An intergrated waste survey and environmental effects of COGIDO, a bleached pulp and paper mill in Vietnam, on the receiving waterbody

An integrated investigation on wastewater characterization and the environmental effects from the COGIDO pulp and paper mill in Bien Hoa Industrial Estate, Vietnam, a chlorine bleached soda integrated pulp and paper mill operating without a chemical recovery system, on the receiving water body was conducted during the rainy and dry seasons in 1993 and 1995. The pollution load from the mill was very high in terms of BOD, COD and SS (COD_m: 58.7 t/d; BOD: 33.3 t/d and SS: 25.1 t/d). The effluent toxicity was determined using four toxicity tests: the green micro-alga, Selenastrum capricornutum, Microtox (marine bacteria: Photobacterium phosphoreum), the duckweed, Lemna aequinoctialis, and fish (silver barb: Puntius gonionotus, and Tilapia: Tilapia nilotica). Selenastrum capricornutum was the most sensitive among the tested organisms. The mill toxicity emission rate (TER) was as high as 338 610 (Selenastrum test). The bleaching-pulp and semi-chemical pulp plants which contributed the largest pollution load to the total COGIDO effluent, therefore, were targeted for abatement measures. Physico-chemical parameters as well as qualitative and quantitative aquatic organism composition for the river water were established. The BOD₅ and COD values exceeded the potable surface water standard by a factor of 2 to 4. The species diversity and abundance of the phytoplankton, zooplankton and zoobenthos were found to be lower (20–40%) than that of unpolluted rivers in Vietnam, whereas pollution-indicator species increased up to four times during the dry season 1995.     

长江口潮滩芦苇根表铁膜磁性特征及其环境意义

湿地植物根表铁膜对包括重金属在内的物质迁移转化具有重要作用,其氧化铁组成研究备受重视,但利用环境磁学方法进行表征的研究还未见报道.本文对长江口潮滩植物芦苇根系及周边沉积物进行了磁学分析,并结合沉积物粒度、漫反射光谱等测试,对芦苇根表铁膜的磁性矿物组成进行了系统研究.结果表明,芦苇根表铁膜磁性矿物主要包括磁铁矿和赤铁矿.由于沉积物不同深度氧化还原环境的不同,铁膜磁性矿物组成存在垂向差异.研究柱样24 cm深度以上,由于相对氧化的环境,铁膜磁性矿物除磁铁矿外,还有较多的赤铁矿贡献;24 cm深度以下,因根系处于相对还原的环境,磁性矿物以磁铁矿为主.与沉积物相比,24 cm以上深度铁膜中亚铁磁性矿物含量较低,24 cm深度以下则相反,反映铁膜和沉积物磁性矿物来源不同.本项研究表明,磁性测量方法有助于认识湿地植物根表铁膜的矿物组成,对湿地生物地球化学过程研究具有重要价值.     

Optimization of Fenton oxidation pre-treatment for B. thuringiensis – Based production of value added products from wastewater sludge

Fenton oxidation pretreatment was investigated for enhancement of biodegradability of wastewater sludge (WWS) which was subsequently used as substrate for the production of value- added products. The Response surface method with fractional factorial and central composite designs was applied to determine the effects of Fenton parameters on solubilization and biodegradability of sludge and the optimization of the Fenton process. Maximum solubilization and biodegradability were obtained as 70% and 74%, respectively at the optimal conditions: 0.01 ml H₂O₂/g SS, 150 [H₂O₂]₀/[Fe²⁺]₀, 25 g/L TS, at 25 °C and 60 min duration. Further, these optimal conditions were tested for the production of a value added product, Bacillus thuringiensis (Bt) which is being used as a biopesticide in the agriculture and forestry sector. It was observed that Bt growth using Fenton oxidized sludge as a substrate was improved with a maximum total cell count of 1.63 × 10⁹ CFU ml^?1 and 96% sporulation after 48 h of fermentation. The results were also tested against ultrasonication treatment and the total cell count was found to be 4.08 × 10⁸ CFU ml^?1 with a sporulation of 90%. Hence, classic Fenton oxidation was demonstrated to be a rather more promising chemical pre-treatment for Bt - based biopesticide production using WWS when compared to ultrasonication as a physical pre-treatment.     

Tsunami mitigation by coastal vegetation considering the effect of tree breaking

Damage to vegetation by tsunami moment and reduction of potential tsunami force are discussed based on a numerical simulation. A numerical model based on two-dimensional nonlinear long-wave equations that include drag forces and turbulence-induced shear force due to the presence of vegetation was developed to estimate tree breaking. The numerical model was then applied to a coastal forest where two dominant tropical vegetation species, Pandanus odoratissimus and Casuarina equisetifolia, were considered. The threshold water depth for tree breaking increased with increasing forest width, and the analysis was consistent with the field investigation results that the critical tsunami water depth for breaking is around 80% of the tree height for P. odoratissimus. C. equisetifolia is stronger than P. odoratissimus against tsunami action, but P. odoratissimus can reduce a greater tsunami force than C. equisetifolia due to its complex of aerial root structures. Even if breakage occurs, P. odoratissimus still has high potential to reduce the tsunami force due to its dense aerial root structures. Previous numerical models that do not include the breaking phenomena may overestimate the vegetation effect for reducing tsunami force. The combination of P. odoratissimus and C. equisetifolia is recommended as a vegetation bioshield to protect coastal areas from tsunami hazards.     

Application of GIS and modelling in health risk assessment for urban road mobility

Transport is an essential sector in modern societies. It connects economic sectors and industries. Next to its contribution to economic development and social interconnection, it also causes adverse impacts on the environment and results in health hazards. Transport is a major source of ground air pollution, especially in urban areas, and therefore contributes to the health problems, such as cardiovascular and respiratory diseases, cancer and physical injuries. This paper presents the results of a health risk assessment that quantifies the mortality and the diseases associated with particulate matter pollution resulting from urban road transport in Haiphong City, Vietnam. The focus is on the integration of modelling and geographic information system approaches in the exposure analysis to increase the accuracy of the assessment and to produce timely and consistent assessment results. The modelling was done to estimate traffic conditions and concentrations of particulate matters based on geo-referenced data. The study shows that health burdens due to particulate matter in Haiphong include 1,200 extra deaths for the situation in 2007. This figure can double by 2020 as the result of the fast economic development the city pursues. In addition, 51,000 extra hospital admissions and more than 850,000 restricted activity days are expected by 2020.     

Arsenic and other trace elements contamination in groundwater and a risk assessment study for the residents in the Kandal Province of Cambodia

Concentrations of arsenic and other trace elements in groundwater were examined at three villages (PT, POT and CHL) in the Kandal Province of Cambodia. Concentrations of arsenic in the groundwater ranged from 6.64 (in POT village) to 1543 microg/L (in PT village), with average and median concentrations of 552 and 353 microg/L, respectively. About 86% out of fifteen samples contained arsenic concentrations exceeding the WHO drinking water guidelines of 10 microg/L. Concentrations of arsenic (III) varied from 4 (in POT village) to 1334 microg/L (in PT village), with an average concentration of 470 microg/L. In addition, about 67%, 80% and 86% of the groundwater samples had higher concentrations for, respectively, barium, manganese and lead than the WHO drinking water guidelines. These results reveal that groundwater in Kandal Province is not only considerably contaminated with arsenic but also with barium, manganese and lead. A risk assessment study found that one sample (PT25) had a cumulative arsenic concentration (6758 mg) slightly higher than the threshold level (6750 mg) that could cause internal cancer in smelter workers with chronic exposure to arsenic from groundwater. High cumulative arsenic ingestion poses a health threat to the residents of Kandal Province.     

Effect of ultrasonication and Fenton oxidation on biodegradation of bis(2-ethylhexyl) phthalate (DEHP) in wastewater sludge

The presence of bis(2-ethylhexyl) phthalate (DEHP) and its metabolites, i.e. 2-ethylhexanol, 2-ethylhexanal, and 2-ethylhexanoic acid in wastewater sludge (WWS) were investigated during aerobic digestion and Bacillus thuringiensis (Bt)-based fermentation of WWS. Ultrasonication and Fenton oxidation pre-treatment was applied to improve biodegradability of WWS and bioavailability of the target compounds for digestion and fermentation. DEHP and 2-ethylhexanoic acid were observed at higher concentration, meanwhile 2-ethylhexanol and 2-ethylhexanal were observed at lower concentration in WWS. After 20-day aerobic digestion, DEHP removal was 72%, 89%, and 85%, and 2-ethylhexanoic acid removal was 71%, 84%, 79%, respectively for raw, ultrasonicated, and Fenton-oxidized sludges. Bt was found to degrade DEHP, leading to DEHP removal of 21%, 40%, and 30%, respectively for raw, ultrasonicated, and Fenton-oxidized sludges in the fermentation. The results suggested that aerobic stabilization and Bt-based fermentation can remove the phthalates, and pre-treatment of WWS was also effective in improvement of DEHP biodegradation. Hence, Bt-based biopesticide production from WWS can be applied safely when taking into consideration the phthalate contaminants.     

Pollution sources and occurrences of selected persistent organic pollutants (POPs) in sediments of the Mekong River delta, South Vietnam

The Mekong River delta is one of the largest agricultural land in the Southeast Asia. It plays a very important role for agriculture and fisheries in South Vietnam. However, comprehensive studies on the environmental pollution of persistent organic pollutants (POPs) in Mekong River delta have not been carried out in recent years. In this study, we collected sediment samples from the Mekong River to evaluate the contamination and ecological risks caused by several POPs. The contamination pattern of POPs was DDT>PCBs>CHLs>HCHs>HCB. DDTs are the most abundant pollutants, their concentration ranging from 0.01 to 110 ng/g dry wt, followed by PCBs (0.039-9.2 ng/g dry wt). DDTs and PCBs concentrations were higher in sediment from adjacent to urban areas than those from rural and agricultural sites, suggesting urban areas as important point sources of DDTs and PCBs to the river. Ratio of p,p'-DDT/p,p'-DDE was lower compared to those previously reported. However, some samples still had the ratio higher than 0.5, indicating recent input of DDT into the aquatic environments. This result shows that although the magnitude of contamination decreased over time, recent inputs of DDTs to the river still occur. Some sediment samples had concentrations of DDT compounds higher than the standards from the Canadian Environmental Quality Guideline, suggesting continuous monitoring for POPs contamination in the Mekong River is necessary.     

Calculating of river water quality sampling frequency by the analytic hierarchy process (AHP)

River water quality sampling frequency is an important aspect of the river water quality monitoring network. A suitable sampling frequency for each station as well as for the whole network will provide a measure of the real water quality status for the water quality managers as well as the decision makers. The analytic hierarchy process (AHP) is an effective method for decision analysis and calculation of weighting factors based on multiple criteria to solve complicated problems. This study introduces a new procedure to design river water quality sampling frequency by applying the AHP. We introduce and combine weighting factors of variables with the relative weights of stations to select the sampling frequency for each station, monthly and yearly. The new procedure was applied for Jingmei and Xindian rivers, Taipei, Taiwan. The results showed that sampling frequency should be increased at high weighted stations while decreased at low weighted stations. In addition, a detailed monitoring plan for each station and each month could be scheduled from the output results. Finally, the study showed that the AHP is a suitable method to design a system for sampling frequency as it could combine multiple weights and multiple levels for stations and variables to calculate a final weight for stations, variables, and months.