Zinc accumulation and synthesis of ZnO nanoparticles using Physalis alkekengi L

A field survey and greenhouse experiments were conducted using Physalis alkekengi L. to investigate strategies of phytoremediation. In addition, ZnO nanoparticles were synthesized using P. alkekengi. P. alkekengi plants grew healthily at Zn levels from 50 to 5000 mg kg⁻¹ in soils. The plants incorporated Zn into their aerial parts (with mean dry weight values of 235-10,980 mg kg⁻¹) and accumulated biomass (with a mean dry weight of 25.7 g plant⁻¹) during 12 weeks. The synthesized ZnO nanoparticles showed a polydisperse behavior and had a mean size of 72.5 nm. The results indicate that P. alkekengi could be used for the remediation of zinc-contaminated soils. Moreover, the synthetic method of synthesizing ZnO nanoparticles from Zn hyperaccumulator plants constitutes a new insight into the recycling of metals in plant sources.     

Arsenic release from arsenic-bearing Fe-Mn binary oxide: effects of E(h) condition

Ferric and manganese binary oxide (FMBO) has been successfully used to remediate arsenic-polluted river, but there still lacks sufficient data to evaluate its effects on environments. The release behaviors of iron (Fe), manganese (Mn), and arsenic (As) in different E_h ranges were investigated for As-bearing FMBO sediment after remediating As-polluted DaSha River by FMBO. Under high E_h range (+550 to +400 mV), slight dissolution of Fe and Mn, which corresponded to 12.2% and 25.6%, and less than 5% of As release were observed in 336 h. Under lower E_h range (+50 to −100 mV), elevated extent of the dissolution of Mn and Fe were observed, which corresponded to as high as 61.3% and 70.1%. Under such conditions, the dissolution rate of Mn was higher than that of Fe. Furthermore, from the established relationship of As release and the dissolution of Fe and Mn, the release of As seemed dominated by the dissolution of Fe. X-ray photoelectron spectroscopy (XPS) analysis demonstrated the release of Fe, Mn, As(III), and As(V) after sodium ascorbate-treatment, and the re-adsorption of As(V), as indicated from the increased binding energy of As 3d from 44.78 to 45.83 eV. Surface element composition analysis indicated significant decrease of Mn from 3.22% to 0.54%, slight increase of Fe from 12.45% to 13.67%, and elevated ratio of As from 0.11% to 0.32% accordingly. The main reactions of Fe and Mn dissolution and the pathways of As release under different E_h ranges were also proposed.     

铁盐与铝盐对腈纶废水生化出水混凝特性的对比

针对腈纶废水生化单元出水,对比研究了Al2(SO4)3和Fe2(SO4)3在不同絮凝剂投量和p H时的混凝处理效果,并利用紫外-可见分光光度法(UV-Vis)、三维荧光光谱(EEM)、凝胶渗透色谱(HPSEC)等对混凝特性进行了初步探讨。研究显示,2种混凝剂在投量为63.5 mg/L时可获得30%以上的COD去除率,且最佳p H为中性附近。当投量小于32 mg/L时,Al2(SO4)3较Fe2(SO4)3具有更高的COD去除率,进一步增大混凝剂的投量很难提高Al2(SO4)3对COD的去除率,而Fe2(SO4)3则在有限范围内能持续提高COD去除率。EEM光谱分析显示,与Al2(SO4)3相比,Fe2(SO4)3对有机物具有更广的处理范围和更好的去除效果。HPSEC分析表明,Fe2(SO4)3相对于Al2(SO4)3在去除重均分子量为2 776、1 856和1 325 Da的有机物组分方面具有优势。铁盐或铝盐混凝是深度净化腈纶废水生化单元出水的可行方案之一。     

腐植酸强化苯酚厌氧发酵降解

在无外加电子受体的条件下,首次研究了腐植酸对活性污泥厌氧降解苯酚的影响。研究结果表明,腐植酸Suwannee River Humic Acid Standard(SR-HA)、Leonardite Humic Acid Standard(L-HA)和Pahokee Peat Humic Acid(PP-HA)作为氧化还原介体能够提高苯酚的厌氧发酵降解效率。其中腐植酸PP-HA对苯酚的厌氧降解表现出了最为明显的强化效果,反应进行36 h后,苯酚去除率提高了18.5%。当单独投加的PP-HA浓度在0至100 mg/L范围内,苯酚的厌氧降解效率随着腐植酸浓度增加而逐渐提高,而浓度大于100 mg/L后,腐植酸对苯酚降解效率的促进作用随着PP-HA浓度的增加逐渐减缓。除此之外,当低浓度的蒽醌-2-磺酸钠(AQS)(0.02 m M)和PP-HA(20 mg/L)在反应体系中共存时,相比于无介体存在的对照组,苯酚厌氧降解效率提高了约1.4倍。产物分析结果表明,乙酸和CH4作为苯酚发酵降解的重要产物被检测出来。最后,在氧化还原介体腐植酸的存在下,初步探讨了苯酚厌氧发酵降解的代谢途径。     

Pseudomonas sp.fz胞外分离物降解四溴双酚A

四溴双酚A(TBBPA)是全球消耗量最大的溴系阻燃剂。通过活性物质的定位、分离和TBBPA产物的分析等步骤,对Pseudomonas sp.fz胞外分离物降解TBBPA进行了研究。结果表明,存在于胞外的活性物质通过异丙基断裂和脱溴两条途径降解TBBPA。通过超滤,Sephadex G-10分离纯化得到了具有降解活性的小分子物质,分子量约为376~456 Da,初步鉴定为短肽类物质。这种小分子物质具有很好的热稳定性(30~80℃),在弱酸性条件下(2.0~5.0)活性较高,其活性还受金属离子、氧气和抑制剂(Na N3)的影响。此外,部分纯化的小分子物质在一定条件下能够产生羟基自由基(·OH)。     

Geochemistry of tin (Sn) in Chinese coals

Environmental Geochemistry and Health - Based on 1625 data collected from the published literature, the geochemistry of tin (Sn) in Chinese coals, including the abundance, distribution, modes of...     

Anaerobic biodegradation of cellulosic material: Batch experiments and modelling based on isotopic data and focusing on aceticlastic and non-aceticlastic methanogenesis

Utilizing stable carbon isotope data to account for aceticlastic and non-aceticlastic pathways of methane generation, a model was created to describe laboratory batch anaerobic decomposition of cellulosic materials (office paper and cardboard). The total organic and inorganic carbon concentrations, methane production volume, and methane and CO₂ partial pressure values were used for the model calibration and validation. According to the fluorescent in situ hybridization observations, three groups of methanogens including strictly hydrogenotrophic methanogens, strictly aceticlastic methanogens (Methanosaeta sp.) and Methanosarcina sp., consuming both acetate and H₂/H₂CO₃ as well as acetate-oxidizing syntrophs, were considered. It was shown that temporary inhibition of aceticlastic methanogens by non-ionized volatile fatty acids or acidic pH was responsible for two-step methane production from office paper at 35 °C where during the first and second steps methane was generated mostly from H₂/H₂CO₃ and acetate, respectively. Water saturated and unsaturated cases were tested. According to the model, at the intermediate moisture (150%), much lower methane production occurred because of full-time inhibition of aceticlastic methanogens. At the lowest moisture, methane production was very low because most likely hydrolysis was seriously inhibited. Simulations showed that during cardboard and office paper biodegradation at 55 °C, non-aceticlastic syntrophic oxidation by acetate-oxidizing syntrophs and hydrogenotrophic methanogens were the dominant methanogenic pathways.     

乡镇工业企业的职业安全卫生工作亟待加强管理

说明目前乡镇工业企业中职业安全卫生问题十分突出。据调查，厂矿工伤事故发生率为８．２３％，每千名职工的工伤发生率为２．６６人，每十万名职工的工伤死亡率为７．０２人。通过对事故的原因进行分析，提出了加强监督管理的建议。     

中国环保事业的回顾与展望

1970年至现在的30年,中国的环境保护事业大致经历了三个阶段:1970年至1978年,是中国环境保护的萌芽和起步阶段;1979年至1991年,是中国环境保护的奠基和成长阶段;1992年至现在,是中国环境保护的发展和壮大阶段。本文对中国环保事业的发展历程进行了回顾和论述,在此基础上,展望了环境保护的前景,抒发了梦想与期待。     

圆柱体相似试件的拉裂破坏模型研究

首先简单介绍了单轴压缩试验的具体情况。对于拉裂破坏模式,提出了相应的力学计算模型,并建立了抗压强度和抗拉强度的关系式。对于由拉裂面的存在而导致试件最终破坏的计算模型,提出了4种相应的假设。其中,对4种特征的拉裂面建立了抗压强度和抗拉强度的关系式。