wind tunnel with various blends of the four synthetic isomers further indicated that the attractive potency of the reconstituted natural blend of 4:4:1:1 was equivalent to that of the natural pheromone and greater than that of the 1:1 blend of (4R,8R)/(4R,8S) used in commercial lures.     

日本企业的环境责任

上世纪90年代初期,日本的许多企业都未将环境管理、指标、社会责任等纳入企业成本、运营和规划中,他们认为这会给企业带来负担。也无必要,这种情形与现阶段的中国企业有着非常类似的“价值取向”,我们希望这篇文章能给中国的同行们带来一些思考和借鉴,从而使得我们的企业更绿,环境更清洁,社会更可持续。[编者按]     

Recycling of cathode ray tube panel glasses as aggregates of concrete blocks and clay bricks

While the cathode ray tube (CRT) funnel containing lead could be transported to a smelting facility to recover lead, which could be an available option in domestic, a proper technology to recycle a CRT panel must be developed. Thus, it was suggested that CRT panel glass be used as aggregates of concrete blocks and clay bricks. Samples of blocks and bricks were fabricated with CRT powders and tested to measure their strength and absorption rate to determine their qualities, and environmental soundness was determined by measuring the leaching rate of hazardous metals. For concrete blocks, CRT panel glass powders incorporated as aggregates up to 40 % replacing stone powder was proposed as the proper condition for manufacturing blocks. Around 2 % of CRT panel incorporated into clay brick to substitute Kaoline was suggested to fabricate the best quality of clay brick. Results of leaching test met the criteria with much less concentration of hazardous metals, even lead compound containing in the CRT funnel. To conclude, the use of CRT panel powder after crushing it to the proper size as an aggregate of concrete blocks or clay bricks could be one of the appropriate alternatives to recycle for CRT glass waste being generated drastically in a short term.     

Carbon dioxide utilization with carbonation using industrial waste-desulfurization gypsum and waste concrete

In this study, we propose a process making calcium carbonate and calcium sulfate and recovering absorbent using ammonia absorbent, carbon dioxide, and industrial waste. The main objective of this study is to confirm the possibility of carbon capture and utilization based on waste materials. We assumed desulfurization gypsum and construction waste (ready mixed concrete washing water, waste concrete, etc.) are CaSO₄, Ca(OH)₂, respectively. And concentration of simulated carbon dioxide gas was 15 vol% similar to flue gas. Calcium carbonate was produced by combination reaction between ionic CO₂ in absorbent and metal ion in the solid waste. Experiments were conducted at normal temperature and pressure. Furthermore, the generated products were characterized by X-ray diffraction, and scanning electron microscope.     

Worker drift and egg dumping by queens in wild Bombus terrestris colonies

Wild bumblebee colonies are hard to find and often inaccessible, so there have been few studies of the genetic structure of bumblebees within natural colonies, and hence, it is not clear how frequently events such as worker reproduction, worker drift and queen usurpation take place. This study aimed to quantify the occurrence of natal-worker reproduction, worker drift and drifter reproduction within 14 wild colonies of Bombus terrestris in Central Scotland. Four unlinked microsatellites were used to identify patterns of relatedness of the colonies’ adults and broods. In colonies with queens (queenright colonies), worker reproduction accounted for just 0.83 % of males, increasing to 12.11 % in queenless colonies. Four colonies contained a total of six workers which were not daughters of the queen, and were assumed to be drifters, and four male offspring of drifters. Drifting is clearly not common and results in few drifter offspring overall, although drifters produced approximately seven times more offspring per capita than workers that remained in their natal colony. Unexpectedly, two colonies contained clusters of sister workers and juvenile offspring that were not sisters to the rest of the adults or brood found in the colonies, demonstrating probable egg dumping by queens. A third colony contained a queen which was not a sister or daughter to the other bees in the colony. Although usurping of bumblebee colonies by queens in early season is well documented, this appears to be the first record of egg dumping, and it remains unclear whether it is being carried out by old queens or newly mated young queens.     

Selective recovery of Cu, Zn, and Ni from acid mine drainage

In Korea, the heavy metal pollution from about 1,000 abandoned mines has been a serious environmental issue. Especially, the surface waters, groundwaters, and soils around mines have been contaminated by heavy metals originating from acid mine drainage (AMD) and mine tailings. So far, AMD was considered as a waste stream to be treated to prevent environmental pollutions; however, the stream contains mainly Fe and Al and valuable metals such as Ni, Zn, and Cu. In this study, Visual MINTEQ simulation was carried out to investigate the speciation of heavy metals as functions of pH and neutralizing agents. Based on the simulation, selective pH values were determined to form hydroxide or carbonate precipitates of Cu, Zn, and Ni. Experiments based on the simulation results show that the recovery yield of Zn and Cu were 91 and 94 %, respectively, in a binary mixture of Cu and Zn, while 95 % of Cu and 94 % of Ni were recovered in a binary mixture of Cu and Ni. However, the recovery yield and purity of Zn and Ni were very low because of similar characteristics of Zn and Ni. Therefore, the mixture of Cu and Zn or Cu and Ni could be recovered by selective precipitation via pH adjustment; however, it is impossible to recover selectively Zn and Ni in the mixture of them.     

Evaluating the role of environmental quality in the sustainable rural economic development of England

The issue of the sustainable development of rural economies in England has recently received considerable attention. This is because many of the poorest areas in the country are rural, often of high environmental quality, but suffering from high unemployment and a lack of services and facilities. The rapid decline in agricultural incomes and in-migration of affluent urban workers since 1990 has exacerbated economic inequality in such areas. A number of factors have the potential to drive rural development and this paper applies, and considers, the feasibility of a method from the USA for combining economic and environmental variables in a regional growth model to examine the hypothesis that environmental quality is an important determinant of sustainable rural development in England. The model output suggests that, although environmental quality does play a role in sustainable rural development in England there are other, more important, factors driving development. These include business and communications infra-structure, the degree and opportunities for commuting and underlying employment prospects. The robustness and limitations of the method for combining economic and environmental variables is discussed in relation to the spatial interrelatedness of Local Authority Districts in England, and conclusions are drawn about areas for refinement and improvement of the method.

Estimation of the shadow prices of pollutants with production/environment inefficiency taken into account: a nonparametric directional distance function approach

This paper deals with the estimation of the shadow prices of pollutants with a nonparametric directional distance function approach, where the inefficiency involved in the production process is taken into account unlike the previous studies. The directional vector, which is critical to the estimation and subject to the criterion for an appropriate efficiency rule proposed here, is calculated by using the annual plans of power plants in terms of production and environment. In the empirical study for Korea's electric power industry during the period of 1990-1995, we find that the average shadow prices of sulfur oxides (SOx), nitrogen oxides (NOx), and total suspended particulates (TSP) are approximately 10% lower than those calculated under the assumption of full efficiency. The methodology we propose and the findings obtained in the empirical study allow us to undertake better decision-making over a broad range of environmental policy issues.     

APPLICATION OF GREY MODEL AND ARTIFICIAL NEURAL NETWORKS TO FLOOD FORECASTING1

The main focus of this study was to compare the Grey model and several artificial neural network (ANN) models for real time flood forecasting, including a comparison of the models for various lead times (ranging from one to six hours). For hydrological applications, the Grey model has the advantage that it can easily be used in forecasting without assuming that forecast storm events exhibit the same stochastic characteristics as the storm events themselves. The major advantage of an ANN in rainfall‐runoff modeling is that there is no requirement for any prior assumptions regarding the processes involved. The Grey model and three ANN models were applied to a 2,509 km² watershed in the Republic of Korea to compare the results for real time flood forecasting with from one to six hours of lead time. The fifth‐order Grey model and the ANN models with the optimal network architectures, represented by ANN1004 (34 input nodes, 21 hidden nodes, and 1 output node), ANN1010 (40 input nodes, 25 hidden nodes, and 1 output node), and ANN1004T (14 input nodes, 21 hidden nodes, and 1 output node), were adopted to evaluate the effects of time lags and differences between area mean and point rainfall. The Grey model and the ANN models, which provided reliable forecasts with one to six hours of lead time, were calibrated and their datasets validated. The results showed that the Grey model and the ANN1010 model achieved the highest level of performance in forecasting runoff for one to six lead hours. The ANN model architectures (ANN1004 and ANN1010) that used point rainfall data performed better than the model that used mean rainfall data (ANN1004T) in the real time forecasting. The selected models thus appear to be a useful tool for flood forecasting in Korea.