石油降解菌XD-1产表面活性剂的性能

从含油废水中筛选分离到1株原油降解菌XD-1,鉴定为假单胞菌（Pseuomonas sp.）.初步实验表明菌XD-1具有较强的产表面活性剂乳化原油的作用,对该菌的产表面活性剂性能进行了研究.实验证明,菌XD-1所产表面活性剂为脂肽类物质,菌在生长对数期产表面活性剂,表面活性剂的产生为生长相关型;充足的碳源是产表面活性剂的必需条件,菌利用原油为碳源时能持续大量地产表面活性剂;原油和尿素为产表面活性剂的最适碳源和氮源,菌XD-1产表面活性剂的最佳营养培养基组成为葡萄糖10 g,尿素4 g,磷酸二氢钾1 g,微量元素液4 mL,水1 L,pH 8.0.     

Kinetic studies of the reaction of hydroxyl radicals with trichloroethylene and tetrachloroethylene

Rate coefficients are reported for the gas-phase reaction of the hydroxyl radical (OH) with C2HCl3 (k(1)) and C2Cl4 (k2) over an extended temperature range at 740+/-10 Torr in a He bath gas. These absolute rate measurements were accomplished using a laser photolysis/laser-induced fluorescence (LP/LIF) technique under slow flow conditions. The simple Arrhenius equation adequately describes the low temperature data for k1 (<650 K) and the entire data set for k2 and is given by (in units of cm3 molecule(-1) s(-1)): k1(291 - 650 K) = (9.73+/-1.15) x 10(-13) exp (158.7+/-44.0)/T, k2(293 - 720 K ) = (1.53+/-0.14) x 10(-12) exp (-688.2+/-67.5)/T. Error limits are 2sigma values. The room temperature values for k1 and k2 are within +/-2sigma of previous data using different techniques. The Arrhenius activation energies for k1 and k2 are a factor of 2-3 lower than previously reported values. The experimental measurements for both k1 and k2 in conjunction with transition state and variation transition state theory calculations infer an OH addition mechanism. The lack of a measurable kinetic isotope effect for k1 is consistent with this mechanism. Insight into the subsequent reactions of the chemically activated intermediate are presented in the form of potential energy diagrams derived from ab initio calculations.     

An antibiotic composite electrode for improving the sensitivity of electrochemically active biofilm biosensor

• Antibiotic azithromycin employed in graphite electrode for EAB biosensor. • Azithromycin at 0.5% dosage increased the sensitivity for toxic formaldehyde. • Azithromycin increased the relative abundance of Geobacter. • Azithromycin regulated thickness of electroactive biofilm. Extensive research has been carried out for improved sensitivity of electroactive biofilm-based sensor (EAB-sensor), which is recognized as a useful tool in water quality early-warning. Antibiotic that is employed widely to treat infection has been proved feasible in this study to regulate the EAB and to increase the EAB-biosensor’s sensitivity. A novel composite electrode was prepared using azithromycin (AZM) and graphite powder (GP), namely AZM@GP electrode, and was employed as the anode in EAB-biosensor. Different dosages of AZM, i.e., 2 mg, 4 mg, and 8 mg, referred to as 0.25%, 0.5% and 1% AZM@GP were under examination. Results showed that EAB-biosensor was greatly benefited from appropriate dosage of AZM (0.5% AZM@GP) with reduced start-up time period, comparatively higher voltage output, more readable electrical signal and increased inhibition rate (30%-65% higher than control sensor with GP electrode) when exposing to toxic formaldehyde. This may be attributed to the fact that AZM inhibited the growth of non-EAM without much influence on the physiologic or metabolism activities of EAM under proper dosage. Further investigation of the biofilm morphology and microbial community analysis suggested that the biofilm formation was optimized with reduced thickness and enriched Geobacter with 0.5% AZM@GP dosage. This novel electrode is easily fabricated and equipped, and therefore would be a promising way to facilitate the practical application of EAB-sensors.     

Coprinus comatus endophytic bacteria characteristics and mechanisms for the cadmium resistance

Environmental Science and Pollution Research - Characteristics and resistant mechanisms of macro-fungus endophytic bacteria to cadmium (Cd) have not been well defined. Strains L1 and L3 with...     

pH值和曝气强度对铁还原预处理硝基苯废水效果的影响

从反应机理方面分析了pH值和曝气强度对铁还原预处理硝基苯废水的影响。研究表明:pH值对铁还原的影响明显,适当的曝气强度可有效提高铁还原预处理效果。综合考虑,最佳pH值范围为2~4,最佳曝气强度为1.50m3/(m2·h)。CODCr去除率达50%~60%,硝基苯去除率达90%以上,出水BOD5/CODCr由不到0.1提高至0.4以上。     

区域环境中三氟乙酸富积多相传质模型研究

建立了描述挥发性有机物在大气、水、土壤和底泥等环境中动态分布的多相传质模型,并用于分析长江流域江苏段及太湖水系区域内三氟乙酸(TFA)在各环境相中的分布. 采集实测数据约300个,比较实测值与模拟值,对模型的可靠行进行验证. 建立了检测环境中微量TFA前处理及方法. 结果表明:多相传质模型能够正确描述研究区域内环境中的TFA分布. 在给定排放量变化规律的前提下,预测未来10年内研究区域环境水体中ρ(TFA)将接近100 ng/L,接近现阶段欧美发达国家主要水体中的ρ(TFA).      

节能型焦化污水生物脱氮新工艺的生产性试验研究

采用节能型生物脱氮新工艺对黑龙江某焦化厂的污水处理站进行生产性试验研究,结果表明:处理后出水达到GB8978-1996《污水综合排放标准》一级,并可回用于熄焦。该工艺适合推广应用于焦化污水、垃圾渗滤液、养殖、化肥等高含氮有机污水的处理。     

大气颗粒物酸性研究

采集了北京市2007年1月总悬浮颗粒物(TSP)、PM10和PM2.5样品,将TSP样品溶解在pH=5.60稀硫酸溶液中,用反滴法测定了颗粒物在酸性条件下的酸度和潜在酸性,评价了实际大气环境下颗粒物对降水酸化的影响.     

佛山,市新区排水制度的论证

排水制度的选择是城市总体规划阶段要求确定的重要任务之一。而排水制度的选择应从一个城市的具体情况出发,经过经济技术比较方能得出结论。本文着重介绍了在佛山市总体规划修编时,通过对本市地形、地貌、地质、水文、气象、水体情况、人文景观、社会发展要求,以及城市财政能力等情况综合分析研究,确定新区排水制度的论证过程。     

膨润土团粒的压实性能研究

高放核废料深地质处置中,膨润土缓冲/回填材料需要满足低渗透性要求,实现阻滞地下水入渗和放射性核素泄漏的目标。增强膨润土防渗能力的常规方法是采用增大压实功提高其密实度,但该方法十分耗时耗能。为此,尝试从调整膨润土团(颗)粒级配角度,探究提高压实度的有效方法。首先,配置不同团粒级配和初始含水率的膨润土试样,再利用压力机压实到45 kN;最后,采用液氮冻干法干燥不同状态的试样,通过压汞仪获得其孔隙分布曲线。结果表明:相同压实荷载下(45 kN),干密度随含水率呈先增大后减小的整体变化趋势,含水率约为20%时压实效果最佳,其中O-B组合与A-B-3组合具有双峰特征;另外,通过调整团粒级配,压实效果显著提升,最大干密度由1.64 g/cm-3提高到1.72 g/cm³,其中A-B-3团粒组合效果最好。孔隙分布曲线表明,压实荷载只能压缩-3.59~0.188 μm-范围的孔隙,而对26 nm左右的孔隙没有影响。当含水率超过20%时,依靠增大压实荷载不能提高其压实度,但当改变团粒组合后,却可以有效提高其压实性能。