Enhancing bioremediation of diesel oil and gasoline in soil amended with an agroindustry sludge

This paper presents a study of the bioremediation of diesel oil and gasoline by a series of controlled laboratory tests. Sludge from an agroindustry was used to enhance bioremediation of both gasoline and diesel oil mixed with a soil mass to compare its efficiency with that of a mineral fertilizer. Effects of soil microbiology and soil mixtures were investigated by means of evolution of CO2, microorganism populations at 90 days, pH at 65 and 95 days, mineral nitrogen, and gas chromatographic analysis of the benzene, toluene, methyl tertiary butyl ether, C8, and C9+total aromatics at the end of the experiments. Treatments containing sludge showed better soil conditions after 170 days of treatment (inorganic nitrogen and microbiota activity) compared with gasoline and diesel oil without amendments. Samples had no detectable traces of the measured hydrocarbons at 170 days of treatment.     

Passive air sampling theory for semivolatile organic compounds

The mathematical modelling underlying passive air sampling theory can be based on mass transfer coefficients or rate constants. Generally, these models have not been inter-related. Starting with basic models, the exchange of chemicals between the gaseous phase and the sampler is developed using mass transfer coefficients and rate constants. Importantly, the inter-relationships between the approaches are demonstrated by relating uptake rate constants and loss rate constants to mass transfer coefficients when either sampler-side or air-side resistance is dominating chemical exchange. The influence of sampler area and sampler volume on chemical exchange is discussed in general terms and as they relate to frequently used parameters such as sampling rates and time to equilibrium. Where air-side or sampler-side resistance dominates, an increase in the surface area of the sampler will increase sampling rates. Sampling rates are not related to the sampler/air partition coefficient (K(SV)) when air-side resistance dominates and increase with K(SV) when sampler-side resistance dominates.     

Modeling mercury fluxes and concentrations in a Georgia watershed receiving atmospheric deposition load from direct and indirect sources

This paper presents a modeling analysis of airborne mercury (Hg) deposited on the Ochlockonee River watershed located in Georgia. Atmospheric deposition monitoring and source attribution data were used along with simulation models to calculate Hg buildup in the subwatershed soils, its subsequent runoff loading and delivery through the tributaries, and its ultimate fate in the mainstem river. The terrestrial model calculated annual watershed yields for total Hg ranging from 0.7 to 1.1 microg/m2. Results suggest that approximately two-thirds of the atmospherically deposited Hg to the watershed is returned to the atmosphere, 10% is delivered to the river, and the rest is retained in the watershed. A check of the aquatic model results against survey data showed a reasonable agreement. Comparing observed and simulated total and methylmercury concentrations gave root mean square error values of 0.26 and 0.10 ng/L, respectively, in the water column, and 5.9 and 1 ng/g, respectively, in the upper sediment layer. Sensitivity analysis results imply that mercury in the Ochlockonee River is dominated by watershed runoff inputs and not by direct atmospheric deposition, and that methylmercury concentrations in the river are determined mainly by net methylation rates in the watershed, presumably in wetted soils and in the wetlands feeding the river.     

Screening of organic halogens and identification of chlorinated benzoic acids in carbonaceous meteorites

The occurrence of halogenated organic compounds measured as a sum parameter and the evidence of chlorinated benzoic acids in four carbonaceous meteorites (Cold Bokkeveld, Murray, Murchison and Orgueil) from four independent fall events is reported. After AOX (Adsorbable organic halogen) and EOX (Extractable organic halogen) screening to quantify organically bound halogens, chlorinated organic compounds were analyzed by gas chromatography. AOX concentrations varying from 124 to 209 microg Cl/g d.w. were observed in carbonaceous meteorites. Ion chromatographic analysis of the distribution of organically bound halogens performed on the Cold Bokkeveld meteorite revealed that chlorinated and brominated organic compounds were extractable, up to 70%, whereas only trace amounts of organofluorines could be extracted. Chlorinated benzoic acids have been identified in carbonaceous meteorite extracts. Their presence and concentrations raise the question concerning the origin of halogenated, especially chlorinated, organic compounds in primitive planetary matter.     

Applicability of Fenton and H2O2/UV reactions in the treatment of tannery wastewaters

In this paper we evaluated the H2O2/UV and the Fenton's oxidation processes for the treatment of tannery wastewater under different experimental conditions. Efficiencies were judged by the amounts of organic substances degraded or eliminated under these treatment techniques. Daphnia magna and Vibrio fischeri were used to monitor toxicity. Organic compounds contained in the untreated and treated tannery wastewater were determined and identified using substance specific techniques. Gas chromatography-mass spectrometry (GC-MS) in positive electron impact (EI(+)) mode was applied to determine volatile organics. Atmospheric pressure ionization (API) mass (MS) and tandem mass spectrometry (MS-MS) coupled with flow injection analysis (FIA) or liquid chromatography (LC) were used to detect or identify polar organic pollutants. The experimental results indicated that both oxidation processes--H2O2/UV at pH 3 and Fenton at pH 3.5--are able to reduce TOC content by mineralisation of the organic compounds.     

Composition of wet and bulk deposition in Erzurum, Turkey

Seasonal variations in the chemical characteristics of wet and bulk deposition samples collected in Erzurum were investigated for the period March 2002-January 2003. Major cations (Ca2+, K+, Mg2+) and major anions (SO4(2-),NO3-) were determined in bulk and wet deposition samples; pH was also measured in wet deposition. The average pH of the wet deposition at Erzurum was 6.6 due to extensive neutralization of the acidity. A strong relationship between pH and SO4(2-) concentrations was observed in all seasons; however, only a weak relationship was found between pH and NO3-. On a seasonal basis, the correlation between Ca2+ and SO4(2-) concentrations was stronger in winter than in summer. Seasonal variations of ions were examined in both wet and bulk deposition samples. Although maximum concentrations of anions generally occurred during winter and spring, cation concentrations peaked in summer for both wet and bulk deposition. Results indicated that Ca2+ was the dominant cation and SO4(2-) the dominant anion in all deposition samples at Erzurum. Even though correlations among the crustal ions (calcium, magnesium and potassium) were high, the relationship between anthropogenic ions (sulfate and nitrate) was less clear in bulk deposition.     

Endocrine disruption of water and sediment extracts in a non-radioactive dot blot/RNAse protection-assay using isolated hepatocytes of rainbow trout

Goal, Scope and Background In order to evaluate the estrogenic activity of sediments and XAD water extracts of selected sites of the catchment area of the River Neckar, a river system in Southern Germany, an integrative assessment approach was used to assess the ecological hazard potential of endocrine-disrupting compounds in sediment and water. Methods The approach is based on estrogen receptor-mediated vitellogenin synthesis induced in isolated hepatocytes of rainbow trout and quantified in a non-radioactive dot blot/RNAse protection-assay in parallel to comprehensive chemical analyses of estrogenic substances. Results and Discussion Numerous investigated extracts revealed an estrogen activity comparable to that of the positive control (1 nM 17?-estradiol corresponding to 270 ng/L in the test medium). Based on a concentration factor of 30 in the extracts and a recovery of XAD resins of approximately 80 %, 17?-estradiol equivalent concentrations between 20 and 26.7 ng/L could be calculated downstream of a sewage treatment plant (< 0.1 ng/L for a reference site). A comparison of the bioassay-derived Bio-TEQs (toxicity equivalents) and the Chem-TEQs revealed a high correlation with a Pearson coefficient of 0.85, indicating that the same ranking of the samples could be obtained with respect to the endocrine disrupting potential with both chemical and bioanalytical analysis. However, the TEQ concentrations computed from chemical analyses were significantly lower than the bioassay-derived TEQ concentrations. In fact, in none of the samples, more than 14 % of the vitellogenin-inducing potency could be attributed to the substances (steroids, alkylphenols, bisphenol A, diethylstilbestrol) analyzed. A comparison of the endocrine disrupting potential of sediments extracted by the solvents acetone and methanol revealed lower biological effects for acetone-extracted samples. Possible reasons may be a masking of endocrine effects in acetone extracts by cytotoxicity, a low extraction efficiency of the solvent acetone, or anti-estrogen potencies of some extracted sediment compounds. Using a mass balance approach, the contribution of the compounds analyzed chemically (Chem-TEQs) to the total endocrine activity (Bio-TEQs) was calculated. Based on the very low detection limits, particularly of the steroids with their high TEF factors, results revealed that a calculation of the Chem-TEQs is associated with considerable scale inaccuracy: Whereas only 7-15 % of the biological effectiveness (Bio-TEQs) could be explained by endocrine substances identified above the detection limits, the assumption of concentrations slightly below the given detection limits would result in a significant over estimation (137-197 %) of the Bio-TEQs. Even the interassay variation of the dot blot assay with different fish donors for primary hepatocyte (factor 2 - 2.5) is relatively low, when compared to the large range of the Chem-TEQ concentrations (factor 20) obtained when applying different modes of calculation. Conclusions and Outlook Overall, only a minor portion of the endocrine activity detected by bioassays could be linked to compounds identified by chemical analysis. In vitro assays for assessment of endocrine activities are useful as sensitive integrating methods that provide quantitative estimates of the total activity of particular receptor-mediated responses. Although discrepancies may also result from different bioanalytical approaches, it is overall likely that bioanalytical and not chemical analytical approaches give the correct estimate of endocrine disrupting potencies in environmental samples. As a conclusion, assessment of endocrine disruption based on chemical analysis alone does not appear sufficient and further research into the spectrum of substances with potential endocrine activity as well as into additive or even synergistic effects in complex environmental samples is urgently needed.     

Interpretation of heavy metal data from mussel by use of multivariate classification techniques

Different strategies of multivariate analysis of metals concentrations (Mn, Fe, Ni, V, Co, Cu, Cd, Hg, Pb, Na, K) in mussel samples from different spanish markets are used to interpret a data base and identify differences between species and origin of the samples. Principal Component Analysis and Potential curves are applied to properly classify unknown samples from representative mussels samples (Mytilus edulis and Perna canaliculus). Also, Principal Components Analysis is used as display method to visualize the relation between the variables and objects of interest.     

Degradation of three phenylurea herbicides (chlortoluron, isoproturon and diuron) by micromycetes isolated from soil

As part of a study conducted on the fate of xenobiotics in the environment, a selection of 100 strains of micromycetes (Ascomycetes, Basidiomycetes and Yeasts) have been cultivated in liquid synthetic medium with 3 phenylurea herbicides: chlortoluron and isoproturon (100mg L-1) and diuron (20mg L-1). While 17 strains depleted isoproturon over 50% only 4 depleted diuron and 2 chlortoluron at the same level. The best results were obtained with Bjerkandera adusta and Oxysporus sp which were the most efficient towards the 3 substrates. After 2 weeks Bjerkandera adusta depleted chlortoluron 98%, diuron 92% and isoproturon 88%.     

The evolution of mass balance models of persistent organic pollutant fate in the environment

Current approaches to modelling the fate of persistent organic pollutants (POPs) in the environment have evolved in response to four dominant characteristics of these substances; namely: (1) the presence of POPs in virtually all environmental phases and the ease with which they move from one to the other requires multi-compartmental modelling. Describing transport across phase boundaries becomes as, or even more, important as quantifying transport within the phases; (2) POPs may persist in the environment for many decades. For chemicals that 'have time', concepts such as equilibrium partitioning and steady-state become more important than for short-lived substances whose fate is more controlled by the rates of transformation; (3) measuring POPs is difficult and expensive and observed concentrations of POPs are not available in high spatial or temporal resolution. Consequently, high resolution tends not to be a high priority in POP models; and (4) detrimental effects of POPs often manifest themselves in top predators, which has led to a focus on modelling biotic uptake and transfer within food chains. The task of building a POPs model is viewed as combining the four 'building blocks' of partitioning, transport, transformation and source data with the help of the law of the conservation of mass. Process models, evaluative models, models of real local, regional and global fate, as well as biological uptake models are presented and references to numerous examples are provided. An attempt is made to forecast future directions in the field of POPs modelling. It is expected that modelling techniques that do not rely on quantitative emission estimates as well as approaches that take into account spatial, temporal and climatic variability as well as parameter uncertainty will increase in importance. Finally, the relationship between modelling POPs and models of other pollutant issues is addressed, as are potential interactions between POPs and pollutant issues such as eutrophication, acidification and global climate change.